Tender For Repair/Maint Of Sheds Brick Work Plastering Hard Standing And Other Connected B/R Works At D And F Coy Area At Lansdowne
Tender Value
27 Lakhs
Estimated cost
Bid Submission
23 Nov 2026
13 days left
EMD
54000
Bank guarantee accepted
Document Fee
500
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Pauri Garhwal → Uttarakhand
EMD Exemption
Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Repair/Maint Of Sheds Brick Work Plastering Hard Standing And Other Connected B/R Works At D And F Coy Area At Lansdowne
BOQ
| Sl. No. | Item Description |
| 1 | Dismantling of timber scantling 40 sqcm and over in section, in any position as in framed work complete all as specified and as directed. |
| 2 | Dismantling of Plain or corrugated steel sheeting,any gauge, thickness, including Nainital or similar pattern roof coverings complete all as specified and directed. |
| 3 | S&F Pre-painted galvalume aluminum zinc coated GI based corrugated steel sheet 0.50mm thick of colour, as approved having tensile strength of 550 Mpa, AZ-150 as in roof covering/cladding to wall, fixed with self tapping screws complete all as specified and directed. |
| 4 | S&F pre-painted galvalume aluminium zinc coating GI based plain steel sheet 0.50mm thick of colour as approved having tensile strength of 550 Mpa, AZ-150 as in roof covering/ cladding to wall, fixed with self tapping screws complete all as specified and directed. |
| 5 | S&F Steel work in tubular trusses including special shaped washer etc. complete using ERW or induction butt welded tubes conforming to I. S.1161- 1979 grade St.-240 complete all as specified and directed. |
| 6 | M&L for two coats of synthetic enamel paint over a coat of red oxide primer including preparation of new steel surface over 10cm width or grith complete all as specified and directed. |
| 7 | M&L for PCC (1:4:8) Type D2 (using 40 mm graded stone aggre-gate) as in foundations, filling and mass-concrete or sub base of floor/ hard standing/ footpath finishing the surfaces even and rough including demolition of cement concrete in ground floor and pavings not exc 15 cm thickness below or above ground level including removal of rubbish out side MOD land complete all as specified and directed. |
| 8 | M&L for sand filling under floors or in foundations including watering and consolidation complete all as specified and directed. |
| 9 | M&Lmachine pressed precast concrete interlocking paver block any shape and size confirming to IS 15658-2006 of 60 mm thickness, M-35 Grade including dismantling floor, hearth or wall tiling including cement mortar bedding (but not backing), removing serviceable tiles to store and rubbish off the premises complete all as specified and directed. |
| 10 | Demolition of brick work or stone/ boulder masonry, built in cement mortar or cement lime mortar including all quoins,arches, pillars,etc. but excluding ashlar facings, dressed stonework and precast concrete articles complete all as specified and directed. |
| 11 | M&L for brick work with old size full brick subclass ‘B’ burnt clay bricks, straight or curved on plan exc 6m mean radius, built in CM (1:6) up to 10 mtr height complete all as specified and directed. |
| 12 | M&L for walling of random rubble, uncoursed well bonded, bedded and solidly hearted, stone masonary work built in CM (1:6) complete all as specified and as directed. Note :- Only quantity of PCC bond stone to be deducted from quantity of random rubble masonary. |
| 13 | Description same all as item No. 12 above but except stone complete all as specified and directed. Note :- Old retreived serviceable stone under demolition item shall be used. |
| 14 | Extra over stone walling for hammer dressing with maximum depression on face from straight edge held against the dressed surfacae not exceeding 40mm to face stone for Lime or sand stone and dressing of face beds and joints, as specified of random rubble walling, uncoursed or brought upto course complet all as specified and directed. |
| 15 | M&L for raised pointing in cement mortar (1:4) to random rubble masonary uncoursed or brought upto course complete all as specified and directed. |
| 16 | M&L rendering 10 mm thick in CM 1:6 on brick or concrete surfaces even and smooth without using extra cement including taking down cement plaster on brick or stone wall surfaces including glazed tiles wherever exists including raking out joints, hacking for key and scrubbing down with water and removing unseviceable materials out side MoD land complete all as specified and directed. |
| 17 | M&L for 15mm thick plastering on ther than fair faces of brick or concrete surfaces in two layers, Ist layer 10mm thick CM (1:6), and IInd layer 5mm thick CM (1:4), surface finished even and smooth with out using extra cement mixed with @ 200ml per bag WPC (liquid type) including taking down cement plaster on brick or stone wall surfaces including glazed tiles wherever exists including raking out joints, hacking for key and scrubbing down with water etc and removing unseviceable materials out side MoD land complete all as specified and directed.complete all as specified and directed. |
| 18 | M&L for 15mm thick plastering on other than fair faces of brick wall in two layers, Ist layer 10mm thick CM (1:6), and IInd layer 5mm thick CM (1:4), surface finished even and smooth with out using extra cement complete all as specified and directed. |
| 19 | M&L preparation of newly plastered surface of external wall by application of 1 mm thick wall care putty to remove the dent and to make the surface even and smooth by grinding or rubbing with sand paper and applying Two or more coats of 100% Premium acrylic emulsion paint having VOC less than 50 gm/litre and UV resistance as per IS 15489:2004, Alkali & fungal resistance, dirt resistance exterior paint of required shade (Company Depot Tinted) with silicon additives @ 1.43 litre/ 10 sqm over and including priming coat of exterior primer applied @ 0.90 litre/ 10 sqm complete all as specified and directed. |
| 20 | M&L preparation of newly plastered surface of internal wall by application of 1 mm thick wall care putty to remove the dent and to make the surface even and smooth by grinding or rubbing with sand paper and applying two coats of acrylic distemper over a coat of primer using roller complete all as specified and directed. Note- Putty shall be measured and paid separately. |
| 21 | M&L for 1 mm thick acrylic water proofing wall putty and surface finished even and smooth with sand paper complete all as specified and directed. |
| 22 | Dismantling of posts or struts (wood, steel or R.C.C.) any section,embeded in concrete including taking out embedded portion from natural ground and making good disturbed ground complete all as specified and directed. |
| 23 | M&L for PCC (1:2:4) type B2 (using 40mm graded stone agg) as in mass concrete for embedding of post including demolition of existing concrete complete all as specified and directed. |
| 24 | Dismantling of fencing wire mesh, any type complete all as specified and directed. |
| 25 | Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc including provission of binding wire complete all as specified and directed. |
| 26 | Supply only Chain link MS galvanisd fencing, any size or type complete all as specified and directed. |
| 27 | S&F galvanised, 2 strand, steel barbed wire 2.24 mm dia barbed with 2 mm dia barbs at 75 mm spacings and straining and fixing to any type of standard rails straining bolts , including,securing or tying at crossings with and Provision of galvanised mild steel wire, staples or steel pins etc. as directed ( each line wire to be measured) complete all as specified and directed. |
| 28 | S&F 11 to 15 mm dia of neck mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, n exc 5cm long complete all as specified and directed. |
| 29 | S&F mild steel work as in hand rails, half round or other steel section or core for wooden hand-rail straight portion, drilled and countersunk for balusters running bars, for doors, balusters, nosing to steps including embeding in concrete and screwing etc. wind ties for roof including securing bolts, posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc and similar work conforming to Fe-290 Gde E-165 steel with and including necessary drilling holes etc complete all as specified and directed.Note: The unit rate quoted by contractor is deemed to be inclusive of cutting to dead lenth where required, notching, drilling, fitting, rivetting and/or welding or connecting with bolts and nuts (including rivets or bolt and nuts), providing and fiitings angle cleats, fish plates, gusset plate etc., also for welding plumbing, truing up and fixing complete. No claim whatso ever shall be entertained by Govt on this account. |
| 30 | S&F mild steel round bars 8mm dia and over as in tighting of chain link fencing including cutting to shape, necessary drilling, bolting, welding etc Fe-410-W (Gde E-250) quality -A or Fe 290 (Gde-E-185) complete all as specified and directed. |
| 31 | S&F framed work as in iron enclosure, doors or gate of angle iron or other section with gussets plate, rails, braces etc drilled for fixing of steel seating other covering, door etc to be prepared for hanging or sliding with and including either hooks and hinges or steel handing door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging, also fastening and fixing conforming to Fe-290 (Gde-E-165) complete all as specified and as directed. Note: The unit rate quoted by contractor is deemed to be inclusive of cutting to dead lenth where required, notching, drilling, fitting, rivetting and/or welding or connecting with bolts and nuts (including rivets or bolt and nuts), providing and fiitings angle cleats, fish plates, gusset plate etc., also for welding plumbing, truing up and fixing complete. No claim whatso ever shall be entertained by Govt on this account. Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Nov 02, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedNov 23, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 13 daysDec 01, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 21 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender