Tender For Improvement To Approach Passages Of Smqs At Gagan Vihar, 26 Ed Under Ge (Af) Marathahalli
Tender Value
43.15 Lakhs
Estimated cost
Bid Submission
09 Dec 2026
18 days left
EMD
86500
Bank guarantee accepted
Document Fee
500
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Bengaluru Urban → Karnataka
EMD Exemption
Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Improvement To Approach Passages Of Smqs At Gagan Vihar, 26 Ed Under Ge (Af) Marathahalli
BOQ
| Sl. No. | Item Description |
| 1 | Excavation in trenches not exc 1.50m wide and not exc 1.50m depth and getting out in Hard/Dense soil including dewatering from the excavated trenches before concreteing for foundation complete all as specified and directed. |
| 2 | Material & labour for plain cement concrete 1:4:8, type D2 using 40mm graded stone aggregate as in foundation, filling and mass concrete. |
| 3 | Material & labour for formwork to side of concrete foundations, footings, plinth beams etc. |
| 4 | M & L M 25 (20 mm graded aggregate ) as in foundations, including rafts, footings, foundation beams; plinth beams; bases for columns, etc.; basement slabs, piles foundation and mass concrete complete all as specified and directed.Note : The work shall be carried out in lowlaying/water logged area, the quoated rate shall be included for dewatering from the foundation before concrete casting of base concrete and base of column or plinth beam etc. |
| 5 | Material & labour for RCC M 25 design mix using 20mm graded stone aggregate for columns, pillers, piers, posts and struts for fair finished flat concrete surfaces. |
| 6 | Material & labour for formwork to column with fair finished surfaces. |
| 7 | Material & labour for RCC M 25 design mix with 20mm graded stone aggregate in beams, cantilevers, bressumers, lintels over 1.50m span. |
| 8 | Material & labour for formwork to side and soffits (if any) of beams, lintels etc. |
| 9 | Returning filling in, including spreading leveling watering and well ramming in layers not exc 25cm. |
| 10 | Removing excavated material not exc 50m and depositing where directed at a level not exc 1.5m above the starting point. |
| 11 | Material and labour for TMT bars 10mm dia and over cut to length, bent to shape required including cranking, bending spirally for hooping for columns hooking ends and binding with MS wire (annealed) not less than 0.90mm dia confirming to Fe 500 D. |
| 12 | Material and labour for TMT bars 5mm dia and over upto and including 10mm dia confirming to Fe 500D as in stirrups, spacers and binders. |
| 13 | Material and Labour for Pre-cast cement concrete 1:3:6 type C1 using 20mm graded stone aggregates as in block masonry with solid blocks exceeding 10cm in width and setting in CM 1:6 complete all as specified and as directed. |
| 14 | Supply and fix 75mm dia PVC (SWR) pipe for weep holes |
| 15 | Material and Labour for rendering in CM 1:4 of 15mm thick on fair faces of brick work or concrete surfaces finished even and smooth without using extra cement complete all as specified and as directed. |
| 16 | Material and Labour for applying two coats cement base paints over one coat of alkali resistant priming paint on newly plastered wall surfaces including preparation complete all as specified and as directed. |
| 17 | M & L Material & Labour for applying Two or more coats of 100% Premium acrylic emulsion paint having VOC less than 50 gm/litre and UV resistance as per IS 15489:2004, Alkali & fungal resistance, dirt resistance exterior paint of required shade (Company Depot Tinted) with silicon additives @ 1.43 litre/ 10 sqm over and including priming coat of exterior primer applied @ 0.90 litre/ 10 sqm over new surfaces |
| 18 | Material and Labour for PCC 1:2:4 type B0 using 12.50 mm graded stone aggregate as in PCC bed blocks for inserting angle iron post including necessary formwork complete all as specified and as directed. |
| 19 | S & F of mild steel work such as posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165 complete all as specified and directed. |
| 20 | Material and labour for prepration of new steel surfaces and applying two coat of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed. |
| 21 | Removing material or debris retrives from above demolition or cleaning to a distance exceed 1.5 Km and not exceeding 5.0 Km and depositing where directed complete all as specified and directed |
| 22 | S & F 300 mm dia Reinfirced concrete pipes, class NP2 , laid and jointed complete with collars complete all as specified and directed. |
| 23 | M & L Concrete bed to 300 mm dia drain pipes including packing under, and haunching against the sides of pipes after they are laid and tested; in complete ll as directed and directed. |
| 24 | M & L 25 mm thick precast cement concrete louvres and jallies, Type B0 (1:2:4) 12.50 mm graded agregate set in CM 1:4 of 25mm thick (measured solid), including all mould- ings but excluding frame (Pre cast frame shall be measured separately and paid for under item 04032) complete all as specified and directed. |
| 25 | S & F Framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing complete all as specified. |
| 26 | S & F 1.25 mm thick Mild steel, plain, black sheet in wall cladding, steel gates and similar work, cut to size, holes punched; including round headed screws, clout nails or rivets and fixed to wood or steel framing with plain 40 mm lap joints with riveted or welded seams, including bending or turning up, mitred angles, etc. as required complete all as specified and directed. |
| 27 | S & F Plates (plain or chequered) channels , square or beams cut or notched (ordinary and counter sunk) forming holes, without any attachments or with rivited, bolted ot welded attachments, etc confirming to Fe 410-W(Gde-E-250)quality-A complete all as specified and directed. Note - cutting to require size and welding or boulting to Beam , post, rafter shall be at site, rate included in this item. |
| 28 | M & L Steel work in tubular trusses including special shaped washer etc. complete using ERW or induction butt welded tubes conforming to I. S.1161- 1979 grade St.-240 ® complete all as specified and directed |
| 29 | M & L Rolled sections as in main and cross beams, hip and jack rafters; purlins where connected to common rafters and running rails and guides for sliding doors; fixed with angle cleats or other connecting plates complete ll as specified and directed |
| 30 | M&L for Hardcore of gauge n exc. 63 mm of broken stone or boulders, deposited, spread and levelled in layers n exc. 15 cm thick, watered and rammed to a true surface complete all as specified and directed. |
| 31 | M & L 100 mm thick PCC 1:4:8 type D-2 using 40 mm graded stone aggregate as in Sub base for concrete. |
| 32 | M & L 150 mm thick PCC type B 1 , 1:2:4 (20 mm graded aggregate) as in floor finish making spike rolling to surfaces or making impressions of expended metal, including side form work support/shuttering and grove cutting with sealing compound as per MORTH specifications whilst the concrete is green complete all as specified and directed. Note: The entire work will be carried out through RMC only. |
| 33 | Demolition of cement concrete (unreinforced) in ground floors and pavings n.exc 15cm thickness (below or above GL) all as specified and directed. |
| 34 | Demolition of cement concrete (reinforced) of any description and in any position not otherwise specifically provided for |
| 35 | Demolition of Brickwork or stone/ boulder masonry, built in cement mortar including all quoins, arches, pillars, etc, but excluding ashlar facings, dressed stonework and precast concrete articles in all as specified |
| 36 | Dismantiling wrought iron or mild steel work of any description not otherwise provided for etc comoplete all as specified. |
| 37 | M&L Cement concrete type B-1, 1:2:4 (20mm graded aggregate) 75 mm thick |
| 38 | M&L Cement concrete type B-1, 1:2:4 (20mm graded aggregate) 50 mm thick |
| 39 | M&L for Chequered cement concrete tiles 30cm x 30cm x 25mm thick,industrial type coloured, Pre polished,set, jointed and pointed in neat cement slurry with gray cement and pigments in floors incl. 20mm thick screed bedding layer in cm 1:4. Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Nov 18, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedDec 09, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 18 daysDec 11, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 20 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender