|
| 1 | Civil Work |
| 2 | 2.31: Clearing jungle including uprooting of rank vegetation, grass, brush wood, trees andsaplings of girth up to 30 cm measured at a height of 1 m above ground level andremoval of rubbish up to a distance of 50 m outside the periphery of the area cleared |
| 3 | 2.8.1: Earth work in excavation by mechanical means (Hydraulic excavator) /manual meansin foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan),including dressing of sides and ramming of bottoms, lift up to 1.5 m, includinggetting out the excavated soil and disposal of surplus excavated soil as directed,within a lead of 50 m.All kinds of soil |
| 4 | 4.1.8: Providing and laying in position cement concrete of specified grade excluding thecost of centering and shuttering - All work up to plinth level:1:4:8 (1 Cement : 4coarse sand (zone-III) derived from natural sources : 8 graded stone aggregate 40 mmnominal size derived from natural sources) |
| 5 | 5.1.2: Providing and laying in position specified grade of reinforced cement concrete,excluding the cost of centering, shuttering, finishing and reinforcement - All work upto plinth level:1:1:5:3 (1 cement 1.5 coarse sand :3 graded stone aggregate 20 mmnominal size derived from natural sources) |
| 6 | 5.9.1: Centering and shuttering including strutting, etc. and removal of formfor:Foundations, footings, bases of columns, etc for mass concrete |
| 7 | 5.22.6: Steel reinforcement for R.C.C work including straightening, cutting, bending, placing in position and binding all complete upto plinth levelThermo - Mechanically Treatedbars of grade Fe-500D or more |
| 8 | 50.10.1: Steel work in built up G I tubular ( round, square or rectangular hollow tubes etc.)trusses etc., including cutting, hoisting,fixing in position and applying a priming coatof approved steel primer, including welding and bolted with special shaped washersetc. complete |
| 9 | 50.10.2: Steel work for purlin/single section with G I pipes including cutting, hoisting, fixingin position and applying a priming coat of approved steel primer, including weldingand bolted with special shaped washers etc. complete |
| 10 | 12.7.1: Providing and fixing 15cm wide, 45 cm overall semi circular plain G.S. sheet gutterwith iron brackets 40x3 mm size, bolts, nuts and washers etc., including makingnecessary connections with rain water pipes complete.0.80 mm thick with zinccoating not less than 275 gm/m2 |
| 11 | 12.41.2: Providing and fixing on wall face unplasticised Rigid PVC rain water pipesconforming to IS : 13592 Type A, including jointing with seal ring conforming to IS :5382, leaving 10 mm gap for thermal expansion, (i) Single socketed pipes.110 mmdiameter |
| 12 | 12.50: Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch ofcorrugation as approved by Engineer-in-charge) 0.50 mm (+0.05%), total coatedthickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade,5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18microns. Sheet should have protective guard film of 25 microns minimum to avoidscratches during transportation and should be supplied in single length upto 12 metreor as desired by Engineer-in-charge. The sheet shall be fixed using self drilling/selftapping screws of size (5.5x55mm) with EPDM seal, complete upto any pitch inhorizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters andtrusses and including cutting to size and shape wherever required. |
| 13 | 50.6.1.5: Solid block masonry using pre cast solid blocks ( Factory made) of size 30x20x20cmor nearest available size confirming to IS 2185 Part I of 1979 for super structure up tofloor two level thickness 20cm and above in: CM 1:6 ( 1 cement : 6 coarse sand) etccomplete |
| 14 | 10.2: Structural steel work riveted, bolted or welded in built up sections, trusses and framedwork, including cutting, hoisting, fixing in position and applying a priming coat ofapproved steel primer all complete. |
| 15 | 13.1.1: 12 mm cement plaster of mix:1:4 ( 1 cement : 4 fine sand) |
| 16 | 13.46.1: Finishing walls with Acrylic Smooth exterior paint of required shade:New work (Twoor more coat applied @ 1.67 ltr/10 sqm over and including priming coat of exteriorprimer applied @ 2.20 kg/10 sqm) |
| 17 | 13.48.3: Finishing with Deluxe Multi surface paint system for interiors and exteriors usingprimer as per manufacturers specifications:Painting Steel work with Deluxe MultiSurface Paint to give an even shade. Two or more coat applied @ 0.90 ltr/10 sqmover an under coat of primer applied @ 0.80 ltr/10 sqm of approved brand andmanufacture |
| 18 | 23.1.1.1: Boring / drilling bore well of required dia for casing / strainer pipe, by suitablemethod prescribed in IS: 2800 ( part I), including collecting samples from differentstrata, preparing and submitting strata chart/ bore log, including hire & runningcharges of all equipments, tools plants & machineries required for the job, allcomplete as per direction of Engineer - in- Charge, upto 90 metre depth below groundlevel.All types of soil300 mm dia |
| 19 | 23.3.2: Supplying, assembling, lowering and fixing in vertical position in bore well,unplasticized PVC medium well casing (CM) pipe of required dia, conforming to IS :12818, including required hire and labour charges, fittings & accessories etc. allcomplete, for all depths, as per direction of Engineer- in- Charge.150 mm nominalsize dia |
| 20 | 23.5: Supplying, filling, spreading & leveling stone boulders of size range 5 cm to 20cm, in recharge pit, in the required thickness, for all leads & lifts, all complete asper direction of Engineer -in- charges |
| 21 | OD72398/2026-2027: Providing suplying and installation of Borewell Submersible Pump-1.5HP watercooling with 6mm dia ss rop including all accessories, fittings etc complete ofapproved IS make as perdesign and drawings and decision of Engineer-at-site. |
| 22 | 50.18.7.4.1: Providing and fixing PVC pipes, fittings including fixing the pipe with clamps at 1.00m spacing. This includes jointing of pipes & fittings with one step PVC solventcement and testing of joints complete as per direction of Engineer-in-Charge 32 mmdia 10Kgf/cm2- Internal work - Exposed on wall |
| 23 | 50.18.8.7.1: Providing and fixing PVC pipes, fittings including fixing the pipe with clamps at 1.00m spacing. This includes jointing of pipes with one step PVC solvent cement andtesting of joints complete as per direction of Engineer-in-Charge. Concealed workincluding cutting chases and making good the wall etc. 63 mm pipe 6 Kgf/cm2 |
| 24 | 50.18.9.20.1: Providing and fixing PVC moulded fittings/ accessories for Rigid PVC pipes,including jointing with PVC solvent cement - 63 mm dia Elbow |
| 25 | 50.18.9.20.2: Providing and fixing PVC moulded fittings/ accessories for Rigid PVC pipes,including jointing with PVC solvent cement -63 dia 45 degree Elbow |
| 26 | 50.18.9.20.4: Providing and fixing PVC moulded fittings/ accessories for Rigid PVC pipes,including jointing with PVC solvent cement - 63 mm dia Bend |
| 27 | 50.18.9.20.8: Providing and fixing PVC moulded fittings/ accessories for Rigid PVC pipes,including jointing with PVC solvent cement - 63 mm dia End cap |
| 28 | 50.18.9.20.9: Providing and fixing PVC moulded fitting / accessories for Rigid PVC pipes,including jointing with PVC solvent cement-63 mm dia Socket /coupling |
| 29 | 50.18.9.20.10: Providing and fixing PVC moulded fittings/accessories for Rigid PVC pipes,including jointing with PVC solvent cement - 63x50 mm dia Reducer |
| 30 | OD72399/2026-2027:Providing and fixing 18 mm thick gang saw cut, mirror, polished, premoulded andprepolished, machine cut for inauguration stone, of required size, approved shade, colour and texture laidover 20 mm thick base cement mortar 1:4 ( 1 cement : 4 coarse sand), joints treated with whitecement,mixed with matching pigment, epoxy touch ups, including rubbing, curing complete at all levels.<br>Area of slab over 0.50 sqm |
| 31 | OD72401/2026-2027: supplying and fixing 63mm hose pipeMaterial |
| 32 | 16.21: Engraving letters in hard stone |
| 33 | 13.71: Lettering with black Japan pint of approved brand and manufacture |
| 34 | 17.7.3: Providing and fixing wash basin with C.I. brackets, 15 mm C.P. brass pillar taps, 32mm C.P. brass waste of standard pattern, including painting of fittings and brackets, cutting and making good the walls wherever require:White Vitreous China Wash basin size 550x400 mm with a pair of 15 mm C.P. brass pillar taps |
| 35 | OD72402/2026-2027: providing and fixing 160 mm PPR pipe triple layer PN 20 |
| 36 | OD72403/2026-2027: PROVIDING AND FIXING PPR 160 mm coupler |
| 37 | OD72404/2026-2027: Providing and fixing ppr 160 mm elbow |
| 38 | OD72422/2026-2027: Providing and fixing PPR end cap |
| 39 | Bio-Fencing |
| 40 | 2.31: Clearing jungle including uprooting of rank vegetation, grass, brush wood, trees and saplings of girth up to 30 cm measured at a height of 1 m above ground level and removal of rubbish up to a distance of 50 m outside the periphery of the area cleared |
| 41 | 50.2.26.1: Filling with contractor own earth (excluding rock) in open areas in layers not exceeding 20 cm in depth, consolidating each deposited layer by ramming and watering, lead up to 50 m and lift up to 1.5 m as per direction of site Engineer-incharge. |
| 42 | 4.1.8; Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:4:8 (1 Cement : 4 coarse sand (zone-III) derived from natural sources : 8 graded stone aggregate 40 mm nominal size derived from natural sources) |
| 43 | 4.1.3: Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:2:4 (cement : 2 coarse sand (zone-III)derived from natural sources : 4 graded stone aggregate 20 mm nominal size derived from natural sources) |
| 44 | 50.6.1.1: Solid block masonry using pre cast solid blocks ( factory made) of size 40x20x20cm or nearest available size confirming to IS 2185 part 1 of 1979 for foundation and plinth with thickness 20 cm and above in: CM 1:6 ( 1 cement : 6 coarse sand) etccomplete |
| 45 | 13.1.1: 12 mm cement plaster of mix:1:4 ( 1 cement : 4 fine sand) Please Enable Macros to View BoQ information |
