Tender For Certain Repairs To Area Drainage, Vertical Stacks, Manholes, Path Ways, Culverts, Compound / Security Wall, Fencing & Periodical Services To Compound / Security Wall / Fencing / Kerb Stones Etc Under Dgqa Under Aor Of Age Br North Under Ge
Tender Value
33.52 Lakhs
Estimated cost
Bid Submission
18 Aug 2026
1 days left
EMD
67040
Bank guarantee accepted
Document Fee
500
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Bengaluru Urban → Karnataka
EMD Exemption
Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Certain Repairs To Area Drainage, Vertical Stacks, Manholes, Path Ways, Culverts, Compound / Security Wall, Fencing & Periodical Services To Compound / Security Wall / Fencing / Kerb Stones Etc Under Dgqa Under Aor Of Age Br North Under Ge (North) Bangalore
BOQ
| Sl. No. | Item Description |
| 1 | Demolition of cement concrete reinforced in ground floor and paving n exc 15cm thick (below or above ground level) complete all as specified and directed. |
| 2 | M&L for Precast cement concrete 1:2:4 type B1 using 20 mm graded stone aggregate as in landings, cover slab (for manholes,drains etc) and similar work including necessary form work and set in CM 1:6 complete all as specified and directed. |
| 3 | Mild Steel TMT bar 6 to 8mm dia cut to length bent to shape required including cranking, bending spirally for hoping for columns hooking ends and binding with & including Mild Steel wire (annealed) not less than 0.9mm dia or securing with clips complete. |
| 4 | Demolition of cement concrete and paving not exc 15 cm thick (below or above ground level) complete all as specified and as directed. |
| 5 | Demolition of brick work or stone/boulder masonry built in cement mortar including all quoins, arches, pillars etc complete all as specified and directed. |
| 6 | Taking down cement plaster any description on brick or stone walls and including wall tiles etc including raking out joints, hacking for key, scrubbing down with water complete all as specified and directed. |
| 7 | M&L for PCC 1:3:6 type C2 using 40mm graded stone aggregate as in fixing of post/ drain foundation filling and mass concrete complete all as specified and directed. |
| 8 | M&L for Pre-cast cement concrete block masonry, Type C1 1:3:6 (20 mm graded stone aggregate) with solid blocks, exc. 10 cm in width and setting in mortar 1:4, complete etc complete all as specified and as directed.. |
| 9 | M&L for Pre-cast cement concrete block masonry, type C1 1:3:6(using 20mm graded stone aggregate) in CM 1:6 with solid blocks, exc 10cm in width and setting in mortar, complete. |
| 10 | M&L for removing old lime wash (if any), hacking for key, raking out joints of old brick work or stone work built in cement or cement lime mortar; not previously plastered; and scrubbing down with water etc. to receive plaster. |
| 11 | M&L Ashlar masonry, plain, well bonded, built in 1:6 of Cement mortar. |
| 12 | M&L for Struck pointing to block in course or ashlar masonry or concrete block walling with Cement mortar in 1:4 |
| 13 | M&L for rendering 15mm thick in CM 1:6 on other than fair faces of brick work or concrete surface finished even and smooth with out using extra cement complete all as specified and directed. |
| 14 | M&L for rendering 10 mm thick in CM (1:4) on fair faces of brick work or concrete surface finished even and smooth without using extra cement etc complete all as specified and as directed. |
| 15 | M&L for cement concrete 1:2:4 type, B0 using 12.5mm graded stone aggregates as in copings, Chajja / kerbs stone, roof padding / staging of water tank etc including necessary fromwork, weathering, slightly rounded or chamfered angles and throating complete all as specified and as directed. |
| 16 | Dismantling of Fencing posts or struts (wood, steel RCC) any section, posts embeded in cocrete, brick work, masonry etc, including taking out embeded portion and making good distrubed ground complete all as specified and as directed. |
| 17 | S & F mild steel works conforming to Fe 290 Gde E-165 as in angle iron post and struts in fencing incl cutting tops to shape as directed drilling holes notching for wire etc. incl all necessary drilling, bolting of riveting etc. etc complete all as specified and as directed. |
| 18 | Taking down existing chain link fencing, and S&F chain link fencing with size of mesh 50x50mm and thickness of wire 2.8mm, including fixing of line wires/flats, rails, straining bolts etc including provision of binding wires including dismantling of Chain link fencing , any type and mesh etc complete all as specified and as directed ( Supply of MS line wire and flat iron, bolt & nuts measured & paid separatly) complete all as specified and directed by Engineer-in-charge. |
| 19 | S&F in repairs Galvanised. 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails straining bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. as directed (each line wire to be measured) incl taking out existing barbed wire fencing. |
| 20 | Restraining, resecuring including making good Galvanised. 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails straining bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steelpins, etc. as directed (each line wire to be measured) incl taking out existing barbed wire fencing. |
| 21 | M&L for Preparation of new steel and iron surfaces of any description, N exc.10 cm in width or girth , not otherwise described and painting with two coats of synthetic enamel paint over a coat of red oxide primer etc complete all as specified and as directed. |
| 22 | M&L for Preparation of new steel and iron surfaces of any description, over 10 cm in width or girth, not otherwise described and painting with two coats of synthetic enamel paint over a coat of red oxide primer etc complete all as specified and as directed. |
| 23 | M&L for Mild steel round bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete. |
| 24 | M & L providing 75 mm thick cement concrete 1:3:6 type C-2 (using 40 mm graded crushed stone aggregate) as in subbase / plinth protection. |
| 25 | M & L providing 100mm thick cement concrete 1:4:8 type D-2 (using 40 mm graded crushed stone aggregate) as in subbase. |
| 26 | Demolition of existing chequered tiles including backing coat, providing Material and labour for providing, exterior grade, glossy finished, rubber pressed, designer Plain cement concrete chequered tiles, of size 30cm x 30cm x 25mm thick set, jointed and pointed in neat cement slurry with grey cement and pigment to match the shade / colour / matrix of tiles as in floor, over and including cement screed bed of 20 mm thick in CM 1:6. complete all as specified and as directed. |
| 27 | M&L for Sand filling under floors or in foundation including watering and consolidation complete all as specified and as directed. |
| 28 | Demolishing paver block tiles, and providing material and labour for, Rubber moulded pressed precast concrete interlocking paver block of any shape and size confirming to IS 15658-2006 of 60 mm thickness, M-35 Grade with grey cement and no pigments complete all as specified and as directed. |
| 29 | M&L for preparing new plastered surface of wall and applying two coat of cement base paint over a priming coat of white wash etc complete all as specified and as directed. |
| 30 | M & L For two coats of Anti fungal weather proof grade exterior acrylic emulsion paint of approved tint for old surface (Apex Ultima or equivalent brand as specified in CA) over a coat of weather proof primer including filling the minor racks etc with crack filling material all as per manufacturers instructions complete all as specified and as directed. |
| 31 | Preparation of old painted steel surfaces of any description exceeding 10 cm in width or girth and applying one coat of synthetic enamel paint complete all as specified and as directed. |
| 32 | Preparation of old treated plastered or unplastered wall surfaces of any description including brooming down with steel wire brushing scrapping down smoke soot’s, moulds, moss and efflorescence, salts, trading oil and greasy spots etc and applying one coat of cement base paint wash on wall surfaces all as specified and as directed. |
| 33 | Supply and fabrication including dismantling old steel as in framed work such as grills, gratings, ladders, balusters, walk ways, railing, etc.. with ends of bars shouldered and/or riveted, or forged into spikes; framework of water tanks and similar work con- forming to Fe.290.Gde-E-165 complete all as specified and as directed. |
| 34 | S&F framed work as in doors or gates including taking down old of angle or other sections with gusset plates, rails braces, etc complete drilled for fixing of steel sheeting or other covering, doors etc, to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings including pintle hinges, stops, hand-made sliding bolts, etc (enclusive of steel sheeting ) and hanging ; also fastening and fixing complete including painted with one shop coat of zinc chromate primer paint (including preparation of surface) at contractors workshop/factory before fabrication complete all as specied and directed. |
| 35 | S&F MS Work including taking down old of angle or other sections (Angle iron, Flat, Nut & bolt, square steel bars, steel rod etc ) as in angle iron post, gates, grills, hold fast, hand rails, wind ties for roofs, post or strut etc in fencing post including cutting tops to shape as directed: welding, drillingholes, notghing for wire, etc, angle iron, flat iron fillets ( for securing barbed wire and concertina coil ) including all necessary drilling, bolting or rivetting, etc and similiar works conforming to Fe-290 Gde E-165 including fabrication & fixing complete. |
| 36 | M & L two coats of synthetic enamel paint over a coat of red oxide zinc chrome primer after preparation of new or previously untreated steel surfaces of any description not otherwise described over 10cm width or girth. |
| 37 | M & L for 20 mm thick Granite (of any type) work (table rubbed and polished) in steps, jambs, pillars, window-cills, cooking platforms and like in cement mortar (1:4) including pointing in white cement (1:2) using marble dust with admixture of pigment to match with shade of granite ,including cutting and polishing laid on 15 mm thick screed bed in CM 1:4 set and jointed including dismantling of old stone slabs laid bedded and pointed in any mortar complete all as specified. |
| 38 | M & L for 20 mm thick Granite (of any type) work (table rubbed and polished) for wall lining in flat or curved (veneering to wall) 12mm thick in cement mortar (1:3) and pointing with white cement (1:2) using marble dust with admixture of pigment to match with shade of granite including cutting and polishing laid on 15 mm thick screed bed in CM 1:4 set and jointed including dismantling of old stone slabs laid bedded and pointed in any mortar complete all as specified. |
| 39 | M & L for Providing edge moulding to 18-20mm thick granite stone any description of counters vanities etc. including machine polishing to edge to give high gloss finish etc complete all as specified. |
| 40 | M & L for 5mm thick PVC sheet fillet of width 35mm for wall paneling inclusive of fixing on to wall to make PVC Frame as per specification and drawing complete all as specified. |
| 41 | M & L for 5mm thick Prelam PVC sheet in strips & channel feathered at the edges for fixing on Solid PVC Wall Lining, Insulated PVC Wall Lining, and Solid PVC Partitions inclusive of Solvent Cement and fixing at site including dismantling of old wall boarding including cover fillet complete all as specified. |
| 42 | S & F in repair 75 mm dia bore PVC (SWR) pipes single socketed in any length with rubber ring joints fixed to walls including necessary fittings all as specified and as directed. |
| 43 | S & F in repair 110 mm dia bore PVC (SWR) pipes single socketed in any length with rubber ring joints fixed to walls including necessary fittings all as specified and as directed. |
| 44 | S&F in repair 75mm dia PVC (SWR) Bends with access door of any radius |
| 45 | S&F in repair 110mm dia PVC (SWR) Bends with access door of any radius |
| 46 | S&F in repair 75mm dia PVC (SWR) junction single (single T) equal or unequal with access door |
| 47 | S&F in repair 110mm dia PVC (SWR) junction single (single T) equal or unequal with access door |
| 48 | S&F in repair 75mm dia PVC(SWR) brach piece, single (single Y) equal or un equal with access door |
| 49 | S&F in repair 110mm dia PVC(SWR) brach piece, single (single Y) equal or un equal with access door |
| 50 | S&F in repair 75mm dia PVC(SWR) brach piece, (double Y) equal or un equal with access door |
| 51 | S&F in repair 110mm dia PVC(SWR) brach piece, (double Y) equal or un equal with access door |
| 52 | S&F in repair 75mm dia PVC(SWR) vent cowl |
| 53 | S&F in repair 110mm dia PVC(SWR) vent cowl Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Jul 28, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedAug 18, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 1 dayAug 20, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 3 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender