Tender For Restoration Of Rain Damages To Water Supply Scheme Passu Dhagwar In Tehsil Dharamshala Distt Kangra (H.P)(Sh: Renovation Of Water Treatment Plant)
Tender Value
4.35 Lakhs
Estimated cost
Bid Submission
02 Nov 2026
6 days left
EMD
8710
Bank guarantee accepted
Document Fee
350
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Kangra → Himachal Pradesh
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Restoration Of Rain Damages To Water Supply Scheme Passu Dhagwar In Tehsil Dharamshala Distt Kangra (H.P)(Sh: Renovation Of Water Treatment Plant)
BOQ
| Sl. No. | Item Description |
| 1 | Excavation in foundations, trenches etc., in earth work, lift upto 1.50 Metres stacking the eacavated soil not more than 3 metres clear from the edge of the excavation and then returning the stacked soil in 15cm. layers, when required in to plinths sides of foundations etc., consolidating each deposited layer by ramming and watering and then disposing of all surplus excavated earth work complete in all respect as per direction and to the entire satisfaction of Engineer- in- charge within all leads and lifts. |
| 2 | Removal of silt and Filter media from filter bed i.e. sand and bazri lift up 1.50meter disposal of unserviceable material an d stacking the serviceable all leads and lifts, as per the directions and to the entire satisfaction of the Engineer-in-Charge. |
| 3 | Providing form work with steel plates 3.15mm.thick welded with angle iron in frame 30x30x 5mm. so as to give a fair finish including centring, shuutering, strutting and propping etc. with wooden battens and ballies, height of propping and centring below supporting floor to ceiling not exceeding 4 Mtrs. and removal of the same for insitu-reinforced concrete & plain concrete work in:- |
| 4 | Vertical surface such as wall (any thickness) partition and the like i/c attached pillasters, butresses plinth and string course including all leads and lifts. |
| 5 | Flat surfaces such as soffits of suspended floor, roofs, landing and the like complete in all respect i/c all leads and lifts. |
| 6 | Providing and laying cement concrete work 1:2:4 (1 Cement:2 Sand:4 graded stone aggregate 40 mm nominal size) and curing complete excluding cost of form work in : In foundation and Plinth complete in all respect as per direction and to the entire satisfaction of Engineer-in-Charge within all leads and lifts. |
| 7 | 20mm cement plaster in two caots backing coat 10mm and finishing coat 10mm thick on fair side of brick/stone masonry walls for interior plastering upto floor two level including arrises,internal rounded angles,chamfers and/or rounded angles not exceeding 80mm in girth and finished even and smooth. Cement mortar (1:3) (1 cement:3 sand) complete in all respect as per direction and to the entire satisfaction of Engineer-in-Charge within all leads and lifts. |
| 8 | 1st class Brick work using common burnt clay building bricks in super structure above plinth level upto floor two level in C.M 1:6 (1cement: 6sand) complete in all respect including all leads and Lifts as per the direction and to the entire satisfaction of Engineer-In-Charge. |
| 9 | Providing & fixing 40x3mm flat iron hold fasts 40cm long i/c fixing in frames with 100mm diameter bolts nuts and wooden plugs and embedding in cement concrete block 30x10x15 cm in CC 1:3:6 (1cement: 3sand: 6 graded stone agg. 20mm nominal size) complete in all respect as per direction and to the entire satisfaction of Engineer- in- charge up to all leads and lifts. |
| 10 | 20 mm thick cement plaster in single coat on rough side of brick/stone masonary for interior plastering upto floor two level including arrises internal rounded angle chamber and or rounded angles not exceeding 80mm in girth and finished even and smooth in Cement Mortor 1:6 (1 Cement: 6 Sand) complete in all respect as per direction and to the entire satisfaction of Engineer- in- charge within all leads and lifts. |
| 11 | Providing & laying Spartic tiles 5.5 thick flooring 300x300 size treads of steps lain on bed of 12mm thick cement morter 1:3 (1 Cement: 3 Sand) complete in all respect as per direction and to the entire satisfaction of Engineer- in- charge within all leads and lifts. |
| 12 | Providing and fixing panelled glazed or panelled and glazed shutters for doors windows and clerestory windows.including black enamelled iron butt hinges with necessary screws 40mm thick (2nd class Deodar wood) complete in all respects as per direction and to the entire satisfaction of Engineer-in-charge witnin all leads and lifts. |
| 13 | Providing and Fixing vitreous china wash basin with pedestal cutting holes and making good the same but excluding fitting inclusing all accessories complete in all respect as per the direction and to the entire satisfaction of Engineer-in-Charge with in all leads and lifts. |
| 14 | Providing and fixing white vitreous china pedestal type water closet (European type W.C. pan) with seat and lid, 10 litre low level white P.V.C. flushing cistern, including flush pipe, with manually controlled device (handle lever), conforming to IS : 7231, with all fittings and fixtures complete, including cutting and making good the walls and floors wherever required : W.C. pan with ISI marked white solid plastic seat and lid complete in all respect as per the direction and to the entire satisfaction of Engineer-in-Charge with in all leads and lifts. |
| 15 | Providing and fixing of cement concrete 1:6:12(1:cement :6 sand:12 graded stone aggregate 40 mm nominal size) and curing complete excluding cost of form work in foundation & plinth complete in all respect as per direction and to the entire satisfaction of Engineer- in- charge within all leads and lifts. |
| 16 | Providing and Laying of cement concrete 1:5:10 (1:cement :5 sand:10 graded stone aggregate 40mm nominal size) with excluding cost of form work in R/wall / B/wall the size of plum shall usely be 150mm to 300mm as per PWD specification complete in all respect inclueing all leads & lifts as per the directions and to the entire satisfaction of Engineer-in-charge. |
| 17 | Providing & Fixing of fencing panel size 1.80 X 1.20 mtrs. of Jali 25 X 25 mm welded to M.S. Black Tube of 32 mm dia of 14 guage mm with M.S. flat 20mm X 3 mm hold fasts made out of M.S. flat of 32 X 5 mm including cutting welding painting with red oxide paint of size 25 X 25 mm should be fixed in 1.20x1.20 mm the work should be executed complete in all respect including all leads and lifts as per the direction and to the entire satisfection of Engineer-In-Charge. |
| 18 | Supply and Fixing Galvanised Mild Steel barbed wire (IS-278-1962 Type-I) weighting 9.38 Kgs./100 metres (Minimum) straining and fixing to any type of standard rails straining bolts including securing with and provision of GMS wire staples of steel kpins etc and straining to bolts shall be paid for seperately complete in all respect as per direction and to be entire satisfation of Engineer- in- charge up to all leads and lifts. |
| 19 | Providing Steel work welded in built up sections,including cutting , hoisting ,fixing in position and applying a priming coat of red lead paint. In R.S. joists,channels,angles tees complete in all respect as per direction and to the entire satisfaction of Engineer-in-Charge within all leads and lifts.. |
| 20 | Wiring for circuit/sub-main with following size PVC insulated heat resistant flame retardant (HRFR) and low smoke single core (flexible) copper conductor cable in surface/recessed steel conduit along with 1 No.HRFRLS/PVC insulated single core copper conductor cable of same size for earthing as required. (2 x1.5) sqm |
| 21 | Supplying and fixing following rating, four pole, 415 volts, Isolator in the existing MCB DB complete with connections, testing and commissioning etc. as required. complete in all respect as per direction and to the entire satisfaction of Engineer-in-Charge within all leads and lifts.. |
| 22 | Wiring for light point / fan point / exhaust fan / call bell point with 1.5 Sq. mm. PVC insulated heat resistant flame retardant (HRFR) and low smoke single core (flexible) copper conductor cable in surface/recessed steel conduit and earthing the light point with 1.5 Sq.mm. HRFRLS/PVC insulated single core copper conductor cable as required complete in all respect as per the direction and to the entire satisfaction of Engineer-in-Charge within all leads and lifts. Group C |
| 23 | Supplying and fixing following rating, double pole, 240 volts, isolator in the existing MCB DB complete with connections, testing and commissioning etc. as required complete in all respect as per direction and to the entire satisfaction of Engineer-in-Charge within all leads and lifts. 63 Amps. Cat-A. |
| 24 | Supplying and fixing following rating Modular switch /socket in the existing switch box/ cover plate including connections etc. as required complete in all respect as per direction and to the entire satisfaction of Engineer-in-Charge within all leads and lifts. |
| 25 | S.P. 5/ 6 Amps one way Modular switch |
| 26 | S.P. 15/ 16 Amps one way Modular switch |
| 27 | 6 pin,5/6 Amps Modular socket outlet. |
| 28 | 6 pin,15/16 Amps Modular socket outlet. Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Oct 24, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedNov 02, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 6 daysNov 02, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 6 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender