|
| 1 | Demolition of cement concrete of any description and in any position not otherwise specifically provided for and removing rubbish to a distance n.exc 100m at low lying area complete all as specified and directed. |
| 2 | M & L for 100mm thick cement concrete (1:2:4) type B-1 ( using 20mm graded stone agg.) as in floor finishing cement concrete surface even and smooth without using extra cement complete all as specified and directed. |
| 3 | M & L for 75mm thick cement concrete (1:3:6) type C-2 ( using 20mm graded stone agg.) as in floor finishing/Plinth protection cement concrete complete all as specified and directed. |
| 4 | M & L for 40mm thick cement concrete (1:2:4) type B-1 ( using 20mm graded stone agg.) as in subbase/below the tiles complete all as specified and directed. |
| 5 | M & L PCC 1:4:8 Type D-2 ( using 40mm graded stone agg.) as in foundation , filling and mass concrete complete all as specified and directed. |
| 6 | M&L for PCC 1:2:4(Nominal mix)(using 20mm gradded stone aggregate) type B1 using stone aggregate as in coping benching complete all as specified and directed. |
| 7 | Demolition of reinforced cement concrete in any position (reinforcement cut as required to facilitate demolition) and removing rubbish to a distance 50m at low lying area complete all as specified and directed |
| 8 | M & L pre-cast RCC 1:2:4 Type B1 using 20mm gradded stone aggregate as in manhole cover/Drain cover slab and setting in CM (1:6) complete all as specified and directed. |
| 9 | M&L for RCC (nominal mix) Type B1(1:2:4) (using 20mm gradded stone aggregate) as in beams and lintels above1.50m clear span etc. complete all as specified and directed. |
| 10 | M&L reinforced cement concrete nominal mix type B1 (1:2:4) using 20 mm graded stone aggregate Slabs supported on walls, beams and columns in floors, roofs, landings, balconies, canopies, deck slabs and in shelves and the like complete all as specified and as directed. |
| 11 | Use and waste for formwork to soffits of suspended slabs such as roof slabs, floor slabs, landings and similar work; not exceeding 200mm thick (Horizontal or sloping)complete all as specified and directed. |
| 12 | Formwork to side and soffits of floor or roof beams,lintels etc flat for fair finished surfaces complete all as specified and directed. |
| 13 | S&F mild steel TMT bars 10mm dia and over, cut to length bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire not less than 0.9mm dia or securing with clip and confirming to grade Fe-410-W(Gde-250) complete all as specified and directed. |
| 14 | All as per item no. 13 here in before but 5mm dia and over upto and incl. 10mm dia in stirrups spacers and binders complete all as specified and directed. |
| 15 | M & L Providing precast cement concrete 1:3:6 Type C0 (12.5mm gradded stone aggregate) louvres and jallies, 25mm thick (measured solid), including all mould- ings setting in CM (1:6) complete all as specified and directed. |
| 16 | Demolition of Stone slabs and tiles laid, bedded and pointed in any mortar any description or thickness in floors, aprons etc complete all as specified and directed. |
| 17 | M&L liquior finish/glossy finish chequered cement concrete tiles 30cm x 30cm x 25 mm thick, set, jointed and pointed in neat cement slurry in floors using white cement and pigments including 15mm thick screed bed in CM 1:6etc (as in patches and as per site condition) as per design/pattern approved by AGE(I) etc complete all as specified and directed. |
| 18 | M&L liquior finish/glossy finish Machine pressed precast concrete interlocking paver block rubber moulded laid with Grey cement and pigment any size and shape conforming to IS 15658-2006 of 60mm thick M-35grade over and including 50 thick sand cushion etc complete all as specified and directed. |
| 19 | Demolition of Brickwork of stone/boulder masonry, build in cement mortar including all quoins, arches, pillars etc, but excluding ashlars facings, dressed stonework and precast concrete articles complete all as specified and directed. |
| 20 | M & L for brick work with sub class 'B' old size brick straight or curved on plan exc 6m mean radius built in cement mortar (1:6) complete all as specified and directed. |
| 21 | M & L for Walling of random rubble, uncoursed, well bonded, bedded and solidly hearted, built in cement mortar1:6 complete all as specified and directed. |
| 22 | All as per item no-21 here in before but except stone complete all as specified and directed. |
| 23 | Extra over stone walling for hammer (granite or trap stone) dressing to face of stone wall and dressing of faces, beds and joint with maximum depression on face from straight edge held against the dressed surfaces n. exc. 20mm complete all as specified and directed. |
| 24 | Raking out joints/ pointing to random rubble or polygonal rubble uncoursed or brought up to courses edge in floors, surface channels, roofs, etc complete all as specified and directed. |
| 25 | M & L Raised pointing to random or polygonal rubble,With cement mortar (1:4) uncoursed or brought upto courses complete all as specified and directed. |
| 26 | Taking down cement plaster of any description on brick or stone walls, Chajjas etc., including raking out joints, hacking for key, scrubbing down with water etc. complete all as specified and directed. |
| 27 | Material & Labour for 15mm thick rendering in Cement Mortar 1:6 on stone masonry surfaces, finished even and smooth without using any extra cement complete all as specified and as directed. |
| 28 | Material & Labour for 15mm thick rendering in Cement Mortar 1:6 on brick work or concrete surfaces, finished even and smooth without using any extra cement complete all as specified and as directed. |
| 29 | M&L for preparation of new surface and and applying two coats of cement base paint over a coat of white cement primer on walls complete all as specified and directed. |
| 30 | M&L for two coats of oil bound distempering over a coat of priming plastered and other surfaces with alkali-resistant priming paint on newly plastered surfaces of wall including preparation of surface complete all as specified and directed. |
| 31 | Dismantling ,posts or struts (wood, steel or RCC) any section , including taking out embedded portion in natural ground and making good disturbed ground complete all as specified and directed. |
| 32 | S&F MS angle iron post & strut etc. in fencing including embedding in concrete and screwing etc. including securing bolts; posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 GdeE-165 complete all as specified and directed. |
| 33 | Excavation of soft/loose soil in post holes (or similar holes) each n exc 0.5 Cum getting out returning ,filling in and ramming earth or broken rubble mixed with earth around ,in layers not exceeding 25cm ,watering complete all as specified and directed. |
| 34 | M&L for cement concrete type C2 1:3:6 (40 mm graded stone aggregate) in foundations, filling and mass concrete or for fixing of RCC/ angle post complete all as specified and directed. |
| 35 | S&F Mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, n exc 5cm long and diameter of neck 5 to 10mm complete all as specified and directed. |
| 36 | Dismantling wrought iron or mild steel work of any description not otherwise provided for complete all as specified and directed. |
| 37 | S&F Mild steel framed work as in grills, with ends of bars shouldered work conforming to Fe-410-0 as per existing grills at site complete all as specified and directed. |
| 38 | S&F Framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to beprepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing complete. Conforming to ( Fe-290 (Gde E-165)) complete all as specified and directed. |
| 39 | S& F Steel work in tubular trusses including special shaped washer etc. complete using ERW or induction butt welded tubes complete all as specified and directed. |
| 40 | Dismantling plain or corrugated steel sheeting, any gauge, thickness, incl nanital or similar pattern roof covering complete all as specified and directed.. |
| 41 | S&F Pre- painted galvalume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws complete all as specified and directed. |
| 42 | M&L preparation of new steel surfaces of any description, over 10cm in width or girth,not otherwise described and apply two coats of synthetic enamel paints over a coat of red oxide zinc chrome primer complete all as specified and directed. Please Enable Macros to View BoQ information |
