Tender For Construction Of Standard Helipad Size 26X26 M And Approach Road At Multi Purpose Hub Mudila In Tahsil Mukhyalya Nautanwa (1/1)
Tender Value
1.71 Crore
Estimated cost
Bid Submission
16 Nov 2026
8 days left
EMD
10.55 Lakhs
Bank guarantee accepted
Document Fee
2714
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Maharajganj → Uttar Pradesh
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Construction Of Standard Helipad Size 26X26 M And Approach Road At Multi Purpose Hub Mudila In Tahsil Mukhyalya Nautanwa (1/1)
BOQ
| Sl. No. | Item Description |
| 1 | Construction of embankment with approved material obtained from borrow pits with all lifts and leads, transporting to site, spreading, grading to required slope and compacting to meet requirement of table 300-2. As per MoRT&H Specification Ref. No. 305 & Sr No. 3.16 (Including labour cess but GST will be paid extra as applicable) (Cartage Earth). |
| 2 | GSB - Construction of granular sub-base by providing Close graded material, mixing in a mechanical mix plant at OMC, carriage of mixed material to work site, spreading in uniform layers with motor grader on prepared surface and compacting with vibratory power roller to achieve the desired density, complete as per clause 401 & Sr. No. 4.01 (Including labour cess but GST will be paid extra as applicable) |
| 3 | DLC - Construction of dry lean cement concrete Sub- base over prepared sub-grade with coarse and fine aggregate conforming to IS: 383, the size of coarse aggregate not exceeding 25 mm, aggregate cement ratio not to exceed 15:1, aggregate gradation after blending to be as per table 600-1, cement content not to be less than 150 kg/ cum, optimum moisture content to be determined during trial length construction, concrete strength not to be less than 10 Mpa at 7 days, mixed in a batching plant, transported to site, laid with a paver with electronic sensor, compacting with 8-10 tonnes vibratory roller, finishing and curing. Specification No. 602 & Sr. No. 6.01. DLC Using Batching Plant-120 cum capacity as per Specification Clause 601 C Sr. No. 21.18 (Including labour cess but GST will be paid extra as applicable) |
| 4 | CC-Cement Concrete Pavement Construction of un-reinforced, dowel jointed at expansion and construction joint only, OPC pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars, near approaches to bridge/culvert and construction joints, admixtures as approved, curing of concrete slabs for 14-days, using curing compound (where specified) and water finishing to lines and grade as per drawing and Technical Specification Clause 1501 & Sr No. 6.4 (Including labour cess but GST will be paid extra as applicable) |
| 5 | Painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade. Two or more coats on new work over an under coat of suitable shade with ordinary paint of approved brand and manufacture. DSR 13.62.1 (Including labour cess but GST will be paid extra as applicable) |
| 6 | Providing and laying 80mm thick factory made chamfered edge Cement Concrete paver blocks in footpath, parks, lawns, drive ways or light traffic parking etc, of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over 50 mm thick compacted bed of sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand. complete all as per direction of Engineer-in-Charge. as per DSR Vol-2 Cha-16 Code No. 16.91. Required for proper completion of the work. (Including labour cess but GST will be paid extra as applicable) |
| 7 | Brick masonry work in Cement mortar in foundation complete excluding pointing and plastering as per drawing and technical specification clause 600, 1202 and 1203 II. Brick masonery in 1:4 cement mortar As per MORD Sr. No. 11.5 (Including labour cess but GST will be paid extra as applicable) |
| 8 | WBM Grading-3 Providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with smooth wheel roller 80-100 kN in stages to proper grade and camber, applying and brooming, stone screening to fill-up the interstices of coarse aggregate, watering and compacting to the required density Grading 3 as per Technical Specification Clause 405. Sr.No. 4.7(3) A By Manual Means. (Including labour cess but GST will be paid extra as applicable) |
| 9 | Excavation for roadway in soil by mechanical means including cutting and pushing the earth to site of embankment upto a distance of 100 m, including trimming bottom and side slopes in accordance with requirements of lines, grades and cross-sections. As per MoRD Specification Ref. No. 3.5 & Sr No. 302 (II) (Including labour cess but GST will be paid extra as applicable) |
| 10 | Providing Concrete for plain/reinforced concrete in open foundation complete as per drawing and Technical specification Clause 802, 803, 1202 & 1203. PCC Grade M-10 (ii) Nominal mix 1:3:6 as per Sr. No. 11.4(I) (Including labour cess but GST will be paid extra as applicable) |
| 11 | Construction of precast RCC railing of M30 Grade, aggregate size not exceeding 12 mm, true to line and grade, tolerance of vertical RCC post not to exceed 1 in 500, centre to centre spacing between vertical post not to exceed 2000 mm, leaving adequate space between vertical post for expansion, complete as per approved drawings and technical specifications. As per MoRTH Specification 2703, 1500, 1600 & 1700 & Sr. No. 14.06 (Including labour cess but GST will be paid extra as applicable) |
| 12 | Structural steel work in single section, fixed with or without connecting plate, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.DSR Item No10.1 For Gate (Including labour cess but GST will be paid extra as applicable) Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Nov 06, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedNov 16, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 8 daysNov 16, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 8 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender