Tender For Provision Of Automatic Servo Voltage Stabilizer And Electric Connection From Dg Set To Bldg No P-12, P-13 &P-14 Under Age E/M At Mil Stn Yol
Tender Value
11.75 Lakhs
Estimated cost
Bid Submission
27 Jul 2026
24 days left
EMD
23500
Bank guarantee accepted
Document Fee
500
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Kangra → Himachal Pradesh
EMD Exemption
Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Provision Of Automatic Servo Voltage Stabilizer And Electric Connection From Dg Set To Bldg No P-12, P-13 &P-14 Under Age E/M At Mil Stn Yol
BOQ
| Sl. No. | Item Description |
| 1 | Earth work in excavation by mechanical means Hydraulic excavator)/ in foundation trenches or drains (not exceeding 1.5m in width or 10sqm on plan), including dressing of sides and ramming of bottoms, lift upto 1.5m, including getting out in all kind of soil excavated soil and disposal of surplus excavated soil, within a lead of 50m complete all as specified and directed. |
| 2 | Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc 25 cm in soft/loose soil complete all as specified and as directed.. |
| 3 | PCC 1:3:6 type D-2, using 40mm graded crushed stone aggregate as in support of angle etc; complete all as specified and directed. |
| 4 | Supply, laying, jointing and testing, laid in trenches/road crossing/under floor/on walls/on poles including clamps or passing through pipes, 1100 volts grade, LT XLPE insulated, armoured heavy duty electric cable with stranded aluminium conductor of cross sectional area 240sqmm, 3.5 core complete all as specified and directed. |
| 5 | Supply, laying, jointing and testing, laid in trenches/road crossing/under floor/on walls/on poles including clamps or passing through pipes, 1100 volts grade, LT XLPE insulated, armoured heavy duty electric cable with stranded aluminium conductor of cross sectional area 16sqmm, 4core complete all as specified and directed. |
| 6 | Supply and fixing in replacement Automatic change over switch 415V in sheet metal enclosures 4 pole of capacity 100 Amps with side /front load handle operated complete all as specified and directed. |
| 7 | GI pipe light grade 40 mm dia for cable protection including cold drilling and making good surface as per existing complete all as specified and directed. |
| 8 | GI pipe light grade 80 mm dia for cable protection including cold drilling and making good surface as per existing complete all as specified and directed. |
| 9 | Double walled corrugated (DWC) pipe of size 40mm/ 32 mm (OD/ID) including snap fit coupler conforming to IS14930 (Pt-II) IS16205 (Pt-II) for protection of cable in underground complete all as specified and directed. |
| 10 | Supply, Installation, commissioning and testing of Servo controlled automatic voltage stabilizer (conforming to BIS:9815: Part-I: 1994 reaffirmed 2009) for automatic operation of capacity 250 KVA , indoor type 3 phase ,4 wire 50 Hz naturally oil cooled, unbalanced type copper wound digital display type relay free smooth and silent operation with 1st filling of transformer oil with test report of oil (IS335/1993 reaffirmed 2005) having following specifications: (i) Input voltage 300V-480V, (ii) output voltage stabilizer at 415 Volt +1%(adjustable) (iii) No distortion in wave form,(iv) Response time not to exceed 10 mile seconds,(v) Sensivity + 1% (vi) Rate of correction 8 Volt/sec for single phase and 20 Volts /sec for phase to phase (vii) No load losses less than 0.5%,(viii) Full load losses less than 2.5 %,(ix) Duty cycle- continuous 24x7 (x) Efficiency more than 95% (xi) Type of load : 3 phase unbalanced type,( xii) Digital display voltmeter/ammeter.(xiii) Capacity 250 KVA Note: -The stabilizer shall be powder coated for water/ dust and vermin proof complete all as specified and as directed. |
| 11 | Earthing complete with galvanized steel earth plate electrode 600mm x 600mm x 6.0mm thick buried directly in ground ( earth pit not less than 2.25 mtr below normal ground level ) with top edge plate not less than 1.5 metre below normal ground level connected to galvanized earth strip of size 25mm x 4mm as earthing lead by means of bolts, nuts, chuck nuts and washers of galvanized iron earth lead with 15 cm thick alternate layers of charcoal dust & common slat including PCC pit in PCC 1:2:4 type B-1, RCC cover made out of cement concrete 1:2:4 type B-1 (using 20 mm graded crushed stone aggregate) reinforced with TMT steel bars 8 mm dia @150 mm c/c both ways with suitable handle and angle iron 40 x 40 x 5 mm frame, GI medium grade watering pipe 20 mm bore and funnel with wire mesh light grade protection pipe 40mm bore up to main board complete as shown on electrical plate No 3 of MES Sch 2009 (Part-I) and testing on completion complete all as specified and directed by the Engineer-in-Charge. Note: - On testing after completion of earthing, if desired earth resistance is not obtained, the earthing will be re-done by the contractor at his own risk & cost to the entire satisfaction. |
| 12 | Supply, installation, testing and commissioning of LT distribution panel, CPRI approved, weather/vermin proof, made of 3.15 mm thick CRCA sheet for outer shell and 2mm thick CRCA sheet for inner shell having MS section not less then 50x50x6 mm thick, factory assembled cubicle pattern modular and compartmentalized construction, IP-54 Protection, outdoor type, 3 phase, 415V, 4 wire 50Hz, AC supply system with front and backside hinged double door with locking arrangement, mounted on angle iron stand above 0.5 meter from GL, duly powder coated, 3 phase and neutral, 500 amps current carrying capacity copper bus bar with epoxy insulated coating with colour code and insulated support of size 25x3mm with terminal switch, inter connecting bus bar connection/linkage complete and comprising of following switch gears and mounting panel board on floor using suitable nuts and bolts duly grouted on floor, including dismantling and taking out old unservicable LT Panel Board and remove from site including reconnecting existing LT Cables with new panel board complete all as directed :- (a) MCCB 4 pole with fixed thermal and fixed magnetic release, 160 Amps having rupturing capacity 36 KA including extendable link -01 No (as incoming) Out going feeders:(b) MCCB 4 pole with fixed thermal and fixed magnetic release, 100 Amps having rupturing capacity 16 KA including extendable link -03 No.(c) MCB SPN 63 amp, 240V, 10KA 'C' curve- 03 No.(d) Volt Meter digital type 0-500 Volt with selector switches - 1 No (f) Ammeter digital type with CT for three Phase 0-400 Amps with selcetor switch - 1 Set (g) LED indication lamps with backup MCB for 3 phase supply –1 set. |
| 13 | Mild steel framed work such as grills, gratings, etc with ends of bars shouldered and/ or riveted, or forged into spikes; framed guard bars; barred iron doors; ladders; framed ballusters walk ways; railings; flat iron for framing grills, framework of water tanks and similar work conforming to Fe.290. Gde-E-165, complete all as specified and directed. |
| 14 | Supply & fixing Pre- painted galvalume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall with two corrugations side lap, fixed with self tapping screws complete all as specified and directed |
| 15 | u8 Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Jul 02, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedJul 27, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 24 daysJul 29, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 26 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender