Tender For Installation, Testing And Commissioning Of Fire Hydrant System For Helipad At Shivkhori
Tender Value
33.99 Lakhs
Estimated cost
Bid Submission
09 Sep 2026
3 days left
EMD
67994
Bank guarantee accepted
Document Fee
1000
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Reasi → Jammu and Kashmir
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Installation, Testing And Commissioning Of Fire Hydrant System For Helipad At Shivkhori
BOQ
| Sl. No. | Item Description |
| 1 | SITC of underground/in culverts MS Pipes (as per IS 1239-3589 as applicable) including cutting, screwing, welding etc. and providing all fittings e.g flanges, bends, tees, elbows reducers, clamps, hinges etc. Underground pipes shall be wrapped & coated as per BIS-10221, cut off valve shall be provided for pipe in trench, culverts and underground. The pipe shall be laid as per BIS 13039. Flushing connection with isolation valve shall be provided. Job includes the cost of material, Labour charges, transportation charges and all taxes. Job also includes P/F of strainer of suitable size at suction side of the pump. |
| 2 | a) 150 mm dia |
| 3 | b) 80 mm dia |
| 4 | SITC of over ground M.S Pipes (as per IS 1239-3589 as applicable) including cutting holes & chases in bricks or RCC wall/slab & Making good the same. Painting with one coat of primer and two coats of synthetic enamel of approved shade of following sizes. The pipe shall be laid as per BIS 13039 with adequate supports. Flushing connection with isolation valve shall be provided. Job includes the cost of material, Labour charges, transportation charges and all taxes |
| 5 | a) 150 mm dia |
| 6 | b) 80 mm dia |
| 7 | SITC of single headed oblique pattern SS hydrant Landing valve with 80mm dia flanged inlet and 63mm dia Instantaneous type female outlet complete with cap and all Accessories ISI marked. Job includes the cost of material, Labour charges, transportation charges and all taxes |
| 8 | Supply of non-percolated flexible hose RRL 63mm dia x 15 mtr (2Nos) long and RRL 63mm dia x 30 mtr (2Nos) complete with instantaneous type 63mm dia male and female ISI marked SS coupling and Reverted to hose pipe with reverts and copper wire.& ISI marked. Job includes the cost of material, Labour charges, transportation charges and all taxes. |
| 9 | SITC of Butterfly valve complete. The butterfly valve shall be considered as per the size of the pipe on which it is being installed. Job includes the cost of material, Labour charges, transportation charges and all taxes |
| 10 | a) 150 mm dia |
| 11 | b) 80 mm dia |
| 12 | SITC of following accessories: |
| 13 | a) 25mm dia spring loaded air release valve with isolation cork. Job includes the cost of material, Labour charges, transportation charges and all taxes |
| 14 | b) Pressure Gauge |
| 15 | c) Pressure Switch |
| 16 | d) 25 mm dia ball valve |
| 17 | P/F of NRV complete as per site requirement. The NRVs shall be considered as per the size of the pipe on which it is being installed. P/F of OS & Y sluice valve for upstream and downstream of the fire pump as per the site requirement. Job includes the cost of material, Labour charges, transportation charges and all taxes |
| 18 | b) 150 / 100 mm/ 80mm/ 65 mm dia |
| 19 | SITC of the AUTOMISATION CONTROL PANEL consist of a control cubicle of fabricated sheet steel suitable for floor mount and for 3 phase, 4 wire, 50 Hz system incorporating suitable isolating main switches, bus bars, relays, contactors, indication lamps, fuses, instruments automatic isolator and axillary switch including connectors complete as required for the main electric pump & jockey pump etc. as required for the system. It should have auto/ manual selector switch. AUTO mode shall operate on pressure drop in the line. Job includes the cost of material, Labour charges, transportation charges and all taxes |
| 20 | Providing and fitting of 3.5 Core of suitable capacity circuit integrity fire resistant cable from electrical panel to AVR for automation of the system along proper thimbling with cramping tools. Job includes the cost of material, Labour charges, transportation charges and all taxes. |
| 21 | SITC of horizontally mounted electric pump set, complete for delivery 1620 LPM against a total head of 110mtrs. With suitable rating 101 HP approx. three phase motor with bronze impeller, base frame, flexible connections on suction & delivery side and AVM pads complete as required. The suction side of the pump shall be fitted with bucket strainer. The pump must work continuously and smoothly under all flow conditions. Job includes the cost of material, Labour charges, transportation charges and all taxes. |
| 22 | SITC of diesel engine driven main fire pump complete for delivery 1620 LPM against a total head of 110mtrs while running at suitable RPM for automatic operation and consisting of following complete in all aspects, as required: (Diesel Driven Pump) Horizontal type, centrifugal pump of cast iron body and bronze impeller, flexible connections on suction & delivery side, AVM Pads. The suction side of the pump shall be fitted with bucket strainer. Diesel engine suitable for the above pump complete with standard accessories, exhaust system and suitable cooling system & related items. Coupling & coupling guard, suitable battery & charger, fuel tank for minimum 2 h. The pump must work continuously and smoothly under all flow conditions. Job includes the cost of material, Labour charges, transportation charges and all taxes. |
| 23 | SITC of Automatic Motor Control Panel for the diesel driven pump with Star Delta starters, switch gear and contactors. The panel shall include necessary indicating lamps for the RYB phases, ammeters and volt meter with selector switch etc. The panel shall have Auto/ Manual selector switch. The panel shall be powder coated in red colour and shall have provisions for foot mounting with all accessories as required complete. Termination of incoming cable to the pump panel and the cabling between the pump and the panel shall be inclusive. |
| 24 | Earthwork excavation in trenches including backfilling and levelling the top after laying of MS pipe. |
| 25 | Supply & installation of weather proof hose cabinets fabricated from 18 swg MS sheet/section with full front glass door and suitable to accommodate 02 Nos 15 mtr and 30 mtr each long hoses and foam branch as req. Job includes the cost of material, Labour charges, transportation charges and all taxes. |
| 26 | SITC of Air vessels of adequate capacity with all necessary fittings, valves, gauges etc. Job includes the cost of material, Labour charges, transportation charges and all taxes |
| 27 | Supply and laying of 2 core copper circuit integrity fire resistant cable of suitable size for connection of motor to starter panel. Job includes the cost of material, Labour charges, transportation charges and all taxes |
| 28 | Providing & fixing ABC type fire extinguishers 9 Kg cap. Complete with discharge arrangement, high-pressure hose pipe complete as required compatible with foam. The powder shall be compatible with foam extinguisher & foam concentrate. Job includes the cost of material, Labour charges, transportation charges and all taxes |
| 29 | Providing & fixing CO2 type fire extinguishers 4.5 Kg capacity as per BIS 15683. Complete with wheel valve arrangement, high-pressure wire Braided hose pipe Job includes the cost of material, Labour charges, transportation charges and all taxes |
| 30 | SITC of Foam making Branch FB - 10X, low expansion type , Aluminium Alloy , having 63 mm male inst. Inlet, Foam concentrate, pick up tube , 450 LPM Foam - water Solution capacity at 7 kg/cm2 pressure , Bearing IS: 2097 as required. The FB10X branch shall have both jet and spray mode. The foam branch shall function properly with the foam concentrate being used. Job includes the cost of material, Labour charges, transportation charges and all taxes |
| 31 | Providing of Foam (20 to 25 ltr pack) certified for ICAO level C performance. Job includes the cost of material, Labour charges, transportation charges and all taxes. (AFFF-3% foam induction). The provision of trolley to move foam cans during emergency shall be included. |
| 32 | Providing of ABC trolleys – 2 nos., 50Kg, CO2 trolleys, 22.5 kg – 2 nos., 45 L foam trolleys – 2nos., Foam 9 L fire extinguisher – 2nos.., Fire proximity suit (Helmet with visor, gloves, boots, tunic & trousers, flash hood) – 6 pair, Large rescue Axe (crash axe, non-wedge or aircraft type) – 1 no., Crowbar of length 105cm– 1 no., First Aid kit - 1 Comprehensive, aviation-grade, Fire blanket - 2 (1.8 m × 1.8 m), Stretcher - 1 Foldable, Rope (lifeline - 15 m, 5 cm circumference) with rescue harness – 1 for Safety use , Megaphone - 1 For Crowd control, Communication device (VHF or mobile) - 1 For Pilot/GHA communication, Adjustable wrench – 01, Hook, grab or salving – 01, Hacksaw (heavy duty) and six spare blades – 01, Ladder (two piece) – 01, Pliers, side cutting (tin snips) – 01, Set of assorted screw drivers – 01, Harness knife and sheath for harness cutters - 6., Man-made mineral fibre (MMMF) filter masks - 11., Gloves fire resistant – 4 Nos., Bolt cutters of 60cm-1 Nos., Sand buckets – 6 nos. Job includes the cost of material, Labour charges, transportation charges and all taxes. The PPE shall be as per the EN standards prescribed in ICAO heliport manual. The powder shall be compatible with foam extinguisher & foam concentrate. |
| 33 | RCC Water tank of size 12’x10’x10’ for storage of water. The job also includes making provision for accessibility to all the hydrants. The job also includes RCC protection wall between pump room and tank of size 25’x6’x9’’ including plinth work. |
| 34 | CGI Shed Pump room of size 10’x10’x10’ with RCC plinth and foundations, flooring, structural steel columns, tie members, purlins, trusses |
| 35 | SITC of 150KVA Three Phase Oil Cooled Automatic Voltage Regulator (AVR) of standard Make with microprocessor based control system, 100% copper wound, overload and short circuit protection, automatic shutdown in case of fault, output voltage 230+/-1% under unstable voltage conditions. Job includes fitting of cables of requisite rating and quantity to make the system operational. Job includes the cost of material, labour charges, transportation charges, installation charges and all taxes |
| 36 | SITC of Pilot operated Pressure Reducing Valves (PRVs) of size 80mm coated with fusion bonded epoxy for fire application UL/FM approved as per the size of the pipe on which it is being installed. The pilot line shall have strainer. Job includes the cost of material, Labour charges, transportation charges and all taxes. |
| 37 | Job charges for carriage of material like sand, bajri, steel, MS pipes, electrical cables, equipment’s etc. by way of mechanical means and on head load. |
| 38 | SITC of pressure relief valves of suitable size & rating as required. Job includes the cost of material, Labour charges, transportation charges and all taxes |
| 39 | SITC of centrifugal jockey pump set complete for delivery 180 LPM against a total pressure of 110mtr head with suitable rating. Three phase motor with suitable speed, base frame, flexible connections on suction & delivery side and AVM pads complete as required. The suction side of the pump shall be fitted with bucket strainer. The complete pumping unit fitted with suitable valves as required, Job includes the cost of material, Labour charges, transportation charges and all taxes. Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Aug 25, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedSep 09, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 3 daysSep 09, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 3 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender