|
| 1 | Clearing jungle including uprooting of rank vegetation, grass, brush wood, trees and saplings of girth upto 30 cm measured at a height of 1 m above ground level and removal of rubbish upto a distance of 50 m outside the periphery of the area cleared. |
| 2 | Earth work in excavation by mechanical means (Hydraulic Excavator)/ manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan) including dressing of sides and ramming of bot toms, lift upto 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m. |
| 3 | Providing wood work in frames of doors, windows, clerestory , windows and other frames,wrought framed and fixed in positfon with hold fast lugs or with dash fastener of required dia and length (hold fast lugs or dash fastener Shall be paid for separately |
| 4 | 9.1.3. Local best quality Tolhao wood. |
| 5 | Providing and fixing Compressed wood flush doors shutter including ISI marked M.S butt hinges bright finished of required size with necessary screws, excluding panelling wchich will be paid for separately, all omplete as per direction of Engineer- in- charge. |
| 6 | Dismantling tile work in floors and roofs laid in cement mortar including stacking material within 50 metres lead. |
| 7 | For thickness of tiles above 10 mm and upto 25 mm |
| 8 | Providing and laying in position cement concrete of specified grade excluding the cost of centering.and shuttering - |
| 9 | All work upto plinth level: |
| 10 | 1:2:4 (1 Cement: 2 coarse sand : 4 graded stone aggregate 20 mm nominal size) |
| 11 | 1:4:8 (1 Cement: 4 coarse sand: 8 graded stone aggregate 40 mm nom size) |
| 12 | Brick work with 1st class common burnt clay F.P.S. (non modular) bricks in foundation and plinth in: |
| 13 | Cement mortar 1:4 (1 cement: 4 coarse sand) |
| 14 | Half brick masonry with 1st class common burnt clay F.P.S. (non modular) bricks in foundation and plinth in: |
| 15 | Cement mortar 1 :3 (1 cement: 3 coarse sand |
| 16 | Providing and laying Vitrified tiles in floor in different sizes (thickness to be specified by the manufacturer) with water absorption less than 0.08% and conforming to IS:15622, Of approved brand & manufacturer, in all colours and shade, laid On 20 mm thick cement mortar 1:4 (1 .cement: 4 coarse sand) jointing with grey cement slurry. @3.3 kg/sqm including grouting |
| 17 | the joints with white cement and matching pigments etc. The tiles must be cut with the'zero chipping diamond cutter only . Laying of tiles will be done with the notch trowel, plier, wedge, clips of required thickness. leveling system and rubber mallet for placing the tiles gently and easily. |
| 18 | Double charge vitrified tile polished finish of size- |
| 19 | Size of Tile 600 x 600 mm |
| 20 | Providing and fixing tiled False Ceiling of approved materials of size 595x595 mm in true horizontal level, suspended on inter locking metal grid of hot dipped galvanised steel sections ( galvanized @ 120 gsm/sqm, both side inclusive) consisting of main \\"T\\" runner with suitably spaced joints to get required length and of size 24x38mm made from.0.30mm thick (minimum) sheet, spaced at 1200mm center to center and cross \\"T\\" of size 24x25mm made of 0.30mm thick (minimum) sheet, 1200mm long spaced between main \\"T at 600mm center to center to form a:grid of 1200x600 mm and secondary cross \\"T\\" of length 600mm .arid sjze 24x25mm made of 0.30 mm thick (minimum) sheet to be interlocked at middle of the 1200x600mm paneLto form grids of 600x600mm and wall angle of size 21x21x0.3 mm and laying false ceiling tiles of approved texture in the grid including, required cutting/making, opening for services like diffusers, grills, light fittings, fixtures, smoke detectors etc, Main \\"T\\" runners to be suspended from ceiling using Gl slotted cleats of size 27x 37 x 25 x 1.6 mm fixed to ceiling with 12.5 mm dia and 50mm long dash fasteners, 4mm Gl adjustable rods with galvanised butterfly level clips of size 85 x 30 x 0.8 mm spaced at 1200mm center to center along.main T, bottom exposed width of 24mm of all T-sections shall be pre-painted with polyester paint, all complete at all heights as per specifications, drawings and as directed by Engineer-in-Charge. (The rate is excluding the cost of tiles which will be paid for separately). 12.48.1. Gl Metal ceiling Lay in plain Tegular edge Global white color tiles of size 595 x 595 mm, and 0.5 mm thick with 8 mm drop, made of Gl sheet having galvanizing of 100 gms/sqm( both sides inclusive) and electro statically polyster powder coated of thickness 60 microns (minimum), including factory painted after bending. |
| 21 | Providing and fixing curtain rods of 1.25 mm thick chromium plated brass plate.with two chromium plated brass brackets fixed with,C.P. brass screws and wooden plugs, etc., wherever necessary complete |
| 22 | Providing and fixing P.V.C. waste pipe for sink or wash basin including P.V.C. waste fittings complete, |
| 23 | Flexible pipe |
| 24 | 32 mm dia |
| 25 | 15 mm cement plaster of mix |
| 26 | 1:4 (1 cement: 4 fine sand) |
| 27 | Steel work in built up tubular (round, square or rectangular tubes etc.) trusses etc., including cutting, hoisting fixing in position and applying a priming coat of approved steel primer, including welding and bolted including special shaped washers etc. complete. |
| 28 | Electric resistance or induction butt welded tubes. |
| 29 | Applying one coat of water thinnable cement primer of approved brand and manufacture on wall surface : |
| 30 | Water thinnable cement primer |
| 31 | Wall painting with plastic emulsion paint of approved brand and manufacture to give an even shade. |
| 32 | Two or more coats on new work- |
| 33 | Finishing walls with Acrylic Smooth exterior paint of required shade New work (Two or more coat applied @1.67 ltr/10 sqm over and including base coat of water proofing cement paint applied @ 2.20 kg /10 sqm). |
| 34 | Applying priming coat :- |
| 35 | with ready mixed red oxide zinc chromate primer of approved brand and manufacture on steel galvanised iron/steel works |
| 36 | Painting with synthetic enamel paint of approved brand and manufacture to give an even shade: |
| 37 | Two or more coats on new work |
| 38 | Providing and fixing white vitreous china pedestal type water closet (European type W.C. pan) with Seat and lid, 10 litre low level white P.V.C. flushing cistern, including flush pipe, with manually controlled device (handle lever), conforming to IS : 7231, with all fittings and fixtures complete, including cutting and making good the walls and floors wherever required |
| 39 | W.C. pan with ISI marked white solid plastic seat and lid. |
| 40 | Providing and fixing Chlorinated Polyvinyl Chloride (CPVC) pipes, having thermal stability for hot & cold water supply, including all CPVC plain & brass threaded fittings, including fixing the pipe with clamps ,at 1.00 m spacing. This .includes jointing of pipes & fittings with one step CPVC, solvent cement and testing of joints complete as per direction of Engineer in Charge. |
| 41 | 20 mm nominal Outer dia Pipes |
| 42 | Providing and fixing C.P. brass bib cock of approved quality conforming, to IS:8931 |
| 43 | 15 mm nominal bore |
| 44 | Providing and fixing C.P. Brass extension nipple (size 15mmx50mm) of approved make and quality as per direction of Engineer-in-charge |
| 45 | Providing and fixing uplasticised PVC connection pipe with brass unions: |
| 46 | 45 cm length |
| 47 | 15 mm nominal bore |
| 48 | Providing and fixing solid plastic seat with lid for pedestal type W.C. pan complete.: |
| 49 | White solid plastic seat with lid |
| 50 | Providing and fixing P.V.C. low level flushing cistern with manually controlled device (handle lever) conforming to IS: 7231, with all fittings and fixtures complete |
| 51 | 10 litre capacity - White |
| 52 | Providing end fixing CP Brass 32mm size Bottle Trap of approved quality & make and as perthe direction.of Engineer-in-charge |
| 53 | Providing and fixing 8 mm dia C.B / S.'S. Jet with flexible tube upto 1 metre long with S.S. triangular plate to Eureopean type W.C. of quality and make as approved by Engineer - in - charge. |
| 54 | Providing and fixing PTMT pillar cock of approved quality and colour. |
| 55 | 15 mm nominal bore, 98 mm long, weighing not less than 75 gms |
| 56 | Providing and fixing PTMT towel rail complete with brackets fixed to wooden cleats with CP brass screws with concealed fittings arrangement of approved quality and colour. |
| 57 | 450 mm long towel rail with total length of 495 mm, 78 mm wide and effective height of 88 mm, weighing not less than 170 gms. |
| 58 | Providing and fixing mirror of superior glass (of approved quality) and.of required shape and size with plastic moulded frame of approved make and shade with 6 mm thick hard board backing : |
| 59 | Rectangular shape 453x357 mm |
| 60 | Providing and placing on terrace polyethlene water storage tank,IS:12701 marked ,with cover and suitable locking arrangement and making necessary holes for inlet,outlet and overflow pipes but without fittings and the base support for tank. Please Enable Macros to View BoQ information |
