Tender For Construction Of Bituminious Road And Both Side Drain Supply/Fixing 1) Bardwan Road To Siddi Vatik Road House, 2) Supply/Fixing Global Pharmacy To Bordar Of Ward 4 & 5, 3) Supply/Fixing Ward 4 &5 Bordar To Ritesh House, 4) Supply/Fixing Bar
Tender Overview
Project Description
Tender for Construction Of Bituminious Road And Both Side Drain Supply/Fixing 1) Bardwan Road To Siddi Vatik Road House, 2) Supply/Fixing Global Pharmacy To Bordar Of Ward 4 & 5, 3) Supply/Fixing Ward 4 &5 Bordar To Ritesh House, 4) Supply/Fixing Bardwan Road To J D Agarwal Land At W.No.05
BOQ
| Sl. No. | Item Description |
| 1 | Providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading inuniformthickness, hand packing, rollingwith3wheeledsteel/ vibratory roller 8-10 tonnes in stages to proper grade and camber, applying andbrooming requisite type of screening/bindingMaterials tofillup the interstices of coarse aggregate, watering and compacting to the requireddensity (Reference to MoRT&H's specification 404). |
| 2 | By Manual Means Grading-2 (Table 400-9) |
| 3 | Using Screening Crushable type such as Moorum or Gravel, Using Screening (Table 400-10), Type-B (11.2 mm aggregate) |
| 4 | Providing and laying bituminous macadam using crushed aggregates of specified grading premixed with bituminous binder, transported tosite, laid over a previously prepared surface with paver finisher to the required grade, level and alignment and rolled as per clauses 501.6 and501.7 to achieve the desired compaction (Reference to MORT&H's specification clause 504). |
| 5 | With Continuous Type HMP (60-90 TPH)for Grading 2 (19 mm nominal size) Layer Thickness 50-75mm |
| 6 | Providing and applying tack coat with paving bitumen of VG-10 grade conforming to IS:73 using emulsion pressure distributor on theprepared bituminous/granular /cement concrete pavement surface cleaned with mechanical broom and high pressure air jet (Reference toMORT&H's specification clause 503). |
| 7 | ii) On Granular surface treated with primer @ 0.25kg-0.30 /sqm. |
| 8 | Providing and laying mastic asphalt by mechanical means done in a centralised batching plant with appropriate built- in pollution controlunits with specified aggregates and lime stone powder (with Calcium Carbonate content not less than 80%) and approved grade of industrialgrade bitumen as per approved design mix, transporting the hot mastic ashphalt to the worksite by thermocontainer with the arrangement ofmaintaing specified temperature during transport,laying with a paver finisher for spreading and floating the plastic mix uniformly on thesurface to the specified width and thickness at correct grade and camber through its heated, distortion free steel float and turning sworddistributors, applying uniform size of bitumen coated stonechips at a specified rate, on the laid surface through a power driven chip spreaderas per the procedure laid down in Annexure - II of IRC : 107 (2013) all complete as per clause 516 along with IRC : 107 for materials anddesign mix etc. |
| 9 | 25 mm Thick Mastic Asphalt |
| 10 | Plain/Reinforced cement concrete in open foundation complete all including vibrating and compacting, finishing, curing, sampling, testingetc. as per drawing and Technical Specifications (Reference to MORT&H'sspecifications1500,1700&2200). |
| 11 | ) PCC Grade M-15, using concrete Mixer (This Item used for only for foundation concrete i.e. Wall, bed in drain, guard wall, culvert etc) |
| 12 | Plaster ( to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering conrners as directed and raking out joints including throating, nosing and drip course, scaffolding/staging where necessary (ground floor). [Excluding cost of chipping over concrete surface]. |
| 13 | (ii) With 1:4 cement mortar . |
| 14 | (b) 15 mm. thick plaster. |
| 15 | Neat cement punning about 1.5mm thick in wall, dado, windowsill, floor etc.NOTE:Cement 0.152 cu.m per100 sq.m. |
| 16 | Direction and Place Identification Signs with size more than 0.9 sqm size BoardProviding and erecting direction and place identification retroreflectorised sign as per IRC :67 made of high intensity grade sheeting videclause 801.3, fixed over aluminium sheeting, 2 mm thick with area exceeding 0.9 sqm supported on a mild steel angle iron post 75 mm x 75mm x 6 mm, 2 Nos. firmly fixed to the ground by means of properly designed foundation with M 15 grade cement concrete45 cm x 45 cm x60 cm, 60 cm below ground level as per approved drawing (Reference to MORT&H's specification 801). |
| 17 | 18% GT Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Tender Published
Tender notice published.
CompletedBid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 12 daysBid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 16 daysTender Documents
Download All (ZIP) ↓We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender