Tender For O/M Of Stp (Two Year Annual Repairing And Rewinding Of Booster Motor And Other Allied Electrical Work At Ugr Stp, Sector-123) Noida
Tender Value
55.98 Lakhs
Estimated cost
Bid Submission
21 Oct 2026
4 days left
EMD
1.33 Lakhs
Bank guarantee accepted
Document Fee
2832
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Ghaziabad → Uttar Pradesh
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for O/M Of Stp (Two Year Annual Repairing And Rewinding Of Booster Motor And Other Allied Electrical Work At Ugr Stp, Sector-123) Noida
BOQ
| Sl. No. | Item Description |
| 1 | Rewinding of VT Motor & Booster Motor (Centrifugal Motor) Kirloskaer make / Equivalent make as per original winding 415 volt with super enamelled copper wire as required gauge complete all respect as per direction of Engineer incharge. It is also include the dismentling / Refixing / Catage from site to workshop / factory and vice versa. The old material will the property of contractor (Old material rate already deducted in AOR) a) 50 HP, 1440 RPM |
| 2 | 100 HP, 1440 RPM |
| 3 | Repairing/Rewinding of 150 HP submersible pump set as per following - a) Motor rewinding with \\"F\\" class insulation |
| 4 | Winding themostat 140 +/- 5 ON/Off Auto cut |
| 5 | Upper mechanical seal |
| 6 | Lower mechanical seal |
| 7 | Cable Protector |
| 8 | S/F \\"O\\" ring set |
| 9 | S/F Oil |
| 10 | S/F Terminal Block |
| 11 | S/F Spring Washers |
| 12 | S/F Cir Clip |
| 13 | S/F Adjustment Screw |
| 14 | S/F Top Cover |
| 15 | S/F Bottom Plate |
| 16 | S/F D.I. Impeller |
| 17 | Motor Pump Dismentling, Assembling i/c labour Charges |
| 18 | Repairing of Fully Automatic Starter 100 HP as per following based on Approved Analysis a) S/I of MNX 225 Amp. Contactor L&T Make |
| 19 | S/I of 250 Amp. MCCB L&T Make |
| 20 | S/F of Timer L&T Make |
| 21 | S/I of VPD Make Soft Hard |
| 22 | S/I of MPD Make Soft Hard |
| 23 | WLC/Seal Monitor (Make Pump Care/Kishor) |
| 24 | S/I of Control Transformer Make Electra Care/Pioneer |
| 25 | S/I Winding Temp. Relay Minilec Make |
| 26 | Auto Transformer suitable for 100 HP induction motor |
| 27 | S/F of 11 KV TPMO Relco/Rama make 9 nos. insulator of Jai shree/BHEL make complete in all respects as per direction of E/I. |
| 28 | S/F of 400 Amp. four pole change over switch on 50x50x6mm angle iron frame i/c the cost of labour, T&P, painting and other material requried for proper completion of the work as per direction and satisfaction of E/I. |
| 29 | S/F 125 Amp. 3 Pole MCCB TM Type, 36 KA (Make L&T C-Power / D-Sine) / Siemens (3WL /VL) / Schnieder (Masterpact / NSX) |
| 30 | S/F 250 Amp. 3 Pole MCCB TM Type, 36 KA (Make L&T C-Power / D-Sine) / Siemens (3WL /VL) / Schnieder (Masterpact / NSX) |
| 31 | S/F 400 Amp 3 Pole MCCB µP type, 50 KA (Make- L&T C-Power/ D-Sine) / Siemens (3WL /VL) / Schnieder (Masterpact / NSX) Only For STP |
| 32 | S/F Ampere meter (Make-AE/ PROCOM / CONZERVE) |
| 33 | S/F Voltmeter (Make-AE/ PROCOM / CONZERVE) |
| 34 | S/F Indicating Light (Make- ESBEE / SIEMENS / SCHNIEDER) |
| 35 | S/F Indicating Light (Blue and White) (Make- ESBEE / SIEMENS / SCHNIEDER) |
| 36 | Supply and laying of 1800 mm x 900 mm x 12 mm thick chequered rubber matting of tested quality. |
| 37 | Supply and fixing of recess / surface mounting square 24 to 32 Watt LED down lighter having powder coated die cast aluminium housing with extended heat sink, diffuser / Reflector and driver set complete in all respects. |
| 38 | Supply and Fixing of LED Street light fitting having die cast aluminium body and diffuser with driver set suitable for 60 to 72 watt. Confirming to IP 66 protection complete in all respects. |
| 39 | S/L of aluminium conductor PVC insulated armoured served, sheathed cable 1100 Volts grade at a depth of 750 mm below ground level over a cushion of 75mm thick sand all around and protected with burnt bricks on sides and on top. On surface the cable run shall be fixed on MS clamps etc. of suitable size or as directed by Engineer-Incharge complete in all respect. The armouring of the cable shall be properly connected with the earth conductor by clamps etc. 120 sqmm 3½ core |
| 40 | Supplying and laying of following site DWC HDPE pipe ISI marked along with all accessories like socket, bend, couplers etc. conforming to IS 14930, Part II complete with fitting and cutting, jointing etc.direct in ground (75 cm below ground level) including excavation and refilling the trench but excluding sand cushioning and protective covering etc., complete as required. 120 mm dia (OD-120 mm & ID-103 mm nominal) Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Oct 16, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedOct 21, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 4 daysOct 22, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 5 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender