Tender For Provision Of Two High Mast Light And Connected E/M And B/R Works At 153 Sqn Af Port Mout Under Ge Minniebay, Sri Vijaya Puram (8886/E8)
Tender Value
29.50 Lakhs
Estimated cost
Bid Submission
29 Sep 2026
13 days left
EMD
59000
Bank guarantee accepted
Document Fee
500
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
South Andamans → Andaman And Nicobar Islands
EMD Exemption
Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Provision Of Two High Mast Light And Connected E/M And B/R Works At 153 Sqn Af Port Mout Under Ge Minniebay, Sri Vijaya Puram (8886/E8)
BOQ
| Sl. No. | Item Description |
| 1 | Supply, Install, testing & commissioning of 16 Mtr high mast lighting system with all accessories. Mast shaft shall be in three sections, hot dip galvanised and suitable for wind velocity as per IS 875 part 3. It shall also include accessories for high mast including head frame, stainless steel wire 6 mm dia rope, integral motor, connector, manual handle, lightining finial, construction, double drum winch, Galvanised Lantern carriage arrangement 'suitable for 06 luminaries symmetrically & its control gear boxes and lightning finial, RCC foundation with M-30grade concrete considering SBC of soil as per site. The mast shall have an integral Power Tool installed inside the base compartment for its motorised operation also manual operation complete all as directed including comprising of the following.Note.1:- Design, casting of suitable RCC foundation with M-30 grade concrete considering SBC of soil as per actual site condition at depth of 2.0 mtr and foundation design is to be submitted for approval to the engineer in charge for approval please . (a) M&L for High mast light foundation / bedding with PCC 1:4:8 type D-2 using 40 mm graded stone aggregate as per manufacturing instructions complete. -02 Nos(b) S & F for foundation bolts manufactured from special steel along with nuts, washer, anchor plate and templates...02 Nos(c) S & F for LED type single dome aviation obstruction light -02 no and including all connected wiring complete. Make : Bajaj , Crompton or equivalent.(d) M&L for foundations, including rafts, footings, foundation beams; plinth beams; bases for columns, etc.; basement slabs, under-reamed piles and mass concrete M30 grade using crushed stone aggregate complete, foundation shall be as per manufacture recommendations. 02 Job (e) M&L for Formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter complete.(f) S & F outdoor stand mounted feeder pillar box 3.15mm thick CRCA sheet, CPRI approved with 32A TPN MCB incomer, single dial time switch, 25A TP contactor for the automatic switching of luminaries, power tool control with 2 no 9A contactors and raise lower push button, Incoming 35 sq. mm and out going 16 & 2.5 sq. mm terminals.. 02 Nos(g) S & F LED flood light 300 W -24 Nos incluing all accessories and silicon filled ported driver, IP66 protection, driver must have BIS registered.(h) Trailing cable PVC armoured type from luminaries to the base of pole and from base to feeder pillar box. (j) Provision of lighting finial at the top of the pole. |
| 2 | Supply, Install, testing & commissioning of 12 Mtr high mast lighting system with all accessories. Mast shaft shall be in three sections, hot dip galvanised and suitable for wind velocity as per IS 875 part 3. It shall also include accessories for high mast including head frame, stainless steel wire 6 mm dia rope, integral motor, connector, manual handle, lightining finial, construction, double drum winch, Galvanised Lantern carriage arrangement 'suitable for 06 luminaries symmetrically & its control gear boxes and lightning finial,RCC foundation with M-30grade concrete considering SBC of soil as per site The mast shall have an integral Power Tool installed inside the base compartment for its motorised operation also manual operation complete all as directed including comprising of the following.Note.1:- Design, casting of suitable RCC foundation with M-30 grade concrete considering SBC of soil as per actual site condition at depth of 2.0 mtr and foundation design is to be submitted for approval to the engineer in charge for approval please . (a) M&L for High mast light foundation / bedding with PCC 1:4:8 type D-2 using 40 mm graded stone aggregate as per manufacturing instructions complete. -02 Nos(b) S & F for foundation bolts manufactured from special steel along with nuts, washer, anchor plate and templates...02 Nos(c) S & F for LED type single dome aviation obstruction light -02 no and including all connected wiring complete. Make : Bajaj , Crompton or equivalent.(d) M&L for foundations, including rafts, footings, foundation beams; plinth beams; bases for columns, etc.; basement slabs, under-reamed piles and mass concrete M30 grade using crushed stone aggregate complete, foundation shall be as per manufacture recommendations. 02 Job (e) M&L for Formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter complete.(f) S & F outdoor stand mounted feeder pillar box 3.15mm thick CRCA sheet, CPRI approved with 32A TPN MCB incomer, single dial time switch, 25A TP contactor for the automatic switching of luminaries, power tool control with 2 no 9A contactors and raise lower push button, Incoming 35 sq. mm and out going 16 & 2.5 sq. mm terminals.. 02 Nos(g) S & F LED flood light 300 W -24 Nos incluing all accessories and silicon filled ported driver, IP66 protection, driver must have BIS registered.(h) Trailing cable PVC armoured type from luminaries to the base of pole and from base to feeder pillar box. (j) Provision of lighting finial at the top of the pole. |
| 3 | M & L for Earthing complete with GI earth electride of size 60cmx60cmx6mm buried directly in ground vertically at a depth not less than 2.25 metre below normal ground level wuith top edge of earth plate at a depth not less than 1.5 metre below normal ground surrounded from all sides by 15cm thick and packed layer of charcoal dust and conmmon salt filling in alternate layers cleaned connected to and including GI earth strip 32 x 6mm size upto 7.5 mtr by means of bolts, nuts, check nuts and washers made of galvanised iron and protected light grade 50mm dia 5 mtr long GI pipe connected to main control board and GI pipe light grade 20mm bore for watering and including funnel wire mesh, RCC pit cover 50mm thick with 10mm dia reinforcement 100mm c/c and PCC chamber pit with pcc 1:2:4 Type C2 (including excavation and earth work disposal of surplus soil to a distance not exceeding 50 metre) and testing after completion all as specified and shown on plate No 3 of SSR Part -I 2009 complete all as specified as directed. |
| 4 | Supply and laying LT UG cable XLPE insulated armoured and PVC sheathed 1100 volts grade with aluminium conductor of 16 Sqmm 4 core with cable lugs all as specified and directed. Note : Earth works excavation, returning filling, removal of surplus soil shall be measured and paid under relevant of this items. |
| 5 | Supply and laying LT UG cable XLPE insulated armoured and PVC sheathed 1100 volts grade with aluminium conductor of 25 Sqmm 3.5 core with cable lugs all as specified and directed. Note : Earth works excavation, returning filling, removal of surplus soil shall be measured and paid under relevant of this items. |
| 6 | Excavation in trenches, not exceeding 1.50m wide and not exeeding 1.50m in depth for foundations, trenches of cable or pipe lines etc or and getting out in soft / loose soil complete all as specified and as directed. |
| 7 | Excavation in trenches, not exceeding 1.50m wide and not exeeding 1.50m in depth for foundations, trenches of cable or pipe lines etc or and getting out in hard / dense soil or roads complete all as specified and as directed. |
| 8 | Returning filling in, including spreading, leveling, watering and well ramming in layers not exceeding 25 cm in soft/loose soil complete all specified and as directed. |
| 9 | Removing excavated materials (soil) to a distance not exceeding 50 meters and depositing where directed at a level not exceeding 1.5 meters above the starting point complete all specified and as directed. |
| 10 | Supply, laying of Telerex DWC (double Wall corrugated) HDPE pipe ISI marked of inner dia 53 mm polethylene including couplers, bends, cap etc., with smooth internal and profiled external surface for non pressure under ground cable complete all specified and as directed. |
| 11 | Supply & Laying Galvanized steel water tubing, medium grade, of 80mm bore for passing cable in trenches, under road/walls etc complete all specified and as directed. |
| 12 | M & L for PCC 1:4:8, Type D-2, using 40 mm graded stone aggregate as in foundation, filling and mass concrete complete all specified and as directed. |
| 13 | M/L for plain cement concrete (1.3.6) type C2 using 40mm graded stone aggregate in foundations filling and mass concrete complete all specified and as directed. |
| 14 | M/L for plain cement concrete (1:2:4) type B1 using 20mm graded stone aggregate for Pole copping including necessary form work complete all specified and as directed. |
| 15 | Design, Supply, installing testing and commissioning factory fabricated out door type totally enclosed LT cubical panel board suitable size with busbar, conforming to relevant IS and protection class IP-65, dust, vermin and weather proof fabricated out of 3.15mm thick CRCA sheet duly powder coated, mounted on 40x40x5mm MS angle iron frame, duly welded in shape and coated with two coats of synthetic enamel paint of approved colour over a coat of redoxide primer including necessary grouting of legs 300mm deep in ground in PCC 1:4:8 type D2 using 40mm graded stone aggregate ,panel base to be 500mm above ground level with suitable compartments for controls and Monitors including cable glands for incoming and outgoing cables, locking arrangement,including accomodating, unserviceable LT panels supply and fixing the following accessories/items with necessary internal panel wiring with suitable size of Copper wire PVC insulated & sheathed multi stranded complete all as specified and as directed by Engr-in-charge.including Supply and fixing the following :- (a) MCCB TPN 250 Amps 50 Hz, 415 V with rupturing capacity 36 KA-1 No (Incoming)make : L& T (b) MCCB TPN 100 Amps 50 Hz, 415 V with rupturing capacity 35 KA-02 Nos (Outgoing)make : L& T (c) MCCB TPN 63 Amps 50 Hz, 415 V with rupturing capacity 25 KA - 01 Nos (Outgoing)make : L& T (d) Voltmeter 0-500V with selector switch (Digital type)-01 Nomake : L& T (e) Ammeter 0-50 Amps with CTs (50/5Amps) and selector switch(Digital type)-01 Nomake : L& T (f) Indicating lamps (RYB) -01 Set Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Sep 08, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedSep 29, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 13 daysOct 01, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 15 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender