Tender For Repairing, Fitting And Fixing Of 02 Nos. Damaged 450 Mm Dia Butterfly Valve With Acuator For Ht Pump Delivery Line At Senpally Bps
Tender Value
2.68 Lakhs
Estimated cost
Bid Submission
24 Sep 2026
2 days left
EMD
6000
Bank guarantee accepted
Document Fee
Ref. Documents
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Kolkata → West Bengal
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Repairing, Fitting And Fixing Of 02 Nos. Damaged 450 Mm Dia Butterfly Valve With Acuator For Ht Pump Delivery Line At Senpally Bps
BOQ
| Sl. No. | Item Description |
| 1 | CHAPTER - II LAYING & JOINTING PIPES, SPECIALS ETC.2.1 C.I. / D.I. Pipe & Specials 2.1 C.I. / D.I. Pipe & Specials 2.3.8 Supplying and fabricating 20 mm to 32mm thick (finished thickness) M.S.Blank Flange properly ribbed, one face machined including drilling holes as per standard table, fitting and fixing the same with M.S. flanged pipe with supply of nuts, bolts, washers, gasket etc. of best quality all complete as per specification and direction of the Engineer-in-charge.450mm dia. |
| 2 | CHAPTER - VII MISCELLANEOUS ITEMS Dewatering by pumps including all leads, lifts and making all arrangements of disposal. where continuous flow of water from a source other than natural or ground water is encountered in case of emergency maintenance works related to leakage. breakage and making wet connections. [Note ;- In case of any other situation demanding such emergency dewatering. use of this item is to be approved by the Superintending Engineer/Tender Accepting Authority. This item shall be executed on the specific direction duly supported by proper clarification of the E.I.C. who will be satisfied in absolute discretion that such work has not been necessitated due to any natural source of water or any fault of the Contractor] |
| 3 | CHAPTER - II LAYING & JOINTING PIPES, SPECIALS ETC.2.1 C.I. / D.I. Pipe & Specials 2.1 C.I. / D.I. Pipe & Specials 2.4Valves 2.4.1 Lowering, fitting and fixing of all types of valves in proper position and alignment using chain pully block or crane(for diameter above 250 mm) by providing temporary support,as required,gaskets,nuts& bolts etc.all cornplete as per specification and direction of the Engineer-in-Charge.[The rate Includes cost of flange joints]450mm dia. |
| 4 | BUILDING WORKS (F) STRUCTURAL STEEL WORKS, GRILLS, GATES ETC. B. REPAIRING 2. Welding in M.S. structural work with gas or electric: (b) Continuous weld. |
| 5 | CHAPTER - II LAYING & JOINTING PIPES, SPECIALS ETC.2.1 C.I. / D.I. Pipe & Specials 2.1 C.I. / D.I. Pipe & Specials 2.1.6 Flange joint to C.l./D.l/MS. pipes and specials including supply of rubber gasket. nuts. bolts. washers etc. of best quality to make the joint watertight at required hydraulic pressure all complete as per specification & direction of the Engineer-in-Charge. Diameter in mm 450mm dia. |
| 6 | CHAPTER - II LAYING & JOINTING PIPES, SPECIALS ETC.2.1 C.I. / D.I. Pipe & Specials 2.1 C.I. / D.I. Pipe & Specials 2.3 M.S. Pipes 2.3.1 Gas cutting of M.S. pipes and/or M.S. plates of different thickness all complete as per specification and direction of the Engineer-in- Charge. Thikness in mm 5mm to 8mm thick plate |
| 7 | S&F WORM SHAFT AFTER REPLACING THE OLD DEFECTIVE ONE. ALL MATERIAL SHOULD BE AS PER THE EXISTING ONE I.E. AS PER SAMPLE |
| 8 | MANUFACTURING & SUPPLY AS PER SAMPLE OF WORM GEAR OF PHOSPHOR BRONZE FOR ACTUATOR. |
| 9 | MANUFACTURING & SUPPLY AS PER SAMPLE OF ACTUATOR COMPONENTS EN-24 STEEL MAIN DRIVING SHAFT (INCLUDING FITTING, FIXING). |
| 10 | SUPPLY & FIXING OIL SEAL FOR ACTUATOR AFTER REMOVING THE OLDER ONE & NECESSARY CLEANING AS PER DIRECTION OF EIC. AS PER SAMPLE |
| 11 | SUPPLY & FIXING THE SET OF GASKET FOR ACTUATOR AFTER REMOVING THE OLDER ONE & NECESSARY CLEANING AS PER DIRECTION OF EIC. |
| 12 | SUPPLY & FIXING P.P. 100 (MONITOR) \\"MARSH\\" MAKE FOR ACTUATOR REPLACING THE OLD ONE. |
| 13 | SUPPLY & FIXING 1(ONE) POT METER WITH ONE PAIR POT METER DRIVE GEAR WITH NECESSARY MACHINING & ADJUSTMENT W.R.T PERCENTAGE METER AT CONTROL PANEL |
| 14 | OIL SEAL KIT FOR ACTUATOR. AS PER SAMPLE. |
| 15 | MATERIALS AND LABOUR 1. Building (B) Labour Rates Per Diem : 17)Fitter Mechanic. Note: (I)The above rates of labour are exclusive of 10% contractors profit and 1% Labour welfare cess which would be admissible to the Contractors, but contractual percentage will not be applicable. (II) The workersemployed on high rise building or any structure over 30 ft in height and also workers engaged in Tunnel shall be paid 20% extra wages. |
| 16 | MATERIALS AND LABOUR 1. Building (B) Labour Rates Per Diem : 18)Fitter Mechanic (Helper). Note: (I)The above rates of labour are exclusive of 10% contractors profit and 1% Labour welfare cess which would be admissible to the Contractors, but contractual percentage will not be applicable. (II) The workersemployed on high rise building or any structure over 30 ft in height and also workers engaged in Tunnel shall be paid 20% extra wages. |
| 17 | MATERIALS AND LABOUR 1. Building (B) Labour Rates Per Diem : 3)Mazdoor (Male). Note: (I)The above rates of labour are exclusive of 10% contractors profit and 1% Labour welfare cess which would be admissible to the Contractors, but contractual percentage will not be applicable. (II) The workersemployed on high rise building or any structure over 30 ft in height and also workers engaged in Tunnel shall be paid 20% extra wages. |
| 18 | SUPPY & FIXING OF SPARE GEAR FOR AT80/1/S1 FITTED WITH BUTTERFLY VALVE. |
| 19 | SUPPY & FIXING OF SPARE WORM FOR AT80/1/S1 FITTED WITH BUTTERFLY VALVE. |
| 20 | CHAPTER - VIII SUPPLYING OF MATERIALS HIRE CHARGES OF MACHINERIES 8.28Hire charges of lighting generator of capacity 5KVA including fuel, mobil, operator, carriage etc. including all complete for water supply works. For minimum engagement of 8 hrs. In a day |
| 21 | CHAPTER - VIII SUPPLYING OF MATERIALS HIRE CHARGES OF MACHINERIES 8.26 Hire charges of moveable crane with fuel & manpower having load handling capacity upto 14MT with the 45 deg. moveable arrangement & the boom length of 40 feets for loading & unloading of various materials / accessories of water supply works. For minimum engagement of 8 hrs. In a day |
| 22 | HIRE OF LMV / TRUCK BY THE CONTRACTOR FOR CARRYING MATERIALS FOR MAINTENANCE WORK. |
| 23 | Sub Total |
| 24 | GST 18% |
| 25 | CESS 1% Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Sep 15, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedSep 24, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 2 daysSep 26, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 4 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender