Tender For Replacement Of 8 Passenger Lift (1No) Of Shakti Bhawan Situated Between Block-2 And 3 I/C Internal/External Electrification Of Lift Shaft At Transmission Block Shakti Bhawan, R Ur, Jabalpur.
Tender Value
28.47 Lakhs
Estimated cost
Bid Submission
22 Jul 2026
8 days left
EMD
56940
Bank guarantee accepted
Document Fee
1770
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
Jabalpur → Madhya Pradesh
EMD Exemption
Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Replacement Of 8 Passenger Lift (1No) Of Shakti Bhawan Situated Between Block-2 And 3 I/C Internal/External Electrification Of Lift Shaft At Transmission Block Shakti Bhawan, R Ur, Jabalpur.
BOQ
| Sl. No. | Item Description |
| 1 | Total of BOQ2 +BOQ3 |
| 2 | Amount as per BOQ2 |
| 3 | Amount as per BOQ3 |
| 4 | 3017630, 44.1.3, Lift/Elevators -Supply, installation, testing, commissioning, and final testing of automatic lift complete in the shaft well and pit already constructed as per CPWD specification including automatic rescue device (ARD), All standard equipments, accessories and control equipments as per manufacturer's design and as per CPWD specification (Part III LIFTS) on turnkey basis, Conforming to NBC/statutory norms and fulfilling following requirements. (i) Type: Passenger lift. (ii) Load: As specified elsewhere from 4 passengers (272Kg) to 26 passengers (1768Kg) (for each person standard weight 68Kg.). (iii) Speed: 1.00 metre/sec. or less as required. (iv) Control: ACV3F, 32bit microprocessor integrated serial communication control system with RMS (remote monitoring system)/BMS (building monitoring system) supporting software. (v) Motor/machine: Permanent magnetic synchronous gearless motor (vi) Operation: Simplex collective selective with/without lift attendant. (vii) Total rise: About 3 mtrs. (approx) two stops only. (viii) Landings: All floors on same side. (ix) Floors served: G+1. (x) Signals: Digital car position indicator, car travel direction indicator inside car & at all landings, voice annunciator with suitable music shall be provided in the lift car. (xi) Shaft size: As per manufacturer's design and as per CPWD specification (Part III LIFTS), Shaft to be constructed separately. (xii) Guide rail: As per manufacturer's specification. (xiii) Lift & car size: As per manufacturer's design and as per CPWD specification (Part III LIFTS). (xiv) Car entrance: As per manufacturer's design and as per CPWD specification (Part III LIFTS). (xv) Landing entrance: As per manufacturer's design and as per CPWD specification (Part III LIFTS). (xvi) Car door: S.S. (stainless steel) hairline finish centre/telescopic opening door with vision panel. (xvii) Landing door: S.S. (stainless steel) hairline finish centre/telescopic opening door with vision panel. (xviii) Door operation: Automatic electric power operated door, full height infrared curtain with multiple criss/cross light beams. (xix) Car interior: S.S. (stainless steel) panel with hair line finish on all sides. (xx) Car floor: Anti skid PVC flooring on heavy duty M S (mild steel) platform. (xxi) Car ceiling & lighting: S. S. (stainless steel) finish with aesthetic appearance with LED ceiling lights (xxii) Carventilation: Pressure fan/blower fan (car fan with automatic sleep timer shall be provided). (xxiii) Emergency lighting in car: Battery operated emergency lighting in the lift car. (xxiv) Intercom system: Battery operated intercom system in lift car, machine room and ground floor/control room. (xxv) Emergencyalarm: Battery operated alarm bell system in lift car & control room / ground floor. (xxvi) Position of machine room: Directly above the hoist-way. (xxvii) Electric power supply: AC 415 V, 3 phases 50 Hz & AC 230 V 1phase 50Hz terminated in machine room. (xxviii) Fire man switch : Fire man switch at machine room/terminal landing (xxix) All car panel buttons and all floor switches must be with Braille language as per lift act. (xxx) Audio visual indication in the lift car showing overloading shall be provided such that doors keep open till excess load is removed. (xxxi) Spring buffer/hydraulic buffer shall be provided (xxxi) Spring buffer/hydraulic buffer shall be provided (xxxii) Mechanical over speed governor, door key holes in the floor doors shall be provided. (xxxiii) Lift machine hoisting arrangement in the lift machine room and monkey ladder for lift pit should be provided by the lift agency, along with the other steel structure works, foundations for the machines etc. (xxxiv) In the hoist way fascia plate shall be provided. (xxxv) Permanent wiring in lift machine room and lift well with proper no. of light points, with fixtures, exhaust fan, plug points and 3 phase 440V power supply shall be made in lift shaft by the department, machine room or at desired level. (xxxvi) Car top safety barricade shall be provided. (xxxvii) ARD (automatic rescue device): Solid state inbuilt automatic rescue device (ARD) automatically rescues passengers trapped in the lift car in between floors in the event of power failure. Automatic operation and immediate action in the event of mains failure, capable of moving the lift to the nearest landing, opens the automatic door of the lift car and floor. Sealed maintenance free battery backup with automatic charging unit and auto changeover device on mains failure. 8 Passenger (544Kg.) |
| 5 | 3017640, 44.3.1 Add extra for every additional floor Add extra to item no. 44.1 for every additional floor beyond initial G+ 1 floor (additional stops beyond two stops) provides all necessary additional parts/equipments as per manufacturer's requirement. Cost for each additional floor : upto 9 stops (For 4-10 Passengers) |
| 6 | 3017644, 44.4.1, Add extra for machine room less (MRL) Add extra to item no. 44.1for machine room less (MRL) lift in place of machine room directly above the hoist way. Extra cost for machine room less (4-13 Passenger) |
| 7 | 3017649, 44.6.1 Gong system, Add extra to item no. 44.1 for hall lantern and arrival gong system, Extra cost/floor, Extra cost for per floor per lift |
| 8 | 3017650, 44.7, Moon rock finish, Add extra to item no. 44.1 cost for moon rock finish S.S. (stainless steel) panel. |
| 9 | 3016355, 27.21.2.8\\" Internal External electrification Supplying and installing of RCBOs (Residual current circuit breaker with overload and short circuit protection) ISI marked complete as per I.S. standard conforming to IEC:61009-1 & IS:12640-2, 240/415V 50 Hz with 10 kA short circuit withstand capacity for earth leakage, overload & short circuit protection including connection in existing enclosure in approved manner as per specification...FP (8module)..4 pole 63Amp, 100/300mA sensitivity \\" |
| 10 | 3016171, 27.3.1\\"Supplying of ISI marked and approved make of moulded case circuit breaker (MCCB) suitable for 3 phase & N, 4 pole, 50 Hz, 415 Volts, (Ics=100%Icu) AC supply with thermal-magnetic release having respective breaking capacity (KA) at 415 Volts cited against their range standard conforming to IS/IEC 60947-2..MCCB 25kA current rating - 63 to10 Amp & adjustable.overload setting 80% -100% of In, adjustable short.circuit setting 6-10 In 4 Pole\\" |
| 11 | 3016277, 27.11.1 \\"Supply of approved make powder coated sheet steel encloser SPN MCB DB inclusive of busbar, neutral bar, earth bar, connection copper wire not less than 16 sq.mm & two earth terminals etc. complete as per IS:13032(exclusive of MCB & isolator)-..2 Way single door\\" |
| 12 | 3017109, 41.4.4.4\\"Supply of XLPE insulated FRLS heavy duty power cable conforming IS-7098 (Part-1) 1988, 1100 Volt grade, 2/3/4/8/10/12 core ISI marked with copper stranded/solid conductor...Armoured 4 core..6 sq. mm. \\" |
| 13 | 3016719, 37.7Supply and laying 4mm dia. copper wire at 0.5 metre below ground level as conductor earth electrode including soldering etc. as required. |
| 14 | 3015704, 25.2.5\\"Supply of I.S.I. Marked iron clad / metal clad triple pole and neutral switch fuse (conduit entry ) /cable gland entry with two earthing terminals ..200 Amps. 415/500 Volts..\\" |
| 15 | 3015110, 1.1.1.3.2 \\"Point wiring (excluding metallic switch box & sheet but including switches, sockets, lamp holders/ceiling roses etc) with 1.5sq. mm. PVC insulated cable FRLS with copper multi strand conductor ISI marked in surface rigid steel conduit ISI marked of suitable size and 1.5sq. mm. PVC insulated FRLS copper earth continuity conductor of green colour inside conduit including painting, screwless connector for joints etc. as required as per specification for :-..Light point/fan points...Primary long point..Using modular accessories.\\" |
| 16 | 3015360, 9.1.1.3.2 \\"Point wiring (excluding metallic switch box &sheet) for 3 Pin 16 Amp. socket outlet point with 4sq. mm. PVC insulated cable FRLS with copper multi strand conductor ISI marked in concealed rigid P.V.C. conduit (HMS) ISI marked of suitable size etc. with 20/16 Amp. F.T. switch & socket/S.S. combined 20/16/6 Amp. of ISI marked and 4sq. mm. PVC insulated FRLS copper earth continuity conductor of green colour inside conduit, screwless connector for joints as per specification for :-...On separate board.Long point.Using modular accessories.\\" |
| 17 | 3016511, 37.1Earthing with G.I. earth pipe 4.5 metre long and 40 mm dia with masonry encloser in cement mortar, cover plate having locking arrangement on the top etc. (but without charcoal or coke and salt) complete as required |
| 18 | 3016717, 37.5.1\\"..Add extra for using salt and charcoal/coke.for G.I. plate or copper plate earth electrode.as required including excavation in hard.rock and refilling the pit with black soil.\\" |
| 19 | 3016543, 31.3.4 \\"Supply and fixing Led tube rod comprising of LED tube with non.integral/integral driver, upto 6500K color temp having 40000 burning hrs life with minimum @ L 70, system lumen output should be minimum with system efficacy> 100 lm/Watt. LED driver PF> 0.95 & THD < 20%. The colour rendering index of LED light should be more than 70. Submission LM 79-08/IS16106 (2012), IEC60598, IEC61347i/c connection wire, testing etc. to complete the job...Tube light LED 1 X 20/22Watt, Integral i/c batten aluminium body,.PC diffuser.\\" |
| 20 | 3016283 ,27.11.7\\"Supply of approved make powder coated sheet steel encloser SPN MCB DB inclusive of busbar, neutral bar, earth bar, connection copper wire not less than 16 sq.mm & two earth terminals etc. complete as per IS:13032(exclusive of MCB & isolator)-..16 Way double door IP 43 protection \\" |
| 21 | Dismantling of existing 6 to 12 passanger lift (5floors) from lift duct i/c dismantling of lift car, all structural material in duct and machine room , motor, pully, gantry beam and other material required for reinstallation of new lift , removing of all dismanted material from site and transportating upto 2KM i/c all loading, unloading ,transportation, taxes, and any other expenses etc complete as per direction of Engineer-incharge. Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Jul 01, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedJul 22, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 8 daysJul 23, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 9 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender