Tender For annual repair & maintenance of To Residential Building Under Sub-Division No-V,Shimla Division No-Iii (S/H:- Painting And Distempring,Repair Of Cup Board,Tiles Works, And Toilets Of Set No-6 Block -A Type Iv At Barnes Court Shimla-2)
Tender Value
Ref. Documents
Estimated cost
Bid Submission
25 Jul 2026
4 days left
EMD
4250
Bank guarantee accepted
Document Fee
350
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Shimla → Himachal Pradesh
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for annual repair & maintenance of To Residential Building Under Sub-Division No-V,Shimla Division No-Iii (S/H:- Painting And Distempring,Repair Of Cup Board,Tiles Works, And Toilets Of Set No-6 Block -A Type Iv At Barnes Court Shimla-2)
BOQ
| Sl. No. | Item Description |
| 1 | Demolishing cement concrete manually/ by mechanical means including disposal of material within 50 metres lead as per direction of Engineer - in - charge. Nominal concrete 1:3:6 or leaner mix (i/c equivalent design mix) |
| 2 | Dismantling old plaster or skirting raking out and cleaning the surface for plaster including disposal of rubbish to the dumping ground within 50 metres lead. |
| 3 | Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level 1:3:6(1 cement : 3 coarse sand) : 6 graded stone aggregate 20 mm nominal size) |
| 4 | 15 mm cement plaster on rough side of single or half brick wall of mix:1:6 (1 cement: 6 coarse sand) complete including carriage of material within all leads and lifts.. |
| 5 | Providing and laying vitrified floor tiles in different sizes (thickness to be specified by the manufacturer) with water absorption less than 0.08% and conforming to IS: 15622, of approved make, in all colours and shades, laid on 20mm thick cement mortar 1:4 (1 cement : 4 coarse sand), jointing with grey cement slurry @ 3.3 kg/ Per Square meter including grouting the joints with white cement and matching pigments etc., 600 x 600mm |
| 6 | Providing and laying full body Vitrified tiles in different sizes (thickness to be specified by manufacturer), with water absorption less than 0.08 % and conforming to I.S. 15622, of approved make, in all colours & shade, in skirting, riser of steps, over 12 mm thick bed of cement mortar 1:3 (1 cement: 3 coarse sand), jointing with grey cement slurry @ 3.3 kg/ sqm including grouting the joint with white cement & matching pigments etc. complete Size of Tile 600x600 mm. complete including carriage of materials within all leads and lifts as per direction of Engineer-in -charge |
| 7 | Providing and laying ceremic floor tiles of approved size, shade,design and quality in flooring, treads of steps and landing laid on a bed of 12mm thick cement mortar 1:3 (1 cement: 3 sand) laid over and jointed with neat cement slurry finished with flush pointing in white cement mixed with pigment of required shade to match the shade of tiles complete including carriage of materials in all leads and lifts. |
| 8 | Providing and fixing 9mm thick water proof kit ply of standard quality ISI mark and approved shade and colour in panelling & wall linning i/c mitring at junctions, butt jointing and nails complete (Frame work for base to be measured & paid for separately) including carriage of materials within all leads and lifts |
| 9 | Providing and fixing 19mm thick water proof commercial board in shelves/box for cup board with butt joints & fixing with nails & screws etc complete) |
| 10 | Providing and fixing 19mm thick Commercial Board shutters for up boards i/c fixing with nickel plated piano hinges with screws etc complete) including carriage of materials within all leads and lifts |
| 11 | Providing and fixing 1.00 mm thick coloured or plain lamination sheet (sunmica) on boards/ply wood sheets with approved adhesive and nails etc complete including carriage of materials within all leads and lifts. |
| 12 | Providing and fixing hard wood square edges cover fillets (beading) 19mmx6mm section i/c mitring at junctions with wood screws and nails complete including carriage of materials within all leads and lifts |
| 13 | Providing and fixing bright finished brass handles with screws etc.complete including carriage of material in all leads and lifts 100mm |
| 14 | Providing and fixing magnetic catcher of approved quality in cupboard / ward robe shutters, including fixing with necessary screws etc. complete. including carrage of material in all leads and lifts. |
| 15 | Providing and fixing Ess-Ess Curtain rod 25mm dia with brackets,end firnels and required number of curtain rings with screws etc.complete including carriage of material in all leads and lifts and as per the direction of the Engineer-in-Charge. |
| 16 | Removing dry or oil bound distemper, water proofing cement paint and the like by scrapping, sand papering and preparing the surface smooth including necessary repairs to scratches etc. complete including carriage of material in all leads and lifts |
| 17 | Providing and applying white cement based putty of average thickness 1 mm, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete. |
| 18 | Wall painting with plastic emulsion paint of approved brand and manufacture to give an even shade one or more coats on old work complete including carriage of materials within all leads and lifts |
| 19 | Painting wood work with Deluxe Multi Surface Paint of required shade. Two or more coat applied @ 0.90 ltr/10 sqm over an under coat of primer applied @0.75 ltr/10 sqm of approved brand and manufacture including carriage of materials within all leads and lifts |
| 20 | Painting with synthetic enamel paint on wood of approved brand and manufacture of required colour to give an even shade One or more coats on old work including carriage of materials within all leads and lifts |
| 21 | Painting Steel with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade.one or more coats on old work. including carriage of materials within all leads and lifts. |
| 22 | Polishing one or more coats with malamine polish of required shade on old wood and stone based surfaces to give an even surface including cleaning the surface of all dirt, dust and sand papered smooth and including a coat of wood filler.complete including carriage of materials within all leads and lifts. |
| 23 | Providing and fixing Single piece white vitreous china pedestal type water closet (European type W.C. pan) with seat and lid, 10 litre low level white P.V.C. flushing cistern, including flush pipe of Cat no.- S1013178 with manually controlled device (handle lever), conforming to IS : 7231, with all fittings and fixtures complete, including cutting and making good the walls and floors wherever required :W.C. pan with ISI marked white solid plastic seat and lid |
| 24 | Providing and fixing 15mm dia C.P.brass Angle cock of approved quality including carriage of materials within all leads and lifts. |
| 25 | Providing and fixing 15mm nominal Bib Tap Long body of approved quality complete including carriage of materials within all leads and lifts. |
| 26 | Providing and fixing CP waste coupling 32mm Dia for wash basin complete including carriage of materials in all leads and lift as per direction of Engineer in Charge. Cat no 4921 including carriage of materials within all leads and lifts. |
| 27 | Providing and fixing 15mm nominal bore C.P. brass Sink mixer of ESS Ess conforming to IS:complete including carriage of materials within all leads and lifts. |
| 28 | roviding and fixing Ess-Ess. Central hole basin mixer without pop-up waste system with 15 mm long flexible hose including carriage of materials within all leads and lifts. |
| 29 | Providing and fixing uplasticised PVC connection pipe with brass unions 45 cm length 15 mm dia complete including carriage of materials within all leads and lifts |
| 30 | Providing and fixing 32mm dia P.V.C. waste pipe for sink or wash basin including P.V.C. waste fittings complete Semi rigid pipe complete including carriage of materials in all leads and lifts |
| 31 | Providing and fixing towel rail complete with brackets fixed to wooden cleats with CP brass screws with concealed fittings arrangement of approved quality and colour. ESS ESS made AC-101 |
| 32 | Providing and fixing towel ring complete with brackets fixed to wooden cleats with CP brass screws with concealed fittings arrangement of approved quality and colour. ESS ESS made AC-502 |
| 33 | Providing and Fixing Acrylic Corner With 3 Nos Shelves including fittings complete .including carriage of materials within all leads and lifts. |
| 34 | Providing and fixing SOAP DISH complete with brackets fixed to wooden cleats with CP brass screws with concealed fittings arrangement of approved quality and colour.ESS-ESS catlogue no .series-4 victorian AC-403 |
| 35 | Providing and fixing grating of approved quality and colour. including carriage of materials within all leads and lifts as per direction of the Engineer - in - charge.Circular type 100mm nominal dia |
| 36 | Providing and fixing G.I/M.I. extension nipple for water tank pipe, fittings of approved quality and colour.complete including carriage of materials in all leads and lift as per direction of Engineer in Charge. 15mm nominal size. |
| 37 | Providing and fixing CP flange of approved quality conforming to IS:8931 :-15 mm nominal bore including carriage of materials within all leads and lifts |
| 38 | Providing and fixing C.P.brass two in one angle cock of approved quality conforming to 15 mm nominal bore including carriage of materials within all leads and lift. |
| 39 | Providing and Fixing of CP.brass han Jet with pipe 1.5 Mtr. With Hook of approved brand including carriage of materials within all leads and lifts. |
| 40 | Providing and fixing high flow divertor for over head shower of approved quality complet including carriage of materials in all leads and lifts |
| 41 | Providing and fixing KUBIX Wall mixer with bend KUP-CHR cat no :- DN 10 N including carriage of materials within all leads and lifts. |
| 42 | Disposal of moorum/ building rubbish/ malba. Similar unserviceable , dismantled or waste material by mechanical transport including loading, Transporting, unloading to approved Monicipal dumping ground for lead upto 10km. Foe lalleafts, complete as per dierection of Engineer- in Charge.Note:-Item to be applicable in urban area having directions for restricted hours movement/ plying of load carring motor vehicle of 3.5 cum. or More. |
| 43 | Providing and fixing 600x450 mm beveled edge mirror of superior glass (of approved quality) complete with 6 mm thick hard board ground fixed to wooden cleats with C.P. Brass screws and complete including carriage of materials within all leads and lifts Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Jul 18, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedJul 25, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 4 daysJul 25, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 4 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender