Tender For Repair To Fencing, Compound Wall, Hard Standing, Drain & Other Allied Work In Jcos/Ors Md Accn-Ii & Iii And Other Area Of Age Br-I Under Ge (North) Ambala Cantt
Tender Value
45 Lakhs
Estimated cost
Bid Submission
18 Aug 2026
17 days left
EMD
90000
Bank guarantee accepted
Document Fee
500
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Ambala → Haryana
EMD Exemption
Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Repair To Fencing, Compound Wall, Hard Standing, Drain & Other Allied Work In Jcos/Ors Md Accn-Ii & Iii And Other Area Of Age Br-I Under Ge (North) Ambala Cantt
BOQ
| Sl. No. | Item Description |
| 1 | Demolition of cement concrete (unreinforced) in ground floors and pavings not exceeding 15 cm thickness (below or above ground level) including removal the rubbish/ demolished material outside defence land, complete, all as specified and directed . |
| 2 | Material and labour machine pressed rubber moulded coloured precast concrete interlocking paver block, any shape and size conforming to IS 15658–2006 of 60 mm thickness, grade M–35 with grey cement and pigments over and including a layer of sand cushioning, 25 mm thick, complete all as specified and as directed. |
| 3 | Material and labour machine pressed rubber moulded precast coloured concrete interlocking paver block, any shape and size conforming to IS 15658–2006 of 80 mm thickness, grade M–40 with grey cement and pigments over and including a layer of sand cushioning, 25 mm thick, complete all as specified and as directed. |
| 4 | Supply and laying at or near ground level factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 (1 cement: 3 coarse sand), including making joints with or without grooves (thickness of joints except at sharp curve shall not to more than 5 mm), including making drainage ,complete all as specified and as directed. |
| 5 | Material and labour for providing PCC (1:4:8) Type D2 using 40mm graded crushed stone aggregate as in foundations, filling and mass concrete, complete all as specified and as directed. |
| 6 | Excavation in trenches, n exc 1.5 m wide and n exc 1.5 m in depth for foundation etc or for shafts, wells, manholes etc. n exc 10 sq m on plan and n exc 1.5 m in depth and getting out in soft/ loose soil ,complete all as specified and as directed . |
| 7 | Removing surplus excavated material to a distance n.exc 50m and depositing where directed at a level n.exc 1.5m above the starting point, complete all as specified and as directed . |
| 8 | Returning, filling in, including spreading, levlling ,watering and well ramming in layers not exceeding 25 mm thick each layer, complete all as specified and as directed . |
| 9 | Material and labour for plain cement concrete 1:3:6, type C-1 (using 20mm graded mechanically crushed stone aggregate), as in surface channels and drains ,complete, all as specified and as directed . |
| 10 | Material and labour for plain cement concrete 1:2:4, type B2 (using 40 mm graded mechanically crushed stone aggreagate), as in surface channels and drains complete all as specified and directed. |
| 11 | Material and labour for 8 to 10mm thick heavy duty vitrified coloured paver tiles of size 300mm x 300mm in floors etc set and jointed in neat cement slurry and pointed in white or coloured cement to match over and including 15mm thick screed bed in cement mortar (1:4) , complete all as specified and as directed. |
| 12 | Material and labour for 8 to 10mm thick heavy duty vitrified coloured paver tiles of size 600mm x 600mm in floors etc set and jointed in neat cement slurry and pointed in white or coloured cement to match over and including 15mm thick screed bed in cement mortar (1:4) , complete all as specified and as directed. |
| 13 | Dismantling dilapated /decayed posts or struts (wood, steel or R.C.C.) of any section /height, including taking out embedded portion, embedded in concrete /brick work /masonry /natural ground and each n exc 0.5 cum in volume below GL, getting out and removing surplus soil to a distance n exc 50 m and making good ,complete all as specified and as directed . |
| 14 | Dismantling of wire mesh fencing of any type/size and in any position, neatly coiled and removing from site, complete, all as specified and as directed . |
| 15 | Excavation in post holes (or similar holes) in soft/loose soil,each not exceeding 0.5 Cum, getting out and removing surplus soil to a distance not exceeding 50m and making good surface ,complete all as specified and as directed . |
| 16 | Material and labour for PCC (1:3:6), Type C-2, using 40mm graded crushed stone aggregate as in foundations, filling and mass concrete, complete, all as specified and as directed . |
| 17 | Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provision of binding wire complete, all as specified and as directed. |
| 18 | Supply only chain link MS galvanised fencing including any size and type to any type of standards, complete, all as specified and as directed . Note :-Weight of chain link fencing shall be ascertained by BOO as ordered by GE. |
| 19 | Material and labour for mild steel work in hand rails, half round or other stock section or core for wooden handrail straight portion, drilled and countersunk for balusters running bars, for doors, balusters, nosing to steps including embedding in concrete and screwing etc. wind ties for roof including securing bolts, posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc. flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc, and similar work conforming to Fe 290 Gde E-165, complete, all as specified and as directed. |
| 20 | Supply and fixing, as in repair, galvanized, 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails straining bolts, including, securing or tying at crossings with and provision of galvanized mild steel wire, staples or steel pins, etc. as directed (each line wire to be measured), complete, all as specified and as directed. |
| 21 | Material and labour for mild steel round bars of 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips quality conforming to Gd I, IS-432 Part I, complete all as specified and as directed. |
| 22 | Supply and fixing 5-10mm dia of shank mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, exc 5cm but n exc 10cm long ,complete all as specified and as directed . |
| 23 | Dismantling wrought iron or mild steel work of any description not otherwise provided for including gates , plates , fillets, grills, stiffener for securing chain link fencing including nuts, bolts, etc. complete, all as specified and as directed . |
| 24 | Material and labour for mild steel framed work as in framed work such as grills, gratings, etc.. with ends of bars shouldered and/or riveted, or forged into spikes, framed guard bars, barred iron doors, ladders, framed balusters, walk ways, railings, framework of water tanks, MS gates and similar work conforming to Fe.290.Gde-E-165 complete all as specified and directed |
| 25 | Material and labour for 16 to 18 mm thick granite (of any type) work (table rubbed and polished) in steps, jambs, pillars, window cills, cooking platforms and like in cement mortar (1:4) including pointing in white cement (1:2) using marble dust with admixture of pigment to match with shade of granite over and including 15mm thick rendering in cemet mortar (1:4), as in repair complete, all as specified and as directed . |
| 26 | Dismantling of brick work built in cement mortar or cement lime mortar including all quoins, arches, pillar, etc. but excluding ashlar facing, dressed stone work and precast concrete articles, complete all as specified and as directed. |
| 27 | Material and labour brick work with sub class 'B' old size bricks straight or curved on plan exceeding 6 metre mean radius built in cement mortar (1:4), complete all as specified and as directed . |
| 28 | All as per serial No. 27 here in before but except bricks (the old serviceable bricks as obtained from serial item No 26 here in before shall be used the rates includes removing motar, cleaning the bricks with water, etc), complete, all as specified and as directed . |
| 29 | Material & Labour brick work with sub class -B bricks, in half brick thick walls, built in cement moratr 1:4 straight or curved on plan to any radius , ,complete all as specified and directed. |
| 30 | Taking down cement or cement lime plaster of any description on brick or stone walls etc including racking out joints, hacking for key scrubbing down with water etc complete all as specified and as directed. |
| 31 | Material and labour rough cast plaster 15 mm thick in cement motar 1:4 complete as specified in SSR Part–I, clause 14.22 shall consisting of following:– firstly apply under coat in cement mortar 1:4 not less than 10 mm thick and while still it is in plastic state the rough cast mixture consisting of crushed stone or fine gravel agg. which is generally of size between 6 to 12 mm depending on texture required mixed with coarse sand and cement in the ratio 1:1:1 shall be applied, complete all as specified and as directed . |
| 32 | Material and labour for rendering 15 mm thick up to any height on any type of faces of brick work or concrete surfaces in cement mortar 1:4 and finished fair and even without using extra cement complete all as specified and as directed. |
| 33 | Prepation of new surfaces of steel any description over 10 cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and as directed. |
| 34 | Prepation of new surfaces of steel any description n. exc 10 cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and as directed . |
| 35 | Material and labour for preparation of new plastered /concrete surface of wall applying of two coats of cement base paint over a coat of primer complete all as specified and directed. |
| 36 | Material and labour preparation of old decorated brick/concrete, plastered /unplastered surfaces of walls, pillars cornices etc by brooming down with steel wire brushing, scrapping down smoke soot, moulds, moss and efflorescent salts and trading oil and greasy spots and applying one coat of cement base paint on the walls, pillars, cornices etc. up to height of triple storey bldg, including necessary scaffolding etc ,complete all as specified and as directed. |
| 37 | Note:- Amount of credit of Rs.46,430.00 for retrieved materials is mentioned in Schedule of Credit Page No.123 of tender documents in pdf form which will be deducted offline while acceptance of tender. Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Jul 28, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedAug 18, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 17 daysAug 20, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 19 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender