Tender For 28- Special Repair Of Thet Papsari Link Road
Tender Value
20.80 Lakhs
Estimated cost
Bid Submission
05 Nov 2026
5 days left
EMD
2.08 Lakhs
Bank guarantee accepted
Document Fee
854
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Bijnor → Uttar Pradesh
EMD Exemption
Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for 28- Special Repair Of Thet Papsari Link Road
BOQ
| Sl. No. | Item Description |
| 1 | Excavation for roadway in soil by mechanical means including cutting and pushing the earth to site of embakment upto a distance of 100 m, including trimming bottom and side slopes in accordance with requirements of lines, grades and cross-sections. As per MORD Specification clause 3.5(ii). (Including labour cess but excluding GST.) |
| 2 | Construction of granular sub-base by providing well graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC, and compacting with smooth wheel roller to achieve the desired density, complete as per Technical Specification Clause 401. As per MORD Specification clause 401 Sr. No. 4.07. (Including labour cess, Royalty but excluding GST.) |
| 3 | WBM Grading 3 (22.4-53 mm) Providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with smooth wheel roller 80-100 kN in stages to proper grade and camber, applying and brooming, stone screening to fill-up the interstices of coarse aggregate, watering and compacting to the required density Grading 3 as per Technical Specification Clause 405. As per MORD Specification clause 401 Sr. No. 4.07(3)(A). (Including labour cess, Royalty but excluding GST.) |
| 4 | Construction of un-reinforced, dowel jointed at expansion and construction joint only, plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 , coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars, near approaches to bridge/culvert and construction joints, admixtures as approved, curing of concrete slabs for 14-days, Using curing compound (where specified) and water finishing to lines and grade as per drawing and Technical Specification Clause 1501. (Including labour cess, Royalty but excluding GST.) |
| 5 | Supply & fitting 80 mm thick Precast cement concerete I-Shape interlocking paver block a with top layer of minimum 8 mm thickness having plan dimension 200x(160+120mm) of O.P. cement, smooth high gloss finish, skid reditant. Manufactured from rubber moulds through vibro-compression machanism. the compressive strength of concrere paver block shall not be less than 30MPA (M-30) and weight 5kg per no confirming to IS:15658-2006 with a 4 cm thick layer of fine sand including cost of material, labour, T&P taxes etc required for proper completion of the work as directed by engineer-in-charge. as per Additional item road furnishing work no. 5(2). Grey Color. |
| 6 | Plain cement concrete M10 (1:3:6 nominal mix) in levelling course below open foundation of head walls as per drawing & Technical Specification Clause 1109. / Rate as per item No. 11.4 of Ch. 11. (Including labour cess, Royalty but excluding GST.) |
| 7 | Providing and laying reinforced cement concrete in superstructure as per drawing and technical specifications Clause 800, 1205.4 & 1205.5/I. R.C.C. grade M 20 (i) For Nominal mix 1:2:4. (Including labour cess, Royalty but excluding GST.) |
| 8 | Supplying, fitting and placing HYSD bar reinforcement in substructure complete as per drawings and technical specifications Clauses 1002, 1005, 1010 and 1202 Sr. No. 12.6. (Including labour cess but excluding GST.) |
| 9 | Supply and fixing of reflected board. (Including labour cess but excluding GST.) Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Oct 30, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedNov 05, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 5 daysNov 05, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 5 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender