Tender For special Repair To Lightening Protection System For Mag No 11, 14, 16, 18, 21, 22, 23, 24, 25, 27, 28, 29, 34 And Ata Mag Installed At Explosive At Amn Sub Depot Of Cod Jabalpur Under Ge (East) Jabalpur
Tender Value
44.31 Lakhs
Estimated cost
Bid Submission
03 Dec 2026
17 days left
EMD
88620
Bank guarantee accepted
Document Fee
500
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Jabalpur → Madhya Pradesh
EMD Exemption
Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for special Repair To Lightening Protection System For Mag No 11, 14, 16, 18, 21, 22, 23, 24, 25, 27, 28, 29, 34 And Ata Mag Installed At Explosive At Amn Sub Depot Of Cod Jabalpur Under Ge (East) Jabalpur
BOQ
| Sl. No. | Item Description |
| 1 | M&L for Stay assembly with stay rod of 16mm dia complete with all accessories as shown in electrical plate No. 1 (loop type insulator, stay clamps, excavation and concrete measured separately) including taking down old unserviceable stay assembly complete all as specified and directed by Engr-in-charge. |
| 2 | M&L for loop type insulator vitreous porcelain white, brown or green large size with dimensions 90mmx140mm, clearance of hole 25.5mm etc including taking down old unserviceable loop type insulator complete all as specified and directed. |
| 3 | M & L for Single pointed air termination aluminium rod, 12mm dia, 300mm longer etc including taking down old unserviceable Al air termination rod type/size complete all as specified and directed. |
| 4 | M&L for aluminium strip 25mm x 3mm complete with saddles and fixing screws as roof conductor etc including taking down old unserviceable aluminium strip any type/size complete all as specified and directed. |
| 5 | M & L for GI strip 32mm x 6 mm buried in ground including taking up old unserviceable GI strip any type/size complete all as specified and directed. |
| 6 | M & L for cross arms, bracing, supports, clamps and back plates, fabricatedfrom structural steel sections including nuts, bolts, washers, welding, bending cold and hot drilling holes for bolts, in any shape or size as indicated or directed inclusive of one primer coat, one under coat and one finishing coat of synthetic enamel paint including taking down old unserviceable cross arms etc complete all as specified and directed by Engineer-in-charge. |
| 7 | M&L for conductor of any size for binding from disc/shackle/loop insulator etc and rebinding after tightening/restringing of AACSR /AAC /LT over head conductors of any size with and including 14 SWG binding wire and taking down old unserviceable aluminium conductor any type/size complete all as specified & directed. |
| 8 | M&L for GI wire for stretching and then strengthening of over head Galvanised steel wire 3.15 or 4mm dia on existing LT poles including binding & jointing the conductor, testing including taking down old unserviceable galvanised steel wire any type/size complete all as specified and directed. |
| 9 | M & L for test point terminal block made of gun or phosphorus bronze size 75 x 75 x 25mm drilled and screwed including 3 Nos 8 mm dia 25 mm long hex. Head screw including removal old existing unserviceable one complete all as specified and directed. |
| 10 | Supply and fix GI tubes, light grade, galvanized of size 40 mm dia with all fittings and fixed complete for supporting the air termination rod and protection of GI strip complete all as specified and directed. |
| 11 | M&L for earthing complete with galvanized steel earth plate electrode 600mmx600mmx 6mm thick buried directly in ground (earth pit not less than 2.25m deep below ground level) with top edge of the plate not less than 1.50 mtr deep below normal ground level connected to and including galvanised steel wire of 4.00 mm dia by means of bolts, nuts, check nuts and washers of galvanized iron or steel including 15 mm dia medium grade pipe for protection of GI wire to the extent of 7.5 mtrs as earthing lead including charcoal dust and salt packed all around the earth plate in the earth pit all as per Electrical plate No 3 of SSR part - I (2009) including PCC foundation/chamber in mix 1:3:6 type C-2 with PCC pit cover including funnel covered with wire mesh and handle duly reinforced with 6 mm round bars both ways @ 125 mm c/c, GI protection pipe 15mm bore light grade and watering pipe 20 mm bore medium grade complete all as specified and directed. |
| 12 | M&L earthing complete with galvanized steel earth plate electrode 600mmx60 0mmx 6mm thick buried directly in ground (earth pit not less than 2.25m deep below ground level) with top edge of the plate not less than 1.50 mtr deep below normal ground level connected to and including GI steel strip of size 32 x 6 mm by means of bolts, nuts, check nuts and washers of galvanized iron or steel including 40 mm dia medium grade pipe for protection of GI strip to the extent of 7.5 mtrs as earthing lead including charcoal dust and salt packed all around the earth plate in the earth pit all as per Electrical plate No 3 of SSR part - I (2009) including PCC foundation/chamber in mix 1:3:6 type C-2 with PCC pit cover including funnel covered with wire mesh and handle duly reinforced with 6 mm round bars both ways @ 125 mm c/c, GI protection pipe 15mm bore light grade and watering pipe 20 mm bore medium grade complete all as specified and directed. |
| 13 | Material and Labour for erection of steel tubular poles type 410 SP - 31 (9.00 metres long) including cast iron base plate, pole cap, swaged type including painted with two coat of aluminium paint over a coat of red oxide primer including marking pole No with black synthetic enameled paint including tarring one coat on steel surface embedded in concrete complete all as specified and as directed. |
| 14 | M & L for cement concrete for comprising of PCC pole coping with PCC (1:2:4) type B-1 with 20mm graded aggregate complete all as specified and directed. |
| 15 | M & L for cement concrete for comprising of PCC Pole foundation with PCC ( 1:3:6) type C-2 with 40mm graded aggregate complete all as specified and directed. |
| 16 | M & L for cement concrete for comprising of PCC pole bedding with PCC (1:4:8) type D-2 with 40 mm graded aggregate complete all as specified and directed. |
| 17 | Excavation in trenches in soft/loose soil not exc. 1.5 metre wide and not exc. 1.5 metre in depth and getting out for laying under ground electric cable complete all as specified and directed. |
| 18 | Excavation in trenches not exceeding 1.5 mtr wide and depth exc 1.5 m depth but n.exc 3mm and getting out in soft/loose soil complete all as specified and directed. |
| 19 | Removing surplus soil to a distance not exceeding 50 mtr and depositing where directed at a level not exc 1.5 mtr above the starting point complete all as specified and as directed. |
| 20 | M&L for shackle type insulator for working pressure 1100 volts, 75mm in height and 90mm dia, porcelain, vitreous, white, brown or green including galvanised mild steel straps, insulator bolts, washers and nuts complete all as specified and directed. |
| 21 | Supply and fix flameproof cum waterproof DB TPN 4 way, made of die cast aluminum housing with IP 66 degree of protection with proper fixing arrangements with incoming cable size upto 3.5 core 50 sqmm with MCB TPN 63 Amp as incomer and outgoing with 12 Nos of MCB SP 6-32 Amp complete all as specified and directed. |
| 22 | Supply and fixing of flameproof cum Waterproof LED Bulk Head light fitting of 100W, IP66 protection of Cast Aluminum alloy material and Heat and Impact resistance toughen 'A' clear glass having Anti corrosive epoxy powder coated finish complete with all accessories pre wired and including connecting up with three core flexible copper conductor cable with suitable size complete all as specified and directed. |
| 23 | Schedule of credit amount of Rs 2,38,230.00 to be deducted during AOC. Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Nov 12, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedDec 03, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 17 daysDec 08, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 22 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender