Tender For Repair To Fencing, Hard Standing And Certain Other Misc Works In Domestic Area And Technical Area At Af Stn Purnea Under Age (I) (Af) Purnea.
Tender Value
12 Lakhs
Estimated cost
Bid Submission
19 Nov 2026
20 days left
EMD
24000
Bank guarantee accepted
Document Fee
500
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Purnia → Bihar
EMD Exemption
Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Repair To Fencing, Hard Standing And Certain Other Misc Works In Domestic Area And Technical Area At Af Stn Purnea Under Age (I) (Af) Purnea.
BOQ
| Sl. No. | Item Description |
| 1 | Excavation in post holes (or similar holes) each n.exc 0.50 cum, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25cm, watering, and removing surplus soil to a distance n.exc 50m and making good surface (Soft/loose soil), complete all as specified and as directed. |
| 2 | Material and labour for cement concrete type C-2 ,1:3:6 (40mm graded crushed stone aggregate) as in foundations, including, plinth beams; bases for columns and mass concrete etc., complete as specified and as directed. |
| 3 | Material and labour for PCC 1:2:4 type B1 (using 20mm graded crushed stone aggregate) as in lintels upto 1.5m clear span, cills, steps; seismic and other similar bands, plinth courses, string courses, lacing courses, parapets and railings upto 60 cm in height, copings, kneelers, apex stones, bed plates, kerbs not provided for in Item 04028, water troughs and the like including weathering, slightly rounded or chamfered angles and throating, complete all as specified and directed. |
| 4 | Demolition of cement concrete (un-reinforced) not exceeding 15 cm thickness (above or below ground level) and removal of debris from site, complete all as specified and as directed. |
| 5 | Material and labour for 75 mm thick PCC (1:3:6) type C-2 (20 mm graded crushed stone aggregate) as in plinth protection including finishing the concrete surface even and smooth without using extra cement, complete all as specified and directed. (Note: The unit rate quoted shall be deemed to include for providing the concrete in alternate bays n exceeding 3 meter long with 12 mm wide and 50 mm deep joint between the bays which shall be filled with mastic filling with hot bitumen 85/25 and 1:2 mix by volume.) |
| 6 | Material and labour for 100 mm thick plain cement concrete (1:3:6) type C2 (using 40 mm graded crushed stone aggregate) as in sub base in floor/paving/hard standing, complete all as specified and directed. |
| 7 | Material and labour for pre-polished and chemically treated smooth finish exterior grade coloured chequered tile for size 300 mm x 300 mm x 24 to 25mm thick, set, jointed and pointed in neat cement slurry in floors with and including 15mm thick screed bed or bedding layer in cement mortar (1:6) as in path, complete all as specified and directed. |
| 8 | Taking down old any type steel barbed wire from their position fixed in fencing post (each line wire to be measured), complete all as specified and directed. |
| 9 | Supply and fixing for galvanised, 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacing's and straining and fixing to any type of standard rails straining bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc as directed (each line wire to be measured), complete all as specified and directed. |
| 10 | Fixing only old barbed wire with restraining & re-securing including making good staples etc., complete all as specified as directed. Note: Old barbed wire to be obtained from Item No.8.00). |
| 11 | Material and labour for applying two coats of synthetic enamel paint over a coat of red oxide primer after preparation of newly steel surfaces of any description over 10 cm width or girth not other wise described, complete as specified and as directed. |
| 12 | Material and labour for preparation of new steel surfaces and applying two coat of synthetic enamel paint over a coat of red oxide primer not exceeding 10cm in width or girth not otherwise described, complete all as specified and directed.. |
| 13 | Material and labour for preparation of new steel surfaces and applying one coat of black bituminous paint on surfaces of any description over 10 cm width or girth not other wise described, complete as specified and as directed. |
| 14 | Dismantling of chain link fencing of any type any size, complete all as specified and as directed. |
| 15 | Supply only chain link MS galvanised fencing of any mesh size or type, complete all as specified and directed.Note : (i) Fixing of chain link fence will be measured and paid separately. (ii) Weight of chain link fencing shall be ascertain through Board of Officers. |
| 16 | Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provision of binding wire, complete all as specified and directed.Note : Chain link fencing will be paid separately. |
| 17 | Fixing only of old chain link fencing with restraining & re-securing including making good staple, complete all as specified and as directed. |
| 18 | Supply and fixing mild steel work like posts and struts in fencing including cutting tops to shape and directed ,drilling holes, notching for wire ,etc , mild steel angle , flat iron fillets for securing chain link/wire mesh including all necessary drilling, bolting or riveting etc, conforming to Fe-290, Gde E-165, complete all as specified and directed. |
| 19 | Dismantling posts or struts (wood, steel or R.C.C) any section, including taking out embedded portion and making good disturbed ground, post embedded in natural ground, complete as specified and as directed. |
| 20 | Material and labour for TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with the including mild steel wire (annealed) not less than 0.9mm dia or securing with clips, complete all as specified and directed. |
| 21 | Supply and fixing mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut diameter of neck in 10mm and 10 cm long, complete all as specified and directed. Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Oct 30, 2026
11:30 IST
Tender Published
Tender notice published.
TodayNov 19, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 20 daysNov 21, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 22 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender