Tender For special Repair To Pathway Along The Road Side From Cmp Chowk Towards Stn Church, Shopping Plaza And Patiala Gate Including Painting To Curbstone And Road Furniture At Yol Mil Stn Under Ge(Kh) Yol.
Tender Value
71.48 Lakhs
Estimated cost
Bid Submission
20 Nov 2026
2 days left
EMD
1.32 Lakhs
Bank guarantee accepted
Document Fee
1000
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Kangra → Himachal Pradesh
EMD Exemption
Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for special Repair To Pathway Along The Road Side From Cmp Chowk Towards Stn Church, Shopping Plaza And Patiala Gate Including Painting To Curbstone And Road Furniture At Yol Mil Stn Under Ge(Kh) Yol.
BOQ
| Sl. No. | Item Description |
| 1 | Demolition of cement concrete (unreinforced) in ground floors and pavings n.exc 15cm thickness (below or above ground level) complete including removal of debris to a distance exc 1.5 km but n.exc 2 Km outside the military stn, all as specified and as directed. |
| 2 | Demolition of cement concrete (reinforced) in ground floors and pavings n.exc 15cm thickness (below or above ground level) (reinforcement cut as required to facilitate demolition) complete including removal of debris to a distance exc 1.5 km but n.exc 2 Km outside the military stn, all as specified and as directed. |
| 3 | Demolition of stones or brick masonry or block walling, built in cement mortar including all quoins, arches etc., but excluding ashlar facing, dressed stone work etc.complete including removal of debris to a distance exc 1.5 km but n.exc 2 Km, all as specified and as directed. |
| 4 | M&L for Walling of random rubble, uncoursed built in CM 1:6 for random or polygonal rubble walling, brought up to course complete all as specified and directed. |
| 5 | Ditto as per item No 4 but except stone. |
| 6 | M&L for Rendering cement plaster 15mm thick in cement mortar 1:4 (1 cement : 4 coarse sand) in two layers (10mm thick first layer,10mm thick second and 5mm thick third layer), mixed with water proofing compound @ 3% by weight of cement on fair faces of brick wall or on concrete surfaces, surface finished even and fair without using extra cement, all as specified and directed. |
| 7 | M&L for preparation of newly plastered surface of walls and applying two coat of cement base paint complete all as specified and as directed. |
| 8 | M&L for Hardcore of Broken stone or boulders gauge n exc. 63 mm, deposited, spread and levelled in layers n exc. 15 cm thick, watered and rammed to a true surface complete all as specified and directed. |
| 9 | M&L for 75 mm thick PCC 1:3:6, type C-2 using 40mm graded aggregate as in sub base finished even and fair without using extra cement, complete all as specified and directed. |
| 10 | M&L for Reinforced cement concrete 1:2:4, Type B1 (Using 20 mm graded stone aggregate) as in Slabs supported on walls, beams and columns in floors,roofs, landings, balconies, canopies, deck slabs and in shelves and the like complete all as specified and directed. |
| 11 | S&F TMT bars 10mm dia and over, cut to length bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire not less than 0.9mm dia complete all as specified and directed. |
| 12 | M & L for chequered cement concrete tiles of size 20cmx20cmx 25mm thick with grey pigment cement and pigments, set jointed & pointed in neat cement slurry mixed with pigment to match the shade of the slab in floors laid over and including 15mm thick screed bed in cement mortar 1:4 complete all as specified and directed. |
| 13 | Providing and laying 80mm thick factory made chamfered edge cement concrete paver block of M-30 grade with approved colour, design & pattern as in footpath, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of coarse sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with fine sand and cutting of paver block as per required size and pattern, finishing and sweeping extra sand incl dismantling of existing paver blocks; complete all as specified and directed. |
| 14 | PCC 1:2:4 type B-1 using 20mm graded crussed stone aggregate. In lintels upto 1.5m clear span, cills, steps, seismic and other similar bands, plinth courses, string courses, parapets and railings upto 60cm in height, copings, kneelers, apex stones, bed plates, kerbs, water troughs and the like including weathering, slightly rounded for chamfered angles and throating, as directed. |
| 15 | M&L for Formwork to soffits of suspendedslabs such as roof slabs, floor slabs, landings and similar work;not exceeding 200mm thick (Horizontal or sloping)flat surface for rough finished surface complete all as specified and directed. |
| 16 | Providing and laying at or near ground level factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 (1 cement: 3 coarse sand), including making joints with or without grooves (thickness of joints except at sharp curve shall not to more than 5 mm), including making drainage opening wherever required including dismantling complete all as specified and as directed. |
| 17 | M&L for preparing newly concrete/plaster surfaces of any description over 10 cm girth or width, not otherwise described and applying two coat of synthetic enamel paint over a coat primer complete all as specified and directed. |
| 18 | M&L for preparing old painted concrete/plaster surfaces of any description over 10 cm girth or width, not otherwise described and applying one coat of synthetic enamel paint complete all as specified and directed. |
| 19 | M&L for preparing bituminous surfaces of road and marking 2.5mm thick centre lines, stop lines, dashes, arrows etc. and the like n. exc 10cm wide on roads pavements with hot applied thermo plastic road marking paint of approved colour confirming to BS 3262-1989 with special applicator machine all as per manufacturers instruction complete all as specified and directed. |
| 20 | Supply and fixing metal tubular dealineator made out of ABS round body fitted with 2 Nos 65 mm dia highly reflective reflectors made out of PMMA and mounted on 45/50 mm dia mild steel pipe of 600 mm height duly powder coated and thermo plastic elastomer 3 bands of green, red and yellow reflector radium tape of 25 mm wide strips with anti theft steel net for reflector protection of make dark eye Model No DA 74 or equivalent as approved including embedding in PCC 1:2:4 (150x150x300mm) type B1 complete all as specified and directed. |
| 21 | Supply and fixing cat eye solar reflective type of metal body alloy of size 100mm x 100mm x 20mm with PAMA striplens reflector of model No. DA 972.0 fixed with and incl MS stud of suitable size as per manufactures instructions complete all as specified and directed.. |
| 22 | Supply and fix solar cat eye aluminum alloy shall (100% water proofing design according to 65) of size 125mm x 125mm x 25mm (shank 65mm) of high efficiency Mono rystafie solar panel 2.4V/ 0.3 watt one NI-ed rechargeable battery (1.2V/ 1600MA) consisting of super bright LED with 10,000 to 18,000 mcd completed as per manufactures instructions etc. all as specified and directed. |
| 23 | S&F rounded Spring post of 750mm height, 80mm dia with round base of 200mm dia made of polyurethane with 3 white reflective bands of minimum size 75 mm made of HIG retro-reflectorised sheeting and fixing to the ground with screws and epoxy based resin as per specifications of manufacturers. |
| 24 | S&F Dual coloured type PVC speed breaker of size 350 x 250 x 50 mm with twin reflector both side complete all as specified and directed. Make: 3M,SHAKTI,DARKEYE. |
| 25 | S&F of road safety convex mirror of size 600 mm dia of approved make, circular shape, having wide-angle visibility, made of high impact resistant acrylic / polycarbonate mirror surface, with weather proof FRP/ABS backing, complete with bright coloured reflective frame (orange/yellow) with retro-reflective tape, including heavy duty adjustable mounting brackets made of MS, duly hot dip galvanized or powder coated, suitable for fixing on pole/wall complete all as specified and directed. |
| 26 | S&F Framed work such as grills,gratings, etc.. with ends of barsshouldered and/or riveted,or forged into spikes; framed guard bars; barred iron doors;ladders; framed balusters; walk ways; railings; framework of water tanks and similar work conforming to Fe.290.Gde-E-165, all as specified and directed. |
| 27 | Deduct Credit Amount as per Schedule of credit as details given on Srl Page No 20 of tender doucments. Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Oct 23, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedNov 20, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 2 daysNov 27, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 9 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender