Public Administrative Department Government Departments Closing in 11 days TDR #58316636

Tender For Kswmp-Tirurangadi Municipality: Construction Of Overhead Tank For Firefighting System : Sulekha No 451/25-Overhead Tank For Firefighting System-General Civil Work-Sulekha Project No: 189

Issued by Government Departments · Malappuram, Kerala
Tender Value
28.59 Lakhs
Estimated cost
Bid Submission
30 Nov 2026
11 days left
EMD
50000
Bank guarantee accepted
Document Fee
2760
Non-refundable
Tender Type
Online

Tender Overview

Competition Type
NCB
Bidding Type
Tender
Location / State
Malappuram → Kerala
EMD Exemption
Available
Quantity
Not Available

Project Description

Tender for Kswmp-Tirurangadi Municipality: Construction Of Overhead Tank For Firefighting System : Sulekha No 451/25-Overhead Tank For Firefighting System-General Civil Work-Sulekha Project No: 189

BOQ

Name of Work:- KSWMP-Tirurangadi Municipality: Construction of overhead tank for firefighting system : Sulekha No 451/25-Overhead tank for firefighting system-General Civil Work-Sulekha Project No: 189
Sl. No. Item Description
1CONSTRUCTION OF OVER HEAD WATER TANK
22.32:Clearing grass and removal of the rubbish up to a distance of 50 m outside the periphery of the area cleared.
320.6.1.1:Vertical load testing of piles in accordance with IS 2911 (Part IV) including installation of loading platform by Kentledge/Anchor piles method and preparation of pile head or construction of test cap and dismantling of test cap after test etc. complete as per specification & the direction of Engineer in-charge.Single pile upto 50 tonne capacityInitial test (Test Load 2.5 times the Safe capacity)
420.6.1.2:Vertical load testing of piles in accordance with IS 2911 (Part IV) including installation of loading platform by Kentledge/Anchor piles method and preparation of pile head or construction of test cap and dismantling of test cap after test etc. complete as per specification & the direction of Engineer in-charge.Single pile upto 50 tonne capacityRoutine test (Test Load 1.5 times the Safe capacity)
5OD161172/2026-2027:Boring with hydraulic piling rigs with power units, providing and installing cast in situ single under reamed piles of specified diameter and length below pile cap in M-25 cement concrete, to carry a safe working load not less than specified, excluding the cost of steel reinforcement but including the cost of boring with bentonite solution and the length of the pile to be embedded in pile cap etc. all complete. (Length of pile for payment shall be measured upto to the bottom of pile cap) :500 mm dia piles
65.33.1.1:Providing and laying in position ready mixed or site batched design mix cement concrete for reinforced cement concrete work; using coarse aggregate and fine aggregate derived from natural sources, Portland Pozzolana / Ordinary Portland /Portland Slag cement, admixtures in recommended proportions as per IS: 9103 to accelerate / retard setting of concrete, to improve durability and workability without impairing strength; including pumping of concrete to site of laying, curing, carriage for all leads; but excluding the cost of centering, shuttering, finishing and reinforcement as per direction of the engineer-in-charge; for the following grades of concrete. Note: Extra cement up to 10% of the minimum specified cement content in design mix shall be payable separately. In case the cement content in design mix is more than 110% of the specified minimum cement content, the contractor shall have discretion to either re-design the mix or bear the cost of extra cementAll work upto plinth levelConcrete of M25 grade with minimum cement content of 330 kg /cum
7OD78038/2025-2026:Providing and laying in position machine batched and machine mixed design mix M-30 grade cement concrete for reinforced cement concrete work, using cement content as per approved design mix, including pumping of concrete to site of laying but excluding the cost of centering, shuttering, finishing and reinforcement, including admixtures in recommended proportions as per IS: 9103 to accelerate, retard setting of concrete, improve workability without impairing strength and durability as per direction of Engineer - in-charge. Note:- Cement content considered in this item is @ 350 kg/ cum. Excess or less cement used as per design mix is payable or recoverable separately.All work upto plinth level
85.9.1:Centering and shuttering including strutting, etc. and removal of form for:Foundations, footings, bases of columns, etc for mass concrete
94.1.8:Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:4:8 (1 Cement : 4 coarse sand (zone-III) derived from natural sources : 8 graded stone aggregate 40 mm nominal size derived from natural sources)
10OD78073/2025-2026:Providing and laying in position machine batched and machine mixed design mix M-30 grade cement concrete for reinforced cement concrete work, using cement content as per approved design mix, including pumping of concrete to site of laying but excluding the cost of centering, shuttering, finishing and reinforcement, including admixtures in recommended proportions as per IS: 9103 to accelerate, retard setting of concrete, improve workability without impairing strength and durability as per direction of Engineer - in-charge. Note:- Cement content considered in this item is @ 350 kg/ cum. Excess or less cement used as per design mix is payable or recoverable separately.All work above plinth level upto floor V level
115.9.6:Centering and shuttering including strutting, etc. and removal of form for:Columns, Pillars, Piers, Abutments, Posts and Struts
125.22.6:Steel reinforcement for R.C.C work including straightening, cutting, bending, placing in position and binding all complete upto plinth levelThermo - Mechanically Treated bars of grade Fe-500D or more
135.9.5:Centering and shuttering including strutting, etc. and removal of form for:Lintels, beams, plinth beams, girders bressumers and cantilevers
145.22A.6:Steel reinforcement for R.C.C work including straightening, cutting, bending, placing in position and binding all complete above plinth level.Thermo - Mechanically Treated bars of grade Fe-500D or more
1550.13.1:9 mm cement plastering of mix : 1:3 (1 cement : 3 fine sand ) including all cost of materials, labour charges etc complete
1613.7.1:12 mm cement plaster finished with a floating coat of neat cement of mix:1:3 ( 1 cement : 3 fine sand)
1713.43.1:Applying one coat of water thinnable cement primer of approved brand and manufacture on wall surface:Water thinnable cement primer
1813.60.1:Wall painting with acrylic emulsion paint of approved brand and manufacture to give an even shade:Two or more coats on new work
1910.25.2:Item Shifted to Sub head 14 as item 14.73Item Shifted to head 14 as item 14.74Steel work welded in built up sections/framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required.In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works
2013.61.1:Painting with synthetic enamel paint of approved brand and manufacture to give an even shade:Two or more coats on new work
2113.21:Extra for providing and mixing water proofing material in cement plaster work in proportion recommended by the manufacturers.
2250.18.9.8.1:Providing and fixing PVC pipes includings jointing of pipes with one step PVC solvent cement, trenching, refilling & testing of joints complete as per direction of Engineer in Charge. 75 mm dia 6 Kgf/ cm2
2350.18.9.7.1:Providing and fixing PVC pipes includings of pipes with one step PVC solvent cement, trenching refilling & testing of joints complete as per direction of Engineer in Charge. 63 mm dia 6Kgf/cm2
24OD161369/2026-2027:Supplying conveying , fitting, trial running and commissioning of electrically driven best quality reputed make ISI Marked open well/boe well type submersible pump set having bronze impeller & stainless steel shaft capable of discharging required 1pm against a total required head including all accessories such as panel board ,suitable starter ,flat submersible cable f sufficient grade ,delivery pipe (up to 10m)connecting to the pumping main etc.complete. The warranty shall be for a minimum period of two years ,1 HP to 10 HP Please Enable Macros to View BoQ information

AI Tender Summary

OUR REF NO 58316636
AUTHORITY Government Departments
TENDER VALUE 28.59 Lakhs
LAST DATE 30-11-2026
Authority
Authority Name Municipality
Work Description Tender for Kswmp-Tirurangadi Municipality: Construction Of Overhead Tank For Firefighting System : Sulekha No 451/25-Overhead Tank For Firefighting System-General Civil Work-Sulekha Project No: 189
Basic Detail
Tender No 02/TGI/KSWMP/2026-27
Bidding Type Tender
Location
City Malappuram
State Kerala
Key Dates
Publish Date 31 Oct 2026
Submission Date 30 Nov 2026
Open Date 30 Nov 2026
Finance
Tender Value 28.59 Lakhs
Tender Fee 2760
EMD 50000
Exemption Available
Document List
2.rar
BOQ_1506897.xls
ee662e33-6fea-4342-86d9-cc7c15405265.html
Tendernotice_1.pdf

Unlock Full AI Tender Summary

Get instant access to the complete AI-generated analysis — scope, eligibility, timeline & more.

Instant Access Secure Free
Your details are secure and used only for document delivery.

Tender Timeline

Oct 31, 2026
11:30 IST

Tender Published

Tender notice published.

Completed
Nov 30, 2026
17:00 IST

Bid Submission Deadline

Online submission via eProcurement portal.

Upcoming · 11 days
Nov 30, 2026

Bid Opening Date

Technical bids will be opened and evaluated.

Upcoming · 11 days

Tender Documents

Download All (ZIP) ↓
rar

2.rar

xls

BOQ_1506897.xls

html

ee662e33-6fea-4342-86d9-cc7c15405265.html

pdf

Tendernotice_1.pdf

Disclaimer

We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender