Tender For Increasing Capacity Of Transformers And Construction Of New Transformers At Various Location Under Chalang Section Under Edsd, It Park Under Edd, Raipur.
Tender Value
32.08 Lakhs
Estimated cost
Bid Submission
03 Oct 2026
7 days left
EMD
75000
Bank guarantee accepted
Document Fee
2360
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Dehradun → Uttarakhand
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Increasing Capacity Of Transformers And Construction Of New Transformers At Various Location Under Chalang Section Under Edsd, It Park Under Edd, Raipur.
BOQ
| Sl. No. | Item Description |
| 1 | Total amount of the \\"Rate Schedule\\" sheet SCHEDULE OF QUANTITY AND RATE FOR INCREASING CAPACITY OF TRANSFORMERS AND CONSTRUCTION OF NEW TRANSFORMERS AT VARIOUS LOCATION UNDER CHALANG SECTION UNDER EDSD, IT PARK UNDER EDD, RAIPUR AGAINST E-TENDER SPECIFICATION NO. 69/EDCRDDUN/2026-27 1- Est.No.-1 (IR.SR2503172)- I/C of T/F 16 KVA to 25 KVA at various location under Chalang Section.2- Est.No.-2 (IR.SR2503306)- I/C of T/F 25 KVA to 100 KVA at various location under Chalang Section. 3- Est.No.-3 (IR.SR2503285) - Construction of New 100 KVA S/S under Chalang Section4- Est.No.-4 (IR.SR2503282)- I/C of T/F 100 KVA to 250 KVA at various location under Chalang Section. Name of The Bidder's Firm: 0.0 Sl. No. Description of Work Unit Est.-1 Est.-2 Est.-3 Est.-4 TotalQty Rate Amount Part [A] (Supply Portion) |
| 2 | PRC Connector for AB Cable 25-150 |
| 3 | Holding Clamp for SP-23 without N&B |
| 4 | Holding Clamp for PCC Pole |
| 5 | Holding Clamp for ST Pole SP-55 with N&B |
| 6 | Earth Wire Clamp for SP-23 With N&B |
| 7 | LT Clamp for PCC Pole with N&B |
| 8 | Stay Clamp for ST Pole with N&B |
| 9 | Stay Clamp for ST Pole SP-23 with N&B |
| 10 | Stay Clamp for ST Pole SP-55 with N&B |
| 11 | LT Clamp for ST Pole SP-23 With N&B |
| 12 | LT Clamp with N&B ST Pole SP-33 with N&B |
| 13 | LT Clamp with N&B ST Pole SP-55 |
| 14 | Dead End Clamp with J Hook |
| 15 | Suspension Clamp with J Hook |
| 16 | MS Clamp with N&B for Distribution Box |
| 17 | Shackle Insulator 100x115 mm with N&B |
| 18 | Distribution Box with N&B AB cable 3 Phase-4Way |
| 19 | Insulation Piercing connector 120 sqmm -50 sqmm |
| 20 | 11 KV Fuse Set |
| 21 | Bolt & Nuts off size |
| 22 | Air Circuit Breaker type complete LT Distribution board for 160/250/400 KVA DTR fitted with 01 No. 800 Amp CT inculding Microprocessor Release IPR-1 Fixed type ( 4 Pole as per IS : 13947-2 & IEC:60947-2) with panel and mounting Structure as per specification |
| 23 | LT XLPE Cable 1x16 mm2 Instulated for DB |
| 24 | LT XLPE Cable 1x50 sqmm |
| 25 | Supply of 250 Amp, 35 KA, MF 4 Pole with Adjustable Microprocesser Relay with earth fault digital Moulded case circuit breaker for 100 KVA T/F with all accessories |
| 26 | LT Fuse set with Fuse Wire |
| 27 | Al. Crimping type lugs 70 sq mm |
| 28 | Al. Crimping type lugs 120 sq mm |
| 29 | Al. Crimping type lugs 400 sq mm |
| 30 | GI Strip 40x6 mm Total - Part [A] 0.0 Part [B] (Labour Portion) |
| 31 | Carriage of following type of Material from store centre/JE store to site of work distance approximate 0-20 km. with loading & unloading complete: - a) ST Pole SP-21/23 (Galvanized) Nos 8.0 16.0 10.0 11.0 45.0 0.0 b) ST Pole SP-55 (Galvanized) Nos 2.0 10.0 8.0 20.0 0.0 c) 16/25 KVA DTR Nos 3.0 0.0 3.0 0.0 d) 100 KVA T/F Nos 5.0 5.0 10.0 0.0 e) 250 KVA DTR Nos 4.0 4.0 0.0 f) Stock Material Qtl 16.88 23.21 31.17 28.74 100.0 0.0 |
| 32 | Head load cartage of following material from road to site (0-1 Km) a) ST Pole SP-21/23 (Galvanized) Nos 8.0 16.0 10.0 11.0 45.0 0.0 b) ST Pole SP-55 (Galvanized) Nos 2.0 10.0 8.0 20.0 0.0 c) 25 KVA DTR Nos 3.0 3.0 0.0 d) 100 KVA T/F Nos 5.0 5.0 10.0 0.0 e)250 KVA DTR Nos 4.0 4.0 0.0 f) Stock Material Qtl 16.88 23.21 31.17 28.74 100.0 0.0 |
| 33 | Excavation of earth for pole pit of size 0.9x0.6x1/6 of full length of pole for erection of pole in all type of soil including proper dressing of sides and ramming of bottom including getting out the excavated soil and disposal of surplus excavated soil as directed complete work |
| 34 | Erection of following Single support pole in proper level and alignment alongwith fixing of all accessories, like top channel & clamps as per RESPO construction Manual. a) ST Pole SP-21(Galvanized) Nos 8.0 8.0 16.0 0.0 b) ST Pole SP-23 (Galvanized) Nos 4.0 2.0 11.0 17.0 0.0 |
| 35 | Erection of following Double support pole in proper level and alignment alongwith fixing of all accessories, like top channel, X-bracing & clamps as per RESPO construction Manual. a) ST Pole SP-23 (Galvanized) Nos 2.0 4.0 6.0 0.0 b) ST Pole SP-55 (Galvanized) Nos 1.0 5.0 4.0 10.0 0.0 |
| 36 | Grouting of pole in size 0.45x0.45x1/9 of the support in CC ratio 1:4:8 (1 cement : 4 graded stone 20mm nominal size : 8 coarse sand ) block including cost of Cement,sand and stone ballast back filling of soil and boulders in pit and ramming and proper alignment, leveling as per RESPO construction Manual. |
| 37 | Muffing of poles size 0.45 cm x 0.60 cm radious with cc 1:3:6 (1 cement : 3 coarse sand : 6 graded stone 10mm nominal size) block size 45cm height from ground level including cost of cement, stone and sand etc. |
| 38 | Fabrication of M.S. Channel Angle iron after cutting in required sizes with drilling of holes upto good finish for top channel, bracing and special type bracket etc as per RESPO sehedule and local approved drawing. |
| 39 | Erection and Earthing of support with M.S. Earth rod of 2.5 meter long including excavation of pit and digging of M.S. Rod to proper depth and connecting the earth electrode with the help of G.I. wire as per construction manual. |
| 40 | Dismantling of Following existing Pole & Transformer. a) PCC Double Pole Nos 2.0 5.0 4.0 11.0 0.0 b) 16 KVA DTR Nos 3.0 3.0 0.0 c) 25 KVA DTR Nos 5.0 5.0 0.0 d) 100 KVA DTR Nos 4.0 4.0 0.0 |
| 41 | Installation/ mounting of new Tranformer on Double pole structure a) 25 KVA DTR Nos 3.0 3.0 0.0 b) 100 KVA DTR Nos 5.0 5.0 10.0 0.0 c) 250 KVA DTR Nos 4.0 4.0 0.0 |
| 42 | Mounting & Fixing of Fuse sets on double pole structures including making of connections complete work |
| 43 | Fixing & Installation of LT Fuse set |
| 44 | Layiing of Rabbit Conductor in HT Line |
| 45 | T-off connection complete 11 KV line |
| 46 | Providing and fixing of Danger Board and number plate complete by providing clamps of M.S. Flat 50x6 mm and Nuts & Bolts, danger Boards of M.S. Sheet 2 mm Thick 11''x7'' size (Including cost of all material) |
| 47 | Making of section Pole |
| 48 | Laying of LT XLPE AB cable 3x25+25 sqmm. |
| 49 | Laying & Fixing of LT XLPE cable |
| 50 | Installation of LT Distribution Box. |
| 51 | Earthing of T/F LA & Body |
| 52 | Installation of MCCB with Box at DTRS |
| 53 | Fixing of accessories |
| 54 | Jumpering of D/P TPMO, fuse set and T/F |
| 55 | Fixing of Channel, Angle on Pole |
| 56 | Installation of ACB Lt Distribution Box |
| 57 | Earthing of MCCB |
| 58 | Earthing of ACB |
| 59 | Excavation, Erection of Stay Set complete work. |
| 60 | Laying/Erection of LT AB Cable 3x120+95SQ |
| 61 | Dismantling of accessories from ST Pole |
| 62 | Route cleareance by cutting of tree branches/pruning, lopping and chopping of trees for LT, 11 & 33 KV line |
| 63 | Back Head load cartage of following material from Site to road (0-1 Km) a) 16 KVA DTR Nos 3.0 3.0 0.0 b) 25 KVA DTR Nos 5.0 5.0 0.0 c) 100 KVA T/F Nos 4.0 4.0 0.0 |
| 64 | Back Carriage of following type of Material from Work Site to store centre/JE store distance approximate 0-20 km. With loading & unloading complete: - a) 16/25 KVA DTR Nos 3.0 5.0 8.0 0.0 b) 100 KVA T/F Nos 4.0 4.0 0.0 c) Stock Material Qtl 1.0 3.7 4.7 0.0 Total - Part [B] 0.0 TOTAL [Part-(A) + Part (B)] 0.0 Place Date Superintending Engineer Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Sep 19, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedOct 03, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 7 daysOct 03, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 7 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender