Tender For Repairs To Boundary Wall, Fencing, Compound Wall, Area Drainage And Hard Standing At Dsc Records, Mh, Pao (Ors) And Mes Area Kannur Under Ge (Army) Trivandrum
Tender Value
27 Lakhs
Estimated cost
Bid Submission
25 Jul 2026
2 days left
EMD
54000
Bank guarantee accepted
Document Fee
500
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Kannur → Kerala
EMD Exemption
Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Repairs To Boundary Wall, Fencing, Compound Wall, Area Drainage And Hard Standing At Dsc Records, Mh, Pao (Ors) And Mes Area Kannur Under Ge (Army) Trivandrum
BOQ
| Sl. No. | Item Description |
| 1 | Demolition of brick work or stone / boulder masonry, built in cement or lime mortar including all quoins, arches, pillars, etc but excluding ashlar facings, dressed stonework and precast concrete articles including removal of debris from site complete all as specified and directed |
| 2 | M&L for laterite stone masonry exceeding 10 cm in width, built in CM (1:6) all as specified and directed. |
| 3 | Taking down cement or cement lime plaster on concrete or brick/stone walls incl raking out joints hacking for key scrubbing down with water etc and removing rubbish outside MD land complete all as specified and directed. |
| 4 | M&L for rendering 15mm thick in cement mortar (1:6) on fair faces of stone masonry surfaces, finished even and smooth without using extra cement complete all as specified and directed. |
| 5 | M&L for rendering 10mm thick in cement mortar (1:4) on fair faces of stone masonry surfaces, finished even and smooth without using extra cement complete all as specified and directed. |
| 6 | M&L cement concrete 1:2:4 type B-1 (using 20mm graded stone aggregate) as in coping, benching, bands, seismic and other similar bands, including weathering, slightly rounded or chamfered angles and throating etc including necessary form work complete all as specified and directed. |
| 7 | M&L for preparing new plastered surface of walls and applying Two or more coats of 100% Premium acrylic emulsion paint having VOC less than 50 gm/litre and UV resistance as per IS 15489:2004, Alkali & fungal resistance, dirt resistance exterior paint of required shade (Company Depot Tinted) with silicon additives @ 1.43 litre/ 10 sqm over and including priming coat of exterior primer applied @ 0.90 litre/ 10 sqm complete all as specified and directed. |
| 8 | M&L for complete removal of existing old treatment from external wall surfaces, removing nails, etc. filling cracks, holes with putty and applying two or more coats of 100% Premium acrylic emulsion paint having VOC less than 50 gm/litre and UV resistance as per IS 15489:2004, Alkali & fungal resistance, dirt resistance exterior paint of required shade (Company Depot Tinted) with silicon additives @ 1.43 litre/ 10 sqm over and including priming coat of exterior primer applied @ 0.90 litre/ 10 sqm over 1mm thick external wall putty complete all as specified and directed. |
| 9 | Dismantling wrought iron or mild steel work of any description not otherwise provided for complete all as specified and directed |
| 10 | S&F mild steel work in framed work such as grills, gratings, etc. with ends of bars shouldered and/or riveted, or forged into spikes; framed guard bars; barred iron doors; ladders; framed balusters; walk ways; railings; framework of water tanks and similar work conforming to Fe.290.Gde-E-165 complete all as specified and directed |
| 11 | M&L preparation of new surfaces or previously untreated surfaces of steel and iron work of any description over 10 cm width or girth with applying two coats of synthetic enamel paint over one coat of red oxide zinc chrome primer etc complete all as specified and directed. |
| 12 | Dismantling barbed wire of any size and dia complete all as specified and directed. |
| 13 | S&F Galvanised 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacing and straining and fixing to any type of standard rails straining bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. complete all as specified and directed.Note : Each line wire to be measured separately |
| 14 | Fixing only Galvanised 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacing and straining and fixing to any type of standard rails straining bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. complete all as specified and directed (Each line wire to be measured separately) Note : This item will be issued under Schedule 'B' |
| 15 | Dismantling fencing wire mesh of any type complete all as specified and directed. |
| 16 | Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provision of binding wire complete all as specified and directed.Note: This item will be issued under Schedule 'B' |
| 17 | Demolition of cement Concrete (unreinforced) in ground floors and pavings not exceeding 15 cm thickness (below or above ground level) and remove rubbish off the premises complete all as specified and as directed. |
| 18 | M&L for PCC 1:4:8, type D2 using 40mm graded crushed stone aggregate as in filling, foundation and mass concrete complete all as specified and directed. |
| 19 | M&L for precast cement concrete block masonry type C1 with solid blocks, exceeding 10cm in width and setting in cement mortar 1:6 complete all as specified and directed. |
| 20 | M&L for PCC 1:3:6, type C2 using 40mm graded stone aggregate as in surface channels and drains complete all as specified and directed. |
| 21 | Extra for forming fair finished drain or channel 30 cm inner girth in cement concrete, using extra cement, including forms, moulds, mitered/stopped ends etc. complete all as specified and directed.Note : Inner girth only measured. |
| 22 | M&L for rendering 15mm thick in cement mortar (1:6) on fair faces of brickwork or concrete surfaces, finished even and smooth without using extra cement complete all as specified and directed. |
| 23 | Demolition of cement concrete (reinforced) of any description and in any position not otherwise specifically provided for complete all as specified and directed. |
| 24 | M&L for precast cement concrete 1:2:4, type B1 (using 20mm graded aggregate) in cover slab and setting in cement mortar 1:6, match the joints complete all as specified and directed. |
| 25 | S&F TMT steel bars 10mm dia and over as in reinforcement, cut to length, bent to shape required including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.90 mm dia or securing with clips complete all as specified and directed. |
| 26 | Dismantling stone slabs and tiles of any description or thickness in floors, aprons etc laid, bedded and pointed in any mortar complete all as specified and directed. |
| 27 | M&L for 75mm thick PCC 1:4:8, type D2 using 40mm graded stone aggregate as in floor or similar work complete all as specified and directed. |
| 28 | Providing and laying 60mm thick factory made chamfered edge cement concrete paver block of M-35 grade with approved colour, design & pattern as in footpath, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand; complete all as specified and directed. |
| 29 | M&L for rendering 15mm thick in cement mortar (1:6) on fair faces of stone masonry surfaces complete all as specified and directed. |
| 30 | M&L for 100mm thick PCC 1:4:8, type D2 using 40mm graded stone aggregate as in floor or similar work complete all as specified and directed. |
| 31 | M&L chequered cement concrete coloured glazy finished tiles 30cm x 30cm x 25mm thick, set, jointed and pointed in neat cement slurry in floors with grey cement and pigments, over 20mm thick screed bed in CM 1:4 complete all as specified and directed |
| 32 | M&L for 100mm thick PCC 1:2:4, type B1 using 20mm graded stone aggregate as in floor or similar work complete all as specified and directed. |
| 33 | M&L for preparation of old treated chequered tile/ concrete surfaces and cornices by cleaning the surface with jet washing and steel wire brushing, remove all existing fungal growth, efflorescent salt and trading oil, greasy spots etc and applying one coat of floor tile guard water based high performance coating paint complete all as specified and directed. |
| 34 | M&L for 50 mm thick PCC 1:3:6 type C-2 using 40mm graded stone aggregate as in plinth protection including finished surface even and smooth without using extra cement complete all as specified and directed. Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Jul 06, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedJul 25, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 2 daysJul 28, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 5 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender