Tender For Repair And Restoration Mastic B.L Dixist Road And Drain From Sathdobatey To Roy Master Jhora Within In Ward No Xv And Xiii Under Kalimpong Municipality.
Tender Value
94.66 Lakhs
Estimated cost
Bid Submission
16 Sep 2026
23 days left
EMD
1.89 Lakhs
Bank guarantee accepted
Document Fee
2000
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Kalimpong → West Bengal
EMD Exemption
Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Repair And Restoration Mastic B.L Dixist Road And Drain From Sathdobatey To Roy Master Jhora Within In Ward No Xv And Xiii Under Kalimpong Municipality.
BOQ
| Sl. No. | Item Description |
| 1 | 1:2:4 ( 1 Cement : 2 coarse sand (zone -III) derived from natural sources:4 graded stone aggregate 40 mm nominal size derived from natural sources ) |
| 2 | Centering and shuttering including strutting, propping etc. and removal of form forFoundations, footings, bases of columns, etc. for mass concrete |
| 3 | 20 mm cement plaster of mix : 1:4 (1 cement: 4 fine sand) |
| 4 | Neat Cement punning |
| 5 | Add Cost Index @ 37 % |
| 6 | Repairing Pot-holes with Bituminous Macadam (Grading - I, for compacted thickness of 80mm to 100mm) Filling Pot Holes with Bituminous Macadam using Mobile Hot Mix plant (6-10 TPH) with approved crushed aggregates of specified grading premixed with bituminous binder @3.3% by wt. of the total mix, transported to site and laid in the pot hole prepared before hand by utting the edges to get a firm vertical face and by removing all the failed and loose materials including dust and applying tack coat evenly on the sides and on the surface as per specification, rolling the filled depression with 8-10 tonne smooth wheeled roller to achieve the desired compaction, including the cost and carriage of stone aggregates and bitumen, hire charges of machinery and equipment, cost of fuel and lubricants and wages of all operationalstaff, quality control except the cost of tack coat complete as per direction of Engineer-incharge. Payment to be made on the basis of the loose net volume of the stone aggregates used in the work. |
| 7 | Bituminous MacadamProviding and laying bituminous macadam with 100-120 TPH hot mix plant using crushed aggregates of specified grading premixed with approved bituminous binder @ 3.3% (min) for Grading -1 and 3.4% (min) for Grading -2 by weight of total mix , transported to site, laid over a previously prepared base with paver finisher to the required grade, level and alignment and rolled as per clauses 501.6 and 501.7 to achieve the desired compaction (Reference to MORT&H's specification clause 504). or Grading II (19 mm nominal maximum aggregate size) Layer Thickness 50-75mm |
| 8 | Tack CoatProviding and applying tack coat with Cationic bitumen emulsion (RS1) complying with IS:8887 using emulsion pressure distributor on the prepared bituminous/granular /cement concrete pavementsurface cleaned with mechanical broom and high pressure air jet (Reference to MORT&H's specification clause 503). |
| 9 | MASTIC ASPHALT 25mm THICKProviding and laying 25 mm thick mastic asphalt wearing course with approved grade bitumen meeting the requirements given in table 500-39, prepared by using mastic cooker and laid to required level and slope after cleaning the surface, including providing antiskid surface with bitumenprecoated fine-grained hard stone chipping of 13.2 mm nominal size at the rate of 0.005cum per 10 sqm and at an approximate spacing of 10 cm center to center in both directions, pressed into surface when the temperature of surfaces is not less than 100°C, protruding 1 mm to 4 mm over mastic surface, all complete as per clause 516 (Reference to MORT&H's specification clause 516 along with IRC:107). |
| 10 | Excavation for Structures Earth work in excavation of foundation of structures as per drawing and technical specification, including setting out, construction of shoring and bracing, removal of stumps and other deleterious matter,dressing of sides and bottom and backfilling with approved material (Reference to MORT&H's specification 304). |
| 11 | PLUM CONCRETE (1:3:6) Plain cement concrete of nominal mix (1:3:6 ) with coarse aggregate of which stone boulder of size 225 mm to 150mm of 60% of total dry volume to be placed in position as directed by Eng-in charge ,67% - 40 mm down single &33% - 20 mm down bazri , Coarse Sand ,Cement ( 53 grade ) mechanically mixed in 1:3:6 of rest volume and placed in position and compacted by any means as directed including cost of shuttering . |
| 12 | Providing weep holes in Brick masonry/Plain/ reinforced concrete abutment, wing wall/ return wall with 100 mm dia AC/PVC/HDPC pipe, extending through the full width of the structure with slope of 1V :20H towards drawing oce. Complete as per drawing and Technical Specifications (Reference to MORT&H's specifications 2706 & 2200). |
| 13 | GST @ 18% Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Aug 22, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedSep 16, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 23 daysSep 21, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 28 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender