|
| 1 | Dismantling old plaster or skirting raking out joints and cleaning the surface for plaster including disposal of rubbish to the dumping ground within 50(Fifty) metres lead including carriage of materials in all leads and lifts as per directions of the Engineer-in-Charge. |
| 2 | 15 mm cement plaster on the rough side of single or half brick wall of mix including waterproofing admixture of Dr Fixit, including carriage of materials in all leads and lifts as per directions of the Engineer-in-Charge. (i) 1:4 ( 1 cement : 4 fine sand) |
| 3 | Providing and applying waterproofing with Dr. Fixit Brownflex , including disposal of material within 50 metres lead as per direction of Engineer - in - charge. |
| 4 | Providing and fixing PVC Panelling etc complete including carriage of materials in all leads and lifts as per directions of the Engineer-in-Charge. |
| 5 | Steel work welded in built up sections, trusses and framed work including cutting hoisting fixing in position and applying a priming coat of red lead paint including carriage of materials in all leads and lifts as per directions of the Engineer-in-Charge. (a) In gratings , frames , guard bar , lasser, railing , brackets , gates and similar works. |
| 6 | Providing and fixing Corrugated polycarbonte sheet, complete including carriage of materials in all leads and lifts as per directions of the Engineer-in-Charge. (i) 4 mm thick |
| 7 | 15 mm cement plaster on the rough side of single or half brick wall of mix including carriage of materials in all leads and lifts as per directions of the Engineer-in-Charge. (i) 1:4 ( 1 cement : 4 fine sand) |
| 8 | Providing corrugated G.S. sheet roofing including vertical / curved surface fixed with polymer coated J or L hooks, bolts and nuts 8 mm diameter with bitumen and G.I. limpet washers or with G.I. limpet washers filled with white lead, including a coat of approved steel primer and two coats of approved paint on overlapping of sheets complete (up to any pitch in horizontal/ vertical or curved surfaces), excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required including carriage of materials in all leads and lifts as per directions of the Engineer-in-Charge. (i) 0.63 mm thick sheet with zinc coating not less than 275 gm/m2 |
| 9 | Providing and fixing cantoinment wire for covering boundary, complete including carriage of materials in all leads and lifts as per directions of the Engineer-in-Charge. |
| 10 | Provdiing and fixing of 40 cm overall width plain G.S sheet fixed with polymer coated J or L hooks , bolts and nuts , G.I limpet and bitumen washer complete , bent to shape and fixed in wall with cement mortar 1:3(1 cement : 3 coarse sand ). including carriage of materials in all leads and lifts as per directions of the Engineer-in-Charge. (i) 1.00 mm thick with zinc coating not less than 275 gm/m2 |
| 11 | Providing and laying cement concrete in retaining walls, return walls, walls (any thickness) including attached pilasters, columns, piers, abutments, pillars, posts, struts, buttresses, string or lacing courses, parapets, coping, bed blocks, anchor blocks, plain window sills, fillets, sunken floor etc., up to floor five level, excluding the cost of centering, shuttering and finishing including carriage of materials in all leads and lifts as per directions of the Engineer-in-Charge. (i) 1:3:6 (One cement : Three coarse sand) : Six graded stone aggregate 20 mm nominal size) |
| 12 | (ii) 1:5:10 (1 cement : 5 Coarse sand ) :10 Graded stone aggregate 40 mm nominal size ) |
| 13 | Cutting in Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm (Thirty centimetre) in depth, 1.5 m (One point five metre) in width as well as 10 sqm (ten Square Metre) on plan) including getting out and disposal of excavated earth all lead and lift as directed by Engineer-in-charge and sorting out useful and unuseful material and transportation of the unuseful material for disposing at dumping site (To be arranged by the contractor) as per satisfaction of Engineer- in -charge through all modes of transportation including head load ,animal load or mechanical means along with its leveling fine dressing and with all kinds of labour, machineries, tools equipments and safety measures and incidentals necessary to complete the work by mechanical means and labour ( if required ) Any loss to the public and private propriety, human being, machinery during the course of execution and disposal of serviceable and unserviceable materials shall be the absolute responsibility of the contractor and shall have to be duly compensated by him in all respects including all incidental charges. (i)All kinds of soil. |
| 14 | Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm (Thirty centimetre) in depth, 1.5 m (One point five metre) in width as well as 10 sqm (ten Square Metre) on plan) including getting out and disposal of excavated earth all lead and lift as directed by Engineer-in-charge and sorting out useful and unuseful material and transportation of the unuseful material for disposing at dumping site (To be arranged by the contractor) as per satisfaction of Engineer- in -charge through all modes of transportation including head load ,animal load or mechanical means along with its leveling fine dressing and with all kinds of labour, machineries, tools equipments and safety measures and incidentals necessary to complete the work by mechanical means and labour ( if required ) Any loss to the public and private propriety, human being, machinery during the course of execution and disposal of serviceable and unserviceable materials shall be the absolute responsibility of the contractor and shall have to be duly compensated by him in all respects including all incidental charges. (i)All kinds of soil. |
| 15 | Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5(seven point five) in superstructure above plinth level up to floor V level in all shapes and sizes in.(i) Cement mortar 1:4 (One cement : four coarse sand) including carriage of materials in all leads and lifts as per directions of the Engineer-in-charge. |
| 16 | Half brick masonry with non modular fly ash bricks of class designation 10, conformingio IS :12894, in super structure above plinth and upto floor V level. (i) Cement mortar 1:4 (One cement : four coarse sand) including carriage of materials in all leads and lifts as per directions of the Engineer-in-charge. |
| 17 | Wall painting with acrylic emulusion paint (ready mixed) having VOC content less than 50gms/litre of approved manufacture of required shade and colour complete including carriage of materials and as per the direction of the Engineer-in-Charge. (i) Two Coats |
| 18 | Providing and applying coat for apex ultima protek, complete including carriage of materials and as per the direction of the Engineer-in-Charge. |
| 19 | Finishing wall with weather proof exterior grade emulsion of approved design Apexultima) or its equarlied on undecorated wall surfaces (two coats) to give an even shade and final finish after throughly cleaning the surface to remove all dirt, dust and other foreign matter etc including sand paper smooth including carriage of materials in all leads as per directions of the Engineer-in-Charge. |
| 20 | Removing dry or oil bound distemper, water proofing cement paint and the like by scrapping, sand papering and preparing the surface smooth including necessary repairs to scratches etc. including carriage of materials in all leads as per directions of the Engineer-in-Charge. |
| 21 | Providing and applying white cement based putty of average thickness 1 mm, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth including carriage of materials in all leads as per directions of the Engineer-in-Charge. |
| 22 | Painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade including carriage of materials in all leads as per directions of the Engineer-in-Charge. (i) One or more coats on old work |
| 23 | Providing and fixing 19mm thick water proof commercial board in shelves/shutters box for cup board with butt joints & fixing with nails & screws etc complete) including carriage of materials in all leads and lifts as per the directions of the Engineer-in-Charge. |
| 24 | Providing and fixing 0.80mm thick coloured or plain lamination sheet (sunmica) on boards/ply wood sheets with approved adhesive and nails etc. complete including carriage of materials in all leads and lifts as per directions of the Engineer-in-Charge. |
| 25 | Providing and fixing ply wood lining with butt jointing and nails (frame work and cove fillets to be measured and paid for separately) including carriage of materials in all leads and lifts as per the directions of the Engineer-in-Charge. (i) 6mm (six milimetre)thick |
| 26 | Providing and fixing square edges cover fillets (beading) 19mmx6mm(Nineteen milimetre into six milimetre) section i/c mitring at junctions with wood screws and nails complete including carriage of matrials in all leads and lifts as per directions of the Engineer-In-Charge.(i)1st class deodar wood. |
| 27 | Providing and fixing bright finished brass ball catcher 10 mm dia including carriage of materials in all leads and lifts as per directions of the Engineer-in-Charge. |
| 28 | Providing and fixing bright / matt finishing stainless steel handles of approved quality & make with necessary screws ,etc complete including carriage of materials in all leads and lifts as per directions of the Engineer-in-Charge. (i) 125 mm |
| 29 | Disposal of muck /denris/ excavated earth upto site approved by Municipal Corporation surrounding Shimla upto all leads and lifts as per directions of the Engineer-in-Charge. |
| 30 | Cement concrete flooring 1:2:4 (one cement : two coarse sand) : four graded stone aggregate ) finished with a floating coat of neat cement , including cement slurry , but excluding the cost of nosing of steps etc complete ,including carriage of materials in all leads and lifts as per directions of the Engineer-in-Charge. (i) 40 mm thick with 20 mm nominal size stone aggregate. |
| 31 | Lettering with black Japan paint of approved brand and manufacturing carriage of materials in all leads and lifts as per directions of the Engineer-in-Charge. |
| 32 | Repair to plaster in patches of 2.50 square meter under and upto 10 to 15mm thick including cutting the patch in proper shape and re-plastering the surface of wall including disposal to the dumping ground with a lead of 20 metres with including carriage of mateirals in all leads and lifts as per directions of the Engineer-in-Charge. (i) Cement Mortar 1:5(One cement: Five sand). |
| 33 | Providing and fixing MS welded Mesh 25x25x3mm thick including carriage of materials in all leads and lifts as per directions of the Engineer-in-Charge. |
| 34 | Providing and fixing Holdfast, including carriage of materials in all leads and lifts as per directions of the Engineer-in-Charge. |
| 35 | Providing and fixing Scaffolding in building side including carriage of materials in all leads and lifts as per directions of the Engineer-in-Charge. Please Enable Macros to View BoQ information |
