Tender For Construction Of A.E Office Rohru Tehsil Rohru Distt. Shimla (H.P) (Sh: repair maintenace INSTALLATION Of Electric Wiring In Sub-Divisional Office Rohru).
Tender Value
3.06 Lakhs
Estimated cost
Bid Submission
03 Oct 2026
1 days left
EMD
6140
Bank guarantee accepted
Document Fee
500
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Shimla → Himachal Pradesh
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Construction Of A.E Office Rohru Tehsil Rohru Distt. Shimla (H.P) (Sh: repair maintenace INSTALLATION Of Electric Wiring In Sub-Divisional Office Rohru).
Corrigendum
| Sr No | Corrigendum Date | Corrigendum | Type | New Submission Date |
|---|---|---|---|---|
| 1 | 29-Sep-2026 | Extend Date | Date | 03-Oct-2026 |
BOQ
| Sl. No. | Item Description |
| 1 | Wiring for Piont/fan / exhaust fan/call bell point with 1.5 Sq. mm PVC insulated heat resistant flame retardant (HRFR) and low smoke single core (felxible) copper counductor cable in surface/ recessed steel conduit and earthing the light point with 1.5Sq. mm HRFRLS/PVC insulated single core copper conductor cable as required Group-B. |
| 2 | Wiring for light plug with 1.5 sq mm. ISI marked PVC insulated HRFR & LS copper conductor cable single core. |
| 3 | Wiring for light plug with 2.5 sq mm. ISI marked PVC insulated HRFR & LS copper conductor cable single core. |
| 4 | Wiring for plug with 4 Sq mm. ISI marked PVC insulated HRFR & LS copper conductor cable single core. |
| 5 | Supplying and fixing following rating Piano- type switch/socket on the existing switch box/ cover including consnection etc. as required: |
| 6 | 5 Pin 5/6 Amp. Socket |
| 7 | 6 pin 15/16 Amp. Socket |
| 8 | 5/6 Amp. Switch |
| 9 | 15.16 Amp. Switch |
| 10 | P/F Ceiling rose bakelite, 2 plate, 5 amps, ISI marked |
| 11 | Supplying and fixing bakelite batten holder including connection etc. as required with in all leads and lifts as per direction of Engineer in charge. |
| 12 | Providing and fixing sleek and decorative strip type fixture with domestic electronic ballast and colored engineering plastic end plates, suitable for 36 watt FLT (T8), complete with all accessories (excluding the tube), connections, testing and commissions etc. as required . 1x36 watt FLT (T8) (category-A) |
| 13 | Supplying and erection of 6 amps. To 32 amps. Rating 10 KA breaking capacity, 240 volts, \\"C\\" curves, miniature circuit breaker of folowing poles in the existing MCB DB complete with connections etc. as required. Single pole Cat-B. |
| 14 | Supplying and erection of 40/50/63 amps. Rating, 10 KA breaking capacity, 240 volts, \\"C\\" curves, miniature circuit breaker of folowing poles in the existing MCB DB complete with connections etc. as required. Single pole Cat-B. |
| 15 | Supplying and fixing of following way, single pole and netural sheet steel MCB distribution board , 240 volts, on surface/recess. Complete with tinned copper bus-bar, wire-set, neutrial link, earth bar, din -bar, detachable gland plate, blanking plate, cable, identification lables inter-connections phosphatized and powder painted, including earthing etc. as required. with in all leads lifts as per direction of the Engineer-in-charge. Double door-8 way. |
| 16 | Providing and installation of stationary storage type Electric water heater (Geyser) of various sizes by means of Expansion- bolts with nuts and washers, including embedding of expansion- bolts in the wall, providing and fixing of Nonreturn valve, Dead weight safety valve, 2 No C.P. connection rods 18\\" long ,making good the damages, electrical connections, safty valve connections, testing and commisioning etc. as required:- |
| 17 | 10 Liter capacity water heater (Cat-A |
| 18 | Providing and fixing vitreous China wash down water closet (European type. W.C. Pan) with integral 'P' or 'S' trap including jointing the trap with soil pipe in cement mortar 1:1 (1Cement : 1 Sand) (Seat and cover to be measured and paid for separately) Ordinary type. |
| 19 | Providing and fixing Stainless steel kitchen sink with drain board with in all leads and lifts as per the directions of the Engineer in charge. 470X 420X 178MM |
| 20 | Providing and fixing PTMT Coloured / white high density polyethlylene / poly propylene 10 liters cap. full flush European standard control low level flushing Cistern with fitting and within all leads and lifts and as directed by the Engin |
| 21 | P/F C.P. brass waste for wash basin or sink (i)32mm diawith in all leads and lifts as per the directions of the Engineer in charge. |
| 22 | P/F C.P. soap dish with C.P. brass brackets fixed to wooden cleats With C.P. brass screws with in all leads and lifts as per the directions of the Engineer in charge. |
| 23 | P/F C.P. Brass Bib tap with capstan head(15mm dia) with in all leads and lifts as per the directions of the Engineer in charge. |
| 24 | P/F brass full wheel valve with capstan head(15mm dia)within all leads and lifts and as directed by the Engineer-in-charge, |
| 25 | P/F C.P. Angle cock 15mm dia within all leads and lifts as per the directions of the Engineer-in-charge, |
| 26 | P/F of GI Elbow 15mm with in all leads and lifts as per the directions of the Engineer in charge. |
| 27 | P/F of GI Tee 15mm with in all leads and lifts as per the directions of the Engineer in charge. |
| 28 | P/F of GI Nipple 15mm with in all leads and lifts as per the directions of the Engineer in charge. |
| 29 | Laying galvanized mild steel tube (heavy class) in wall. Ceiling including with in all leads and lifts as per the directions of the Engineer in charge .15mm dia(fiifteen milimetres)nominal size. |
| 30 | Providing and fixing MS BP Sheet 1.66 to 2mm thick in eaves board/acia/soffits/cealing includind fixing and welding to steel roor member and applying a coat of red lead primer complete in all respect. Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Sep 29, 2026
11:30 IST
Tender Published
Tender notice published.
Completed
Oct 03, 2026
18:00 IST
Corrigendum-1 Issued
Clarifications on tender conditions and amendments issued.
Upcoming · 1 dayOct 03, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 1 dayOct 03, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 1 dayTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender