Tender For Special Repair Of 03 X Store Shelters (T-479, T-480, T-488) At Depot Area Of 3 Inf Div Ord Unit Under Ge 865 Ews.
Tender Value
32.06 Lakhs
Estimated cost
Bid Submission
08 Oct 2026
0 days left
EMD
64200
Bank guarantee accepted
Document Fee
500
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
leh → Ladakh
EMD Exemption
Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender For Special Repair Of 03 X Store Shelters (T-479, T-480, T-488) At Depot Area Of 3 Inf Div Ord Unit Under Ge 865 Ews.
BOQ
| Sl. No. | Item Description |
| 1 | Demolition of precast concrete block walling built in cement mortar including all quoins, arches , pillars etc all as specified and as directed |
| 2 | M&L for PCC type D2(1:4:8) using 40mm graded crushed aggregate as mass conc and filling of foundation and mass concrete, complete all as specified and as directed. |
| 3 | M&L for pre cast solid block masonry set in CM 1:6 & casted in cement concrete type C-1 (1:3:6) using 20mm graded curshed stone aggregate complete all as specified and directed. |
| 4 | M&L for 10mm thick rendering on other than fair faces of Stone wall works finished even and smooth without using extra cement in cement mortar 1:6 complete all as specified and as directed |
| 5 | M&L for 15 mm thick rendering on other thsn faces of stone masonry works finished even and smooth without using extra cement in cement mortar 1: 4 complete all as specified and as directed |
| 6 | Supply only integral liquid water proofing compound complete all as specified and directed.Make : Pidilite/Sika |
| 7 | M & L for two coat of cement base paint on newly plastered wall surfaces including preparation of surfaces, complete all as specified and as directed. |
| 8 | M&L for preperation of old plastered wall surface of any description and applying two coat of white wash complete all as specified and as directed. |
| 9 | Demolition of cement concrete in ground floor and pavings n'exc 15cm thick below or above ground level complete all as specified and as directed |
| 10 | M&L Hardcore with boken stone of gauge n exc 63 mm, deposited, spread and levelled and layer n exc 15 cm thick, water and rolled /rammed to a true surface, complete all as specified and directed. |
| 11 | M & L for 100 mm PCC 1:3:6 type C-2 using 20mm graded aggregate as in floor of hard standing finished even and smooth with out using extra cement all as specified. |
| 12 | M&L Forming Contraction (Dummy) joints 65 mm deep x 10mm wide, filled with sealing compound Grade 'A' in floor surface of hard standing . |
| 13 | M & L for 75 mm PCC 1:3:6 type C-2 using 20mm graded aggregate as plinth protection finished even and smooth with out using extra cement, complete all as specified and as directed. |
| 14 | M&L Forming Contraction (Dummy) joints 65 mm deep x 10mm wide, filled with sealing compound Grade 'A' in plinth protection, complete all as specified and as directed. |
| 15 | Dismantling plain or corrugated steel /fibre sheeting any guage thickness including nanital or similar pattern complete all as specified and as directed. |
| 16 | S&F Pre painted galvalumealuminium zinc coating GI based corrugated steel sheet 0.50mm thick of an colour having tensile strength of 550 Mps as in roof covering /cladding to wall fixed with self tapping screws as specified. |
| 17 | S&F Pre painted galvalumealuminium zinc coating GI based Plain steel sheet 0.50mm thick as in ridges , valley gutters drip etc of an colour having tensile strength of 550 Mps as in roof covering /cladding to wall fixed with self tapping screws as specified. |
| 18 | Dismantling wrought iron or mild steel work of any description not otherwise provided for angle iron or flat iron as in post and gourd bars or grating complete all as spd and as directed by Engr-in-Charge. |
| 19 | S & F framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc, complete drilled for fixing of steel sheeting or other covering. Doors, etc, to be prepared for hanging or sliding with and incl either hooks and hinges or steel hanging door fittings (exclusive of steel,) sheeting or other covering, running rails and guides) and hanging, also fastening and fixing complet, Fe 410-W (Gde-E-250) quality A, complete all as specified and directed. |
| 20 | S&F MS Rolled sections in main and cross beams,hip and jack rafters ;purlins where connected to common rafters running rails and guids for sliding doors ;fixed with angle cleats or other connecting plates and similar work confirming to Fe-290, Gde-E-165 complete all as specified and as directed. |
| 21 | M&L preparation of newly untreated steel surfaces, of any description, over 10 cm width or girth, and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed by Engr-in-charge. |
| 22 | M&L for preperation and removal of old Steel / CGI Sheet surface any description over 10cm in width or girth and applaying two coat of synthetic enamal paint all as specified and as directed complete all as specified and as directed. |
| 23 | M&L for Cement concrete type D-2,1:4:8 (40mm graded aggreate) 75 mm thick as in sub -floors ,sub- bases ,floors and pavings,etc., complete all as specifed and directed. |
| 24 | Demolition of stone slabs and tiles of any description or thickness in floors aprons etc.laid bedded and pointed in any mortar, complete all as specifed and directed. |
| 25 | Chequred cement concrete tiles (glazed) 30cm X 30cm X 20mm thick, set ,pointed & jointed in neat cement slurry in floors polished with grey cement & pigments .Layed over 20mm thick cement screed base (1:6), complete all as specifed and directed. |
| 26 | Taking down carefully copper/aluminium point wiring (light, fan, socket and power point) complete fittings such as switches, ceiling rose, regulators, socket etc and removing material from site and making good disturbed surfaces of walls, floors/ceiling to match the existing surface all as spfd and directed by Engr-in-Charge. |
| 27 | Point wiring complete with 1.5Sq.mm nominal area of copper conductor multi stranded PVC insulated and unsheathed 1100 volts cable drawn through & including PVC Casing & caping with standard accessories such as elbows, tees, junctions etc. and PVC moulded terminal box with top cover of including PVC insulated unsheathed solid 1.5Sqmm copper conductor cable as continuous earth lead all as specified and directed for the followings:- |
| 28 | (a) One light/exhaust fan point controlled by one way switch |
| 29 | (b) One switch socket outlet 6 Amps, 230 volts point on Same board |
| 30 | (c) One switch socket outlet 6 Amps, 230 volts point on independent board |
| 31 | All as item No 27 above, but using cables 4 Sq mm size |
| 32 | Lamp holder, PVC/Polycarbonate type with cord grip cap suitable for batten fittings, complete all as specified and directed. |
| 33 | Switch piano flush button single pole 6 Amps 230 volts one way, complete all as specified and directed. |
| 34 | Socket outlet 5 pin 6 Amps flush type.230 volts, complete all as specified and directed. |
| 35 | Switch Socket outlet two in one 5 pin 6 Amps flush type.230 volts, complete all as specified and directed. |
| 36 | Switch Socket combination outlet multi purpose 5 pin 6 Amps and 16Amps 230 volts, complete all as specified and directed. |
| 37 | Ceiling rose 3 terminal bakelite 65mm x50mm surface type, PVC/ Polycarbonate, isolated body, complete all as specified and directed. |
| 38 | Replacement of MCB DB, SPN, 6 way sheet metal enclosures double door 230 V AC, 50 Hz AC with IP 54 and IK 09 rating having fully insulated copper busbar of rating 200 Amps, insulated neutral bar, earth bar and cable ties for cable management including polyuthrene gasket complete complete in all respect flushed in wall including cutting chases on wall for taking out old unsv DB and fixing of new DB and making good disturbed surface of wall with cement mortar 1:4 and finishes to match exisiting surface, complete all as specified and directed. |
| 39 | MCB, SPN, AC, 240 volts \\"C\\" series capacity of 40-63 Amps, 10kA and making connections, complete all as specified & directed. |
| 40 | MCB, SP, AC, 240 volts \\"C\\" series capacity of 6-32 Amps, 10kA and making connections, complete all as specified & directed |
| 41 | Replacement of LED lights/bulbs 12 watt complete with all accessories holder screws plugs including connection, testind and commissioning, complete all as specified & directed |
| 42 | Replacement of LED light fitting 1X20 W, 220 V, AC decorative box type with driver, holder including LED tube light connecting up with three core flexible copper conductor cable of suitable size from ceiling rose and making good disturbed surface of wall with cement mortar 1:4 and finishes to match exisiting surface, complete all as specified and directed. |
| 43 | Supply, fixing, connecting and testing in replacement LED security light fitting 35 watt, 230 volt, AC outdoor type with high pressure die cast aluminium housing and heat resistant complete with driver, lamp and bracket with impact and corrossion resistant incl thermal management in multiple optics complete with IP65/66 protection including connecting up with driver three core flexible copper conductor cases of suitable size and making good disturbed surface with cement mortar 1:4 and finishes to match exisiting surface, complete all as specified and directed. |
| 44 | M&L for Earthing complete with galvanized steel earth plate electrode 600mm x600mmx 6mm thick buried directly in ground. (earth pit not less than 2.25m deep below ground level) with top edge of plate not less than 1.5m below normal ground level, connected to galvanized earth lead wire 4mm dia by GI watering pipe with funnel and wire mesh and 15mm dia protection pipe earth work etc complete all as shown in electrical plate No 3 of MES SSR Part -I of 2009 complete all as specified and directed. |
| 45 | Supply and laying in replacement of XLPE insulated, armoured, haeavy duty electric cables (heavy duty) with stranded aluminium conductor rating 1100 volts grade of size 10 Sqmm 2 core laid in trences or passing through pipes.ducts or fixed to walls/poles including taking down ol unserviceable cable and cable covers complete all as specified and/or directed. |
| 46 | Excavation in trenches not exc 1.5 m wide and not exc 1.5 m in depth and getting it out for laying of cable / pole in hard/dense soil complete all as specified and directed. |
| 47 | Returning, filling in, including spreading, leveling watering, and well ramming in layers not exc 25 cm in hard/dense soil complete all as specified and directed. |
| 48 | Removing excavated material n.exc 50m and depositing where directed at a level exc. 1.5 cm above the starting point complete all as specified and directed. |
| 49 | M&L for crushed stone sand cushioning to UG cable, provide with the layer 8 cm before and 15 cm after laying and stretching jointing and testing the cable complete all as specified and directed. |
| 50 | Supply and laid Un-reinforced precast concrete cable cover class LV 1 flat size 250 mm x 150 mm x 40 mm complete all as specified and directed. |
| 51 | Supply and fix GI Pipe Light grade with all connected accessories of sizes 40 mm dia complete all as specified and directed. |
| 52 | Deduct Schedule of Credit of Rs (-) 183908.00 (Minus) as listed in Schedule 'A' (Contd). Contract Sum shall be arrived after deducting the credit amount.Note :- Tenderers will not quote against this item being a firm amount. Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Sep 17, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedOct 08, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
TodayOct 16, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 8 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender