Defence Statutory Bodies & Commissions/Committees Closing in 1 days TDR #58361806

Tender For Repairs To Footpath, Broken Steps On Hills, Hardstanding, Handrails, Surface Dressing Under Phase-Iii (U And L Dahung, Dum Dum Nalla, Mh, Mes Offices And Messes) Of Age B/R Under Ge Tenga

Issued by Statutory Bodies & Commissions/Committees · kameng, Arunachal Pradesh
Tender Value
40 Lakhs
Estimated cost
Bid Submission
17 Nov 2026
1 days left
EMD
80000
Bank guarantee accepted
Document Fee
500
Non-refundable
Tender Type
Online

Tender Overview

Competition Type
NCB
Bidding Type
Tender
Location / State
kameng → Arunachal Pradesh
EMD Exemption
Available
Quantity
Not Available

Project Description

Tender for Repairs To Footpath, Broken Steps On Hills, Hardstanding, Handrails, Surface Dressing Under Phase-Iii (U And L Dahung, Dum Dum Nalla, Mh, Mes Offices And Messes) Of Age B/R Under Ge Tenga

BOQ

Name of Work:-
Sl. No. Item Description
1Taking down cement plaster on brick walls or stone walls any description etc including raking out joints, hacking for key, scrubbing down with water etc all as specified and directed.
2Demolition of cement concrete (unreinforced) of any description and in any position not otherwise specifically provided for all as specified & directed.
3Demolition of brick work or stone / boulder masonry, built in cement mortar 1:6 including all quoined, arches, pillars but excluding ashlar facings.dressed stone work complete all as specified and directed.
4-ditto- as per srl item No. 3 here- in-before but pre-cast concrete block walling complete all as specified and as directed.
5M&L for walling Random Rubble stone masonary uncoursed in CM 1:6 complete all as specified and directed.
6-Ditto- all as per item No.5 hereinbefore but except stone all as specified & directedNote:- stone obtained from item No.3 shall be reused.
7S&F PVC (SWR) 75mm bore pipe as in weep holes all as specified and directed.
8M&L for Hand packing (any thickness) of broken stone or boulders of size 20 to 40 mm at back of wall over arches etc and raising (or lowering) to the required level complete all as specified and as directed.
9M&L for precast cement concrete type C1, 1:3:6 (20 mm graded stone aggregate) as in bond stones set in CM 1:6 complete all as specified and directed.
10M&L for raised pointing to random or polygonal rubble, uncoursed or brought upto courses in CM 1:3 complete all as specified and directed.
11M&L for extra over lime or sandstone walling for hammer dressing to face stones and dressing of face beds and joints, as specified, of random rubble walling, uncoursed or brought upto courses with maximum depression on face from straight edge held against the dressed surface n exc. 40mm complete all as specified and directed.
12M&L for Providing precast cement concrete solid building blocks exc 10cm in width of type C1 (1:3:6) (20mm graded stone aggregates) and setting in cement mortar 1:6, in walls, complete all as specified and directed.
13M&L for Wire netting of galvanised steel wire of dia 1.40 mm and mesh size 20 mm including cutting & fixing all as specified and directed.
14M&L for Wire netting of galvanised steel wire of dia 0.91mm and mesh size 12mm including cutting & fixing all as specified and directed.
15M&L for Rendering 15 mm thick in cement mortar 1:6 on fair faces of brick work or concrete surfaces, to be finished even and smooth (without using extra lime or cement) complete all as specified and directed.
16M&L for Rendering 20 mm thick in cement mortar 1:4 on fair faces of brick work or concrete surfaces, finished fair and even (without using extra lime or cement) complete all as specified and directed.
17M&L for Preparation of new plastered or unplastered surfaces of wall and applying two coats of cement base paint over a coat of alkali resistance primer complete all as specified and directed.
18Demolition of Stone slabs and tiles of any description or thickness laid bedded and pointed in any mortar in floors, aprons etc..
19M&L for 100 mm thick PCC 1:4:8 type D-2 (40 mm graded aggregate) as in subbase to flooring complete all as specified and as diretcted.
20M&L for 75 mm thick PCC 1:4:8 type D-2 (40 mm graded aggregate) as in subbase to flooring complete all as specified and as diretcted.
21M&L for 40 mm thick PCC 1:2:4 ,type B-1(20 mm graded aggregate) in flooring with finishing cement concrete surface even and smooth without using extra cement complete all as specified and directed.
22M&L for Glass dividing strips, 3 mm thick 38mm wide inserted in position complete all as specified and directed.
23M&L for PCC 1:2:4, type B-1, using 20 mm graded mechanically crushed stone aggregates for hardstanding, mass concrete etc complete all as specified and directed.
24M&L for chequered cement concrete tile 20cmx20cmx25mm/30cmX30cmX 20 to 25mm thick set jointed and pointed in neat cement slurry in floor with grey cement and pigments over 20mm thick screed bed or bedding layer of CM (1:6) complete all as specified and as directed.
25M&L for Machine pressed precast concrete interlocking paver block any shape and size conferming to IS 15658-2006 of 60 mm thick M-35 Grade with grey cement and pigment complete all as specified and directed.
26M&L for 50mm avg thickness sand filling / cushioning bed with necessary consolidation for bedding layer of tiles etc complete all as specified & directed.
27M&L for 18-20mm thick granite (of any type) work (table rubbed and polished) in steps, jambs pillars, window cills ,cooking platform and like including pointing in white cement (1:2) using marble dust with admixture of pigments to match with shade or granite over including rendering 10mm thick in CM (1:4) etc complete all as specified and directed.
28M&L for cement concrete Type B-0 using 12.5mm graded stone aggregate (Nominal mix in 1:2:4) in copings, benching and the like including weathering slightly rounded or chamfered angles as directed including necessary form work and finishing all exposed surfaces complete all as specified and directed.
29Demolition of reinforced cement concrete (Reinforcement cut as required to facilitate deomolitions) of any description and in any position not otherwise specifically provided for complete all as specified and directed.
30Dismantling structural steel work including doors, gates but excluding framed truss etc. complete all as specified and directed.
31M&L for Reinforced cement concrete type B1, 1:2:4 using 20 mm graded aggregate as in foundation, including rafts, footings,foundation beams, base for columns etc, basement slabs, under-reamed piles and mass concrete complete, all as specified and directed.
32M&L for Reinforced cement concrete type B1, 1:2:4 using 20 mm graded aggregate as in columns, pillars, piers, posts and struts complete, all as specified and directed.
33M&L for RCC 1:2:4 type B-1 (20 mm graded aggregates) as in Beams, cantilevers, bressummers, lintels over 1.5m span complete all as specified and as directed.
34Use and waste of form work to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits(if any) in foundation, plinth beams and similar work vertical or to batter for rough finished surfaces on flat surfaces of concrete all as specified and directed.
35Use and waste of Form work to sides of square or rectangular columns, pillars, posts and struts for rough finished surfaces of concrete complete.
36Use and waste of form work to sides and soffits of beams, beam haunchings, girders, bressummers, lintels, cantilevers, shelves etc in fair finished surface complete all as specified and as directed.
37M & L for Mild steel TMT steel bar 10mm dia & over cut to length bent to shape required and binding wire with and including MS wire annealed not less than 0.9mm dia as in reinforcement complete all as directed and as specified.
38M&L for MS TMT bars 05mm and over, upto and including 10mm dia in stirrups, spaces and binders complete all as specified and directed.
39S&F mild steel framed work such as grills, gratings as for ornamental and intricate design gates side hung including pintle hinges, stops, hand made sliding bolts, etc confirming to Fe-290, Gde-E-165 complete all as specified and directed.
40M&L for PCC 1:3:6 type C-1 (using 20mm graded aggr) as in surface channels & drains,benching of manholes complete all as spd and directed.
41M&L for Extra for forming fair finished drain or channel 30cm inner girth in cement concrete, using extra cement, including forms, moulds, mitred/stop ends etc.
42Add or deduct for 25 mm grith or part thereof over or under 30 cm inner girth in cement concrete complete as specified and directed(qty Reffer by item no 41)
43Dismantling of cast iron or reinforced concrete drain pipes of 300mm dia, jointed in cement mortar and taking out of trenches complete all as specified and directed.
44Dismantling of cast iron or reinforced concrete drain pipes of 600mm dia, jointed in cement mortar and taking out of trenches complete all as specified and directed.
45M&L for Reinforced concrete pipes, class NP2, 250mm dia laid and jointed complete with collars complete all specified and directed.
46M&L for Reinforced concrete pipes, class NP2,600mm dia laid and jointed complete with collars complete all specified and directed.
47M&L for cement concrete 1:3:6 type C-2 (using 40 mm graded stone aggregate) to bed of drain pipes including packing under and haunching against the sides of pipes, after they are laid and tested for 250 mm bore pipe complete all as specified and directed
48M&L for cement concrete 1:3:6 type C-2 (using 40 mm graded stone aggregate) to bed of drain pipes including packing under and haunching against the sides of pipes, after they are laid and tested for 600 mm bore pipe complete all as specified and directed
49Material & Labour in repair for providing and fixing stainless steel (Grade 304) railing made of hollow tubes, channels, plates etc., including welding, grinding, buffing, polishing and making curvature (where ever required) and fitting the same with necessary stainless steel nuts and bolts complete, including fixing the railing with necessary accessories & stainless steel dash fasteners, stainless steel bolts etc., of required size, on the top of floor or the side of waist slab with suitable arrangement.
50Separating, scraping and cleaning of reinforcement (Demolition of concrete measured separately) complete all as directed.
51M&L for Pre-cast cement concrete cover slab for manhole and drain in plain cement concrete 1:2:4 type B-1, (using 20 mm graded stone aggregate) set in cement mortar 1:4 with plain faces complete all as specified and as directed. (Note:- Reinforcement shall be measured and paid seperately) Please Enable Macros to View BoQ information

AI Tender Summary

OUR REF NO 58361806
AUTHORITY Statutory Bodies & Commissions/Committees
TENDER VALUE 40 Lakhs
LAST DATE 17-11-2026
Authority
Authority Name Military Engineer Services
Work Description Tender for Repairs To Footpath, Broken Steps On Hills, Hardstanding, Handrails, Surface Dressing Under Phase-Iii (U And L Dahung, Dum Dum Nalla, Mh, Mes Offices And Messes) Of Age B/R Under Ge Tenga
Basic Detail
Tender No 8280/E8
Bidding Type Tender
Location
City kameng
State Arunachal Pradesh
Key Dates
Publish Date 03 Nov 2026
Submission Date 17 Nov 2026
Open Date 24 Nov 2026
Finance
Tender Value 40 Lakhs
Tender Fee 500
EMD 80000
Exemption Available
Document List
1cbf2419-7638-4da6-9239-5c1319a45f1b.html
BOQ_894171.xls
Tender.pdf
Tendernotice_1.pdf

Unlock Full AI Tender Summary

Get instant access to the complete AI-generated analysis — scope, eligibility, timeline & more.

Instant Access Secure Free
Your details are secure and used only for document delivery.

Tender Timeline

Nov 03, 2026
11:30 IST

Tender Published

Tender notice published.

Completed
Nov 17, 2026
17:00 IST

Bid Submission Deadline

Online submission via eProcurement portal.

Upcoming · 1 day
Nov 24, 2026

Bid Opening Date

Technical bids will be opened and evaluated.

Upcoming · 8 days

Tender Documents

Download All (ZIP) ↓
html

1cbf2419-7638-4da6-9239-5c1319a45f1b.html

xls

BOQ_894171.xls

pdf

Tender.pdf

pdf

Tendernotice_1.pdf

Disclaimer

We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender