Tender For Supply And Construction Of 9 X Reinforced Cement Concrete Universal Pds
Tender Value
Ref. Documents
Estimated cost
Bid Submission
09 Nov 2026
6 days left
EMD
2.09 Lakhs
Bank guarantee accepted
Document Fee
Ref. Documents
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Amritsar → Punjab
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Supply And Construction Of 9 X Reinforced Cement Concrete Universal Pds
BOQ
| Sl. No. | Item Description |
| 1 | 9 x RCC UNIVERSAL PDs |
| 2 | Excavating over areas, n exc 1.5 m deep and getting out soft /loose soil all as specified. |
| 3 | Excavating over areas, exc 1.5 m deep and n exc 3.0 m deep and getting out hard /dense soil all as specified. |
| 4 | Material and Labour for Cement concrete 75 mm thick in fdn type B-2, 1:2:4 (40 mm graded aggregate) complete all as specified. |
| 5 | Material and Labour for RCC M-25 (Design Mix) using 20 mm graded aggregate in Foundation, including rafts, footing, foundation beams, bases for column etc complete all as specified. |
| 6 | Material and Labour for formwork to sides of rough finished flat surface of concrete foundations, footings, raft, bases of colums, plinth beams and simillar work vertical or to batter with cover blocks all as specified. |
| 7 | Material and Labour for RCC M-25 (Design Mix) using 20 mm graded aggregate) in walls, retaining walls, basement walls, and the like, any thickness, above top of footings, including attached pilasters and buttresses all as specified. |
| 8 | Material and Labour Formwork to sides rough finished square, rectangular or polygonl surface of pillars, posts, struts, piers, columns and stanchions with cover blocks all as specified. |
| 9 | Material and Labour for RCC M-25 (Design Mix) using 20 mm graded aggregate in Slabs supported on walls, beams and columns in floors, roofs, landings, Balconies, canopies, deck slabs and in shelves and the like all as specified. |
| 10 | Material and Labour for Formwork to rough finished flat surface of concrete, soffits of suspended slabs such as roof slabs, floor slabs, landing and similar work exceeding 200mm thick (Horizontal or sloping) with cover blocks all as specified. |
| 11 | Material and Labour for Formwork to edges of rough finished flat surfaces of concrete roofs exc 20 cm wide with cover blocks all as specified. |
| 12 | Material and Labour for Brick work with subclass 'B' bricks straight or curved on plan exeding 6 mtr mean radius built in parapet wall in CM 1:4 all as specified. |
| 13 | Material and Labour for providing Cement concrete type B1, 1:2:4 (20 mm )graded aggregate) in coping complete all as specified. |
| 14 | Material and Labour for Mild steel TMT Bar 8mm dia and over cut to length, bent to shape required, including cranking, bending spirally for hooping for columns hooking ends and binding with and including mild steel wire (annealed) not less than 0.9 mm dia or securing with clips for strirrups all as specified. |
| 15 | -ditto- as per item No 13 but in stirrups. |
| 16 | Material and Labour for Rendering 15 mm thick on wall in CM 1:4 on fair faces of bricks work or concrete surfaces complete all as specified. |
| 17 | Material and Labour for Rendering 10mm thick on wall in CM 1:6 on fair faces of bricks work or concrete surfaces complete all as specified. |
| 18 | Material and Labour for Rendering 10mm thick on wall in CM 1:3 on fair faces concrete surfaces on ceiling work complete all as specified. |
| 19 | M&L for 10mm thk rendering on fair faces concrete surfaces roof cement mortar in 1:4 with water proofing treatment 3% weight of cement complete all as specified. |
| 20 | Material and Labour for Priming surfaces and applying bitumen as a primer in base of APP membrane complete all as specified. |
| 21 | Material and Labour for APP based polymeric membrane minimum weighing 3 kg/sqm and minimum 3mm thick reinforced with polyster non woven fabric (wt not less than 150 gms/sqm) land on primed surface by forced application complete all as specified. |
| 22 | Material and Labour for 50mm thk PCC 1:2:4 Type B1 using 20mm graded stone aggregate on roof slab with water proofing compound the weight 3% of cement complete all as specified. (Note : Water proofing compound shall be measured separately) |
| 23 | Supply only for Integral water proofing compund |
| 24 | Material and Labour for preparation of new plastered surfaces of wall and applying two coats of synthetic enamel paint of approved colour and pattern over a coat of cement based primer complete all as specified. |
| 25 | Material and Labour for preparation of new plastered surfaces of wall and applying two coats of Cement base paint of approved colour and pattern over a coat of cement based primer complete all as specified. |
| 26 | Matearial and Labour for Cement concrete 75 mm thick in flooring type B-2, 1:2:4 (40 mm graded aggregate) complete as specified. |
| 27 | Supply and Fixing for mild steel Framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing Fe 410 -W (Gde- E- 250) quality- A complete all as specified. Make - SAIL/TATA/JSW/JINDAL/RINL. |
| 28 | Material and Labour for preparation of new MS surfaces of door and loop hole and applying two coats of synthetic enamel paint of approved colour and pattern over a coat of red oxide primer complete all as specified. |
| 29 | Returning,filling in including spreading , levelling,watering and well ramming in layers not exc 25 cm.complete all as specified. |
| 30 | Removing excavated soil n'exc 50m and depositing wheredirected at a level n'exc 1.50m above the starting point complete all as specified. |
| 31 | Material and Labour for Cement concrete in stairs in PCC 1:8:16 (40 mm graded aggregate) complete all as specified. |
| 32 | Supply and Fixing for 125mm Butt hinges, heavy weight, cold rolled mild steel, and fixed complete all as specified. |
| 33 | Supply and Fixing for 300mm Mild steel sliding door bolts, plate type, stove enamelled black, with bright bolt not less than 16mm dia with and including a minimum of 6 bolts and nuts, four on bolt plate and two on staple plate and fixed ® complete all as specified and directed. |
| 34 | Supply and fixing in Wall PVC (SWR) pipe 110 mm dia for rainwater drainage complete all as specified. |
| 35 | Supply and fixing in trenches 80 mm dia GI pipe light grade with all fittings complete all as specified. |
| 36 | Material and Labour for MS Sun shades made of 0.60 mm PPGI sheet reinforced with ISA frame 35 x 35 x 5 mm and MS flat 35 x 3 mm, will be provided above loop hole and door opening. The minimum projection of sun shade shall be 450 mm and 300 mm wide more than the opening. Sun shade shall be fixed in 20 degree downword slope and fixed with 8 Nos 12 mm dia 150 mm long nut & bolt in RCC wall including two coats of syenthetic enamel paint of approved colour and pattern complete all as specified. Make : SAIL/TATA/JSW. |
| 37 | 5 Pin 15 Amp Switch Socket Combination with PVC Gang Box |
| 38 | PVC Wire 1.5 Sqmm |
| 39 | 45 Watt solar ceiling light for Indoor purposes |
| 40 | LCs Set complete with all accessories as per details give below :- (i) Zinc & Alloy Coated safe Earthing Electrode (76.3mm dia) 2mtr long with back filled compound conductolite - 2 Bags CPRI Approved).(ii) Air terminal single pointed aluminium rod 12mm dia and 600mm long fitted on GI pipe.(iii) GI Pipe med grade 06 mtr long 40mm dia, Make : TATA/Jindal/ Bansal.(iv) Insulator with screw - 10 Nos.(v) Copper cable 70 sqmm multi-stranded single core. Make : Plaza/Havells/ Rallison/ISI - 15 RM.(vi) Testing points terminal box made out of GI Gun Metal or phosphorous of size 75x75x25mm with screw.(vii) Nut and bolts 2” x 1/2\\" - 08 Nos.(viii) Foundation Nuts & bolts 16mm x 400mm - 04 Nos(ix) FRP Earthing pit cover - 01 Nos(x) Copper Lugs 70 Swmm for connection of cable with nut & bolt of suitable size - 02 Nos. Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Oct 31, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedNov 09, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 6 daysNov 09, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 6 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender