Housing Urban and Rular Development Local Bodies Closing in 8 days TDR #58616018

Tender For Construction And Development Work Of The Canal Junction In The Vashistha Kunj Housing Scheme, Ayodhya.

Issued by Local Bodies · Ayodhya, Uttar Pradesh
Tender Value
54.18 Lakhs
Estimated cost
Bid Submission
28 Nov 2026
8 days left
EMD
1.08 Lakhs
Bank guarantee accepted
Document Fee
5900
Non-refundable
Tender Type
Online

Tender Overview

Competition Type
NCB
Bidding Type
Tender
Location / State
Ayodhya → Uttar Pradesh
EMD Exemption
Not Available
Quantity
Not Available

Project Description

Tender for Construction And Development Work Of The Canal Junction In The Vashistha Kunj Housing Scheme, Ayodhya.

BOQ

Name of Work:- Construction and development work of the Canal Junction in the Vashistha Kunj Housing Scheme, Ayodhya.
Sl. No. Item Description
1Civil Road and Drain Work
2Earth work in excavation by mechanical means (Hydraulic excavator) / manual means over areas (exceeding 30cm in depth, 1.5m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth, lead up to 50m and lift up to 1.5m,as directed by Engineer-in-Charge. All kind of soil-DSR 2023/ 2.6.1
3Earthwork in filling upto 8 km-SR
4Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:4:8 (1 Cement : 4 coarse sand : 8 graded stone aggregate 40 mm nominal size)-DSR 2023 / 4.1.8
5Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level :1:2:4 (1 cement : 2 coarse sand (zone-III) derived from natural sources : 4 graded stone aggregate 20 mm nominal size derived from natural sources)-DSR 4.1.3
6Providing and laying in position ready mixed or site batched design mix cement concrete for reinforced cement concrete work; using coarse aggregate and fine aggregate derived from natural sources, Portland Pozzolana / Ordinary Portland /Portland Slag cement, admixtures in recommended proportions as per IS: 9103 to accelerate / retard setting of concrete, to improve durability and workability without impairing strength; including pumping of concrete to site of laying, curing, carriage for all leads; but excluding the cost of centering, shuttering, finishing and reinforcement as per direction of the engineer-in charge; for the following grades of concrete. Concrete of M25 grade with minimum cement content of 330 kg /cum-DSR 5.33.1.1
7Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete upto plinth level.Thermo-Mechanically Treated bars of grade Fe-500D or more-DSR 5.22.6
8Centering and shuttering including strutting, propping etc. And removal of form for :Foundations, footings, bases of columns, etc. for mass concrete-DSR 5.9.1
9Centering and shuttering including strutting, propping etc. And removal of form for :Lintels, beams, plinth beams, girders, bressumers and cantilevers-DSR 5.9.5
10Centering and shuttering including strutting, propping etc. And removal of form for :Columns, Pillars, Piers, Abutments, Posts and Struts-DSR 5.9.6
11Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in foundation and plinth in: Cement mortar 1:6 (1 cement :6 coarse sand)- DSR 6.1.2
12Polished Granite stone slab of all colour and texture except Black, Cherry/Ruby Red -DSR 11.56.2
13Providing edge moulding to 18 mm thick marble stone counters, Vanities etc., including machine polishing to edge to give high gloss finish etc. complete as per design approved by Engineerin- Charge.Granite work-DSR 8.3.2
14Steel work welded in built up sections/ framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required. In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works. -DSR 10.25.2
15Extra for CNC design & cutting on MS/SS sheet of thickness above 3 mm and not more than 6 mm thickness-SR
168 layer Acryflex Synthetic system Paint (LDA approved rate)-SR
17Providing and fixing post delineators made of ABS round body fitted with 2 nos 100 mm dia high reflective reflectors and mounted on MS pipe of 65 mm dia duly powder coated anti-rust and anti theft steel to be installed as per direction of Engineer-in-charge.-DSR 16.65
18Providing and fixing Glow studs of size 100x20 mm made of heavy duty body shall be moulded ASA (Acrylic styrene Acryloretrite ) or HIP (High impact polystyrene) or ABS having electronically welded micro- prismatic lens with abrasion resistant coating as approved by Engineer in charge. The glow stud shall support a load of 13635 kg tested in accordancewith ASTM D4280. The slope of retro- reflective surface shall be 35 (+/-5) degress to base. The reflective panels on both sides with at least 12 cm of reflective area up each side. The luminance intensity should be as per the specification and shall be tested as described in ASTM I: 809 as recommended in BS: 873 part 4 : 1973. The studs shall be fixed to the Road surface using the adhesive conforming to IS, as per procedure recommended by the manufacturer complete and as per direction of Engineer-in-charge.-DSR 16.50
19Metal Sculpture ( Book Stand)Supply and installation of a Metal sculpture with 2 to 3 mm Corten steel sheet with inside iron armature, Sculpture Size 10 ft. Height x 10 ft. Length x 7.5 ft. Width Corten steel, an Anti- rust metal properties, with the least maintenance, with inside armature, PU paint, coloring according to the design, laser cutting and fabrication with High class finish sculpture with inside LED Light all associated costs for materials, transportation, installation, and artist fees.Excluding:1- Outside focus light on the sculpture 2- Civil Pedestals
20Providing, fixing and Painting of CNC Cut Logo on 5 mm MS sheet size
21Horticulture works
22Digging holes in ordinary soil and refilling the same with the excavated earth mixed with manure or sludge in the ratio of 2:1 by volume (2 parts of stacked volume of earth after reduction by 20% : 1 part of stacked volume of manure after reduction by 8%) flooding with water, dressing including removal of rubbish and surplus earth, if any, with all leads and lifts (cost of manure, sludge or extra good earth if needed to be paid for separately) , 0.60 cm dia and 0.6 cm deep ( Code no 2.14.3 DSR- 2025)-DSR 2.14.3
23Digging holes in ordinary soil and refilling the same with the excavated earth mixed with manure or sludge in the ratio of 2:1 by volume (2 parts of stacked volume of earth after reduction by 20% : 1 part of stacked volume of manure after reduction by 8%) flooding with water, dressing including removal of rubbish and surplus earth, if any, with all leads and lifts (cost of manure, sludge or extra good earth if needed to be paid for separately) Holes 45 cm dia, and 45 cm deep-DSR 2.14.4
24Supplying and stacking at site dump manure from approved source, including carriage upto 5 km lead complete (manure measured in stacks will be reduced by 8% for payment) : Screened through sieve of I.S. designation 20 mm(code no 2.4 DSR-2025)-DSR 2.4.1
25Spreading of sludge, dump manure and/or good earth in required thickness as per direction of officer-in-charge (cost of sludge, dump manure and/ or good earth to be paid separately).(code no 2.8 DSR-2025)-DSR 2.8
26Mixing earth and sludge or manure in the required proportion specified or directed by the Officer-in-charge-DSR 2.9
27Filling mixture of earth and sludge or manure in the desired proportion in trenches, flooding with water and leveling (cost of supplying earth and sludge or manure and mixing excluded).-DSR 2.20
28Supply and mixing of Local Sand(@0.01CuM/Plant) including, cartage, loading, unloading all.
29Providing, stacking and Displaying Furcaria variegated well developed with fresh &healthy foliage 8 to 10 leaves in 30 cm Earthen Pot/ Plastic Pot and as per direction of the officer-in-charge.-DSR 5.31
30Providing and stacking of Euphorbia caracasana (bronze colour leaves) of height 60-75 cm. with 2-3 branches in earthen pot of size 20 cm as per direction of the officer-in-charge.-DSR 8.16
31Providing and stacking of Excoecaria bicolor of height 45-60 cm. in earthen pot of size 20 cm as per direction of the officer-in-charge.-DSR 8.21
32Plantation and reffiling-DSR 2.57
33Electrical work
34Supply and laying of 3Corex6 sqmm aluminium conductor PVC insulated armoured served sheathed cables 1100 Volts grade at a depth of 750 mm below ground level over a cushion of 75 mm. thick sand all around and protected with burnt bricks on sides and on top. On surface the cable run shall be fixed on M.S. clamps etc. of suitable size or as directed by the Engineer-Incharge, complete in all respect. The armouring of the cable shall be properly connected with the earth conductor by clamps etc.-SOR-2022/501/e
35Supply and laying of 4Corex16 sqmm aluminium conductor PVC insulated armoured served sheathed cables 1100 Volts grade at a depth of 750 mm below ground level over a cushion of 75 mm. thick sand all around and protected with burnt bricks on sides and on top. On surface the cable run shall be fixed on M.S. clamps etc. of suitable size or as directed by the Engineer-Incharge, complete in all respect. The armouring of the cable shall be properly connected with the earth conductor by clamps etc. Cable for Incomming supply-SOR-2022/501/I
36Supply and fixing of decorative 8 to 16 Watt LED bollard luminaire with driver set confirming to IP 65 and above protection complete in all respect (Agency should be provide the sample of lightg for approval in ADA Bollard light. hight should be 750mm to 1000mm ) Make-UP PWD)-SOR 2022/1442
37Supply and fixing following capacity of automatic street light cubicle control panel painted with anti corrosive alkali and acid proof paint consisting of time switch TSO 100 series with contactors, HRC fuses/MCB, isolating switch metering instrument & instrument box with CTs etc. in case of TPN, complete in all respect-SOR 2022/807 f/i
38S&F of 0.5 Amp. to 5 Amp. DP MCB (10 KA) C Curve-SOR 2022/1008
39Supply and fixing of brass nickle plated compression gland for PVC insulated & armoured served sheathed, underground cable including rubber ring etc. complete in all respect. The armouring of the cable shall be properly connected with the earth as per direction of Engineer-Incharge.-SOR 2022/504D
40Supply and fixing of plain or pin type copper/Alluminium tin plated cable socket ( lug ) to the cable leads, insulating with tape and making connection etc. complete in all respect as per direction of the Engineer-SOR 2022/504/D
41Supply & Fixing of 40 Watt LED Surface Mounting Luminaire with PC Housing and opal finish cover confirming to IP 65 Complete in all respect for focus of sculture.-SOR 2022/1418(A)
42Supply and fixing and concealing of 32 mm dia. 2mm thick PVC conduit pipe with ISI mark embossed and with PVC accessories confirming to IS No. 3419 for drawing wires duly sealed at joints with original resin / adhesive to make the complete piping rigid, plastering with cement sand mortar finished to the level with matching colour wash including cost of all material labour and T&P etc required for proper completion of the work as per directions and to the satisfaction of Engineer in charge-SOR 2022/150(A) Please Enable Macros to View BoQ information

AI Tender Summary

OUR REF NO 58616018
AUTHORITY Local Bodies
TENDER VALUE 54.18 Lakhs
LAST DATE 28-11-2026
Authority
Authority Name Ayodhya Farizabad Development Authority
Work Description Tender for Construction And Development Work Of The Canal Junction In The Vashistha Kunj Housing Scheme, Ayodhya.
Basic Detail
Tender No ADA 33 Tender DT 12-11-2026
Bidding Type Tender
Location
City Ayodhya
State Uttar Pradesh
Key Dates
Publish Date 19 Nov 2026
Submission Date 28 Nov 2026
Open Date 30 Nov 2026
Finance
Tender Value 54.18 Lakhs
Tender Fee 5900
EMD 1.08 Lakhs
Exemption Not Available
Document List
5106b2b3-ba78-40e6-8d75-798b58d75242.html
BOQ_2292608.xls
DOCUMENT.pdf
Tendernotice_1.pdf

Unlock Full AI Tender Summary

Get instant access to the complete AI-generated analysis — scope, eligibility, timeline & more.

Instant Access Secure Free
Your details are secure and used only for document delivery.

Tender Timeline

Nov 19, 2026
11:30 IST

Tender Published

Tender notice published.

Completed
Nov 28, 2026
17:00 IST

Bid Submission Deadline

Online submission via eProcurement portal.

Upcoming · 8 days
Nov 30, 2026

Bid Opening Date

Technical bids will be opened and evaluated.

Upcoming · 10 days

Tender Documents

Download All (ZIP) ↓
html

5106b2b3-ba78-40e6-8d75-798b58d75242.html

xls

BOQ_2292608.xls

pdf

DOCUMENT.pdf

pdf

Tendernotice_1.pdf

Disclaimer

We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender