Tender For Special Repair To Road Berms From Trg Bn Office To Long Road Of 58 Gtc Under Ge Shillong
Tender Value
77 Lakhs
Estimated cost
Bid Submission
07 Oct 2026
2 days left
EMD
1.40 Lakhs
Bank guarantee accepted
Document Fee
1000
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
East Khasi Hills → Meghalaya
EMD Exemption
Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Special Repair To Road Berms From Trg Bn Office To Long Road Of 58 Gtc Under Ge Shillong
BOQ
| Sl. No. | Item Description |
| 1 | Repair to potholes any depth, not exceeding 1 sqm each including sweeping free from dust and mud, or water, scoring sunken surfaces in roads, paths, etc., cutting around edges to at least 25 mm in depth, making good by applying tack coat at the rate of 5 kg per 10 Sqm, putting in bituminous macadam well rammed (including supply of bituminious carpet, binder and chhipping) and sealed with bitumen 9.8 kg per 10 sqm blinded with 0.09 cum stone chippings, 6.3 mm size depth of pot holes exc 30mm and rolled and compacted with power roller 8 to 12 tonnes to required camber and gradient complete all as specified and as directed. |
| 2 | Scarifying or picking gravelled, macadam or bituminous macadam surfaces in area exceeding 400 sqm, depth of pot hole exceeding 50 mm but not exceeding 100 mm including rolling over the broken surfaces using 8 to 10 tonnes power roller to required camber and gradient complete all as specified and as directed. |
| 3 | Material and labour for providing premixed bituminous macadam laid/rolled and compacted to required gradient and camber using 8 to 10 tone capacity power roller (consolidated thickness 75mm or less) using paving bitumen (VG 30 Grade) @ 4% by weight of total mix complete all as specified and directed. Note:- (i) The exact bitumen content required shall be determined Mix Design procedure and approved by GE. The adjustment in rate on MINUS side variation in quantity of bitumen if any shall be priced at the rate of ₹95 per kg. No claim whatsoever shall be made for adjustment in plus side. (ii) Bituminous macadam shall be laid using self propelled hydrostatic paver finisher and preparation of mix shall be using hot mix plant and transporting the mix in tipper. |
| 4 | Preparing existing black top surfaces by brushing with wire brushes for removing caked mud etc., sweeping with brooms and finally fanning the cleaned surface with gunny bags to remove all loose dirt etc. complete all as specified and as directed. |
| 5 | M & L for applying evenly a tack coat with bituminous primer (paving grade bitumen VG-10 grade) @ 5 kg per 10 sq metres complete all as specified & as directed. |
| 6 | M & L for bituminous premixed semi-dense asphaltic concrete, 40mm consolidated thickness using 5.5% paving bitumen (VG 30 Grade) binder content any penetration by weight of total mix, mixed in central computerized hot mix plant and laid using mechanical self propelled paver and rolled and compacted with 8 to 12 tonne power roller to uniform surfaces with required camber and gradient complete all as specified and as directed.Note:- Semi dense asphaltic bituminous concrete shall be designed as per design mix. Contractor shall quote his unit rate considering the bitumen contents as 5.5 %. Any variation in binder content on minus side shall be adjusted at the rate of ₹95.00 per KG of binder. No adjustment in price shall be made if the variation is on plus side. \\" |
| 7 | M & L for preparing bituminous surfaces of road and marking 2.5mm thick centre lines stop line dashe arrow etc and the like exceeding 10cm wide on road pavement with hot applied thermo plastic road marking paint of approved colour conforming to BS 3262-1989 with special applicator machine including glass beads @ 300gm/ sqm for reflecting all as per manufacturers instruction complete all as specified and directed. |
| 8 | S&F in repair speed breaker of size 750mm X250 mm X75mm made out of ABS material with two highly reflective reflectors moulded in PMMA materials welded with ABS plate through ultrasonic welding process fixed on to the speed breaker so the dust and water can not touch reflectors inside and fixed complete all as specified and directed. |
| 9 | S&F in repair traffic convex mirror of of 60cm dia having 130 degree viewing angle made of polycarbonate material , brim and back holding plate is made of metal/FRB along with pole mounted brackets and pole 60mm dia made with galvanised steel pipe of suitable length fixed to the ground by means of PCC 1:2:4 type B2 (using 40mm dia graded stone aggregate) in foundation/filling (size 50cmx50cmx60cm) all as specified and as and as directed. |
| 10 | S & F in repair metal tubular delineators (road way indicators) made out of ABS round body fitted with 2 Nos of 65 mm dia highly reflective reflectors made out of PMMA and mounted on 45/50 mm mild steel pipe of 600 mm height duly power coated and thermo plastic elastomers 3 bands of green, red and yellow reflector radium tape of 25 mm wide strip with anti theft steel net for reflector protection including embedded 200 mm below ground level including excavation and PCC M15(Nominal Mix) (150x150x300mm) with using 20 mm graded stone aggregate in foundation and making good surface complete all as specified and as directed. |
| 11 | S & F in repair cat eye solar reflective type of metal body alloy of size 100mm x 100mm x 20mm with PAMA striplens reflector of odel No. DA 972.0 fixed with and incl MS stud of suitable size as per manufactures instructions complete all as specified and as directed. |
| 12 | S & F in repair solar cat eye aluminum alloy shall (100% water proofing design according to 65) of size 125mm x 125mm x 25mm (shank 65mm) of high efficiency Mono rystafie solar panel 2.4V/ 0.3 watt one NI-ed rechargeable battery (1.2V/ 1600MA) consisting of super bright LED with 10,000 to 18,000 mcd, 3 pieces each side and total 6 pieces are used for high brightness and backup for 12 hours completed as per manufactures instructions etc complete all as specified and as directed. |
| 13 | Demolition of cement concrete(unreinforced) in ground floors and paving not exceeding 15 cm thickness (below or above ground level) and complete all as specified and as directed. |
| 14 | Providing and laying 80mm thick factory made chamfered edge cement concrete paver block of M-30 grade with approved colour, design & pattern as in footpath, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of coarse sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with fine sand and cutting of paver block as per required size and pattern, finishing and sweeping extra sand; complete all as specified and as directed. |
| 15 | M & L for cement concrete M15 (Nominal Mix) using 12.50 mm nominal size graded crushed stone aggregate in lintels upto 1.5 m clear span, cills, steps; seismic and other similar bands, plinth courses, string courses, lacing courses, parapets and railings upto 60 cm in height, copings, kneelers, apex stones, bed plates, kerbs, water troughs, slab staging for water tanks, filling of pressed steel door frame, fixing of hold fasts and the like including weathering, slightly rounded or chamfered angles and throating including necessary formworks complete all as specified and directed. |
| 16 | M & L for cement concrete in surface channels and drains in M10(Nominal Mix) using 40 mm nominal size graded crushed stone aggregate complete all as specified and as directed. |
| 17 | M & L for extra for forming fair finished drain or channel 30 cm inner girth in cement concrete, using extra cement, including forms, moulds, mitred/ stopped ends etc. complete all as specified and as directed. |
| 18 | Demolition of reinforced cement concrete of any description (reinforcement cut as required to facilitate demolition) and in any position, above or below ground floors, not otherwise specifically provided for complete all as specified and as directed. |
| 19 | M & L for hardcore (broken stone or boulders) of gauge not exceeding 63 mm, deposited, spread and levelled in layers not exceeding 15 cm thick, watered and rammed to a true surface complete all as specified and as directed. |
| 20 | M & L for RCC M20 (Nominal Mix) using 20 mm nominal size graded crushed stone aggregate as in slabs supported on walls, beams and columns in floors, roofs, landings, balconies, canopies, deck slabs and in shelves and the like complete all as specified and as directed. |
| 21 | M & L for mild steel TMT bars 10 mm dia and over, cut to length, bent to shape required, including hooking ends and binding with and including mild steel wire (annealed) not less than 0.9 mm dia or securing with clips and including welding has to be done with minimum 20 cm over lap for new and old of any height complete all as specified and as directed. |
| 22 | M & L for formwork to soffits of suspended slabs such as roof slabs, floor slabs, landings and similar work; not exceeding 200 mm thick (Horizontal or sloping) for rough finished flat surfaces of concrete complete all as specified and as directed. |
| 23 | M & L for cement concrete M7.5 (Nominal Mix) using 40 mm nominal size graded crushed stone aggregate 75 mm thick in sub base for laying tiles, pavings, floorings etc. complete all as specified and as directed. Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Sep 09, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedOct 07, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 2 daysOct 09, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 4 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender