Drinking Water Supply and Sanitation Government Departments Closing in 5 days TDR #58600314

Tender For Estimate For Laying Of Di Rising Main From 2Nd Tube Well To Headwork Site Of Malatipur Pwss At Chanchal-Ii Block Under Malda Division, Phe Dte, Govt. Of West Bengal.

Issued by Government Departments · Maldah, West Bengal
Tender Value
4.85 Lakhs
Estimated cost
Bid Submission
27 Nov 2026
5 days left
EMD
9710
Bank guarantee accepted
Document Fee
Ref. Documents
Non-refundable
Tender Type
Online

Tender Overview

Competition Type
NCB
Bidding Type
Tender
Location / State
Maldah → West Bengal
EMD Exemption
Available
Quantity
Not Available

Project Description

Tender for Estimate For Laying Of Di Rising Main From 2Nd Tube Well To Headwork Site Of Malatipur Pwss At Chanchal-Ii Block Under Malda Division, Phe Dte, Govt. Of West Bengal.

BOQ

Name of Work:- Estimate for Laying of DI Rising Main from 2nd Tube well to Headwork site of MALATIPUR PWSS at Chanchal-II Block under Malda Division, PHE Dte, Govt. of West Bengal.
Sl. No. Item Description
1Carrying CI/DI pipes with specials and valves and lowering placing in position and laying carefully inside the trenches in proper alignment and gradient etc. including earth work in excavation of adequate width as per specification having min. clear cover from top of pipe is 1.10mtr. below existing ground level in any kind of soil including mixed with boulder, road sub-grade and its flank,but excluding moorum and laterite and stone etc.without damaging the exisiting telephone/electric cable etc.(in case of damaged if any type of cable line during excecution , necessary damaged charges as applicable by the respective authority will be borne by the agency in his own cost) preparing the bottom surface for continuous bedding of pipe line and laying pipes, fitting, fixing specials and valves with bailing out water if any including carriage of pipes, specials and valves from local deptt. store within 8KM and back filling the trenches with excavated earth in layers to original condition as per specification and direction of EIC. The surplus materials after execution of work are to be return to the deptt. store.N.B: i) Any deviation from required clear cover of 1.10mtr., due to site adverse condition, prior permission is to be obtained from the EIC in exceptional situation and payment will be made on prorate basis over the rate of entire itemii) No payment will be made without hydraulic test of the pipe line either part or fulliii) The pipes, specials and valves , rubber gasket will be supplied deptt. free of cost.
2a) 150 mm dia D.I,
3b) 200 mm dia D.I,
4Cutting DI pipe (all class & type) to required length with cutting device etc. and grinding the cutting portion with file as per direction and satisfaction of EIC.
5b) 150mm.dia.to 200mm.dia pipe
6Chamfering the spigot end of all type/class of DI pipe for proper using of push joint by means of grinder set at site for proper joint etc. all complete as per direction of EIC.
7b) 150mm dia.
8c) 200mm dia.
9Filling the pipe line with water, testing hydraulically as per I.S 3114-1965 (Article-6) in section of a length not exceeding 500mtr. for head of pressure as per specification including supplying installing and fixing all equipments such as diesel pump set, blank flange, pressure gauge, valve, pressure pump and all other tools and plants including drilling topping and plugging of necessary holes to pipes, blocking ends providing temporary thrust block and subsequent blocking of holes and other jointing materials and dismantling and removal of the same including disposal of water etc. all complete as per specification and direction of EIC. The rate is inclusive of cost of requisite water to be arranged by the contractor (Recovery rate of water @ Rs.10.00/m3, if contractor used water from deptt. source).
10A) For CI/DI pipe
11a) 150 mm dia D.I,
12b) 200 mm dia D.I,
13Cleaning thoroughly the inner surface of pipe line including specials and valves by flushing with water and subsequently disinfection of the same pipe line by flushing again with water containing bleaching powder resulting in residual chlorine not less than 15mg/ltrs. after 24hrs. of such filling including laboratory testing of water samples obtain from the disinfested pipe line and disposal of water from the pipe line after completion of the work. The rates including of cost of requisite water to be arranged by the contractor) (The rate of water @Rs. 10/m3 may be recovered, if the contractor used water from deptt. source).
14A) For CI/DI pipe
15a) 150 mm dia D.I,
16b) 200 mm dia D.I,
17Making rubber gasket joint to CI/DI pipes maintaining proper alignment level etc. by mechanical arrangement with or without using mobile cranes where necessary and with help of all other equipment stools and tackles etc. as required providing lubricants of approved quality and direction of EIC. (rubber gasket will be supplied deptt. free of cost)
18a) 150 mm dia D.I, K-9
19b) 200 mm dia D.I, K-9
20Supply and delivery of different dia. D I specials including loading unloading and carriage inclusive of taxes and all charges whatsoever
21Double Flanged Bend 80X 90
22Double Flanged Reducer 80X150
23Double Socket Bend 150X90
24Double Socket Bend 150X45
25Double Socket Bend 150X22.5
26Double Socket Bend 150X11.25
27Double Socket Bend 200X90
28Double Socket Bend 200X45
29Double Socket Bend 200X22.5
30Double Socket Bend 200X11.25
31CIDF Duckfoot Bend, CIDF short piece
32For150 mm dia
33a) FLANGE SPIGOT 150
34b) FLANGE SOCKET 150
35c) Mechanical Collar 150
36d) All Flange Tee 150X150
37i) Double Flanged Short Piece 150X1.0 M
38For 200 mm dia
39a) FLANGE SPIGOT 200
40b) FLANGE SOCKET 200
41c) Mechanical Collar 200
42d) Double Flanged Reducer 200X150
43e) DIDF Short Piece 200X1 mtr long
44f) All Flange Tee 200X200X200
45g) Double Flanged Bend 200X11.25
46h)Double Flanged Bend 200X22.5
47Making flange joint to DI/CI pipes, specials and valves where necessary with supply of required rubber insertion and nut bolts, washers etc. of approved quality and type all complete as per specification and direction of EIC (Nut and bolts shall be of TATA/GKW make).
48b) 150 mm dia D.I,
49c) 200 mm dia D.I,
50HORIZONTAL ROAD CROSSING:Horizontal road crossing by Augor-boring including boring charge, pipe laying and jointing, making baricates, lighting arrangement etc. all complete as per direction of E.I.C. For 80 mm dia. to 200 mm dia. pipes.
51Dismantling all type of plain cement concrete works, stacking serviceable materials of site and removing rubbish as directed within a lead of 75mtr. for laying all dia pipe line in ground floor, a) upto 150mm thick.
52b) above 150 mm thickness
53Filling in foundation or plinth by fine sand in layers not exceeding 150mm as directed and consolidating same by thorough saturation with water ramming complete. Including the cost of supply of sand.( Payment to be made on measurment of finished quantity )
54Single brick flat soling of picked jhama bricks including ramming and dressing bed to proper level and filling joints with powdered earth or local sand.
55Ordinary Cement concrete (mix 1:2:4) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement,if any, in ground floor as per relevant IS codes.
56Making lighting arrangement for continuation work during night including all charges (Applicable exclusively for emergency situation and as per direction of EIC.)
57Making barricading of excavation trenches of road width upto 15mtr. to avoid any accident by providing 75mm dia bamboo post placed vertically & horizontally with the help of 6”size iron rail as per direction and satisfaction of EIC. (Applicable where critical situation arise and take up the work as per direction of EIC)
58Hire and labour charges for shuttering with centering and necessery staging upto 4m using approved stout props and thick hard wood planks of approved thickness with required bracing for concrete slabs, beams and columns, lintels curved or straight including fitting, fixing and stricking out after completion of works (upto roof of ground floor) a) 25mm to 30mm thick wooden shutering as per deceision & direction of engineer-in-charge
59Hire and labour charges for shoring work (including necessary close plank walling, framing, Eucalyptus/Jhou bulla piling , strutting etc.) complete as per direction of the Engineer-in-charge for foundation excavation (vertical surface are in contact with supported earth is to to be measured.) (This item should be executed on specific direction of the Engineer-in-charge)
60a) Depth upto 1.5m.
61Carriage of different type of departmental pipes from Divisional/Sub-divisional store to the work site by truck including loading, unloading, stacking etc. including cost of fuel, lubricant and also cost of driver, helper etc. and all other taxes and charges as applicable as per direction of EIC
62a) Above 20 Km upto 30 Km
63Add Includng GST @18%
64Add Includng CESS @1% Please Enable Macros to View BoQ information

AI Tender Summary

OUR REF NO 58600314
AUTHORITY Government Departments
TENDER VALUE 4.85 Lakhs
LAST DATE 27-11-2026
Authority
Authority Name Public Health Engineering Department
Work Description Tender for Estimate For Laying Of Di Rising Main From 2Nd Tube Well To Headwork Site Of Malatipur Pwss At Chanchal-Ii Block Under Malda Division, Phe Dte, Govt. Of West Bengal.
Basic Detail
Tender No WBPHED/EE/MD/NIeT_38 of 2026-2027
Bidding Type Tender
Location
City Maldah
State West Bengal
Key Dates
Publish Date 18 Nov 2026
Submission Date 27 Nov 2026
Open Date 30 Nov 2026
Finance
Tender Value 4.85 Lakhs
Tender Fee Ref. Documents
EMD 9710
Exemption Available
Document List
96e9fb62-3d64-4e36-a5c1-9bde7545de74.html
BOQ_5214544.xls
Tendernotice_1.pdf
Tendernotice_2.pdf
Tendernotice_3.pdf
Tendernotice_4.pdf

Unlock Full AI Tender Summary

Get instant access to the complete AI-generated analysis — scope, eligibility, timeline & more.

Instant Access Secure Free
Your details are secure and used only for document delivery.

Tender Timeline

Nov 18, 2026
11:30 IST

Tender Published

Tender notice published.

Completed
Nov 27, 2026
17:00 IST

Bid Submission Deadline

Online submission via eProcurement portal.

Upcoming · 5 days
Nov 30, 2026

Bid Opening Date

Technical bids will be opened and evaluated.

Upcoming · 8 days

Tender Documents

Download All (ZIP) ↓
html

96e9fb62-3d64-4e36-a5c1-9bde7545de74.html

xls

BOQ_5214544.xls

pdf

Tendernotice_1.pdf

pdf

Tendernotice_2.pdf

pdf

Tendernotice_3.pdf

pdf

Tendernotice_4.pdf

Disclaimer

We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender