Tender For Providing Lwss To Village Dusseran In Gp Dusseran Tehsil Arki District Solan Hp Sh_ Construction Of Sump Well Providing And Installation Submersible Pumping Machinery With Allied Accessories And Providing And Fixing Reflux Valve And Sulice
Tender Value
Ref. Documents
Estimated cost
Bid Submission
16 Nov 2026
9 days left
EMD
13850
Bank guarantee accepted
Document Fee
350
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Solan → Himachal Pradesh
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Providing Lwss To Village Dusseran In Gp Dusseran Tehsil Arki District Solan Hp Sh_ Construction Of Sump Well Providing And Installation Submersible Pumping Machinery With Allied Accessories And Providing And Fixing Reflux Valve And Sulice Valve. Under Dmft
BOQ
| Sl. No. | Item Description |
| 1 | Excavation in foundations, trenches etc. in earth work in all type of soil such as pick work, jumper work, stacking the blasting work kankar, moorum singles including decomposed soft and hard rock etc. upto all heights excavation and then stacking the excavated earth not more than 3 meters clear from the edge of excavation and than returning the stacked soil in 15cm layers when required into p[linths and sides of foundation etc. consolidating each deposited layer by ramming and watering and than disposing of all surplus excavated earth upto all leads and lifts as directed by the Engineer-in Charge complete in all respects. Pit/Collection Tank at Ali Khad. |
| 2 | Providing and laying cement concrete 1:3:6 (1 cement: 3 sand: 6 graded stone aggregate 40mm nominal size) excluding cost of centring & shuttering in. |
| 3 | Providing and laying cement concrete 1:1½:3 (1 cement: 1½ sand: 3 graded stone aggregate 20mm nominal size) and curing complete excluding cost of form work and reinforcement for reinforced concrete work in. |
| 4 | Providing mild steel/tor steel reinforcement for RCC work including bending, binding and placing in position complete upto floor two level. |
| 5 | Providing form work with steel plates 3.15mm thick welded with angle iron 30x30x5mm so as to give a fair finish including centring, shuttering, strutting and propping etc. with wooden batten and ballies, height of propping and centering below supporting floor to ceiling not exceeding 4 metres and removal of the same for insitu reinforced concrete & plain conrete work in. |
| 6 | Form work for intake columns, pillars, etc. |
| 7 | Flat surfaces such as soffits of suspended floors, roofs, landings & the like. (Floors upto 200mm th.) |
| 8 | Edges of Slab |
| 9 | Providing and laying No fine Cement Concrete1:6 (1cement: 4 graded stone aggregate 20mm N/S)and curing complete excluding cost of form work& reinforcement for reinforced concrete work, For intake tank |
| 10 | Boulder filling behind retaining wall & crate wall within all leads and lifts. |
| 11 | Providing and installing submersible pump of Crompton / KSB make confirming to ISI- 9034-1976 along with a directly coupled submersible type squirrel case electric submersible motor suitable for operation on 230 V, single phase 50 CPS, AC supply with water lubricated bearing, provided with pivoted segment type thrust bearings to with stand vertical pressure with minimum wear and terar and with device to take up the expansion of water with heating of motor complete in all respects.( 1 Set of 5HP)Total Head :- 15 MtrDlischarge : 3.00 LPS R / Main 32mm dia (L) 40 Rmt |
| 12 | Supplying and fixing rope wire 6mm2 dia suitable to wear the weight of submersible motor pumps set and GI Pipe etc. including all leads and lifts complete in all respects. |
| 13 | Supplying and fixing submersible cable 4mm2 3 core submersible cable of L&T /Havell make complete in all respects. |
| 14 | Supplying and fixing single phase panal board of BS / L & T / Havells / BS make with Ampears meter, volt meter Over load relay kit kat indicator set MCCB etc. including carriage of material up to all leads and lifts complete in all respects. |
| 15 | Supply and fixing of supporting clamps to submersible pump set of required size complete in all respects. |
| 16 | Providing and fixing of double flanged cast iron non return valve/Reflux valve of 65 mm dia of PN-1.6 of make Leader/ Kirloskar/KSB of equivalent make as per IS -5312 with upto date amendments including nuts and bolts, fiber seat alongwith providing and welding of flange table-17 on commen header 65 mm dai with in all leads and lifts and as per direction of Engineer in Charge. |
| 17 | Providing and fixing double flanged cast iron reflux valves of Leader make and of 50 mm dia of PN 1.0 having bye pass arrangement for rising main and capable of with standing normal seat pressure as per BS-114846 (P-I)with upto date amendments. |
| 18 | Providing and fixing double cast iron sluice valves of Leader make and of 50 mm dia of PN 1.00 having bye pass arrangement for rising main and capable of with standing normal seat pressure as per BS-14846 (P-I)with upto date amendments. Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Nov 06, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedNov 16, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 9 daysNov 16, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 9 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender