|
| 1 | Demolition of brick work or stone/ boulder masonry, built in cement mortar or cement lime mortar including all quoins,arches, pillars,etc. but excluding ashlar facings, dressed stonework and precast concrete articles complete all as specified and directed. |
| 2 | M&L for brick work with old size full brick subclass ‘B’ burnt clay bricks, straight or curved on plan exc 6m mean radius, built in CM (1:6) complete all as specified and directed. |
| 3 | M&L for walling of random rubble masonary, well bonded, bedded and solidly hearted, brought upto courses, built in cement mortar (1:6) complete all as specified and directed.Note :- Only quantity of PCC bond stone to be deducted from quantity of random rubble masonary. |
| 4 | Description same all as item No. 03 above but except stone complete all as specified and directed. Note :- Old retreived serviceable stone under demolition item shall be used. |
| 5 | Extra over stone walling for hammer dressing with maximum depression on face from straight edge held against the dressed surfacae not exceeding 40mm to face stone for Lime or sand stone and dressing of face beds and joints, as specified of random rubble walling, uncoursed or brought upto courses complete all as specified and directed. |
| 6 | M&L for raised pointing in cement mortar (1:4) to random rubble or polygonal rubble masonary uncoursed or brought upto course complete all as specified and directed. |
| 7 | Demolition of Stone slabs and tiles of any description or thickness in floors, aprons etc complete all as specified and directed. |
| 8 | S&F 60mm thick factory made chamfered edge cement concrete paver block of M-35 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc.of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand complete all as specified and directed. |
| 9 | M&L for chequered cement concrete tiles, with grey cement and pigment of size 30cmx30cmx3 cm thick set and jointed and pointed in neat cement slurry in floors over and including 20mm thick screed bed in cement mortar (1:6) complete all as specified and as directed. |
| 10 | Demolition of cement Concrete in ground floors and pavings n exc 15 cm thickness (below or above ground level) including removal of rubbish out side MOD land complete all as specified and directed. |
| 11 | M&L for 75 mm thick PCC (1:4:8) type D2, (using 40 mm graded stone agg) as in sub base of floor complete all as specified and directed. |
| 12 | M&L for 75mm thick PCC (1:3:6), type C-2 using 40mm graded stone aggregate as in plinth protection, surface finished even & smooth with using extra cement, including necessary form work complete all as specified and directed. |
| 13 | Taking down cement plaster on brick or stone wall surfaces including glazed tiles wherever exists including raking out joints, hacking for key and scrubbing down with water etc and removing unseviceable materials out side MoD land distance n exc 1.5 km complete all as specified and as directed. |
| 14 | M&L for 10 mm thick plastering on brick or contrete surfaces, in CM (1:6), surface finished even and smooth without using extra cement complete all as specified and directed. |
| 15 | M&L for 15 mm thick plastering on other than fair faces of brick or contrete surfaces, in CM (1:4), using water proofing liquid compound as per manufacturer's instruction surface finished even and smooth without using extra cement complete all as specified and directed. |
| 16 | M&L preparation of newly plastered surface of external wall by application of 1 mm thick wall care putty to remove the dent and to make the surface even and smooth by grinding or rubbing with sand paper and applying two or more coats of 100% premium acrylic emulsion paint and including priming coat of exterior primer applied @ 0.90 ltr/10sqm complete all as specified and directed.(Putty shall be measured and paid separately.) |
| 17 | M&L preparation of newly plastered surface of internal wall by application of 1 mm thick wall care putty to remove the dent and to make the surface even and smooth by grinding or rubbing with sand paper and applying two coats of acrylic distemper over a coat of primer using roller complete all as specified and directed.(Putty shall be measured and paid separately.) |
| 18 | M&L for 1 mm thick acrylic/water proofing wall putty and surface finished even and smooth with sand paper complete all as specified and directed. |
| 19 | Demolition of reinforced cement Concrete in ground floors n exc 15 cm thickness (below or above ground level) including removal of rubbish out side MOD land complete all as specified and directed. |
| 20 | M&L for RCC (1:2:4) type B1, (using 20mm graded stone aggregates) as in precast cover slab (for manholes and soak well) and set in CM (1:4) including necessary fair finish formwork complete all as specified and directed.(Note- Reinforcement shall be measured and paid separately) |
| 21 | M&L for RCC (1:2:4) Nominal mix type B1(using 20mm graded stone aggregates) as in beams, cantilevers, bressummers, lintels over 1.5m span complete all as specified and directed. |
| 22 | M&L for formwork for rough finish to sides and soffits of floor or roof beams, beam haunchings, girders, bressum-mers, lintels, cantilevers, shelves including supports, overhangs, etc. also splays between floors and beams, etc complete all as specified and directed. |
| 23 | M&L for mild steel TMT bars as in reinforcement, 10mm dia and over cut to length, bent to shape required including cranking, bending spirally for hooping for coloumn, hooking ends and binding with mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and directed. |
| 24 | Dismantling of posts or struts (wood, steel or R.C.C.) any section, including taking out embedded portion from natural ground and making good disturbed ground complete all as specified and directed. |
| 25 | Excavating in post holes (or similar holes) in hard/ dense soil, each n exc 0.5 cum, getting out and removing surplus soil to a distance n.exc 50 m and making good surface complete all as specified and directed. |
| 26 | M&L for PCC (1:2:4) type B2 (using 40mm graded stone agg) as in foundation, embedding of post etc complete all as specified and directed. |
| 27 | Dismantling of fencing wire mesh, any type complete all as specified and directed. |
| 28 | Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provission of binding wire complete all as specified and directed. |
| 29 | Supply only Chain link MS galvanisd fencing, anysize or type complete all as specified and directed. |
| 30 | S&F galvanised, 2 strand, steel barbed wire 2.24 mm dia barbed with 2 mm dia barbs at 75 mm spacings and straining and fixing to any type of standard rails straining bolts , including,securing or tying at crossings with and Provision of galvanised mild steel wire, staples or steel pins etc. as directed ( each line wire to be measured) complete all as specified and directed. |
| 31 | S&F 11 to 15 mm dia of neck mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, n exc 5cm long complete all as specified and directed. Please Enable Macros to View BoQ information |
| 32 | S&F 11 to 15 mm dia of neck mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, n exc 5cm long complete all as specified and directed. Please Enable Macros to View BoQ information |
