Tender For Development Work Of Balance Service Road Along 60M Wide Road Between Sector-1 & Agriculture Green (Sector-1 Side) & Resurfacing Of Service Road (Sector Agriculture Green Side), Greater Noida.
Tender Value
12.46 Crore
Estimated cost
Bid Submission
16 Sep 2026
1 days left
EMD
22.47 Lakhs
Bank guarantee accepted
Document Fee
6770
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Gautam Buddha Nagar → Uttar Pradesh
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Development Work Of Balance Service Road Along 60M Wide Road Between Sector-1 & Agriculture Green (Sector-1 Side) & Resurfacing Of Service Road (Sector Agriculture Green Side), Greater Noida.
BOQ
| Sl. No. | Item Description |
| 1 | Construction of sub-grade and earthen shoulders with approved material obtained from borrow pits with all lifts & leads. Transporting to site, spreading, grading to required slope and compacted to meet requirement of Table No 300-2: lead upto of 5.00KM (MORTH-20/305/3.18) |
| 2 | Extra for compaction of earth work in embankment under optimum moisture conditions to give at least 95% of the maximum dry density (proctor density). (DSR-2023/16.2/SOR) |
| 3 | Granular sub-base with graded material, plant mix method Construction of granular sub-base by providing close graded material, mixing in a mechanical mix plant at OMC, carriage of mixed material to work site, spreading in uniform layers with motor grader on prepared surface and compacting with vibratory power roller to achieve the desired density, complete as per clause 401. MORTH/4.01/401(A) |
| 4 | Providing, laying, spreading and compacting graded stone aggregate to wet mix macadam specification including premixing the Material with water at OMC in mechanical mix plant carriage of mixed Material by tipper to site, laying in uniform layers with paver in sub- base / base course on well prepared surface and compacting with vibratory roller to achieve the desired density.morth (MORTH-407) |
| 5 | Brick edging in full brick width and half brick depth including excavation, refilling and disposal of surplus earth lead upto 50 metres.With common burnt clay F.P.S. (non modular) bricks of class designation 7.5 (DSR-2023/16.7.1) |
| 6 | Providing and applying primer coat with SS1 grade bitumen emulsion on prepared surface of granular Base including clearing of road surface and spraying primer at the rate of 0.75 kg/sqm using mechanical means. (MORTH 502/5.01/A(i)) |
| 7 | Providing and applying tack coat with bitumen grade VG-10 using emulsion pressure distributor at the rate of 0.25 kg per Sqm on the prepared bituminous surface cleaned with mechnical broom. (MORTH-503(II)/502) |
| 8 | Providing and laying dense graded bituminous macadam with higher capacity batch type HMP using crushed aggregates of specified grading, premixed with bituminous binder VG-30 @4.5 percent by weight of total mix and filler, transporting the hot mix to work site, laying with a hydrostatic paver finisher with sensor control to the required grade, level and alignment, rolling with smooth wheeled, vibratory and tandem rollers to achieve the desired compaction as per MoRT&H specification clause No. 505 complete in all respects. |
| 9 | 40mm compacted thickness with bitumen penetration of 60/70 4.5@ by Weight of total mix |
| 10 | Providing and laying bituminous concrete with higher capacity batch type hot mix plant using crushed aggregates of specified grading, premixed with bituminous binder [email protected]% of mix and filler transporting the hot mix to work site laying with hydrostatic paver finsher with sensor control to the required grade, level and alignment rolling with smooth, wheeled, vibrator and tendom roller to achieve the desired compaction as per MORTH specification clause 507 complete in all respect (MORTH/507(B)/5.05) |
| 11 | 30mm compacted thickness with bitumen peretration of [email protected]% by weight of total mix |
| 12 | Road Marking with Hot Applied Thermoplastic Compound with Reflectorising Glass Beads on Bituminous Surface.Providing and laying of hot applied thermoplastic compound 2.5 mm thick including reflectorising glass beads 250 gms per sqm area, thickness of 2.5 mm is exclusive of surface applied glass beads as per IRC:35-2015 The finished surface to be level, uniform and free from streaks and holes (SOR-2025/Ch-6.2/MORTH-802 (8.13)) |
| 13 | Part-B Drain workEarth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and for all lift, as directed by Engineerin- charge. : All kinds of soil (DSR-2023/2.6.1) |
| 14 | Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:4:8 (1 Cement : 4 coarse sand (zone-III) derived from natural sources : 8 graded stone aggregate 40 mm nominal size derived from natural sources) (DSR-2023/4.1.8) |
| 15 | Providing and laying in position ready mixed or site batched design mix cement concrete for reinforced cement concrete work; using coarse aggregate and fine aggregate derived from natural sources, Portland Pozzolana / Ordinary Portland /Portland Slag cement, admixtures in recommended proportions as per IS: 9103 to accelerate / retard setting of concrete, to improve durability and workability without impairing strength; including pumping of concrete to site of laying, curing, carriage for all leads; but excluding the cost of centering, shuttering, finishing and reinforcement as per direction of the engineer-in-charge; for the following grades of concrete. |
| 16 | Note: Extra cement up to 10% of the minimum specified cement content in design mix shall be payable separately. In case the cement content in design mix is more than 110% of the specified minimum cement content, the contractor shall have discretion to either re-design the mix or bear the cost of extra cement. : All works upto plinth level : Concrete of M25 grade with minimum cement content of 330 kg /cum (DSR-2023/5.33.1.1) |
| 17 | Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete upto plinth level. : Thermo-Mechanically Treated bars of grade Fe-500D or more. (DSR-2023/5.22.6) |
| 18 | Centering and shuttering including strutting, propping etc. and removal of form for : (DSR-2023/5.9) |
| 19 | Walls (any thickness) including attached pilasters, butteresses, plinth and string courses etc.(DSR-2023/5.9.2) |
| 20 | Foundations, footings, bases of columns, etc. for mass concrete (DSR-2023/5.9.1) |
| 21 | Suspended floors, roofs, landings, balconies and access platform (DSR-2023/5.9.3) |
| 22 | Labour cess and GST will be paid extra as per Govt. orders. Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Sep 03, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedSep 16, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 1 daySep 18, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 3 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender