Tender For Providing Of Single Offrs Living Acn At Dinjan Mil Stn Under Ge Dinjan
Tender Value
3.36 Crore
Estimated cost
Bid Submission
06 Oct 2026
23 days left
EMD
4.11 Lakhs
Bank guarantee accepted
Document Fee
2000
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Tinsukia → Assam
EMD Exemption
Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender For Providing Of Single Offrs Living Acn At Dinjan Mil Stn Under Ge Dinjan
BOQ
| Sl. No. | Item Description |
| 1 | Total amount of Sch 'A' Part-I Building Works Note :- This schedule is not pre-priced by MES and the rate indicated as \\"Rs. 0.00\\" under column 6 signifies this fact only. |
| 2 | Design, Fabrication and Construction of OTM ACCN FOR OR in RCC Framed Structure as per Arch Drg No. CWE/DIN/15/25 sheet No. 1/3 to 3/3 dated 20.01.2025 AND CWE/DIN/15/25 sheet No. 1/1 dated 20.01.2025 and revised thereof. Specification given in Sch A Notes and Particular Specifications including complete RCC foundation and plinth, Flooring, Joinery and Finishes complete all as specified. NOTE : Soil investigation done by HQ CESZ, Shillong through contigency vide their letter No 23501/183/E2(Plg) dt 15 Jun 2026.(i) Size – As per Arch drawing (ii) Height – as per Drg(iii) Fdn – To be design as per SBC report with RCC framed construction. (iv) Plinth – Burnt Brick wk in CM 1:6(v) DPC – 40 mm thick PCC 1:2:4 with WPC(vi) Super Structure – All RCC structure to be M25 design mix burnt brick wk wall upto ceiling.(vii) Seismic Zone – Strengthening measures for Zone V(viii) Roof – 0.50mm thick Pre-painted Galvalume sheet with MS steel frame structure on living area, roof slab with roof treatment - 150 mm thick on ground floor roof verandhah & Bathroom. (ix) Ceiling : False ceiling with powder coated snap grid frame work. (x) Internal Plaster – Internal 15 mm thick in CM (1:6)(xi) Mirror polished kota stone on, verandah & non skid ceramic tiles in toilet and bathroom over 15 mm thick screed bed in base of CM 1:6 over a layer of PCC 1:2:4 over sub base of 1:5:10.(xii) Dado/Skirting – Glazed ceramic tiles over 10 mm thick cement screed in CM (1:3) up to lintel height.(xiii) Joinery – Frames – pressed steel, shutter – Factory made flush door shutter (TD Drg No CESZ/2015/TD/03 Sheet 1/2 & 2/2) & molded / WPC doors in toilet bathroom(xiv) Joinery Window – aluminum powder coated window with Guard bars/grill (TD Drg No CESZ/2015/TD/07 Sheet No 1R/5, 2R/5, 3R/5, 4R/5 & 5R/5)(xv) Stainless steel routing on first floor of verandah & staircase.(xvi) Iron monger – Prefabricated aluminum anodized fittings. (TD Drg No CESZ/2015/TD/03 Sheet 1/2 & 2/2)(xvii) Plinth Protection – 75 mm thick PCC 1:3:6 over stone hard core. (xviii) Painting – Synthetic enamel paint on steel/wooden surface.(xix) Finishes – Internal - 02 coats of oil emulsion distemper incl 1mm thick wall care putty over a coat of primer. External - 02 Coats of weather proof exterior emulsion over one coat of primer. (xx) Antitermite treatment - As per IS-6313 Part-II : 2001 (xxi) Mosquito proofing - All external doors & Windows (xxii) 18mm thick granite over CM 1:3 for steps(xxiii) Sanitory Fitting – Vitreous China EWC, WHB ect of approved make including plumbing work (TD Drg No CESZ/TD-38 Sheet No 1/2 & 2/2 and TD Drg No CESZ/TD-31 Sheet No 1/2 & 2/2).(xxiv) Mosquito Proofing – All external Door and window.(xxv) Green marbles on steps & raiser on staircase. |
| 3 | NOTE: Schedule ‘A’ Part II to VIII are Prepriced by MES. Bidders shall insert their lumpsum amount in the Green coloured. |
| 4 | Total amount of Sch ‘A’ Part II (Site Clearance, Site Development & Earthworks) |
| 5 | Total amount of Sch ‘A’ Part III (Cooling Appliance) |
| 6 | Total amount of Sch ‘A’ Part IV (Air Conditioning) |
| 7 | Total amount of Sch ‘A’ Part V (Road/Path/Culvert) |
| 8 | Total amount of Sch ‘A’ Part VI (External Water Supply) |
| 9 | Total amount of Sch ‘A’ Part VII (External Electric Supply) |
| 10 | Total amount of Sch ‘A’ Part VIII (Sewage Disposal) |
| 11 | Total amount of Sch ‘A’ Part IX (Hot Water Supply) |
| 12 | Total amount of Sch ‘A’ Part X (Area Drainage) |
| 13 | Total amount of Sch ‘A’ Part XI (Security Fencing) |
| 14 | Total amount of Sch ‘A’ Part XII (Roof Top Solar) |
| 15 | SCH 'A PART IX (Miscellaneous B/R and E/M works) Note: This schedule is not pre-priced by MES and the rate indicated as \\"Rs 0.00\\" under Col 6 signifies this fact only |
| 16 | Rough excavation and bringing approved earth(as approved by Garrison Engineer) from sources outside defence land including cost or royality if any, transportation, taxes etc,for filling. Note: Earth required for the item shall be supplied by contractor,from outside MOD land at his own arrengement. All cost of procurement of earth including cost of transportation, roualties,taxes etc.shall be deemed to be included in the unit rate quoted by the contractor with referance to clause 3.6 of MES schdule Part-II on serial page No 18 it is clarified that measurement of the above item shall be of finished embarkment/ treverse of filled earth after consolidation and 10% deduction shall be made of from measured and calculated volume to allow for increase in bulk |
| 17 | Supply and fix Voltage stabilizer for automatic operation, single phase naturally air cooled indoor type & designed for input variation between 140 V to 280 V with output voltage stabilized at 230 V with accuracy of ± 2.5% and of capacity 3 KVA complete all as specified and as directed. |
| 18 | Fabrication, supply, installation, testing and commissioning electrical cubical control panel board an ISO: 9001 factory assembled made out door pedestal type feeder pillar box wheather and vermin proof fabricated of 3.0 mm CRCA MS sheet of Suitable size, 3 phase 4 wire 415 Volt ac 50 Hz complete duly painted with powder coating complete with locking arrangement, earthing terminals with suitable rating aluminium strips for incoming/outgoing MCCB's including and Mounting measuring instrument such as Volt meter, Ammeter , Selector switchs, CT's, Phase indicator lamps with holder , toggle switches and backelite fuse cut outs etc including incoming and outgoing cables connections with suitable cable glands, lugs including grouting of feeder pillar box 60 cm above ground level by providing 90 cm long angle iron size 50x50x6mm welded on all four corner embedded in PCC (1:2:4) using 20mm graded upto 30cm complete all as specified and directed by the Engg-in-charge (Feeder piller box shall be consisting the following)(a) 4 Nos electrolytic aluminium bus bars high conductivity aluminium alloy proper insulated suitable for 300 Amp with provision of extension and mounting on porcelain support Incoming:-(b) MCCB FP 200 amps, 36 KA , 415 volts, with thermal magnetic release 50Hz = 01 NoOutgoing:-(c) MCCB FP 160 amps, 36 KA , 415 volts, with thermal magnetic release 50Hz = 01 No (d) MCB SPN C curve 6-32A - 02 Nos.(e) Insulated Aluminium bus bars of suitable size shall be provided from the main bus bar to the out going MCCBs.(f) RYB indicating lamp, LED type 01 sets. |
| 19 | Supply & fixing bollard light fitting 08 Watt 1 mtr with IP 65 protection for illumination at garden light all as specified. |
| 20 | Supply and fix Loop in loop out box of FRP made with IP 65 protection of thermoplastic circuit breaker boxes with metric knockouts for cable entry and exit , combi climate cable glands of IP 66 / 67 for cable entry and grommets IP 65 for conduit for cable exit ,terminals as PVC connector heavy duty 32 Amps, 4 way for cable necessary fixing arrangements and with cable glands ,etc all as specified and directed. Please Enable Macros to View BoQ information |
| 21 | Supply and fix Loop in loop out box of FRP made with IP 65 protection of thermoplastic circuit breaker boxes with metric knockouts for cable entry and exit , combi climate cable glands of IP 66 / 67 for cable entry and grommets IP 65 for conduit for cable exit ,terminals as PVC connector heavy duty 32 Amps, 4 way for cable necessary fixing arrangements and with cable glands ,etc all as specified and directed. Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Sep 03, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedOct 06, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 23 daysOct 13, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 30 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender