|
| 1 | SPECIAL REPAIRS TO CHAIN LINK FENCING AT VARIOUS LOCATIONS UNDER AGE B/R II AT DSSC WELLINGTON. |
| 2 | Dismantling wrought iron or mild steel work of any description not otherwise provided for steel members of Fence,gate etc complete all as spcified and as directed. |
| 3 | Demolition of Unreinfoced cement Concrete of any description and in any position not otherwise specifically provided for drain,kerb stone,parapet etcconcrete etc all as spcified and as directed. |
| 4 | Dismantling fencing wire mesh, any type complete all as directed |
| 5 | Demolition of Unreinfoced cement concrete in ground floors and pavings n exc 15 cm thickness (below or above ground level) and removing debris off the site complete all as spcified and as directed. |
| 6 | Demolition for brickwork or stone masonry laid with cement mortar or cement lime mortar |
| 7 | Demolition of Reinforced Cement Concrete of any description and in any position not otherwise specifically provided complete all as specified and as directed |
| 8 | Excavating in trenches, n exc 1.5 m wide and n exc 1.5 m in depth; for foundation, etc. or for shafts, wells, cesspits,manholes, pier holes, etc. n exc 10 sq m on plan and n exc 1.5 m in depth and getting out hard/dense soil all as spcified and as directed. |
| 9 | Material and labour for providing plain cement concrete 1:3:6 type C2, using( 40mm graded stone aggregate )as in foundation filling and mass concrete all as specified and as directed. |
| 10 | M& L for 75mm thick PCC type C-2(1:3:6) using 40mm graded stone aggregate as in sub base for finish the surface even and rough complete all as spcified and as directed. |
| 11 | M&L Cement Concrete 1:3:6 type C2(40mm graded stone aggregate) 75mm thick in Plinth Protection, etc., Laid in Alternate Panels, finished Concrete Surfaces Even and Smoooth without Using Extra Cement, complete all as specified and as directed. |
| 12 | M&L for Walling of random rubble,uncoursed, well bonded, bedded and solidly hearted, built in cement mortar in CM(1:6) as in retaining wall,toe wall etc complete. |
| 13 | All as item No 11 above but using old stone obtained from demolition vide item No 5 above |
| 14 | M&L for Precast cement concrete block Type C1(1:3:6)(using 20 mm graded aggregate) masonry with solid solid blocks exc 10cm width and setting in mortar(1:6) complete. |
| 15 | M&L for RCC Type B1-1:2:4 (using 20mm graded aggregate )as in Columns, pillars, piers, posts and struts etc |
| 16 | Excavating in post holes (or similar holes) each n exc 0.5 cu. m, getting out, returning,filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25 cm,complete as in hard or dence soil all as directed. |
| 17 | S&F mild steel posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165 complete all as specified and as directed |
| 18 | S&F mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed the other,or screwed both ends,each screwed and to be fitted with washer and the hexogonel or square nut dia 5 to 10 mm not exc 5cm long complete all as specified and as directed |
| 19 | S&F mild steel round bars 10mm dia and over, in horizontal support for chain link straining of fencing including cut to length, bent to shape required including cranking, bending spirally for hooking ends and binding with mild steel wire (annealed) not less than 0.9mm dia or securing with clips quality conforming to Fe-410-W (Gde E-250) complete all as specified and directed. |
| 20 | S&F TMT Mild steel bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete as specified and as directed. |
| 21 | S&F TMT Mild steel bars 5mm dia and over upto and including 10mm dia in stirrups, spacers and binders complete as specified and as directed. |
| 22 | M&L for form work to sides (Flat)of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter complete all as specified |
| 23 | M & L for Square, rectangular Formwork to sides of pillars, posts, struts, piers, columns and stanchions complete all as specified |
| 24 | M&L 10mm thick rendering plaster on fair face of brick-work or concrete surface incl finish the surface even and rough as in CM 1:4 complete all as specified and as directed . |
| 25 | M&L for removing the steel gates with or without removing the gate pillars and re-fixing the gates to the existing or new pillars by changing the location of the hinges through necessary cutting and rewelding /re-fixing the hinges, aldrops, stoppers etc complete all as specified and as directed |
| 26 | Material and labour for Granite work with 20mm thick machine cut, Jet Black granite slab in single piece or two piece length, table rubbed and polished, laid over and including 15mm thick rendering in cement mortar 1:4 bedded and jointed with grey cement slurry and pointed with white cement (1:2) using marble dust and admixture of pigments to match with shade of granite stone as in vertival surface of column,steps etc etc, including cutting, polishing and rounding to edges of stone slabs etc., complete all as specified and as directed. |
| 27 | M&L for framed work such as grills, gratings, etc.. with ends of bars shouldered and/or riveted, or forged into spikes; framed guard bars; barred iron doors; ladders; framed balusters; walk ways; railings; frame work of water tanks and similar work con- forming to Fe.290.Gde-E-165. |
| 28 | S&F mild steel for Framed work as in doors or gates of angle or other section with gusset plates, rails, braces, prong ,water tank frame work,monkey gauge etc., complete, drilled for fixing of steel sheeting or other covering, doors, etc. to be prepared for hanging or sliding with and including either hooks and pintel hinges or steel hanging door fittings,( exclusive of steel sheeting or other covering, running rails and guides), CI ornaments fitting; also fastening and fixing complete and similar work confirming to Fe-290 Gde E- 165 complete all as specified and as directed |
| 29 | M&L for new or previously untreated steel surface of any description exc. 10cm width or girth and applying two coats of synthetic enamel paint over a coat of Red oxide zinc chrome primer complete all as specified and as directed |
| 30 | M&L for new or previously untreated steel Surfaces of any description, n.exc 10cm in width or girth when unconnected with other painting or when painted in a different tint and applying two coats of synthetic enamel paint over a coat of Red oxide zinc chrome primer complete all as specified and as directed |
| 31 | Supply & Fixing chain link fencing including line wires, any mesh, any size and type ( but weight not less than 3kg/sqm)of standards, rails, straining bolts, etc including provision of binding wire complete all as specified and as directed |
| 32 | M&L for chequered cement concrete tiles of size 20cmx20cmx 25mm thick ,set ,jointed and pointed in neat cement slurry in floors with grey cement and pigments of required colour over 20mm thick thick screed bed in CM (1:6) complete as specified and as directed. |
| 33 | Supply and fixing and as in repair Galvanised. 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails straining bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. as directed (each line wire to be measured) |
| 34 | M&L Raised pointing to random or polygonal rubble, uncoursed or brought upto courses in CM 1:4 complete all as specified and as directed. |
| 35 | M&L raised pointing in cement mortar 1:4 to random or polygonal rubble, uncoursed or brought upto courses including raking out joints to the joints to existing random rubble or polygonal rubble uncoursed or brought up to courses in cement mortar complete all as specified and as directed. |
| 36 | M&L 15mm thick rendering plaster on fair face of brick-work or concrete surface incl finish the surface even and smooth without using extra cement in CM 1:6 complete all as specified and as directed . |
| 37 | Material and labour for providing plain cement concrete 1:3:6 type C2, using( 40mm graded stone aggregate )as in drain / surface channel including necessary form work complete all as specified and as directed. |
| 38 | Material and labour for complete removal of existing surface of wall of any description and appying two coat cement base paint over one coat chalk white primer on newly plastered surface including preperation of the surface all as specified and directed., |
| 39 | Material and labour for appying two coat cement base paint over one coat chalk white primer on newly plastered surface including preperation of the surface all as specified and directed., |
| 40 | S&F UPVC (SWR) pipes single socketed, in any length as in weep hole etc fixed to walls (110mm bore) complete all as specified and as directed |
| 41 | Returning filling including spreading leveling watering and well ramming in layers not exc 25 cm hard and dense soil |
| 42 | Removing excavated material (soils)not exc 50M and depositing where directed at a level not exc.1.5 mtr above the starting point |
| 43 | M & L for PCC 1:3:6 type C-1 using 20mm graded stone aggragate as in lintels upto 1.5m clear steps,cills; seismic and other similar bands,plinth courses, string courses,lacing courses, parapets and railings upto 60 cm in height,copings, kneelers, apex stones,bed plates, kerbs and the like including weathering, slightly rounded or chamfered angles and throating, complete all as directed |
| 44 | PROVN OF DRAIN ALONG WITH TOE WALL AT REAR SIDE OF NN 7 TO 9 AT DSSC WELLINGTON. |
| 45 | Excavating in trenches, n.exc 1.5m wide and n exc 1.5 in depth; for foundation getting out hard/dense soil. |
| 46 | Material and labour for providing plain cement concrete 1:4:8 type D2, using( 40mm graded stone aggregate )as in foundation filling and mass concrete for manhole&Septic tank all as specified and as directed. |
| 47 | M&L for Precast cement concrete block Type C1(1:3:6)(using 20 mm graded aggregate) masonry with solid solid blocks exc 10cm width and setting in mortar(1:4) complete. |
| 48 | Plastering 15mm thick on fair faces of brick work or concrete surfaces to be finished fair & even without using extra cement in CM 1:4 on walls complete all as specified and as directed. |
| 49 | M & L for PCC (1:2:4) type B-0 (using 12.5 mm graded stone aggregate) as in coping over, drain walls including gormwork, weathering, slightly rounded or charmfered angles and throating complete all as specified and as directed. |
| 50 | Extra for forming fair finished drain or channel 30 cm inner girth in cement concrete, using ex- tra cement, including forms, moulds,stopped ends etc. |
| 51 | Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc 25 cm complete as in hard /dense soil all as spcified and as directed. |
| 52 | Removing excavated material(soils) n exc. 50m and depositing where directed at a level n exc. 1.5 m above the starting point all as spcified and as directed. |
| 53 | Note: Please note that if rate quoted for similar items are different, the lowest rate quoted for item shall be only considered for payments of works Please Enable Macros to View BoQ information |
