Bids Are invited for Repair, Maintenance, And Installation Of Plant/ Systems/Equipments (Version 2) - 45 Attending Breakdown Complaints And B Check Servicing Of 10 Nos Various Dg Sets On Call Basis Under Kodagu Oa Phase 3; Power Generators; Service P

Sharing tender

Bids Are invited for Repair, Maintenance, And Installation Of Plant/ Systems/Equipments (Version 2) - 45 Attending Breakdown Complaints And B Check Servicing Of 10 Nos Various Dg Sets On Call Basis Under Kodagu Oa Phase 3; Power Generators; Service Provider - Replacement Of Alternator Winding Of 40Kva, 3Phase, 415 Volts Dg Set [Against Burnt Alternator Winding] I/C Dismantling Alternator, Taking It Out From The Canopy, Transportation Of Same From Hakattur To Near By Alternator Rewinding Shop To & From By Engaging A Suitable Transport Vehicle, Rewinding Of Alternator With Suitable Copper Conductor, Varnishing, Prdg Rated Insulation, Baking, Physical Checks, Fixing Same To Alternator At Hakattur, Exciting With Battery Supply Externally To The Field To Magnetise The Core, Testing Running The Dg, Checking Output & Parameters On Both Noload & On Exchange Load Etc As Reqd. , Replacement Of Damaged/ Burnt Dc Control Wiring From Starter To Ignition Board And To Dynamo With Suitable Copper Conductor Wires And Lugs Etc To Avoid Further Burning Of The Wiring Upon Starting Etc As Reqd. , Replacement Of Stator Winding Of 20Kva, 3Phase, 415 Volts Dg Set ( Against Burnt Winding ) I/C Dismantling Alternator, Taking It Out From The Canopy, Transportation Of Same From Hattihole To Near By Alternator Rewinding Shop To & From By Engaging A Suitable Transport Vehicle, Rewinding Of Stator With Suitable Copper Conductor, Varnishing, Prdg Rated Insulation, Baking, Physical Checks, Fixing Same To Alternator At Hattihole, Exciting With Battery Supply Externally To The Field To Magnetise The Core, Testing Running The Dg, Checking Output & Parameters On Both Noload & On Exchange Load Etc As Reqd. , B-Check Servicing Of Following Capacity Dg Set By Engaging Dg Mechanic By Utilising The Existing Consumables Like Oil, Filters Etc, Draining Out Of Engine Oil From The Sump, Filling New Oil, Replacing Fuel And Oil Filters, Oil Bath Type Air Filter, Tightening All The Bolts & Nuts To The Reqd Torque, General Check Up Of Working Parameters And Checking The V-Belt, Testng As Reqd. (Consumables Like Oil, Filters Will Be Paid Separately) , Supply Of The Following Consumables / Spares For The Engine During Servicing / Repair Works , Testing Complete As Required. Make :- Kirloskar/Volvoline/ Servo /Castrol/ Shell Simlr Supr Make & Grades. , Lube Oil Filter With O Ring. , Diesel Filters- Set Of 2 (Pre & Micro) With O Ring , Replacement Of V Belts Of Size A-28/A-32/ A-40 / A-46/ A-48/ A-49/ A-51 , S&F Of Hydraulic/ Metal Braided Flexible Fuel Pipe With Banjo Bolts & Copper Washers Etc. Up To 2½ Feet Long. , S&F Of Hydraulic/ Metal Braided Flexible Fuel Pipe With Banjo Bolts & Copper Washers Etc. 3 Feet To 5 Feet Long. , S&F Of Pvc Braided Flexible Fuel Pipe With Banjo Bolts & Copper Washers Etc. Up To Up To 2½ Feet Long. , S&F Of Pvc Braided Flexible Fuel Pipe With Banjo Bolts & Copper Washers Etc. 3 Feet To 5 Feet Long. , S&F Of Nozzle Return Pipe , S&F Of Oil Pressure Hose Pipe Of Suitable Length , Replacement Of Ignition Switch Unit Normally Open Type With Operating Key Suitable For Above Dg Sets I/C Making Connection, Checking Etc As Reqd. , Providing Self Adhessive Waterproof Sealing Black Tar Felt Asphalt Sheet/ Water Proof Sheet At The On The Roof/ Top Side Of Dg Set Canopy Of Size Apprx 2.5Mtrs X 1.5Mtrs To Avoid Seapage Of Rain Water Inside Canopy I/C Covering It Fully Leaving No Room For Rain Water Entry Inside With Associated Spares Complete Etc As Reqd. , S&F Of Counter Type Electrical Run Hour Meter Operating On 230V, 1 Ph, 50Hz, Ac Supply I/C Connecting To The Existing Power Cable With Necessary Terminations And Clamping If Required Etc As Reqd. (Make: Quartz//Krish/ Isi Approved) , Repair Of Faulty 12 Volts Dynamo Of Dg Set I/C Transportation To Work Shop To & From, Replacement Of Commutator, Set Of Carbon Brushes With Cutouts, Fixing The Same To The Dg Set And Testing, Checking The Output Voltage Complete Etc As Reqd. , Repair Of Faulty 12 Volts Starter Of Dg Set I/C Transportation To Work Shop To & From, Replacement Of Bentex, Rectifier, Set Of Bearings, Shaft Fixing The Same To The Dg Set And Testing, Checking The Output Voltage Complete Etc As Reqd. , Supply And Fixing The Electronic Type Automatic Voltage Controller Suitable For 15/20/40 Kva Capacity Alternator Etc As Reqd. Note [Optional Item, It May Be Supplied After Consent Of Sde/Jto(Ele @ Site) (Make : Oem/ Swastik Or Approved Make) , Supply And Fixing Battery Lead Of Size 25Sqmm Pvc Insulated Multistrand Single Core Copper Conductor Cable And Properly Bolted To Existing Terminal Etc As Reqd. , Supply And Fixing 2 Nos Brass Terminals For Battery Positive & Negetive Polarities With Bolts And Nuts Etc As Reqd. , Supply And Fixing Ms Wired 1 X 1 Welded Wire Mesh Of Following Sizes With Screws/ Nuts/ Bolts/ Washers Etc To Cover The Opened Portion At Flywheel Side/ Alternator Side To Avoid Rodent Entries/ Safety To The Operating Personal Etc As Reqd. , Dismantling The Radiator Assembly From Existing 15/20/30/40 Kva Capacity Dg Set, Servicing And De-Scaling The Radiator At Site, Water Wash, Flushing, Removing The Blockages If Any, Checking For The Leakages, Refixing The Radiator Assembly To The Dg With Its Accessories Etc As Reqd. , Supply & Fixing Of Radiator Hose Pipes (Straight/ Bent) Of Suitable Size, Thickness And Length With Ring/ Banjo Clamps To The Radiator Of 15/20/30/40 Kva Capacity Dg Set Etc As Reqd. , Complete Cleaning Of Upto 40Kva Existing Dg Set I/C Removing The Dust, Sticky Dirts, Sediments, Oil Spillages, Carbon Deposits With Existing Diesel/ Cleaning Agents Then Dry Cleaning, Then Painting With Enamelled Oil Paint Matching To Existing Colour, Finishing, Making It Neat Complete Etc As Reqd. , Supply & Fixing Of Ms Hinges To The Doors Of The Dg Canopy I/C Drilling, Fixing, Welding, Fabrication Work Complete Etc As Reqd. , Sitc Of 12 Volts, 10 Amps Battery Charger Smps Type To Charge Dg Set Batteries Suitable For Operation On 230 V, 50Hz Input Ac Supply Of Range 170V To 270V, Output 13.3V To 13.8Volts Dc, With Protections For Over Current, Over Charging, Reverse Polarity Complete With Power Supply Cable, Termination Points And Other Accessories Etc I/C Supply Of Heavy Duty Charging Crocodile Clips-2Nos Etc Complete As Reqd. (Make: Nhp Or Ss Make)