Tender For Special Repair To Bldg No Est-263 And Est-264 At Z Gali Under Ge 874 Ews.
Tender Value
21.02 Lakhs
Estimated cost
Bid Submission
11 Nov 2026
11 days left
EMD
42100
Bank guarantee accepted
Document Fee
500
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Kupwara → Jammu and Kashmir
EMD Exemption
Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender For Special Repair To Bldg No Est-263 And Est-264 At Z Gali Under Ge 874 Ews.
BOQ
| Sl. No. | Item Description |
| 1 | S&F of Pre-painted galvalume aluminium Zink coating GI based corrugated steel sheet 0.50mm thick of an colour having tensile strength of 550MPa as in roof covering/cladding to wall, fixed with self tapping screw including necessary scaffolding, upto four storey building including dismantling old unserviceable GI/pre painted sheet complete all as specified and directed. Note : Cost of scaffolding work for fixing of roof sheet to be included in the unit rate quoted by tenderer. |
| 2 | S & F Pre-painted galvalume aluminium zinc coating GI based Plain steel sheet (profiled as ridge) 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, valley gutter fixed with self tapping screws including necessary scaffolding, upto four storey building including dismantling old unserviceable GI/pre painted sheet complete all as specified and directed. Note : Cost of scaffolding work for fixing of roof sheet to be included in the unit rate quoted by tenderer. |
| 3 | M&L Non - skid Coloured Ceramic tiles 7 to 8 mm thick area of each tile exceeding 0.18 sqm but not exceeding 0.38 sqm, in floors etc. set and jointed in neat cement slurry and pointed in white or coloured cement to match the colour of tile on 15mm thick screed bed in CM 1:4 including dismantling of floor, hearth or wall tiling including cement mortar bedding complete all as specified and directed. |
| 4 | S&F in repair 40 mm (for ceiling) puff insulated panel made of 0.50mm thick hot dipped galvanised sheet on both side with 40mm thick ridge polyurethane foam provided with tongue and groove joint for interlocking, to be fixed with inverted CRCA tee section 50x50x5mm thick and L section of 50x50x5mm thick fixed to roof trusses complete all as specified and directed. |
| 5 | Taking down chowkats with shutters (without taking off shutters from the frame) n exc. 1.50 sqm each & removing from site complete all as specified and directed. |
| 6 | Refixing of door/window in same opening of shutter exc 1 sq. m and n exc 2 sqm each complete all as specified and directed |
| 7 | S&F 35mm thick second class soft wood Plain, framed, panelled shutters for door (any number of panels), with panels of timber flat on both sides (feather edged), or of veneered particle board medium density, wood particle board with commercial face veneers: supplied and fitted to chowkats complete all as specified and directed. |
| 8 | M & L for Aluminium sliding three track window with powder coated aluminium (minimum thickness of powder coating 50 micron) frame of aluminium section 62.5mm x 37mm x 1.5mm thick with shutters having style and rails of aluminium section 47.62mm x 44.45mm x 1.5mm thick including joining cleats, glazing clips, rubber packing, aluminium snap beading, screws anodized aluminium fittings such as fixing window handles, tower bolts and provision for fixing lock etc., including 4.5 mm thick tinted glass fixed with beading, silicon lining and gaskets and stainless steel wire netting fixed in repairs, complete all as specified and directed. |
| 9 | S&F in repair plywood grade BWR type BB, 9mm thick fixed with nails to timber frame work in wall/ ceiling complete all as specified and directed |
| 10 | M&L for 25 mm Cement concrete type B-1, 1:2:4 (20mm graded aggregate) in subbase complete all as specified and directed. |
| 11 | M&L for brick work with sub class 'B' bricks straight or curved on plan exceeding 6 M mean radius built in cement mortar 1:4 including Demolition of brick/stone masonry, built in cement mortar including all quoins, arches, pillars etc but excluding ashlar facing, dressed stonework and precast concrete articles complete all as specified and directed. |
| 12 | M & L for 15 mm thick rendering on fair faces of brick work or concrete surfaces in CM 1:4, rendering finished even and smooth (without using extra cement) complete all as specified and directed. |
| 13 | Demolition of cement concrete (unreinforced) in ground floors and paving not exceeding 15 cm thickness (below or above ground level) complete all as specified and directed. |
| 14 | M & L for Second class clean sawn soft-wood in scantlings unframed timber scantlings in fillets, rails, posts, rafters, purlins, etc. under 40 sq. cm in section including dismantling of timber scantling complete all as specified and directed. |
| 15 | M&L for applying two coats of synthetic enamel paint over one coat of pink primer by preparing of new wooden surfaces of any description, not otherwise described over 10cm width or girth complete all as specified and directed. |
| 16 | M&L for Plain fillets exc 3 & n exc 6 sqcm square, rectangular or triangular in section, clean sawn, secured with nails or brads of 2nd class soft wood complete all as specified and directed. |
| 17 | M&L for preparation of newly/old plastered wall surfaces and applying two coats of cement based paint over a coat of primer complete all as specified and directed. |
| 18 | S&F extruded aluminium alloy with galvanised mild steel hinge pin Butt hinges 100mm long type B-21 complete all as specified and directed. |
| 19 | S&F Aluminium anodised, barrel tower bolts of extruded section and fixed 150 mm long complete all as specified and directed. |
| 20 | S&F extruded aluminium alloy handles 150 mm, fabricated type, anodised complete all as specified and directed. |
| 21 | S&F Aluminium alloy, anodised, sliding door bolt with hasp, staple (bolt type) 250mm long not less than 12mm dia with and including minimum of 06 bolts and nuts, 4 on plate and 2 on staple and fixing clips of sheet, cast or extruded sections and fixing bolts and sliding bolts of extruded sections or cast-aluminium alloy and fixed, plate and fixed complete all as specified and directed.. |
| 22 | M&L for 75 mm thick PCC (1:3:6) type C-2 (using 40 mm graded stone aggregates as in floor/path/hardstanding/plinth protection etc. complete all as directed. |
| 23 | S&F in repairs 500 ltrs Rotational Moulded polyethylene water storage tanks (cylindrical vertical with closed top) hoisted and fixed in position all as specified in SSR Part-I. complete all as specified and directed. |
| 24 | S & F stainless steel drapery or curtain rods, 25 mm dia, with end brackets, decorative type, cut to length as required size, colour coating including matching socket and brackets, complete all as specified and directed. |
| 25 | M&L for mild steel work as in bands, straps, supports or stays for rainwater, ventilating pipes, including bolts, if required: hooks (stay), heavy, for large gates; hook and pintle hinges: large hasps and staples; chains; hand made sliding bolts; clamps; hold fasts; wall ties; hooks for hanging fans; plain angle cleats for securing purlins to wood/steel trusses or rafters; knee piece inserts; two way and three way straps, plate washers and similar small articles conforming to Fe-290 Gde-E-165 complete all as specified and directed |
| 26 | M&L for preparation of new/old steel surfaces of any description over 10 cm width or girth and applying two coats of synthetic enamelled paint over a coat of red oxide primer complete all as specified and directed. |
| 27 | S&F 75 mm bore PVC SWR pipe single socketed (ISI Marked) any length with rubber ring joints complete fittings etc fixed to wall with MS clamps 8mm dia with two nuts wall nails etc including dismantling of rain water pipe and sewage line pipe of any type and any size including fitting complete all as specified and as directed. complete all as specified and directed. |
| 28 | S&F PVC (SWR) bends any radius, 75mm bore, fitted with oval access door complete all as specified and directed. |
| 29 | S & F 2nd class soft wood plain solid straight chowkats and frames wrought framed, rebated on the solid complete all as specified and directed. |
| 30 | M & L for point wiring One light/one fan/one bell point controlled by one switch, with PVC insulated unsheathed single core multistranded copper conductor 1.5 sqmm, 1100 volts grade cable, FRLSH, drawn through PVC casing capping including accessories and provisioning of PVC boxes for mounting switches, switch socket, fan regulator, as required on site or as directed by Engineer-in-Charge including one run of PVC insulated unsheathed multistranded copper conductor cable 1.5 sqmm (green colour) earth wire and connected to earth dolly complete all as specified and directed. |
| 31 | As per item No 30 above but point wiring for One socket outlet 5 pins 5 amps controlled by one switch on same board. |
| 32 | As per item No 30 above but point wiring One socket outlet 5 pins 5 amps controlled by one switch on independent board. |
| 33 | All as per item No 30 herein before but wiring with 2.5 sqmm copper wire (FRLSH) and 2.5 sqmm earth wire for socket outlet 6 pin 15 amp on independent board. |
| 34 | S&F switch piano flush button, single pole, one way 5 amps complete all as specified and directed. |
| 35 | S&F socket outlet multi 5 pins 6 amp, complete all as specified and directed. |
| 36 | S & F switch socket combination 2 in 1, 6A flush type complete all as specified and directed. |
| 37 | S & F switch socket combination 3 pin 16A flush type complete all as specified and directed. |
| 38 | S&F ceiling rose, PVC/poly carbonate, isolated body three terminal complete all as specified and directed. |
| 39 | Supply and fixing in replacement LED lights fitting 1x 20W, 220V, AC decorative box type with driver, holder including LED tube light connecting up with three core flexible copper conductor cable of suitable size from ceiling rose complete all as specified and directed. |
| 40 | S & F in replacement LED light fitting 1x9W/10W bulk head luminaires including LED light driver holder connecting up with three core flexible copper conductor cable of suitable size complete all as specified and directed. |
| 41 | Supply and fixing LED light fitting mirror type with high out put diffuser 2 feet, 10 watt 220 V AC decorative type with driver holder including LED light connecting up with three core flexible copper cable of suitable size complete all as specified and directed. |
| 42 | S&F lamp holder angle as specified, PVC/Poly carbonate type insulated body with back plate suitable for batten/wall fixing complete all as specified and directed. |
| 43 | Supply and fix LED Bulb 9 Watt complete all as specified and directed. |
| 44 | S&F in repair sheet metal enclosure for DBs (double door type) when MCBs to be used single pole and neutral 8 way including blanking plate as required with 200 amps rated busbar 240V fixed sun flush to the wall or niche including taking down old one complete all as specified and directed. |
| 45 | S&F MCB single pole & neutral 40 to 63 Amps 230 Volts 'C' series, 10 KA complete all as specified and directed. |
| 46 | S&F MCB's single pole 240 volts 6 to 32Amps 10 KA 'C' series complete all as specified and directed. |
| 47 | Supply and fixing 1100 volts grade heavy duty cable PVC insulated stranded aluminium conductor, served with inner sheathed of PVC tape overall PVC sheathed in service connections suspended by insulating hangers not more than 3 metre apart including 4 mm suspension wire, one twin core cable of size 16 Sqmm complete all as specified and directed. |
| 48 | M & L for earthing complete with galvanized steel earth plate electrode 60cmx60cmx6mm thick buried directly in ground (earth pit not less than 2.25m deep below normal ground level) with top edge of the plate not less than 1.5m below normal ground level, connected to galvanized iron wire 4.0 mm dia by means of bolts, nuts and washers, galvanized iron or steel, protected by GI light grade pipe 15mm bore including GI light grade water pipe 20mm dia with funnel as shown in elect. No. 03 of 2009 SSR Pt-I and testing on completion including earth work in any type of soil, PCC 1:2:4 type B-0 as in earth pit and cover 40mm thick with XPM (weight not less than 4.0Kg/Sqm) and frame of angle iron 25x25x3mm with lugs 2 Nos and with 6mm MS bar handle made to shape, common salt, charcoal and testing on completion complete all as specified and directed. Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Oct 21, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedNov 11, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 11 daysNov 13, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 13 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender