|
| 1 | Demolition of cement concrete in ground floor and pavings (un-reinfored) n.exc 15 cm thickness (below or above ground level) complete all as specified. |
| 2 | M&L for 75mm thick PCC 1:4:8, type D2 (using 40mm graded stone aggregate) as in sub base complete all as specified. |
| 3 | M&L for Sand filling under floors or in foundation including watering and consolidation complete all as specified. |
| 4 | M&L Machine pressed precast concrete interlocking paver block any shape and size confirming to IS 15658-2006 of 60mm thickness, M-35 Grade with grey cement and pigment complete all as specified. |
| 5 | M&L for 40mm thick PCC (1:2:4) type B-0, using 12.50mm graded stone aggregate as bearing coat concrete to floor finish complete all as specified. |
| 6 | M&L for pre-cast concrete block as in Kerb Stone (Machine made) with solid blocks Type B1, 1:2:4 (20mm graded stone aggregate) exc 10 cm in width and setting in cement mortar 1:4 complete all as specified. |
| 7 | Demolition of Brickwork or stone/boulder masonry, built in cement mortar including all quoins, arches, pillars, etc but excluding ashlar facings, dressed stonework and precast concrete articles complete all as specified. |
| 8 | M&L for square rubble walling Jodhpur type regular course well bonded bedded and solidly hearted built in cement mortar (1:6) complete all as specified. |
| 9 | All as per Ser Item No 20 above but except stone complete all as specified. |
| 10 | Extra over on stone walling for hammer dressing to face stone with maximum depression on face from straight edge n exc 20mm and dressing faces beds and joints as specified and square rubble walling regular course Jodhpur type complete all as specified. |
| 11 | Raking out joints/pointing to squarred rubble masonry, coursed or uncoursed built in cement mortar complete all as specified. |
| 12 | M&L for keyed pointing to stone masonry surface in CM 1:4 complete all as specified. |
| 13 | M&L for PCC (1:4:8) type-D2 by using 40 mm graded stone agg as in foudation, filling and mass concrete complete all as specified. |
| 14 | M&L brickwork with fly ash bricks, straight or curved on plan exc 6m mean radius built in CM 1:6 complete all as specified. |
| 15 | M&L for rendering 15mm thick in CM (1:4) finished even and smooth without using extra cement on external surfaces of concrete surfaces of wall complete all as specified. |
| 16 | M&L for preparation of new plastered surface of wall and applying two coat of white wash complete all as specified. |
| 17 | M&L for Providing precast cement concrete (1:2:4) type B-0 using 12.5 mm graded stone agg for Jallies 50 mm thick (measure solid) including all moulding and set in CM (1:4) complete all as specified. |
| 18 | M&L cement concrete type C2 1:3:6 (40mm graded aggregate) as in surface channel of drains complete all as specified. |
| 19 | M&L cement concrete type B1, 1:2:4 (20mm graded aggregate) as in coping and similar etc complete all as specified. |
| 20 | M&L for Extra for forming fair finished drain or channel 30cm inner girth in cement concrete, using extra cement, including forms, moulds, mitred/stopped ends etc complete all as specified. |
| 21 | M&L for 50mm thick PCC 1:3:6 type C-2 (using 40 mm graded stone aggregate) as in ramp concrete shall be laid in alternate bays not exceeding 3.00 m in length, finished even and smooth without using extra cement complete all as specified. |
| 22 | M&L 100mm thick PCC type B-2, 1:2:4 (40mm graded aggregate) as in hardstanding concrete shall be laid in alternate bays not exceeding 3.00 m in length, finished even and smooth without using extra cement complete all as specified. |
| 23 | Taking down cement plaster on brick or stone walls, etc. including raking out joints, hacking for key, scrubbing down with water etc complete all as specified. |
| 24 | M&L for rendering 15mm thick ready mix plaster in ratio 1:4 factory made blended mixture of OPC and graded sand (silica sand) and high quality additives designed for consistant quality and and high adhesion on fair face of stone/concrete surfaces finished even and fair without using extra cement including taking down of cement plaster complete all as specified. |
| 25 | Material and labour for 15mm thick rendering in CM 1:4 on stone masonry/concrete surfaces and Extra over rendering or plastering for work in isolated widths or in widths not forming part of general plastering such as in bands, sunk panels, cornices, skirtings, drip moulds and similar work n exc 15 cm in width or girth; including cutting to edges, all mitres and stopped ends etc complete all as specified.Note:- WPC shall be measured and paid separately. |
| 26 | Material and labour for preparation of newly plastered surface of walls and applying two coats of cement base paint complete all as specified. |
| 27 | M&L for one coat of cement base paint on old plastered/pointed surfaces of walls including necessary preparation of surfaces complete all as specified. Please Enable Macros to View BoQ information |
