Tender For Providing 2 Nos Of New Borewell,Rev Ing Of 1 Nos Of Borewell And Requirements Of Material For 4 Nos Damaged Borewells In (Zone 1) Thanjavur City Municipal Corporation
Tender Value
19.80 Lakhs
Estimated cost
Bid Submission
13 Aug 2026
8 days left
EMD
19800
Bank guarantee accepted
Document Fee
Ref. Documents
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Thanjavur → Tamil Nadu
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Providing 2 Nos Of New Borewell,Rev Ing Of 1 Nos Of Borewell And Requirements Of Material For 4 Nos Damaged Borewells In (Zone 1) Thanjavur City Municipal Corporation
BOQ
| Sl. No. | Item Description |
| 1 | Drilling of Bore wells any where in Tamilnadu including transportation from one place to another with in Tamilnadu inalluvial soilsed imentary strata of clay and sand stone shale pebbles boulders etc. By first taking a pilot bore of 140mm /150mm dia and then enlarging to required dia director reverserotary mud circulation method using rotary rigs,fuel,labour and drilling bentonite and water requiredf or drilling at site (Site will besh own by the TWAD BoardOfficers) including construction of mud pit. |
| 2 | Upto 60 mts. Depth ending below ground level.(WD-W0783) |
| 3 | From 60 mts to 90m(WD-W0784) |
| 4 | From 90 mts to 120m(TWAD SOR 25-26/WD-W0785) |
| 5 | Reaming 140/150 mm dia pilot bore to 300mm dia bore as directed by the TWAD Board Officer |
| 6 | Upto 60 mts. Depth ending below ground level.(WD-W0794) |
| 7 | From 60 mts to 90m(WD-W0795) |
| 8 | From 90 mts to 120m(TWAD SOR 25-26/WD-W0796) |
| 9 | Supplying and delivery of 150mm dia following OD PVC blue casing pipe suitable for medium wells with standard approved quality and make etc., complete as per the instructions of the departmental authorities. |
| 10 | Slotted PVC Pipe( WD-M0029) |
| 11 | Unslotted PVC pipe( WD-M0028) |
| 12 | Labour charges for inserting PVC casing pipe (with slots and without slots) in the drilled hole including jointing the pipe with cement paste etc., complete and supplying and packing of annular space with pebbles etc., complete as per standard specification. ( WD-W0830) |
| 13 | Charges for developing the borewells with air compressor of 600 CFM capacity including transportation labour and fuel charges for compressor as directed by the departmental officers and conducting yield test by \\"V\\" notch method etc., complete as per standard specification. |
| 14 | Supply and delivery of wet type submersible pumpset as per IS 8034/2002 and IS 9283/1995 suitable to pump 350/75M head with dry run preventor etc., complete as per standard specifications. (10 HP) |
| 15 | For Requirements (15Hp)(TWAD SOR 25-26/WD-M1681) |
| 16 | Supply and fixing of 3 Phase panel board with star delta with two level guard and auto start etc., complete as per standard specifications (10 HP) including timer facility |
| 17 | For Requirements (15Hp)(TWAD SOR 25-26/WD-M1918) |
| 18 | Supply and delivery of 6 Sq.mm. PVC insulated and sheathed 3 core flat type copper cable comfirming to IS 694/1990 etc., complete as per standard specifications. |
| 19 | Supply and delivery of 100 AMPS TPN Sheet steel doubler break switch with HRC Fuse and neutral on suitable angle frame work MS cable entry boxes with PWD earthing. |
| 20 | Supply and delivery of power capacitor for power factor improvement with oil filled with discharge resistance 3 phase 415/440V 50 HZ conforming to ISS 2834 with ISI marking etc., complete as per standard specifications. |
| 21 | Supply and fixing of 80mm UPVC Pipe etc., complete as per standard specifications. |
| 22 | Supply and delivery of following specials as per standard specifications. |
| 23 | 90 MM dia PVC 6kg/cm2 |
| 24 | 80MM Reflex valve As per I.S. 5312 / Part I / 84 with Bye pass arrangements(PN-1) With IS Marking . |
| 25 | 80mm GI Bend |
| 26 | 80mm GI Flange set |
| 27 | Clamp set 80MM dia |
| 28 | 200mm dia End cap |
| 29 | 200mm dia bore cover plate |
| 30 | 20mm dia GI Pipe service pipe |
| 31 | 20mm dia GI Bend |
| 32 | 80mm dia GI coupling |
| 33 | 20mm dia GI Coupling |
| 34 | 20mm dia GI Elbow |
| 35 | 20mm dia GI Pipe Hex Nipple |
| 36 | 100mm CI D/F Sluice valve LAP / Wheel as per IS 14846/2000 PNI with IS marking |
| 37 | Nylon Rope |
| 38 | Earthwork excavation for pipe line in all type of soil and sub soils etc., complete as per standard specifications.Other than loose soil |
| 39 | Refilling the excavated earth into the trench etc., complete as per standard specifications. |
| 40 | Labour charges for the erection of submersible pumpset in borewell/ open well including fixing and jointing submersible cable with proper clamps upto the starter to required depth and also fixing of riser pipes to the required depth valves erection clamps, pressure gauges upto the exterior wall of pump room and erection of panel board consisting of TPICN switches starter, voltmeter, Ammeter , three pilot ( indicating ) lamps capacitor single phasing preventor, water level guard and laying and jointing the cables and twin earthing as per IE rules etc., complete and testing the pumpset and trail run for 10 days . (Above 10.00 HP to 20.00 HP ) |
| 41 | Supply and delivery of VIR wire etc., complete as per standard specifications. |
| 42 | Post to Metre Board (9/16) |
| 43 | Metre Board to Main Switch (7/16) |
| 44 | Supply and delivery of following Electrical accessories etc., complete as per standard specifications. |
| 45 | 1/18 SWG Multi Wire |
| 46 | 5 Amps flush type Switch |
| 47 | 3/20 SWG Multi wire |
| 48 | Earthwork excavation in all soils and subsoils to full depth as may be directed except hardrock requiring blastering inclusive of all shoring, strutting and bailing out water wherever necessary and depositing the surplus earth with initial lead and lift etc., complete as per standard specifications. |
| 49 | Supplying and filling in foundation and basement with filling sand in layers of not more than 15cm.thick well rammed watered and compacted etc., complete complying with standard specification. |
| 50 | Cement Concrete 1:4:8 mix (One cement five sand and ten metal) using 40mm ISS HBG metal including cost and conveyance of all materials and labour etc complete as per standard specifications. |
| 51 | Brickwork in Cement Mortor 1:5 (One cement five sand) mix using country burnt of standard size 8 3/4\\"x4 1/4\\"x2 3/4\\" including cost and conveyance of all materials and labour etc complete as per standard specifications upto basement. |
| 52 | Upto Basement |
| 53 | For Superstructure |
| 54 | Plastering in Cement Mortor 1:5 (One cement five sand) 12mm thick including cost and conveyance of all materials and labour etc., complete as per standard specifications. |
| 55 | Supplying and fixing MSSheet door using 10 gauge MS Sheet using MS equal angle frame for outer and inner and cross bracings for stiffness and necessary locking arrangements including 1 coat of redoxide priming cost and conveyance of all materials and labour etc., complete as per standard specifications. |
| 56 | Supply and fixing of Cuddapah slabs of 38/40mm thick over the existing flooring concrete laid in cement mortar 1:3 ( one cement and three sand), 20mm and pointing with the same black oxide mixed cement mortar including polishing etc., complete |
| 57 | White washing two coats using best shell lime including cost and conveyance of all materials and labour charges etc., complete as per standard specifications. |
| 58 | Painting two coat over cement two plastered surface using cement paint of approved quality and colour including cost and conveyance of all materials and labour etc., complete as per standard specifications. |
| 59 | Painting two coat over new iron grill work using synthetic enamel paint of approved quality and colour including cost and conveyance of all materials and labour etc., complete as per standard specifications |
| 60 | Floor Plastering in Cement Mortor 1:4 (One cement four sand) 20mm thick including cost and conveyance of all materials and labour etc., complete as per standard specifications. |
| 61 | Wiring with 2x1.5 sqmm ( 22/0.3) PVC insulated unsheathed SC. Cu. Conductor of 1100 V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories with TW switch box with 5 A F.T switch inflush with wall, covered with hylum sheet of 3 mm thick with painting of suitable colour for open PVC light ( 6 points per coil ) ( For the rooms like Bath, Toilets & Pump rooms ).SD. 26 |
| 62 | Wiring with 2x1.5 sqmm ( 22/0.3) PVC insulated unsheathed SC. Cu. Conductor of 1100 V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories with 150x100x113 mm TW switch box for 5 A 3pin non interlocking CS plug with painting of suitable colour with continous earth connection of 14 SWG TC wire for open PVC plug point.SD. 36 |
| 63 | Supply and fixing of bulk head fitting with guard (Philips/Bajaj/Crompton/K.Lite) suitable for 11W CFL lamp CFL.(SD-83) Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Aug 05, 2026
11:30 IST
Tender Published
Tender notice published.
TodayAug 13, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 8 daysAug 13, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 8 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender