Tender For Special Repairs To Parking Shed Alongwith Hardstanding And Other Connected Works Near Bldg No P-101, Provn Of Wall Panelling At Bldg No P-295 (Fmsd) And Addn/Altn And Special Repair To P-34A, P-37, P-38, P-39, P-40, P-45, P-46, P-47, P-48,
Tender Value
42.90 Lakhs
Estimated cost
Bid Submission
20 Jul 2026
15 days left
EMD
85800
Bank guarantee accepted
Document Fee
500
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
South Andamans → Andaman And Nicobar Islands
EMD Exemption
Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Tender for Special Repairs To Parking Shed Alongwith Hardstanding And Other Connected Works Near Bldg No P-101, Provn Of Wall Panelling At Bldg No P-295 (Fmsd) And Addn/Altn And Special Repair To P-34A, P-37, P-38, P-39, P-40, P-45, P-46, P-47, P-48, P-49 (Fire Points) At installation Jarawa Under Ge Haddo, Sri Vijaya Puram
BOQ
| Sl. No. | Item Description |
| 1 | Demolition of cement concrete (unreinforced) in ground floors and pavings n.exc 15cm thick (above or below GL) complete all as specified and directed |
| 2 | M & L for hardcore of gauge n exc 63 mm deposited spread and levelled in layers n exc 15 cm thick watered and rammed to a true surface of broken stone or boulders all as specified and as directed. |
| 3 | M & L for providing 100 mm thick, PCC 1:4:8 type D2 using 40 mm graded stone aggregate as in sub base of floors all as specified and as directed. |
| 4 | M&L chequered Cement concrete tiles 30cmx30cmx 25 mm thick set, jointed and pointed neat cement slurry in floor with grey cement and pigments , incl CM (1: 4) 20 mm thick screed bed all as specified and as directed. |
| 5 | M&L 60mm thick factory made chamfered edge cement concrete paver block of M-35 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand complete including dismantling old paver block complete all as specified. |
| 6 | M & L for Non-Skid heavy duty vitrified tiles of size 600 X 600 X (12-16mm) thick, or high dimension (except thickness) of any colour any design Durastone, weather proof impact resistant, abrasion resistant exterior tiles, as in floors and etc , set and jointed in neat cement slurry over and pointed in white or coloured cement to match, over 15mm thick screed bed in CM (1:4) including demolition of old tiles complete all as specified and as directed. |
| 7 | S&F mild steel roof trusses (framed), trussed, purlins, crane gantries, rails and fastenings and heavy bracket framming (Beam,Tee, Angle, Channels or flat sections) including distance pieces, cleats etc conforming to Fe 410-W (Gde-E-250) quality-A all as specified and as directed. |
| 8 | Dismantling plain or corrugated steel sheeting, any gauge, thickness including nainital or similar pattern in roof coverings complete all as specified and as directed |
| 9 | S&F Pre-painted galvalume aluminium zinc coating GI based corrugated steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws all as specified and directed |
| 10 | S&F Pre-painted galvalume aluminium zinc coating GI based plain steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, ridge etc fixed with self tapping screws all as specified and as directed. |
| 11 | M&L cement concrete (1:2:4) type B-1 using 20mm graded aggregate as in coping including necessary formwork all as specified and as directed. |
| 12 | Dismantling structural steel work of any description and in any position etc complete all as specified and as directed. |
| 13 | S&F for stainless steel (Grade 304) railing made of hollow tubes, channels, plates, connecting chains etc, including welding, grinding, buffing, polishing and making curvature (where ever required) and fitting the same with necessary stainless steel nuts and bolts complete, including fixing the railing with necessary accessories and stainless steel dash fasteners, stainless steel bolts etc of required size on the top of floor or the side of waist slab with suitable arrangement complete all as specified and as directed. |
| 14 | Dismantling stone slabs and tiles of any description laid bedded and pointed in mortar all as specified and as directed. |
| 15 | M&L for 20mm thick Granite (of any type) work (table rubbed and polished) in steps, jambs, pillars, window-cills, cooking platforms and like in cement mortar (1:4) including pointing in white cement (1:2) using marble dust with admixture of pigment to match with shade of granite complete all as specified and as directed. |
| 16 | S&F mild steel Plates (plain or chequered) channels, square cut or notched (ordinary and counter sunk) forming holes, without any attachment complete all as specified and as directed. |
| 17 | M&L for framed work such as grills, gratings, etc,. With ends of bars shouldered and/ or riveted, or forged into spikes; framed guard bars, barred iron doors ladders including portions framed and hung as gates, including pintle hinges, stops, hand made sliding bolts for ornamental and intricate design as specified and directed |
| 18 | Demolition of precast cement concrete block walling built in CM or cement lime Mortar complete all as specified and as directed. |
| 19 | M& L for precast cement concrete block masonry with solid blocks using PCC 1:3:6, type C1(using 20mm graded stoneaggregate), exc. 10cm in width, set in CM 1:6 all as specified and as directed. |
| 20 | PCC 1:2:4 type B1 using 20 mm graded crushed stone aggregate as in filling, foundation and mass concrete complete all as specified and as directed. |
| 21 | Taking down cement plaster of any description including raking out joints, hacking for key, scrubbing down with water complete all as specified and directed |
| 22 | M&L Rendering 15mm thick on fair faces of brick work or concrete surfaces finished with even and smooth without using extra cement in CM 1:4 complete all as specified and as directed. |
| 23 | Material & Labour for preparing newly plastered wall surface and applying Two or more coats of 100% Premium acrylic emulsion paint having VOC less than 50 gm/litre and UV resistance as per IS 15489:2004, Alkali & fungal resistance, dirt resistance exterior paint of required shade (Company Depot Tinted) with silicon additives @ 1.43 litre/ 10 sqm over and including priming coat of exterior primer applied @ 0.90 litre/ 10 sqm over new surfaces complete all as specified and as directed. |
| 24 | Demolition of reinforced cement concrete of any description and in any position not otherwise specifically provided for complete all as specified and directed |
| 25 | M&L Reinforced cement concrete (nominal mix) Type A1 1:1.5:3 (20 mm graded aggregate) in columns, pillars, piers, posts and struts complete all as specified and directed |
| 26 | M&L for Reinforced cement concrete (nominal mix) Type A1 1:1.5:3 (20 mm aggregate) in Foundations, including rafts, footings, foundation beams; plinth beams; bases for columns, etc.; basement slabs, under-reamed piles and mass concrete complete all as specified and as directed. |
| 27 | M&L formwork for rough finished flat surface to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams and similar work, vertical or to batter complete all as specified and as directed |
| 28 | M&L formwork for rough finished surface of square, rectangular or triangular surface to sides of pillars, posts, struts, piers, columns and stanchions complete all as specified and as directed |
| 29 | M&L for mild steel TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and as directed |
| 30 | M&L for mild steel TMT bars 5mm dia and over upto and including 10mm dia in stirrups, spacers and binders complete all as specified and directed |
| 31 | M & L for Aluminium composite panel sheet of 3mm thick of any colour or design with skin thickness of 0.25mm of aluminium on both sides, sandwiched by 2.5mm polyethylene core with PVDF coating of 30 microm fixed with Angles or MS or SS Flats etc for by screws/ bolt & nuts etc for View cutter in approved pattern etc including taking down complete all as specified and as directed. |
| 32 | M & L for preparing of new of previously untreated steel surface of any description, not otherwise described, over 10 cm width or girth applyig two coats of synthetic enamel paint over a coat of red oxide zinc chrome primer complete all as specified and as directed. |
| 33 | M & L WPC (Wood Plastic Composite) louvers and PVC UV Marble sheet combination wall panelling as in interiors fixed over box structure using suitable wooden scantling/ frames and suitable wooden scantling/ frames and suitable plywood for fixing of wall panels and as per the manufacturers instructions as in rooms, staircase portion etc complete all as specified and as directed. |
| 34 | M&L for 18mm thick designed rubco hut rubber wood frame shutter for cupboard, WHB counter cupboard, wall with finish to match all adjoining surfaces including sanding and applying mixture of filler and NCD thinner (Sheenlac make), pasting chalk putty, applying sealer (Sheenlac make) and wall nut colour stainer and finally applying waxpol (Silicon make) complete all as specified and as directed |
| 35 | M&L for applying two coats of oil bound distemper over a coat of average 1mm thick wall care putty over a coat of primer to make the surface smooth after complete removal of existing treatment complete all as specified and as directed |
| 36 | Excavating in post holes in hard/dense soil (or similar holes) each n exc 0.5 cu. m, getting out, returning, filling in and ramming earth or broken rubble mixed withearth around, in layers not exceeding 25 cm, watering and removing surplus soil to a distance n.exc 50m and making good surface complete all as specified and as directed |
| 37 | M&L for cement concrete 1:2:4 type B1 (Using 20mm graded stone aggregate) as in foundation of posts, railing and similar work complete all as specified and as directed |
| 38 | Excavation in trenches n. exc 1.5m wide and n. exc 1.5m in depth in hard/dense soil for foundation, etc or for shafts, wells, cesspits, manholes, pierholes, etc n. exc 10 Sqm on plan and getting out complete all as specified and as directed |
| 39 | M&L for returning filling in hard/dense soil including spreading levelling watering and well ramming in layers n. exc 25cm thick complete all as specified and as directed |
| 40 | M&L for removing excavated material (any type of soil) to a distance n. exc 50m and depositing where directed at a level n. exc 1.5m above the starting point complete all as specified and as directed |
| 41 | M&L Cement concrete 1:4:8 type D2 (using 40mm graded stone aggregate) as in foundations or mass concrete complete all as specified and as directed Please Enable Macros to View BoQ information |
AI Tender Summary
Tender Timeline
Jun 29, 2026
11:30 IST
Tender Published
Tender notice published.
CompletedJul 20, 2026
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
Upcoming · 15 daysJul 22, 2026
Bid Opening Date
Technical bids will be opened and evaluated.
Upcoming · 17 daysTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender