Road Transport and Highways Government Departments Closing in 11 days TDR #57740165

Tender For special repair (Special Repair) Work ,Providing Mastic Asphalt Work On Worn Out cement concrete Portion, Construction Of Drain At Viratnagar, Providing Street Lights At Km 106/200 (Nadka), Km 108/400 (Peeproli), Km 110/500 (Goha), Km 113/0

Issued by Government Departments · Jaipur, Rajasthan
Tender Value
7.66 Crore
Estimated cost
Bid Submission
30 Nov 2026
11 days left
EMD
15.32 Lakhs
Bank guarantee accepted
Document Fee
10000
Non-refundable
Tender Type
Online

Tender Overview

Competition Type
NCB
Bidding Type
Tender
Location / State
Jaipur → Rajasthan
EMD Exemption
Not Available
Quantity
Not Available

Project Description

Tender for special repair (Special Repair) Work ,Providing Mastic Asphalt Work On Worn Out cement concrete Portion, Construction Of Drain At Viratnagar, Providing Street Lights At Km 106/200 (Nadka), Km 108/400 (Peeproli), Km 110/500 (Goha), Km 113/00 (Ramgarh Town), Km 123/00 (Mandapur), Km 124/00 (Naugaon) And Junction Improvement Work Shahpura-Nuh Section Of Nh-248A In The State Of Rajasthan (Dlp Period Three Years)

Corrigendum

Sr No Corrigendum Date Corrigendum Type New Submission Date
1 23-Oct-2026 Corrigendum 1 Date Date 05-Nov-2026
2 03-Nov-2026 Corrigendum 2 Date Date 16-Nov-2026
3 23-Oct-2026 Corrigendum 1 Date Date 05-Nov-2026
4 16-Nov-2026 Corrigendum 3 Date EE Date 30-Nov-2026

BOQ

Name of Work:- SR (SPECIAL REPAIR) WORK ,PROVIDING MASTIC ASPHALT WORK ON WORN OUT CC PORTION, CONSTRUCTION OF DRAIN AT VIRATNAGAR, PROVIDING STREET LIGHTS AT KM 106/200 (NADKA), KM 108/400 (PEEPROLI), KM 110/500 (GOHA), KM 113/00 (RAMGARH TOWN), KM 123/00 (MANDAPUR), KM 124/00 (NAUGAON) AND JUNCTION IMPROVEMENT WORK SHAHPURA-NUH SECTION OF NH-248A IN THE STATE OF RAJASTHAN (DLP PERIOD THREE YEARS)
Sl. No. Item Description
1Providing and laying 25 mm thick mastic asphalt wearing course with paving grade bitumen (PMB - 40) / industrial grade bitumen meeting the requirements given in Table 500-39, 40, 41, 42, prepared by using mastic cooker and laid to required level and slope after cleaning the surface, including providing anti- skid surface with bitumen precoated fine grained hard stone chipping of 13.2 mm nominal size at the rate of 0.005 cum per 10 Sqm and at an approximate spacing of 10 Cm center to center in both directions, pressed into surface when the temperature of surfaces is not less than 1000 C, protruding 1 mm to 4 mm over mastic surface, all complete as per MoRTH specification Clause 516.
2Earth work in excavation for foundation of structure complete with all lift, dewatering shoring and shuttering etc. .including refilling of trenches in 25.mm layers, ramming, watering and disposal of surplus soil within a lead of 1000 meters, as per drawing and technical specification.[MoRTH Specification : Clause : 304]
3Structural cement concrete (Design Mix) in open foundations, with form work, at any level. Cement concrete for plain/reinforced concrete in open foundation as per drawing and technical specification. [MoRTH Specification : Section 1700(N)&1500(N)]. Using Batching Plant, Transit Mixture, and Concrete Pump. P.C.C.M-15 grade (PCC Below Drain)
4Structural cement concrete (Design Mix) in open foundations, with form work, at any level. Cement concrete for plain/reinforced concrete in open foundation as per drawing and technical specification. [MoRTH Specification : Section 1700(N)&1500(N)]. Using Batching Plant, Transit Mixture, and Concrete Pump. R.C.C.M-25 grade
5Steel reinforcement in substructure complete.[MoRTHSpecification : Section 1600(N)] RCC Drain (Provide Steel 65 Kg/m3)
6Providing and applying tack coat on the prepared surface, with bitumen emulsion RS-1 as per IS : 8887 & manufacturer’s specifications @ 2 kg /10sqm. With a self propelled or towed bitumen pressure sprayer equipped for spraying the material uniformly at specified rates and temperatures as per MoRTH specification Clause 503 & 112 ( Including cleaning of bituminous road surface )
7Providing and laying bituminous concrete as per design mix on prepared surface with specified graded stone as per table 500-16 & 500-17 for wearing course including loading of aggregate with Front end loader and hot mixing of binder (including cost of anti-stripping compound, wherever required) and filler as per table 500-9 with aggregates in hot mix plant More than 60-90 TPH Transporting the mix material with tipper and laying with sensor paver finisher (as per clause 507.3.5) to the required level , grades and rolling with vibratory compactor and pneumatic tyred roller 150-250 KN,TP=0.7 Mpa, to achieve the desired density (approved by the department) excluding cost of primer/tack coat (MoRTH Specification : Clause -507 & 112) with all lead.Grading II (13.20 mm nominal size) - Bitumen @ minimum 5.40% of mix & thickness 30 - 40 mm PMB - 40 Grade.
8Construction of dry lean cement concrete Sub- base over a prepared sub-grade with coarse and fine aggregate conforming to IS: 383, coarse aggregate 26.5mm nominal size aggregate cement ratio not to exceed 15:1, aggregate gradation after blending to be as per table 600-1, cement content not to be less than 150 kg/ cum, optimum moisture content to be determined during trial length construction, concrete strength not to be less than 10 Mpa at 7 days, mixed in a batching plant, transported to site, laid with a paver with electronic sensor, compacting with 8-10 tonnes vibratory roller, finishing and curing. as per MoRTH Specification cl. 601.
9Construction of un-reinforced, dowel jointed, plain cement concrete pavement over a prepared sub base with OPC 43 grade cement , coarse and fine aggregate (table 600-2 & 600- 3) conforming to IS 383, maximum size of coarse aggregate 31.5mm nominal size mixed in a batching and mixing plant as per approved Mix design to achieve required design mix grade of controlled concrete, transported to site, laid with aslip form paver, spread, compacted and finished in a continuous operation including provision of contraction, expansion, construction and longitudinal joints, joint filler bord , separation membrane, sealant primer, joint sealant (Table 600-4), debonding strip, dowel bar (IS : 432 Grade-I), tie rod (IS : 1786 Fe500 or IS : 432 Grade-I) , admixtures (IS : 9103 & IS : 6925) as approved, curing compound, finishing to lines and grades as per drawing including joimt cutting & texturing etc complete as per MoRTH Specification cl. 602 (with flexural strengthe minimum 4.5 MPa).
10Supply and erection of Galvanized Iron pole with galvanizing done in single dipping (Average coating thickness Minimum 65 Microns) Swaged tubular pole conforming to IS: 2713-1980 (part I to II) with galvanised base plate, The pole shall be made from steel tube & Pipe (IS:1141, Fe 410) including excavation of the pit and filling the same with C.C. of M-20 grade (1:1.5:3) from base plate to 50 cm above ground level, with the help of steel frame not less than 40 cm dia up to 114.3mm outer dia and 50 cm beyond 114.3mm outer dia around the pole. Duly finished with cement plaster, earthing terminals, cable entry with 32 mm dia. 'B' class GI cable sleeves complete as required. of following height & designation. ( See Table P - 02 for specs. ) All as per pre approved by Engineer in-charge. For additional technical parameters of products/ work , refer Annexure \\"A\\" attached with this BSR
11Supply and Fixing of Pole OEM fabricated hot dipped galvanised M.S. Overhang (48.3 X 3.25 mm) with cap (400 x 88.9 / 114.3 x 3.25 mm) over the existing poles. All as per pre approved by Engineer in-charge. For additional technical parameters of products/ work , refer Annexure \\"A\\" attached with this BSR . Single arm overhang
12S& F of all in one solar LED street light fixture with Integrated high efficient Monocrystalline panel with Lithium (LiFePO4) Ferro Phosphate battery with BIS approved make .luminaire should be secondary optic lenses for better distribution with delivered efficacy of > 100 Lumen perwatt.Bidder shall have in house R&D Laboratory which is recognised by ministry of Science & Technology department, Govt. OfIndia/ NABL. Bidder shall have inhouse pole & luminaire manufacturing facility. Luminaire can be supplied with Hybrid switch along with indicator to understand the source of power( either from solar or AC supply).shall have certificate tested fromMNRE approved Lab. Guarantee for total system is two years .Note: All the above should be integrated and should be 1 system. make: Bajaj/ Philips / Crompton.Compact Solar LED Street Light - 90W(MONO) 18V/ 12.8V42Ah/60W
13Deduct @ 18% GST Please Enable Macros to View BoQ information
14Deduct @ 18% GST Please Enable Macros to View BoQ information

AI Tender Summary

OUR REF NO 57740165
AUTHORITY Government Departments
TENDER VALUE 7.66 Crore
LAST DATE 30-11-2026
Authority
Authority Name Ministry Of Road Transport And Highways
Work Description Tender for special repair (Special Repair) Work ,Providing Mastic Asphalt Work On Worn Out cement concrete Portion, Construction Of Drain At Viratnagar, Providing Street Lights At Km 106/200 (Nadka), Km 108/400 (Peeproli), Km 110/500 (Goha), Km 113/00 (Ramgarh Town), Km 123/00 (Mandapur), Km 124/00 (Naugaon) And Junction Improvement Work Shahpura-Nuh Section Of Nh-248A In The State Of Rajasthan (Dlp Period Three Years)
Basic Detail
Tender No NIT 05/2026-27 EE PWD NH Dn-I, Jaipur
Bidding Type Tender
Location
City Jaipur
State Rajasthan
Key Dates
Publish Date 16 Nov 2026
Submission Date 30 Nov 2026
Open Date 01 Dec 2026
Finance
Tender Value 7.66 Crore
Tender Fee 10000
EMD 15.32 Lakhs
Exemption Not Available
Document List
41dbc441-16e8-4800-a720-97481eeff78d.html
BOQ_975102.xls
SBD_SR_NH_248A_Part_I.pdf
SBD_SR_NH_248A_Part_II.pdf
Tendernotice_1.pdf

Unlock Full AI Tender Summary

Get instant access to the complete AI-generated analysis — scope, eligibility, timeline & more.

Instant Access Secure Free
Your details are secure and used only for document delivery.

Tender Timeline

Nov 16, 2026
11:30 IST

Tender Published

Tender notice published.

Completed
Nov 05, 2026
18:00 IST

Corrigendum-1 Issued

Clarifications on tender conditions and amendments issued.

Completed
Nov 16, 2026
18:00 IST

Corrigendum-2 Issued

Clarifications on tender conditions and amendments issued.

Completed
Nov 05, 2026
18:00 IST

Corrigendum-3 Issued

Clarifications on tender conditions and amendments issued.

Completed
Nov 30, 2026
18:00 IST

Corrigendum-4 Issued

Clarifications on tender conditions and amendments issued.

Upcoming · 11 days
Nov 30, 2026
17:00 IST

Bid Submission Deadline

Online submission via eProcurement portal.

Upcoming · 11 days
Dec 01, 2026

Bid Opening Date

Technical bids will be opened and evaluated.

Upcoming · 12 days

Tender Documents

Download All (ZIP) ↓
html

41dbc441-16e8-4800-a720-97481eeff78d.html

xls

BOQ_975102.xls

pdf

SBD_SR_NH_248A_Part_I.pdf

pdf

SBD_SR_NH_248A_Part_II.pdf

pdf

Tendernotice_1.pdf

Disclaimer

We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender