|
| 1 | Boring with hydraulic piling rigs with power units, providing and installing cast in situ single under reamed piles of specified 300 mm dia meter and 3 mtr length below pile cap in M-25 cement concrete, to carry a safe working load not less than specified, excluding the cost of steel reinforcement but including the cost of boring with bentonite solution and the length of the pile to be embedded in pile cap etc. all complete. (Length of pile for payment shall be measured upto to the bottom of pile cap) : |
| 2 | Providing and laying in position ready mixed or site batched design mix cement concrete for reinforced cement concrete work; using coarse aggregate and fine aggregate derived from natural sources, Portland Pozzolana I Ordinary Portland /Portland Slag cement, admixtures in recommended proportions as per IS: 9103 to accelerate I retard setting of concrete, to improve durability and workability without impairing strength; including pumping of concrete to site of laying, curing, carriage for all leads; but excluding the cost of centering, shuttering, finishing and reinforcement as per direction of the engineer-in-charge, for the following grades of concrete.: Note: Extra cement up to 10% of the minimum specified cement content in design mix shall be payable separately. In case the cement content in design mix is more than 110% of the specified minimum cement content, the contractor shall have discretion to either re-design the mix or bear the cost of extra cement. |
| 3 | Centring and shuttring in Columns strutting, propping etc. and removal of form work. |
| 4 | Providing and laying in position ready mixed or site batched design mix cement concrete for reinforced cement concrete work; using coarse aggregate and fine aggregate derived from natural sources, Portland Pozzolana I Ordinary Portland /Portland Slag cement, admixtures in recommended proportions as per IS: 9103 to accelerate I retard setting of concrete, to improve durability and workability without impairing strength; including pumping of concrete to site of laying, curing, carriage for all leads; but excluding the cost of centering, shuttering, finishing and reinforcement as per direction of the engineer-in-charge, for the following grades of concrete.: Note: Extra cement up to 10% of the minimum specified cement content in design mix shall be payable separately. In case the cement content in design mix is more than 110% of the specified minimum cement content, the contractor shall have discretion to either re-design the mix or bear the cost of extra cement. |
| 5 | Centring and shuttring in Plinth beams including strutting, propping etc. and removal of form work. |
| 6 | Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in superstructure above plinth level up to floor V level in all shapes and sizes in: |
| 7 | Structurl Steel work Riveted, Bolted or welded in built up section, trusses and freamd work including cutting hoisting fixing in position and applying a priming coat of approved steel primer, etc. complete Hot finished welded type tubes. (AS per DSR coad no 10.2) |
| 8 | Providing corrugated G.S. sheet roofing including vertical / curved surface fixed with polymer coated J or L hooks, bolts and nuts 8 mm diameter with bitumen and G.I. limpet washers or with G.I. limpet washers filled with white lead, including a coat of approved steel primer and two coats of approved paint on overlapping of sheets complete (up to any pitch in horizontal/ vertical or curved surfaces), excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required. 1mm thicknes |
| 9 | 12 mm cement plaster of mix :1:6 (1 cement: 6 coarse sand) |
| 10 | Providing and laying Vitrified tiles in different sizes (thickness to be specified by manufacturer), with water absorption less than 0.08 % and conforming to LS. 15622, of approved make, in all colours & shade, in skirting, riser of steps, over 12 mm thick bed of cement mortar 1 :3 (1 cement: 3 coarse sand), jointing with grey cement slurry @ 3.3 kg/ sqm including grouting the joint with white cement & matching pigments etc. complete. Size of Tile 600x600 mm |
| 11 | Providing and applying white cement based putty of average thickness 1 mm, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete. |
| 12 | Finishing walls with Premium Acrylic Smooth exterior paint with Silicone additives of required shade:New work (Two or more coats applied @ 1.43 ltr/10 sqm over and including priming coat of exterior primer applied @ 0.90 litre/10 sqm) |
| 13 | Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete upto plinth level Thermo-Mechanically Treated bars of grade Fe-500D or more. |
| 14 | Supplying and fixing rolling shutters of approved make, made of required size M.S. laths, interlocked together through their entire length and jointed together at the end by end locks, mounted on specially designed pipe shaft with brackets, side guides and arrangements for inside and outside locking with push and pull operation complete, including the cost of providing and fixing necessary 27.5 cm long wire springs manufactured from high tensile steel wire of adequate strength conforming to IS: 4454 - part 1 and M.S. top cover of required thickness for rolling shutters.80x1 .25 mm M.S. laths with 1.25 mm thick top cover |
| 15 | Providing and fixing ball bearing for rolling shutters. |
| 16 | Witing for twin control light point with 1.5 sqmm FRLS PVC insulated copper conductor single core cable in surface/recessed medium class PVC conduit, with modular switch, modular plate, suitable GI box and earthing the point with 1.5 sq.mm PRLS PVC insulated copper counductor single core cable etc. as required. |
| 17 | Wiring for light point fan point/call bell point with 1.5 sq.mm FRLS PVC insuilated copper conductor single core cablein surface/recessed medium class PVC conduit with plano type switch phenolic laminled sheet suitable size M.S. box and earthing the point with 1.5 sq.mm FRLS PVC insulated copper conductor single core cable etc as required. |
| 18 | Supply and writing of 4 number 10 sq.mm FRLSH PVC insulated 1100 V grade sngle core copper 32 mm dia heavy gauge rigid PVC conduit on surface with 2 number 6 sq.mm single copper conductor cable as earth continully wire drawn in condiit complete in all respect. |
| 19 | Earthing with G.I earth plate 600 mm x 600 mm x 6 mm thick including accessories and providing masonry enclosure with cover plate having locking arrangment and watering pipe of 2.7 meter long etc.with charcoal/coke and salt as required. |
| 20 | Supply & Laying of 25 mm x 3mm G.I. strip from earth lectrode directly in the ground as required complete in all respects. |
| 21 | Supply and fixing of with two number 8 SWG G.I. wire in 15mm dia G.I. pipe for earthing, laid in ground or in wall duly concealed including the cost of cement, sand, labour, T&P other material required for proper completion of the work as directed at site. |
| 22 | Supply and fixinfg of IP 20 Front Lit Mid power SMD type LED Light recess/Surface mounting round 18 watt to 20 watt cut out min 150mm Hight min 40 mm LED Down Lighter having Powder coated die cast aluminium housing with heat sink, High purity/transmisivity UV stabilized Non yellowish diffuser/Reflector for uniform light distribution detachable driver set suitable for 24 Hr Conlinuous Operation Complete in All Respect. 1980-2200 System lumens, > 110 Lm/W PF>0.95 THE<10% at full load CRI>80, with 3 years warrantee. SI No. 23.03 CAT-AA |
| 23 | Providing and fixing following capacity 32 A TP&N disconnector fuse switch unit inside the existing panel board with ISI marked HRC fuses including drilling holes in cubicle panel, making connections. Etc as required. |
| 24 | Supplying and fixing Single pole and neutral 5A to 32 A rating, 240/415 V, 10 ka, \\"C\\" curve miniature circuit breaker suitable for load of following poles in the existing MCB DB complete with connections, testing and commissioning etc. |
| 25 | Supply in fixing of stone granite with letter wrriting in all of comletcition of work. |
| 26 | Add 18% GST Please Enable Macros to View BoQ information |
