Tender For Repairs/Resurfacing Of Roads, Road Furnitures And Allied Works At Aoc Centre, 454 Fd Hosp And At Other Than Aoc Centre Under Age B/R (S) No-Ii Of Ge South Secunderabad.
Tender Value
1.19 Crore
Estimated cost
Bid Submission
25 Sep 2026
4 days left
EMD
1.95 Lakhs
Bank guarantee accepted
Document Fee
1000
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Hyderabad → Telangana
EMD Exemption
Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Repairs/Resurfacing Of Roads, Road Furnitures And Allied Works At Aoc Centre, 454 Fd Hosp And At Other Than Aoc Centre Under Age B/R (S) No-Ii Of Ge South Secunderabad.
BOQ
| Sl. No. | Item Description |
| 1 | M&L for repair to pot holes of any depth, not exceeding 1 Sqm each including sweeping free from dust and mud, or water, scoring sunken surfaces in roads, paths etc cutting around edges to at least 25mm in depth, making good by applying a tack coat @ 5 Kg/ 10 Sqm , putting in premixed bituminous macadam , well rammed and sealed with binder 9.8 Kg / 10 m2, blended with 0.09 m3 of stone chippings 6.3 mm size and again well rammed (including supply of premixed macadam ,binder and chippings l) depth of holes exceeding 30mm complete all as specified and as directed . |
| 2 | M&L for preparing black top surfaces by brushing with wire brushes for removing caked mud etc. Sweeping with brooms and finally fanning the cleaned surface with gunny bags to remove all loose dirt etc. complete all as specified and as directed |
| 3 | M&L for applying evenly a tack coat of Cationic Bitumen Emulsion (RS-1) conforming to IS: 8887 at a rate of application of 0.2-0.3 kg/sqm on bituminous surface as specified in Table 500-5 of MoRTH specification for road and bridge works 2013, using mechanical sprayer after cleaning of existing surface as specified and directed. |
| 4 | M&L for premixed bituminous macadam laid / rolled with power road roller 8 to 12 Tonne capacity and compacted to required gradient and camber ( consolidated thickness 75 mm or less ) using paving bitumen of grade VG-30 with minimum binder content of 4% by weight of total mix all as specified and directed . |
| 5 | M&L for bituminous premix semi dense asphaltic concrete (SDAC) 30mm (consolidated thickness) in single layer using paving bitumen of grade VG-30 with 5.5% minimum binder content mixed by weight of total mix as wearing course, using hot mix plant and laid by using mechanical sensor paver, rolled and compacted to required camber and gradient complete all as specified.(Note: No Extra payment shall be paid to the contractor for more quantity of bitumen than mentioned in Sch 'A'.) |
| 6 | M & L for preparing bituminous surfaces of new/old road and marking 2.5mm thick centre lines, stop lines, dashes, arrows etc. and the like n.exc 10cm wide on roads pavements with hot applied thermo plastic road marking paint of approved colour confirming to BS 3262-1989 with special applicator machine all as per manufacturers instruction complete all as specified and directed. |
| 7 | M & L for preparing bituminous surfaces of new/old road and marking 2.5mm thick centre lines, stop lines, dashes, arrows etc. and the like exc 10cm wide on roads pavements with hot applied thermo plastic road marking paint of approved colour confirming to BS 3262-1989 with special applicator machine all as per manufacturers instruction complete all as specified and directed. |
| 8 | Supply and fixing in repairs cat eye solar reflective type of metal body alloy of size 100mm x 100mm x 20mm with PAMA striplens reflector of model No. DA 972.0 fixed with and incl MS stud of suitable size as per manufacturers instructions complete all as specified and as directed.. Make : Mr Illumination/3M/Aktion/Dark eye |
| 9 | S&F in repairs solar cat eye aluminum alloy (100% water proofing design according to 65) of size 125mm x 125mm x 25mm (shank 65mm) of high efficiency Mono rystafie solar panel 2.4V/0.3 watt one NI-ed rechargeable battery (1.2V/1600MA) consisting of super bright LED with 10,000 to 18,000 mcd complete as per manufacturers instructions etc complete all as specified and as directed. |
| 10 | S&F in repairs road delinators as per IRC-79-1981 (road way indicators) dual directions, retro reflective, round delinator made out of 16 gauge MS pipe 75 mm dia and of height 900mm duly powder coat painted and provided with three reflective band of colour red, white and yellow colour, 150 mm wide and 50 micron thick and protected with welded wire cage including necessary excavation of size 300x300x450mm and PCC 1:2:4 type B2 foundation complete all as specified and as directed |
| 11 | S&F in repairs for 32 inches (80cm) dia polycorbonate convex mirror fibre moulded water proof and weather proof, fixed to Stainless Steel pole of 50mm outer dia (Grade 304), thickness not less than 2.50mm with necessary brackets for fixing as required and laid with PCC 1:2:4 Type B1 in existing position of Appx size 450x450x600mm etc complete all as specified and as directed. Make : Dhruv of Dark Eye, TATA BP Solar or equivalent |
| 12 | Supply and fix in repair Black and yellow colour rubber speed breaker (rumble strip) of size 500x400x75mm height including bolting and grouting with appropriate grout material all as specified and directed. Make: 3M, Dark eye or equivalent. |
| 13 | Providing and laying at or near ground level factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 (1 cement: 3 coarse sand), including making joints with or without grooves (thickness of joints except at sharp curve shall not be more than 5 mm), including making drainage opening wherever required, demolition of existing kerb stone complete all as specified and directed. |
| 14 | Material and labour for preparation of newly plastered surfaces over 10cm girth or width of Kerb stone and applying two coats of Synthetic enamel paint over a coat of primer complete all as specified and directed. |
| 15 | Supply and fix of Precast reinforced cement concrete of size (L= 900 mm, Ht= 750mm, Base= 400mm and Top 100 mm) type B-1, 1:2:4( 20 mm graded aggregate) for road dividers/median barriers including reinforcement, moulding, finishing painting of Yellow and Black synthetic enamel paint, reflectors and allied works complete as per drg and dismantling of existing dividers all as specified and directed. |
| 16 | Dismantling wrought iron or mild steel work of any description not otherwise provided for complete all as specified and as directed. |
| 17 | M&L for stainless steel of grade 304, including bending ends, cutting, welding,smoothing cutting to holes, embedded in cement concrete etc all as specified and directed by Engr-in-Charge (PCC shall be measured and paid separately). |
| 18 | M&L for Micro Prismatic type XI retro reflective 4mm thick ACM (Aluminium Composite Materials) sheet shall be fixed back SS frame fixed with reveting or welding all as directed. |
| 19 | M&L for retro reflective letters including symbols (commas, dashes and arrows) letter height is n exc 10CM all as directed. |
| 20 | Excavation post holes or similar works, each n.exc. 0.5Cum, getting out soft/loose soil. Returning, filling in and ramming earth or broken rubble mixed with earth around, in layers n. exc. 25 cm and watering and removing surplus soil to a distance not exceeding 50m and making good surfaces complete all as specified and directed. |
| 21 | M&L for PCC 1:2:4 type B2 foundation for post holes of size 450x300x450mm all as specified and directed. |
| 22 | M&L for surface dressing hard and dense soil n exc 15cm deep complete all as specified and directed. |
| 23 | M&L for moorum/red bajri filling in road side berms, paving, laid in layers n exc 75mm thick, spread, levelled and rammed including watering using light weight roller all as specified and directed. |
| 24 | M&L for cement concrete in foundation filling and mass concrete type D2 1:4:8 (40mm graded aggregate) all as specified and directed.. |
| 25 | Demolition of cement concrete un-reinforced in any position and paving not exc 15 cm thick above or below ground level complete all as specified and as directed. |
| 26 | M&L for 100 mm thick PCC 1:4:8 type D2( 40 mm graded aggregate) as in sub bases, sub flooring finished even and rough all as specified and directed. |
| 27 | Providing and laying 80 mm thick factory made chamfered edge cement concrete paver block of M30 grade with approved colour, design & pattern as in footpath, parks, lawns,drive ways or light traffic parking etc. of required strength , thickness & size/shape,made by table vibratory method using PU mould, laid in required colour & pattern over and including 50 mm thick compacted bed of fine sand, compacting and proper embedding /laying of inter locking paver blocks including the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand complete all as specified and directed. Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Aug 28, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedSep 25, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 4 daysOct 02, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 11 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender