Tender For Special Repairs/Replacement Of 2 Mt Goods Lift And Its Comprehensive Maintenance At Nsd Under Ge (Navy) Chennai
Tender Value
70.75 Lakhs
Estimated cost
Bid Submission
27 Aug 2026
3 days left
EMD
1.31 Lakhs
Bank guarantee accepted
Document Fee
1000
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Chennai → Tamil Nadu
EMD Exemption
Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Special Repairs/Replacement Of 2 Mt Goods Lift And Its Comprehensive Maintenance At Nsd Under Ge (Navy) Chennai
Corrigendum
| Sr No | Corrigendum Date | Corrigendum | Type | New Submission Date |
|---|---|---|---|---|
| 1 | 14-Aug-2026 | Date2 | Date | 27-Aug-2026 |
| 2 | 12-Aug-2026 | BOQ | BOQ | 27-Aug-2026 |
| 3 | 12-Aug-2026 | DATE | Date | 22-Aug-2026 |
| 4 | 12-Aug-2026 | BOQ | BOQ | 22-Aug-2026 |
| 5 | 12-Aug-2026 | DATE | Date | 22-Aug-2026 |
BOQ
| Sl. No. | Item Description |
| 1 | Phase-I Sch A Part I- B/R portion |
| 2 | Material and Labour for machine cut pre-polished Kota stone slab in single piece , 18-20 mm thick with round nosing and three numbers of serration as in treads of steps for staircase laid over cement screed base 15 mm thk in 1:6 , laid and jointed with grey cement slurry mixed with pigment to match the shade of the slab including grinding, rubbing and polishing (granite finish) the exposed edges complete all as specified and as directed. |
| 3 | Material and Labour for machine cut pre-polished Kota stone slab 15-18 mm thick (single piece in riser of steps) in vertical surfaces such as risers of steps, skirting, dado over cement screed base 10mm thick in CM 1:4 laid and jointed with grey cement slurry mixed with pigment to match the shade of the slab including grinding, rubbing and polishing complete all as specified and as directed. |
| 4 | Taking down cement plaster on brick or concrete stone walls/ceilings etc. including raking out joints hacking for key scrubbing down with water etc. complete all as specified and as directed. |
| 5 | Material and Labour for 15mm thick rendering in CM 1:6 on fair face of brick work or concrete surface finished even and smooth with out using extra cement complete all as specified and directed. |
| 6 | Material and Labour for 10mm thick rendering in CM 1:3 on soffits of ceiling finished even and smooth with out using extra cement complete all as specified and directed. |
| 7 | Material and Labour for preparation of new plastered wall/concrete surfaces and applying two coats of oil bound distemper over a coat of primer and 3mm thick wall care putty complete all as specified and as directed. |
| 8 | Material and labour for preparation of newly plastered surfaces of ceiling and applying three coats of white wash all as specified and as directed. |
| 9 | Material and labour for preparation of old decorated surfaces of ceiling and applying two coats of white wash all as specified and as directed. |
| 10 | Material and labour for fixing Granite (of any type) , 20mm thick (table rubbed and polished) in steps, jambs, pillars, window calls, cooking platforms and like in cement mortar (1:4) including pointing in white cement (1:2) using marble dust with admixture of pigment to match with shade of granite over a including a screed bed 15 mm thick in CM (1:6), complete all as specified and directed. |
| 11 | Material and labour for engraving grooves in granite stone surfaces for design purpose and applying two coats of golden colour paint over a coat of primer as directed by Engr-in-charge. |
| 12 | Sch A Part I- E/M portion |
| 13 | Taking down 2 Metric Ton Goods Lift serving G+ 02 floors with connected cables & controls after disconnecting electric supply from electric sources without damaging any other equipments and making good matching with existing surface complete and including transportation of old unserviceable lift to MES store yard with all accessories. Before disconnecting/ taking down, the inventory of the goods lift and connected cables, Control, Motors, gears, ropes with starters are to be prepared and submitted to Engineer-in-charge before disconnecting the same. |
| 14 | Design, supply, installation, testing & commissioning of goods lift 2MT , speed 0.5 metre/sec with single speed motor, 415 volts, 3 phase AC 50 Hz supply, conforming to IS-14665 and as amended, suitable to serve G+02 upper floors with AC Variable Voltage & Variable Frequency Drive (VVVF drive) complete with all standard accessories, simplex automatic & manual dual controlled operation with/without attendant, centre opening doors with door drive (electric motor driven mechanism), sliding stainless steel doors, automatic rescue device (ARD) system, 3D infra red sensor in full height of door & built in announcing system without hand set (03 Nos, one each in car, Machine room & near Ground floor landing door) complete all as specified.Note :- The rate quoted shall be Including the rate for comperhensive maintenance period for two years after completion of the work.ie during defect liability period Please Enable Macros to View BoQ information |
| 15 | Design, supply, installation, testing & commissioning of goods lift 2MT , speed 0.5 metre/sec with single speed motor, 415 volts, 3 phase AC 50 Hz supply, conforming to IS-14665 and as amended, suitable to serve G+02 upper floors with AC Variable Voltage & Variable Frequency Drive (VVVF drive) complete with all standard accessories, simplex automatic & manual dual controlled operation with/without attendant, centre opening doors with door drive (electric motor driven mechanism), sliding stainless steel doors, automatic rescue device (ARD) system, 3D infra red sensor in full height of door & built in announcing system without hand set (03 Nos, one each in car, Machine room & near Ground floor landing door) complete all as specified.Note :- The rate quoted shall be Including the rate for comperhensive maintenance period for two years after completion of the work.ie during defect liability period Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Aug 14, 2026
11:30 IST
Tender Published
Tender notice published.
Completed
Aug 27, 2026
18:00 IST
Corrigendum-1 Issued
Clarifications on tender conditions and amendments issued.
Upcoming · 3 days
Aug 27, 2026
18:00 IST
Corrigendum-2 Issued
Clarifications on tender conditions and amendments issued.
Upcoming · 3 days
Aug 22, 2026
18:00 IST
Corrigendum-3 Issued
Clarifications on tender conditions and amendments issued.
Completed
Aug 22, 2026
18:00 IST
Corrigendum-4 Issued
Clarifications on tender conditions and amendments issued.
Completed
Aug 22, 2026
18:00 IST
Corrigendum-5 Issued
Clarifications on tender conditions and amendments issued.
CompletedAug 27, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 3 daysAug 29, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 5 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender