Tender For Providing Of Single Officer Accommodation At Naushera Under Ge 862 Ews
Tender Value
1 Crore
Estimated cost
Bid Submission
27 Nov 2026
20 days left
EMD
1.76 Lakhs
Bank guarantee accepted
Document Fee
1000
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Rajouri → Jammu and Kashmir
EMD Exemption
Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender For Providing Of Single Officer Accommodation At Naushera Under Ge 862 Ews
BOQ
| Sl. No. | Item Description |
| 1 | Schedule 'A' Part-I (Building Work) Note : This schedule is not pre-priced by MES and the pre-priced rate indicated as \\"Rs 0.00\\" under Col. 5 siginifies this fact only. |
| 2 | Construction of SINGLE LIVING OFFICER ACCOMODATION (SINGLE STORIED) with servant room all as shown on drawings and as specified. ( BLOCK No. I & II ) |
| 3 | Construction of SINGLE LIVING OFFICER ACCOMODATION (SINGLE STORIED) without servant room all as shown on drawings and as specified. ( BLOCK No. III ) |
| 4 | Schedule 'A' Part-II (Internal Electrification works) |
| 5 | Total amount of Sch 'A' Part-II (Internal Electrification works) brought forward from srl page No-23 |
| 6 | Schedule 'A' Part-III (Internal water supply Works) |
| 7 | Total amount of Sch 'A' Part-III (Internal water supply Works) brought forward from srl page No- 25 |
| 8 | Schedule 'A'Part-IV (Road / Path / Hardstanding Works) |
| 9 | Total amount of Sch 'A' Part-IV (Road / Path / Hardstanding Works) brought forward from srl page No-27 |
| 10 | Schedule 'A' Part-V (Protective Works) |
| 11 | Total amount of Sch 'A' Part-V (Protective Works) brought forward from srl page No-29 |
| 12 | Schedule 'A'Part-VI (Sewage Disposal Works) |
| 13 | Total amount of Sch 'A' Part-VI (Sewage Disposal Works) brought forward from srl page No-31 |
| 14 | Schedule 'A'Part-VII (Area Drainage Works) |
| 15 | Total amount of Sch 'A' Part-VII (Area Drainage Works) brought forward from srl page No-32 |
| 16 | Schedule 'A'Part-VIII (External Electrification Works) |
| 17 | Total amount of Sch 'A' Part-VIII (External Electrification Works) brought forward from srl page No-34 |
| 18 | Schedule 'A'Part-IX (External Water Supply Works) |
| 19 | Total amount of Sch 'A' Part-IX (External Water Supply Works) brought forward from srl page No-35 |
| 20 | Schedule 'A'Part-X (Hot Water Supply Works) |
| 21 | Total amount of Sch 'A' Part-X (Hot Water Supply Works) brought forward from srl page No- 36 |
| 22 | Schedule 'A'Part-XI (Site Clearance Works) |
| 23 | Total amount of Sch 'A' Part-XI (Site Clearance Works) brought forward from srl page No- 38 |
| 24 | Schedule 'A'Part-XII (Misc Items of Works) Note : This schedule is not pre-priced by MES and the pre-priced rate indicated as \\"Rs 0.00\\" under Col. 5 siginifies this fact only. |
| 25 | Construction of On site RCC Hume pipe septic tank designed to carry sewage and sludge water for 10 users with & including earthwork in any type of soil, PCC 1:4:8 below foundation, vent shaft & making connection, complete alol as specified. |
| 26 | Costruction of soakage well 1.8 mtr dia and 3.00 mtr deep below inlet (depth) from inlet pipe to ground level 45cm including excavation and earth work in any type of soil, PCC 1:4:8 type D2 using 40mm graded crushed stone aggregate in foundation, wall in honey combed brick work in CM 1:4 cover slab of M-25 filling with brick bats, earth cushion on brick lining on top and inlet pipe 150mm dia and complete all as specified and shown on drawing |
| 27 | Point wiring with two single core 1.5 Sqmm (nominal cross section area) FRLSH PVC insulated unsheathed copper conductor cable and one single core 1.5 Sqmm (nominal cross section area) FRLS PVC insulated unsheathed copper conductor cable as earth continuity to common earth and connecting to earth dolly running in and including medium grade rigid nonmetallic PVC concealed conduit of 25mm dia in wall after cutting chases in wall including concealed modular sheet terminal box factory made of suitable size with modular cover plate with frame for mounting modular switches, sockets, fan regulators etc. and all requisite accessories such as PVC elbow, Tee, collars, bends etc. for mounting switches, sockets, fan regulators etc for one light / fan / exhaust fan point controlled by one way switch 6 Amp, complete all as specified.Note:-The colour coding of wiring to be followed as Red/Yellow/Blue for Phase/Neutral/Earth respectively. |
| 28 | Description all as per item No. 12.03 here-in before but for 3 Pin socket outlet 5/6 Amps point on independent board with PVC insulated unsheathed copper conductor cable 1.5sqmm complete all as specified and directed. |
| 29 | Description all as per item No. 12.03 here-in-before but for 3 Pin socket outlet 15 Amps point on independent board controlled by other switches with 2.5sqmm copper conductor PVC insulated cable 1100 Volts grade with 2.5sqmm copper conductor as earthwire, complete all as specified and directed. |
| 30 | Sub main wiring complete with 2 run of 4 sqmm, single core, copper conductor cable 1100 volts grade, FRLSH type, PVC insulated, unsheathed, flexible, multi stranded duly colour coded cable drawn through and including PVC conduit of 32mm bore concealed with all accessories as required along with 01 run of 4 sqmm single core, copper conductor cable 1100 volts grade, FRLSH type, PVC insulated, unsheathed, flexible, multi stranded of green colour as continuous earth wire and connecting to existing main switch board /distribution board and testing on completion complete all as specified and directed.(Note: - Colour coding of wiring to be followed as red/yellow/blue for phase, black for neutral and green for earth). |
| 31 | Supply, installation, testing and commissioning LT Panel Board cubical outdoor type ,made out of 3.15mm thick CRCA sheet powder coated dust and vermin proof floor mounted , floor mounted , with MS angle iron Base frame made out of 50x50x6mm angle of size double door as required at site, grouted in PCC 1:3:6 type C-1 using 20 mm graded mechanically crushed stone aggregates for fixing panel board with and including necessary fixing arrangements,totally enclosed dust and vermin proof, front opening with locking arrangement, suitable for AC 415V, 3 phase, 50 Hz system, Red, Yellow, Blue and Black coloured insulated copper bus bar of suitable size to carry 200 amp , Painted internally and externally with two coats of synthetic enamel paint over a coat of red oxide primer of any tint and marking wiring circuits complete, front opering door type switch board with copper insulated wiring suitable as per site requirement (CPRI approved , with 50 KA Short Circuit and IP-55 protection duly insulated with heat shrinkable sleeve as per colour, supported on epoxy insulator 01 set, with two earth terminal out side panel board, cable alley cable gland with independent plate at bottom and complete comprising the followings:- :-Incomming:-a) MCCB 63 Amp 4 pole 16 KA -01 Nob) Digital Ammeter(0-100A) - 01 No c) Digital Voltmeter)( 0-415V) - 01 No d) CT's -03 Nose) Indicating lamp LED type-set of 3- 03 sets Outgoing:- a) MCB TPN 32 Amp 415volts 25 KA 'C' series - 03 No b) MCB SPN 20 Amp 240 volts 10 KA 'C' series - 01 No |
| 32 | Street light bracket made out of 32mm dia GI ligt grade pipe 1.2 meter long bend to shape 120 degree and duly fixed alongwith existing pole/building with the help of 2 Nos MS clamp of size 32x3mm including suitable size bolt , nuts and washers complete all as specified. |
| 33 | LED inverter lights fitting 1 X 20W, 4 Ft length with internal lithium-ion battery backup for 4 hours auto charging feature high surge protection and 6500K CCT and holder including LED tube light connecting up with three core flexible copper conductor cable of suitable size from celling rose complete all as specified and as directed. |
| 34 | Enviornmently friendly, ultramorden, energy saving, surface mounted, decorative oval plastic bulk head 10 watt, 6000 K LED luminaire comprising of high brightness LEDs , IP54 protection including connecting electrically using cord flexible 3 core PVC insulated over all sheathead with flexible copper conductor of 0.75 sqmm all as specified and as directed. |
| 35 | Earthing complete with galvanised steel earth plate electrode 600mmx600mmx6mm thick buried directed in ground (earth plate not less than 2.25m deep below normal ground level) with top edge of the plate not less than 1.5m below normal ground level) connected to and including earth wire 4.0mm dia by means of bolts, nuts, check nuts and washers of galvanised iron including PCC 1:2:4 in pit, angle iron 25x25x3mm frame work with precast RCC 1:2:4 cover reinforced with 8mm dia TMT bars @ 150mm C/C both ways and 12 mm dia MS fabricated handle, medium grade GI watering pipe 20mm bore with funnel, wire mesh and light grade GI protection pipe 15mm bore upto 7.5m length for drawing in earth lead wire, salt, charcoal, etc. Including excavation and earth work in any type of soil, removal of surplus soil to a distance not exc. 50m complete all as shown in electrical plate No 3 of MES schedule 2009 (Pt-I) and connected to main control board all as specified or indicated including testing on completion, complete all as specified and as directed. |
| 36 | Earthing complete with galvanised steel earth plate electrode 600mmx600mmx6mm thick buried directed in ground (earth plate not less than 2.25m deep below normal ground level) with top edge of the plate not less than 1.5m below normal ground level) connected to GI earth strip 32 x 6mm by means of bolts, nuts, check nuts and washers of galvanised iron including PCC 1:2:4 in pit, angle iron 25x25x3mm frame work with precast RCC 1:2:4 cover reinforced with 8mm dia TMT bars @ 150mm C/C both ways and 12 mm dia MS fabricated handle, medium grade GI watering pipe 20mm bore with funnel, wire mesh and light grade GI protection pipe 40mm bore upto 7.5m length for drawing in earth lead wire, salt, charcoal, etc. Including excavation and earth work in any type of soil, removal of surplus soil to a distance not exc. 50m complete all as shown in electrical plate No 3 of MES schedule 2009 (Pt-I) and connected to main control board all as specified or indicated including testing on completion, complete all as specified and as directed. Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Nov 06, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedNov 27, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 20 daysDec 04, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 27 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender