Tender For Repair/ Maintenance Of Solar Energy Generation Plant & Infrastrature Near Kalua Nala And Certain Repair/Maint Of Stp At Central & North Zone Area Under Ge (N) Binnaguri
Tender Value
65 Lakhs
Estimated cost
Bid Submission
19 Dec 2026
27 days left
EMD
1.25 Lakhs
Bank guarantee accepted
Document Fee
1000
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Jalpaiguri → West Bengal
EMD Exemption
Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Repair/ Maintenance Of Solar Energy Generation Plant & Infrastrature Near Kalua Nala And Certain Repair/Maint Of Stp At Central & North Zone Area Under Ge (N) Binnaguri
BOQ
| Sl. No. | Item Description |
| 1 | Taking up cast iron main with flanged ends including disconnecting pipes and fittings complete as specified and directed:- |
| 2 | (a) 200 mm bore |
| 3 | (b) 150 mm bore |
| 4 | Taking down GI Tubing including disconnecting pipes and fittings complete as specified and directed :- |
| 5 | (a) 40/50 mm bore |
| 6 | M/L for DI pipes with flanged ends, centrifugally cast, class LA, in any length laid in trenches as specified and directed :- |
| 7 | (a) 200 mm bore |
| 8 | (b) 150 mm bore |
| 9 | Refixing old CI/DI pipes mains obtained from dismantling with flanged ends complete all as specified and directed :- |
| 10 | (a) 200mm bore |
| 11 | (b) 150 mm bore |
| 12 | Supply and fix in replacement CI butterfly valve 150 mm dia confirming to IS code 13095:2020 with complete screwed for iron pipe and fixed for 150 mm bore as specified and directed . |
| 13 | Supply and fixing GI tubing medium grade ISI Marked on wall/ laying on floor/ceiling including with all fittings such as elbow, union, reducer, tees, bends etc and short length complete all as specified and directed for following sizes:- |
| 14 | (a) 40 mm bore |
| 15 | (b) 50 mm bore |
| 16 | Taking out accumulated mixture of sludge and sludge water from underground sump behind army school,raw sump of North Zone STP & raw sump of Central Zone STP by mechanically using equipment & disposal of the same to a distance exc 25 mtr and exc 50 mtr to drying bed at North Zone STP and spreading leveling by mechanically using equipment & transportation to outside military defence land area etc complete all as specified and as directed by the Engineer-in-Charge (Note : This operation shall be carried out once in every three months ) |
| 17 | Taking out accumulated mixture of sludge and sludge water from 2 Nos aeration tank of North Zone STP & 2 Nos aeration tank of Central Zone STP by mechanically using equipment & disposal of the same to a distance exc 25 mtr and not exc 50 mtr to drying bed at North Zone STP and spreading leveling by mechanically using equipment & transportation to outside military defence land area etc complete all as specified and as directed by the Engineer-in-Charge (Note : This operation shall be carried out once in every three months ) |
| 18 | Taking out accumulated mixture of sludge and sludge water from flocculator tank of North Zone STP by mechanically using equipment & disposal of the same to a distance exc 25 mtr and not exc 50 mtr to drying bed at North Zone STP and spreading leveling etc complete all as specified and as directed by the Engineer-in-Charge (Note : This operation shall be carried out once in every three months ) |
| 19 | Taking out accumulated mixture of sludge and sludge water from 1 No tube settler tank of North Zone STP & 2 Nos tube settler tank of Central Zone STP by mechanically using equipment & disposal of the same to a distance exc 25 mtr and not exc 50 mtr to drying bed at North Zone STP and spreading leveling etc complete all as specified and as directed by the Engineer-in-Charge (Note : This operation shall be carried out once in every three months ) |
| 20 | Taking out accumulated mixture of sludge and sludge water from chlorine contact tank of North Zone STP & chlorine contact tank of Central Zone STP by mechanically using equipment & disposal of the same to a distance exc 25 mtr and not exc 50 mtr to drying bed at North Zone STP and spreading leveling etc complete all as specified and as directed by the Engineer-in-Charge (Note : This operation shall be carried out once in every three months ) |
| 21 | Taking out accumulated mixture of sludge water and treated water from treated water tank of North Zone STP & treated water tank of Central Zone STP by mechanically using equipment & disposal of the same to a distance exc 25 mtr and not exc 50 mtr to drying bed at North Zone STP and spreading leveling etc complete all as specified and as directed by the Engineer-in-Charge (Note : This operation shall be carried out once in every three months ) |
| 22 | Taking out accumulated mixture of sludge and sludge water from sludge holding tank of North Zone STP by mechanically using equipment & disposal of the same to a distance exc 25 mtr and not exc 50 mtr to drying bed at North Zone STP and spreading leveling etc complete all as specified and as directed by the Engineer-in-Charge (Note : This operation shall be carried out once in every three months ) |
| 23 | Cleaning of blockage of Primary & secondary Bio-filter (each bio-filter consists of four arms) nozzle by wire or by opening the nozzle lid complete all as specified and as directed. (Note : This cleaning work shall be done whenever blockage occured.) |
| 24 | Taking out accumulated mixture of sludge and sludge water from digester by mechanically using equipment and disposal of the same to a distance exc 10 mtr and not exc 50 mtr to drying bed, spreading, leveling complete all as directed by the Engineer-in-charge (Note : This operation shall be carried out once in every six months. |
| 25 | Taking out accumulate dry sludge (Dry manure) from drying beds by mechanically using equipment and removing from site all as directed by Engineer-in-charge (Note : The drying manure obtain from this item shall become contractors property and recovery shall be made in advance with credit schedule). |
| 26 | Dismantling defective current collector assembly of primary and secondary clarifiers and refixing in position after carrying out servicing/replacement of the following worn-out parts as given below after re-doing all electrical connections complete all as specified and directed. (a) Carbon brush with spring as per existing size and specification - 4 Nos. (b) Carbon brush holder as per existing size and specification - 04 Nos. (c) Cleaning/greasing of centre bearing of clarifier bridge all as directed. |
| 27 | S&F in repair 'V' belt size SPC - 440 for Air blowerr complete all as specified and directed. |
| 28 | M&L in repair of gland packaging 15 mm size for non clogging pumping sets, sluice valves at STP all as specified and ditected. |
| 29 | M&L in replacement for earthing with galvanized steel earth plate electrode 60 cm x 60cm x 6mm thick, buried directly in ground (earth pit not less than 2.25m below normal ground level) with top edge of earth plate not less than 1.5m below normal ground level connected to galvanized earth lead strip 25x4mm (earthing lead from earth electrode to test point upto 7.5m ) by means of bolts, nut, checknuts and washers of galvanized iron or steel all as shown in electrical plate No 3 of MES Schedule Pt-I 1991, GI earth lead strip of size 25mm x 4mm protected by GI pipe 40mm dia light grade and connected to earth test point including excavation & earthwork including testing on completion complete all as specified and directed. |
| 30 | M & L for disconnection of Electrical/Mechanical connection and taking out carefuly of electric motor capacity 7.5/5HP (3 phase, 415V 50 HZ, AC Supply) of any make and rewinding the same with super enameled copper wire of existing gauge/specification making of heat varnishing, greasing and one coat spray/ brush painting with synthetic enemel paint of recommended colour including replacement of bearings NDE and DE as per existing specification and size including refixing the motor in position making all electrical and mechanical connections and testing complete all as specified and as directed . |
| 31 | All as per item no 30 here-in- before but capacity 3/ 2HP |
| 32 | M & L for disconnection of Electrical/Mechanical connection and taking out carefuly of submersible Raw Sewage pump capacity 7.5/ 10 HP (3 phase, 415V 50 HZ, AC Supply) of any make and rewinding the same with super enameled copper wire of existing gauge/specification making of heat varnishing, including refixing the motor in position making all electrical and mechanical connections and testing complete all as specified and as directed . |
| 33 | All as per item no 32 here-in- before but capacity 5 HP |
| 34 | M & L for disconnection of Mechanical connection and taking out carefuly of Air Blower of capacity 900 Cum per hour and replacement of Air Filter ,gear oil, grease, oil seal , bearings NDE and DE as per existing specification and size including refixing the Air blower in position making all mechanical connections and testing complete all as specified and as directed . |
| 35 | M&L for cutting the bushes, grass, thorney bushes, small plants/trees up to a height of 5 mtr in and around STP north zone and central zone incl surface dressing and removing the waste material to a distance not exceeding 50 mtr from the starting point complete all as specified and directed. |
| 36 | M & L for repairing of motor control Panel with dismantling all unserviceable fitting and electric connection and reassembling the same after carry out the following replacement/jobs and painting with one coat of synthetic enamel paint after prepartion of internal and external surface includingre wiring with suitable size of copper wire,connectors & circuit indicators and lugs etc. Testing on load complete all as specified and as directed. (Note : Accessories to be replaced shall be measured and paid separately as supply in replacement which mentioned here-after. |
| 37 | Supply in replacement only following spares for motor control Panel |
| 38 | Motor protection circuit breaker with 415 V breaking capacity, Icu 50 KA, 32 Amp |
| 39 | Motor protection circuit breaker with 415 V breaking capacity, Icu 50 KA, 63 Amp Capacity |
| 40 | Motor protection circuit breaker with 415 V breaking capacity, Icu 50 KA, 125 Amp Capacity |
| 41 | Motor protection circuit breaker with 415 V breaking capacity, Icu 50 KA, 160 Amp Capacity |
| 42 | Power contactor suitable for operation on 03 Phase, 415 Voltage, Max. opt. current 18 Amps. |
| 43 | Power contactor suitable for operation on 03 Phase, 415 Voltage, Max. opt. current 32 Amps. |
| 44 | Power contactor suitable for operation on 03 Phase, 415 Voltage, Max. opt. current 40 Amps. |
| 45 | Pump protection relay, 03 Phase 415 Volt, Imin 35 Amp, Imax 45 Amp. |
| 46 | Pump protection relay, 03 Phase 415 Volt, Imin 12.5 Amp, Imax 18.5 Amp. |
| 47 | Pump protection relay, 03 Phase 415 Volt, Imin 8.5 Amp, Imax 12.5 Amp. |
| 48 | Electronic timer 415 volt, 3-10 sec switching time. |
| 49 | Volt meter 0-500 Volt square type 96mm x 96mm size |
| 50 | Ammeter 0-100 Amp. Square type 96mm x 96 mm size |
| 51 | Selector switch for Ammeter/ Volt meter. |
| 52 | Indicator lamp with holder ( RED, YELLOW and BLUE), Volt with built in resistor. |
| 53 | Push button switch for starter ON/OFF. |
| 54 | Terminal block 3 way |
| 55 | CT Coil 100/5 ratio. |
| 56 | Supply & use of Disinfectant polyelectrolyte chemical amphoteric |
| 57 | Supply & use of Poly aluminium chloride chemical Medium basicity 40% & pH Value 2.5 to 4.5 Make : E-in-C approved |
| 58 | Supply & use of Sodium hypochlorite Granules chemical 4 to 6 % & pH value 11-13 Make : E-in-C approved |
| 59 | Supply & use of Calcium hypochlorite Granules chemical 65 to 70% & pH value 10.5 -11 Make : E-in-C approved Please Enable Macros to View BoQ information |
| 60 | Supply & use of Calcium hypochlorite Granules chemical 65 to 70% & pH value 10.5 -11 Make : E-in-C approved Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Nov 19, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedDec 19, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 27 daysDec 21, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 29 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender