Tender For Cleaning Of Sewage Line, Manholes And Septic Tanks And Other Misc Repairs To Upkeep The Hygienic Conditions Of The Area Of Dgqa Under Aor Of Age Br North Under Ge (North) Bangalore
Tender Value
35 Lakhs
Estimated cost
Bid Submission
18 Aug 2026
13 days left
EMD
70000
Bank guarantee accepted
Document Fee
500
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Bengaluru Urban → Karnataka
EMD Exemption
Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Cleaning Of Sewage Line, Manholes And Septic Tanks And Other Misc Repairs To Upkeep The Hygienic Conditions Of The Area Of Dgqa Under Aor Of Age Br North Under Ge (North) Bangalore
BOQ
| Sl. No. | Item Description |
| 1 | Mechanically pumping out sewage liquid from septic tanks of any size and depth and removal the same to distance/place as earmarked by state auth out side defence land including any type of T & P required etc. dewatering of water complete all as directed. |
| 2 | Removing carefully the cover slabs of man holes of any size and shape and removing the scum/sludge including any organic or inorganic matters to a distance exc 50m and not exc 1500m and deposting eco friendly where as directed by engineer-in-charge and setting the man hole cover in position in CM (1:6 ) after cleaning the sludge upto 1.50mtr depths of manholes Note: Manhole cover if provided new shall be measured & paid separately. |
| 3 | All as per item No 2 but depth of manhole exc 1.5m but n.exc 3.00mtr |
| 4 | All as per item No 2 but depth of manhole exc 3.00m but n.exc 4.00mtrNote:-(a) Contractor shall detail his supervisor to office of AGE B/R North daily by 9.00 AM who will report to concerned JE B/R /Engineer-in-Charge to receive all complaints of entire area under this contract.(b) Contractor shall provide service providers (sweepers) both the complaint cell located at (DGQA,DIQA & Gunatha vihar) as per the complaints list given alongwith all requisite tools, equipments, including safely measures for attending complaint and ensure completion report by 5.00 PM same day.(c) Please note that all the complaints relating to sewage line shall be attended within same day (within 12 hour). In case of blockage in sewage line could not be detacted/completed same day and concerned JE / Engineer-in-Charge is satisfied to the efforts applied but the same shall be attended and all blockage must be cleared by 24 hours (next day by 5.00 PM) without fails.(d) In case any complaint pertaining to clearing of blockage in sewage line is not removed /cleared within 24 hours (next day 5.00 PM). A penalty @ Rs. 200/- per complaint shall affected from contractor payments.(e) Blockage cleared between two man holes irrespective of length in between shall be treated as one complaint. |
| 5 | Cleaning of blocked sewage drain pipe 110mm dia till the flow of sewage/sludge water is smooth including taking out all sludge/mud from pipes by means of mechanically by pressure vehicle or roding & remove to a distance exc 50m and n.exc 1500m and depositing eco friendly where as directed by engineer in charge. following size of pipes:- |
| 6 | All as per item No 5 but internal Dia of the Pipe 150mm |
| 7 | All as per item No 5 but internal Dia of the Pipe 200mm |
| 8 | All as per item No 5 but internal Dia of the Pipe 300mm |
| 9 | Clearing & removal of blockage, of any type in WC, bathroom, kitchen including floor/nahani traps, soil waste/vent pipes gully trap upto 1st manhole, in any situation by way of cleaning / desludging and removing foreign materials to a place as earmarked by state auth out side the defence land to the entire satisfaction of engineer-in-charge. |
| 10 | Excavation in trenches not exceeding 1.5m wide and not exceeding 1.5m depth for foundation etc or for shafts, wells cesspits manholes pier holes etc not exceeding 10 sqm on plan and not exceeding 1.5m depth in hard / dese soil etc complete all as specified and directed |
| 11 | Demolition and breaking up drain pipe (salt glazed ware, AC or reinforced concrete) set in cement mortor for 150 mm internal dia of pipe complete all as specified and directed. |
| 12 | Demolition and breaking up drain pipe (salt glazed ware, AC or reinforced concrete) set in cement mortor for 200 mm internal dia of pipe complete all as specified and directed. |
| 13 | Demolition and breaking up drain pipe (salt glazed ware, AC or reinforced concrete) set in cement mortor for 300 mm internal dia of pipe complete all as specified and directed. |
| 14 | M&L for cement concrete bed to drain pipes including packing under and haunching against the sides of pipe after they are laid & tested for 150 mm bore of pipe with cement concrete 1:4:8 type D-2 using 40mm graded stone aggregate complete all as specified and directed. |
| 15 | M&L for cement concrete bed to drain pipes including packing under and haunching against the sides of pipe after they are laid & tested for 200 mm bore of pipe with cement concrete 1:4:8 type D-2 using 40mm graded stone aggregate complete all as specified and directed. |
| 16 | M&L for cement concrete bed to drain pipes including packing under and haunching against the sides of pipe after they are laid & tested for 200 mm bore of pipe with cement concrete 1:4:8 type D-2 using 40mm graded stone aggregate complete all as specified and directed. |
| 17 | M&L for laying DWCP 150 mm dia pipes in trenches Class SN-4 conforming to IS 16098 (Part -2) in 6 mtr length with coupler complete all as specified and directed by Engr-in-charge |
| 18 | M&L for laying DWCP 200 mm dia pipes in trenches Class SN-4 conforming to IS 16098 (Part -2) in 6 mtr length with coupler complete all as specified and directed by Engr-in-charge |
| 19 | M&L for laying DWCP 300 mm dia pipes in trenches Class SN-4 conforming to IS 16098 (Part -2) in 6 mtr length with coupler complete all as specified and directed by Engr-in-charge |
| 20 | M&L for Cutting into existing manholes for connecting new drains, making good to pipe and rendering, cutting out existing benching for and forming branch channel (½ round or ¾ section) in cement concrete 1:2:4 type B-1 smooth finished ,and reforming benching as required for 150 mm internal dia of pipe complete all as specified and directed. |
| 21 | M&L for Cutting into existing manholes for connecting new drains, making good to pipe and rendering, cutting out existing benching for and forming branch channel (½ round or ¾ section) in cement concrete 1:2:4 type B-1 smooth finished ,and reforming benching as required for 200 mm internal dia of pipe complete all as specified and directed. |
| 22 | Demolition of cement concrete reinforced in ground floor and paving n exc 15cm thick (below or above ground level) complete all as specified and directed. |
| 23 | M&L for Precast cement concrete 1:2:4 type B1 using 20 mm graded stone aggregate as in landings, cover slab (for manholes etc) and similar work including necessary form work and set in CM 1:6 complete all as specified and directed. |
| 24 | Mild Steel TMT bar 6 to 8mm dia cut to length bent to shape required including cranking, bending spirally for hoping for columns hooking ends and binding with & including Mild Steel wire (annealed) not less than 0.9mm dia or securing with clips complete. |
| 25 | Taking down cement plaster any description on brick or stone walls and including wall tiles etc including raking out joints, hacking for key, scrubbing down with water complete all as specified and directed. |
| 26 | Demolition of brick work or stone/boulder masonry built in cement mortar including all quoins, arches, pillars etc complete all as specified and directed. |
| 27 | M&L for Pre-cast cement concrete block masonry, Type C1 1:3:6 (20 mm graded aggregate) with solid blocks, exc. 10 cm in width and setting in mortar 1:4, complete etc complete all as specified and as directed |
| 28 | Demolition of cement concrete and paving not exc 15 cm thick (below or above ground level) complete all as specified and as directed. |
| 29 | M&L for PCC 1:4:8 type D2 using 40mm graded stone aggregate as in foundation filling and mass concrete complete all as specified and directed. |
| 30 | M&L for PCC 1:2:4 type B-2 using 40 mm graded stone aggregate as in surface channels and drains complete all as specified and directed. |
| 31 | M&L for cement concrete 1:2:4 type, B0 using 12.5mm graded stone aggregates as in lintels upto 1.5m clear span, cills, steps; seismic and other similar bands, plinth courses, string courses, lacing courses, parapets and railings upto 60 cm in height, copings, kneelers, apex stones, bed plates, kerbs including necessary fromwork, weathering, slightly rounded or chamfered angles and throating complete all as specified and as directed |
| 32 | M&L for rendering on fair faces of brick work or concrete surface of wall 15mm thick in CM 1:4 mixed water proofing compound as per mfd instruction to be finished even and smooth with out using extra cement complete all as specified and directed Notes :WPC shall be meased and paid sepeartely |
| 33 | M&L for rendering 10 mm thick in CM (1:4) on fair faces of brick work or concrete surface finished even and smooth without using extra cement etc complete all as specified and as directed |
| 34 | Supply only water proofing compound (Liquid) complete all as specified and as directed. |
| 35 | M&L Extra for forming fair finished drain or channel 40 cm inner girth in cement concrete, using extra cement, including forms, moulds, mitred / stopped ends etc complete all as specified and directed. |
| 36 | Dismantling of stone slabs and tiles laid dry or laid dry and pointed of any description or thickness in floors, aprons etc. |
| 37 | M & L providing 100mm thick cement concrete 1:4:8 type D-2 (using 40 mm graded crushed stone aggregate) as in subbase. |
| 38 | M&L for Sand filling under floors or in foundation including watering and consolidation complete all as specified and as directed. |
| 39 | M&L for Machine pressed precast concrete interlocking paver block with grey cement and pigments any shape and size confirming to IS 15658-2006 of 60mm thickness, M-35 Grade complete all as specified and as directed. |
| 40 | Returning, filing in, excavated soil including spreading, levelling, watering and well ramming in layers not exceeding 25cm etc complete all as specified and directed |
| 41 | M&L for rubber Moulded Pre-cast Kerb stones of cement concrete Type B-1 1:2:4 (with using 20mm graded stone aggregates) factory made, size, shape, pattern and finished as approved, including rounding, chamfered or half round and bedded of perfectly leveled surface pointed and jointed in CM 1:4 including fixing etc complete all as specified and a as directed |
| 42 | M&L for preparing new concrete surface (Kerb Stone) and applying two coat of synthetic enamel paint over a coat of primer etc complete all as specified and as directed |
| 43 | Removal of excavated materials not exceeding 50 m and depositing where directed at a level not exceeding 1.5 m above the starting points etc complete all as specified and directed |
| 44 | Dismantling wrought iron or mild steel work of any description not otherwise provided for |
| 45 | M&L for rolled sections as in main and cross beams, hip and jack rafters; purlins where connected to common rafters and running rails and guides for sliding doors; fixed with angle cleats or other connecting plates |
| 46 | M & L applying two coats of synthetic enamel paint over a coat of red oxide primer on steel surfaces over 10 cm width or girth including preparation of new steel surfaces |
| 47 | S&F Pre- painted galvalume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws including dismantling of sheet of any type and any thickness complete all as specified and directed. |
| 48 | S&F Pre-painted galvalume aluminum zinc coating GI based Plain steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws including dismantling of sheet of any type and any thickness complete all as specified and directed. Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Jul 28, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedAug 18, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 13 daysAug 20, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 15 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender